Superfluid critical-velocity measurements utilizing phase coupling
Superfluid flow through parallel channel, obtaining critical velocity measurements by phase coupling
Corke, H. E.↗
SEARCH · Engineering Papers
Results for “phase measurement”
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Phase average measurements of the coherent structure in a Mach number 0.6 jet
Phase averaged measurements of the axial mass velocity, radial velocity, and the product of the two have been made in an artificially excited cold air jet. The radial velocity fluctuations had a lower amplitude for both the full wave and phase averaged fluctuations compared to the axial mass velocity fluctuations. The Reynolds stress tended to decay faster in amplitude than the axial mass velocity and radial velocity fluctuations for both the full wave and phase averaged components. The radial velocity fluctuations possessed higher levels of coherence than the axial mass velocity fluctuation and the Reynolds stress. When the jet was excited at the frequency of St = 0.474, a high amplitude component at that frequency dominated the entire phase averaged flowfield from X/D = 1 to 10. This fundamental frequency was accompanied by several relatively high amplitude harmonics. These harmonics were more pronounced in the radial velocity fluctuations than for the axial fluctuations or the Reynolds stress.
Emami, S.↗
Measurement of phase variance and autocorrelation during radio-star visibility fades.
Phase variance and autocorrelation measurement during radio star visibility fades
Fremouw, E. J.↗
British American satellite time transfer experiment
The use of the Timation satellite for navigation purposes is discussed. The advantages of the satellite for navigation and time transfer are defined as: (1) well-known position, (2) line-of-sight signal which allows use of ultrahigh frequency signals, (3) worldwide coverage, and (4) celestial navigation solution similar to the conventional celestial navigation practices. A diagram of range measurement by phase measure is provided. The application of an intercept chart for determining position using the navigation satellite is demonstrated. The results of a ground based time transfer experiment are reported.
EASTON R. L.↗
(abstract) Studies of Interferometric Penetration into Vegetation Canopies using Multifrequency Interferometry Data at JPL
Radar interferometric observations both from spaceborne and airborne platforms have been used to generate accurate topographic maps, measure milimeter level displacements from earthquakes and volcanoes, and for making land cover classification and land cover change maps. Interferometric observations have two basic measurements, interferometric phase, which depends upon the path difference between the two antennas and the correlation. One of the key questions concerning interferometric observations of vegetated regions is where in the canopy does the interferometric phase measure the height. Results for two methods of extracting tree heights and other vegetation parameters based upon the amount of volumetric decorrelation will be presented.
radar interferometry vegetation land cover↗
Distributed antenna system and method
System and methods are disclosed for employing one or more radiators having non-unique phase centers mounted to a body with respect to a plurality of transmitters to determine location characteristics of the body such as the position and/or attitude of the body. The one or more radiators may consist of a single, continuous element or of two or more discrete radiation elements whose received signals are combined. In a preferred embodiment, the location characteristics are determined using carrier phase measurements whereby phase center information may be determined or estimated. A distributed antenna having a wide angle view may be mounted to a moveable body in accord with the present invention. The distributed antenna may be utilized for maintaining signal contact with multiple spaced apart transmitters, such as a GPS constellation, as the body rotates without the need for RF switches to thereby provide continuous attitude and position determination of the body.
Fink, Patrick W.↗
Two-dimensional high temperature optical strain measurement system, phase 2
A laser speckle strain measurement system with two-dimensional measurement capabilities has been built and tested for high temperature applications. The 1st and 2nd principle strains at a point on a specimen are calculated from three components of one-dimensional strain. Strain components are detected by cross-correlating reference and shifted speckle patterns recorded before and after straining the specimen. Speckle patterns are recorded by a linear photodiode array camera. Accurate strains have been measured at temperatures up to 650 C. Stable speckle correlations and linear stress-strain relations have been demonstrated up to 750 C. The resolution of the system is 15 microstrains, with a gauge length less than 1 mm.
