Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “optical astronomy”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
NASA NTRS1992

POLARIS-II - An acousto-optic imaging spectropolarimeter for ground-based astronomy

A compact, acousto-optic tunable filter (AOTF) imaging spectropolarimeter for ground based astronomy from 400-1100 nm has been constructed at NASA/GSFC. The key components of this instrument are a TeO2 non-collinear AOTF, CCD camera, and an all-reflective optical relay assembly which uses a single elliptical mirror to produce side-by-side orthogonally polarized spectral images. The instrument was used at the Lowell Observatory 42-inch telescope for 'first light' planetary imaging and measurements of photometric standard stars. Narrow-band images of Saturn near 700 nm appear to show polarization effects which result from multiple scattering by aerosols. The instrument has recently been upgraded in order to integrate the RF drive electronics and eliminate contamination by scattered light. Design of the instrument and some initial results are presented.

Glenar, D. A.↗
NASA NTRS1985

Glancing incidence X-ray optics for solar X-ray astronomy

Glancing incidence X-ray optics have been developed into a highly valuable tool for high-resolution investigations of the sun in the X-ray/XUV regime. A brief overview of the development of X-ray optics technology is presented. Techniques currently under study for increasing the plate scale and improving the off-axis performance of future X-ray telescopes for solar X-ray astronomy are briefly discussed.

Hoover, Richard B.↗
NASA NTRS1981

Bulk and integrated acousto-optic spectrometers for radio astronomy

The development of sensitive heterodyne receivers (front end) in the centimeter and millimeter range, and the construction of sensitive RF spectrometers (back end) enable the spectral lines of interstellar molecules to be detected and identified. A technique was developed which combines acoustic bending of a collimated coherent light beam by a Bragg cell followed by detection by a sensitive array of photodetectors (thus forming an RF acousto-optic spectrometer (AOS). An AOS has wide bandwidth, large number of channels, and high resolution, and is compact, lightweight, and energy efficient. The thrust of receiver development is towards high frequency heterodyne systems, particularly in the millimeter, submillimeter, far infrared, and 10 micron spectral ranges.

Chin, G.↗
NASA NTRS2009

Hard X-ray Optics Technology Development for Astronomy at the Marshall Space Flight Center

Grazing-incidence telescopes based on Wolter 1 geometry have delivered impressive advances in astrophysics at soft-x-ray wavelengths, while the hard xray region remains relatively unexplored at fine angular resolution and high sensitivities. The ability to perform ground-breaking science in the hard-x-ray energy range had been the motivation for technology developments aimed at fabricating low-cost, light-weight, high-quality x-ray mirrors. Grazing-incidence x-ray optics for high-energy astrophysical applications is being developed at MSFC using the electroform-nickel replication process.

Gubarev, Mikhail↗
NASA NTRS2021

Discovery of an Extremely Short Duration Flare from Proxima Centauri Using Millimeter through Far-ultraviolet Observations

We present the discovery of an extreme flaring event from Proxima Cen by the Australian Square Kilometre Array Pathfinder(ASKAP), Atacama Large Millimeter/submillimeter Array(ALMA), Hubble Space Telescope(HST),Transiting Exoplanet Survey Satellite(TESS), and the du Pont Telescope that occurred on 2019 May 1. In the millimeter and FUV, this flare is the brightest ever detected, brightening by a factor of>1000 and>14,000 as seen by ALMA and HST, respectively. The millimeter and FUV continuum emission trace each other closely during the flare, suggesting that millimeter emission could serve as a proxy for FUV emission from stellar flares and become a powerful new tool to constrain the high-energy radiation environment of exoplanets. Surprisingly, optical emission associated with the event peaks at a much lower level with a time delay. The initial burst has an extremely short duration, lasting for<10 s. Taken together with the growing sample of millimeter M dwarf flares, this event suggests that millimeter emission is actually common during stellar flares and often originates from short burst-like events.