Lant, Christian T.↗
Translating Phased Array Measurements of a Low-Noise Top-Mounted Propulsion Installation for a Supersonic Airliner
A novel translating-phased-array technique was applied during a model-scale validation test of low-noise propulsion concepts for supersonic transport aircraft. The test involved particle image velocimetry, far field and translating phased array acoustic measurements. This paper covers the translating phased array portion. Data were acquired for a series of nozzles with different chevron designs, both uninstalled and installed on a representative aircraft planform. The far field data confirmed the noise reduction potential of top-mounted installation, while the phased array results gave insights into how the reduction occurred and highlighted areas for improvement. This was the inaugural test for the new translating phased array, which measures source maps as seen by observers at different polar angles. Propagation effects through the free jet were documented for the different viewing angles. The source maps obtained were used to understand important aspects of the far field noise measurements.
Beamforming↗
Phase Averaged Measurements of the Coherent Structure of a Mach Number 0.6 Jet
The existence of a large scale structure in a Mach number 0.6, axisymmetric jet of cold air was proven. In order to further characterize the coherent structure, phase averaged measurements of the axial mass velocity, radial velocity, and the product of the two were made. These measurements yield information about the percent of the total fluctuations contained in the coherent structure. These measured values were compared to the total fluctuation levels for each quantity and the result expressed as a percent of the total fluctuation level contained in the organized structure at a given frequency. These measurements were performed for five frequencies (St=0.16, 0.32, 0.474, 0.95, and 1.26). All of the phase averaged measurements required that the jet be artificially excited.
Emami, S.↗
Measurement-induced phase transition in teleportation and wormholes
We demonstrate that some quantum teleportation protocols exhibit measurement induced phase transitions in Sachdev-Ye-Kitaev model. Namely, Kitaev-Yoshida and Gao-Jafferis-Wall protocols have a phase transition if we apply them at a large projection rate or at a large coupling rate respectively. It is well-known that at small rates they allow teleportation to happen only within a small time-window. We show that at large rates, the system goes into a new steady state, where the teleportation can be performed at any moment. In dual Jackiw-Teitelboim gravity these phase transitions correspond to the formation of an eternal traversable wormhole. In the Kitaev-Yoshida case this novel type of wormhole is supported by continuous projections.
Physics↗
Analog circuit for the measurement of phase difference between two noisy sine-wave signals
A simple circuit was designed to measure the phase difference between two noisy sine waves. It locks over a wide range of frequencies and produces an output proportional to the phase difference of rapidly varying signals. A square wave locked in frequency and phase to the first signal is produced by a phase-locked loop and is amplified by an operational amplifier.
Shakkottai, P.↗
A probability density function model describing height estimation uncertainty due to image pixel intensity noise in digital fringe projection measurements
Digital fringe projection is a surface-profiling technique used for highly accurate non-contact measurements. As with any measurement technique, a variety of sources degrade to the measurement accuracy of the method. Here, this paper presents an analytically-derived probability density function that explicitly models the surface height measurement error due to inevitable phase measurement error, and it includes the specific case of pixel noise inducing the phase measurement error that ultimately leads to the height estimation error. The accuracy of the model was validated through Monte-Carlo simulations of resultant height distributions subject to arbitrarily correlated pixel intensity noise and experimental digital fringe projection measurements where the pixel-by-pixel height uncertainty estimations were compared to the predictions of the derived model.
42 ENGINEERING↗
High latitude proton precipitation and light-ion density profiles during the magnetic storm initial phase
Measurements of precipitating protons and light ion densities by experiments on OGO-4 indicate that widespread proton precipitation occurs in predawn hours during the magnetic storm initial phase from the latitude of the high-latitude ion trough, or plasmapause , up to Lambda 75 deg. A softening of the proton spectrum is apparent as the plasmapause is approached. The separation of the low-latitude precipitation boundaries for 7.3 kev and 23.8 kev protons is approximately 1 deg, compared with a 3.6 deg separation which has been computed using the formulas of Gendrin and Eather and Carovillano. Consideration of probable proton drift morphology leads to the conclusion that protons ase injected in predawn hours, with widespread precipitation occurring in the region outside the plasmapause. Protons less energetic than approximately 7 kev drift eastward, while the more energetic protons drift westward, producing the observed dawn-dusk asymmetry for the lower-energy protons.