Stellar activity↗
DOE OSTI2023

Hours-long Near-UV/Optical Emission from Mildly Relativistic Outflows in Black Hole–Neutron Star Mergers

The ongoing LIGO–Virgo–KAGRA observing run O4 provides an opportunity to discover new multimessenger events, including binary neutron star (BNS) mergers such as GW170817 and the highly anticipated first detection of a multimessenger black hole–neutron star (BH–NS) merger. While BNS mergers were predicted to exhibit early optical emission from mildly relativistic outflows, it has remained uncertain whether the BH–NS merger ejecta provides the conditions for similar signals to emerge. We present the first modeling of early near-ultraviolet/optical emission from mildly relativistic outflows in BH–NS mergers. Adopting optimal binary properties, a mass ratio of q = 2, and a rapidly rotating BH, we utilize numerical relativity and general relativistic magnetohydrodynamic (GRMHD) simulations to follow the binary's evolution from premerger to homologous expansion. We use an M1 neutrino transport GRMHD simulation to self-consistently estimate the opacity distribution in the outflows and find a bright near-ultraviolet/optical signal that emerges due to jet-powered cocoon cooling emission, outshining the kilonova emission at early time. The signal peaks at an absolute magnitude of ~–15 a few hours after the merger, longer than previous estimates, which did not consider the first principles–based jet launching. By late 2024, the Rubin Observatory will have the capability to track the entire signal evolution or detect its peak up to distances of ≳1 Gpc. In 2026, ULTRASAT will conduct all-sky surveys within minutes, detecting some of these events within ~200 Mpc. The BH–NS mergers with higher mass ratios or lower BH spins would produce shorter and fainter signals.

79 ASTRONOMY AND ASTROPHYSICS↗
NASA NTRS1977

Spaceborne astronomy with electro-optical image sensors

The Space Telescope, planned for orbiting in the early 1980s, is described, with emphasis on its electro-optical image sensing capability. Relative advantages of image tubes and solid state arrays as image detectors are summarized; image tube technology is well characterized, but preference may be given to a more versatile tandem solid state array consisting of one module with high silicon response covering most of the spectrum, and a second intensified array with ultraviolet sensitivity and low noise readout. The classical 'photoelectron noise limit' calculation is reviewed, and a detailed calculation of sensitivity limits adaptable to analysis of image tube or solid state array detectors is also given. In particular, characteristics of a filter to optimize the signal to noise ratio is determined. Typical sensitivity calculations for an image tube detector show that with an exposure of one orbital night (approximately 2000 seconds), 10% photometry may be done to a low limit of visual magnitude.

Bradley, W. C.↗
NASA NTRS1999

Polycapillary X-Ray Optics for X-Ray Astronomy

High-energy x-ray spectrometry from astronomical sources is difficult due to low flux rates and high background. Polycapillary x-ray optics can be used to increase the signal-to-noise ratio by focusing photons onto a small energy dispersive detector. Two optics, both designed for x-ray astronomy, have been built and tested as collimating optics with a microfocus x-ray source for x-ray energies up to 70 keV and as focusing optics with parallel x-rays up to 50 keV. Results from these tests show that polycapillary x-ray optics have transmission efficiencies ranging from 5% to 40% and signal gains ranging from 5 to over 100 for energies up to 50 keV. Furthermore the results show that these optics have potential for use up to 100 keV. The experimental results as well as simulations for the measured and for optimized optics will be discussed.

Russell, C. H.↗
NASA NTRSDate not supplied

Curved Diffractive X-ray Optics for X-ray Astronomy

We report on a concept for curved diffractive X-ray optics (CDXO). CDXO would enable potential new optical designs for X-ray instruments, such as a two element spectrometer, in which the secondary element of an X-ray mirror pair is patterned with an X-ray grating. A two-element spectrometer design eliminates the grating assembly, resulting in decreased instrument mass and reduced power requirements. In addition, a two-element spectrometer may realize cost/schedule savings by eliminating a separate grating alignment effort, and yield increased effective area over three element designs. We present a raytrace concept study of a two-element spectrometer compact enough to fit within a sounding rocket payload. We also review the progress made in electron-beam lithography (EBL) techniques that would enable curved diffractive X-ray optics to be patterned, and outline a procedure by which the accuracy of the EBL patterning process can be measured interferometrically.

Casey T. DeRoo↗
NASA NTRS1993

Astronomy and the limits of vision

Celestial visibility is the study of the limits of observability of objects in the sky, with application to deducing the truth about historical events or to the derivation of astronomical information of modern utility. This study is based on what is seen by ordinary humans, either in their everyday lives or at times of historical events. The results of such studies have more relevance to non-scientists than does any other area of astronomy. Celestial visibility is a young discipline in the sense that the number of interesting applications with simple solutions outnumber the solved problems; it is a broad interdisciplinary field that involves work with astronomy, meteorology, optics, physics, physiology, history, and archeology. Each of these disciplines contribute specialized mathematical formulations which quantify the many processes that affect light as it leaves a source, traverses the atmosphere, and is detected by the human eye. These formulas can then be combined as appropriate to create mathematical models for the visibility of the source under the conditions of interest. These model results can then be applied a wide variety of problems arising in history, astronomy, archeology, meteorological optics, and archeoastronomy. This review also presents a dozen suggestions for observing projects, many of which can be directly taken for individual study, for classroom projects, or for professional research.

Schaefer, Bradley E.↗
NASA NTRS1990

Lunar astronomical observatories - Design studies

The best location in the inner solar system for the grand observatories of the 21st century may be the moon. A multidisciplinary team including university students and faculty in engineering, astronomy, physics, and geology, and engineers from industry is investigating the moon as a site for astronomical observatories and is doing conceptual and preliminary designs for these future observatories. Studies encompass lunar facilities for radio astronomy and astronomy at optical, ultraviolet, and infrared wavelengths of the electromagnetic spectrum. Although there are significant engineering challenges in design and construction on the moon, the rewards for astronomy can be great, such as detection and study of earth-like planets orbiting nearby stars, and the task for engineers promises to stimulate advances in analysis and design, materials and structures, automation and robotics, foundations, and controls. Fabricating structures in the reduced-gravity environment of the moon will be easier than in the zero-gravity environment of earth orbit, as Apollo and space-shuttle missions have revealed. Construction of observatories on the moon can be adapted from techniques developed on the earth, with the advantage that the moon's weaker gravitational pull makes it possible to build larger devices than are practical on earth.

Johnson, Stewart W.↗
NASA NTRS2000

The Extended-Image Tracking Technique Based on the Maximum Likelihood Estimation

This paper describes an extended-image tracking technique based on the maximum likelihood estimation. The target image is assume to have a known profile covering more than one element of a focal plane detector array. It is assumed that the relative position between the imager and the target is changing with time and the received target image has each of its pixels disturbed by an independent additive white Gaussian noise. When a rotation-invariant movement between imager and target is considered, the maximum likelihood based image tracking technique described in this paper is a closed-loop structure capable of providing iterative update of the movement estimate by calculating the loop feedback signals from a weighted correlation between the currently received target image and the previously estimated reference image in the transform domain. The movement estimate is then used to direct the imager to closely follow the moving target. This image tracking technique has many potential applications, including free-space optical communications and astronomy where accurate and stabilized optical pointing is essential.

Tsou, Haiping↗
NASA NTRS2012

Reflective Coating for Lightweight X-Ray Optics

X-ray reflective coating for next generation's lightweight, high resolution, optics for astronomy requires thin-film deposition that is precisely fine-tuned so that it will not distort the thin sub-mm substrates. Film of very low stress is required. Alternatively, mirror distortion can be cancelled by precisely balancing the deformation from multiple films. We will present results on metallic film deposition for the lightweight optics under development. These efforts include: low-stress deposition by magnetron sputtering and atomic layer deposition of the metals, balancing of gross deformation with two-layer depositions of opposite stresses and with depositions on both sides of the thin mirrors.

Chan, Kai-Wing↗