Burch, J. L.↗
High-latitude proton precipitation and light ion density profiles during the magnetic storm initial phase.
Measurements of precipitating protons and light ion densities by experiments on Ogo 4 indicate that widespread proton precipitation occurs in predawn hours during the magnetic storm initial phase from the latitude of the high-latitude ion trough, or plasmapause, up to latitudes greater than 75 deg. A softening of the proton spectrum is apparent as the plasmapause is approached. The separation of the low-latitude precipitation boundaries for 7.3-keV and 23.8-keV protons is less than about 1 deg, compared with a 3.6-deg separation that has been computed by using the formulas of Gendrin and Eather and Carovillano. Consideration of probable proton drift morphology leads to the conclusion that protons are injected in predawn hours, widespread precipitation occurring in the region outside the plasmapause. Protons less energetic than 7 keV drift eastward, whereas the more energetic protons drift westward, producing the observed dawn-dusk asymmetry for the lower-energy protons.
Burch, J. L.↗
Phase coherency measurements on ATS-6 L-band emissions
The phase difference between two receivers was measured as a function of their spatial separation up to a maximum of 800 ft. The ATS-6 L-band emission was used in the experiment. Phase fluctuations appear uncorrelated at the large baselines.
Lim, T. L.↗
Evidence of ordering in Cu-Ni alloys from experimental electronic entropy measurements
Phase diagrams exhibiting extended solid-solution and lenslike melting are often reproduced using ideal solutions, where ideal mixing considers a fully random configurational entropy of mixing. In the field of irreversible thermodynamics, experimental measurements of the composition variation of high-temperature electronic transport and molten-state properties suggest, however, a strong role for short-range atomic ordering in these systems. Herein, measurements of the thermopower and resistivity are reported for Cu-Ni solid solutions as a function of temperature and composition. The electronic transport properties were interpreted with an irreversible thermodynamic framework, revealing a large electronic contribution to the entropy of mixing. By considering a cluster model for the configurational entropy that uses the electronic contribution to inform the existence of ordered associates, we rationalize such a contribution of the electronic entropy with the ideal entropy of mixing commonly used to model such systems. In conclusion, these results suggest that the short-range order of the atoms plays a significant role in both solid and liquid states, even when there are no dominant intermetallic compounds in these alloys.
36 MATERIALS SCIENCE↗
An Overview of Recent Phased Array Measurements at NASA Glenn
A review of measurements made at the NASA Glenn Research Center using an OptiNAV Array 48 phased array system is provided. Data were acquired on a series of round convergent and convergent-divergent nozzles using the Small Hot Jet Acoustic Rig. Tests were conducted over a range of jet operating conditions, including subsonic and supersonic and cold and hot jets. Phased array measurements were also acquired on a Williams International FJ44 engine. These measurements show how the noise generated by the engine is split between the inlet-radiated and exhaust-radiated components. The data also show inlet noise being reflected off of the inflow control device used during the test.
Podboy, Gary G.↗
Adhesive bond evaluation using phase sensitive detection techniques
Quadrature phase detection techniques have been used to monitor the amplitude and phase of a toneburst ultrasonic wave normally reflected from adhesively-bonded steel/rubber interface. The measured phase change values of the reflected signals were found to correlate with variations in sample preparation. It was determined that measured phase shift changes were larger for samples with weaker bonds as manifested by smaller measured values of the applied tensile loads at failure. A model calculation which incorporates the concept of interfacial strength into the usual problem of wave propagation in multi-layered isotropic elastic media was used to deduce a bond-quality parameter from an experimentally measured phase shift.
Smith, Alphonso C.↗