Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “X-Band”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5

The variation of radar cross section with wind

X-band (8910 megahertz) and C-band (4455 megahertz) measurements indicate that two domains exist in the variation of radar cross section with wind at incident angles far from the normal. The first domain for flow windspeeds is characterized by a rapid variation of radar cross section with wind and the second domain at higher windspeeds by an asymptotic approach to an upper limit (saturation). The transaction between the two domains occurs at a windspeed of approximately 10 knots. Recent Joint Ocean Surface Study I observations tend to confirm this observation and offer additional proof of the validity of a composite surface model which relates the radar cross section of the sea to the wave-height spectrum. This confirmation was obtained by comparing the radar cross section measured by the four-frequency radar system with the radar cross section calculated from the ocean wave-height spectrum that had been determined by the optical analysis of photographs taken at the same time. A possible explanation for the wind variation of the radar cross section of the open ocean also was evolved, based on radar measurements in a wave tank under various wind conditions and subsequent comparison with optically determined spectra.

Guinard, N. W.↗

Millimeter-wave generation with spiraling electron beams

The feasibility of using the interaction between a thin, solid, spiraling electron beam of 10 to 20 kV energy and a microwave cavity to generate watts of CW millimeter-wave power was investigated. Experimental results are given for several prototype devices operating at 9.4 GHz and at 94 GHz. Power outputs of 5 W, and electronic efficiencies near 3%, were obtained at X band, and moderate gain was obtained at 94 GHz. The small-signal theory gives a good fit to the X-band data, and the device behavior at 94 GHz is as expected from the given beam characteristics. The performance is limited chiefly by the velocity spread in the spiraling electron beam, and once this can be brought under control, high-power generation of millimeter waves appears quite feasible with this type of device.

Kulke, B.↗

Polarization effects with a combined radar-radiometer

Described is a unique microwave sensor. The device uses a coherent X-band radar, a radiometer at the same wavelength and an antenna with a polarization that can be varied electronically. This microwave sensor was developed to acquire polarization signature information about various surfaces in both the active and passive mode simultaneously. One application for the sensor is expected to be the location and identification of plant life.

Martin, D.↗

Dielectric constants of soils at microwave frequencies

A knowledge of the complex dielectric constant of soils is essential in the interpretation of microwave airborne radiometer data of the earth's surface. Measurements were made at 37 GHz on various soils from the Phoenix, Ariz., area. Extensive data have been obtained for dry soil and soil with water content in the range from 0.6 to 35 percent by dry weight. Measurements were made in a two arm microwave bridge and results were corrected for reflections at the sample interfaces by solution of the parallel dielectric plate problem. The maximum dielectric constants are about a factor of 3 lower than those reported for similar soils at X-band frequencies.

Geiger, F. E.↗

A microwave-biased millimeter- and submillimeter-wave detector using InSb.

Description of a high-purity n-type indium antimonide sample mounted in a reentrant cavity, cooled to 4.2 K, and operated as a millimeter-wave detector. The scheme utilizes a down-conversion process, and free-carrier absorption is the mechanism responsible for the detection process. Power applied at the millimeter-wave frequency causes a change in the material conductivity, which in turn causes a change in the X-band power absorption. Cavity perturbation techniques are used to analyze the scheme. The detector was operated successfully at frequencies between 35 and 150 GHz with no long-wavelength or short-wavelength cutoff observed. The scheme offers a fast, highly sensitive, and rugged detector with low conversion loss.

Eldumiati, I. I.↗

Radio science experiments - The Viking Mars Orbiter and Lander.

The objective of the radio science investigations is to extract the maximum scientific information from the data provided by the radio and radar systems on the Viking Orbiters and Landers. Unique features of the Viking missions include tracking of the landers on the surface of Mars, dual-frequency S- and X-band tracking data from the orbiters, lander-to-orbiter communications system data, and lander radar data, all of which provide sources of information for a number of scientific investigations. Post-flight analyses will provide both new and improved scientific information on physical and surface properties of Mars, on atmospheric and ionospheric properties of Mars, and on solar system properties.

Michael, W. H., Jr.↗

Material injection alleviation and plasma diagnostic measurements during the RAM C-III flight.

The results of a material injection RF blackout alleviation experiment and of plasma diagnostic measurements using electrostatic probes and an S-band reflectometer in a 25,000 ft/sec reentry flight are presented. Significant alleviation of RF blackout is observed at altitudes of from 270,000 feet to 120,000 feet due to injection of water and Freon E-3 on VHF, S-band, C-band, and X-band frequencies. Electrostatic probe data, attenuation data, and S-band diagnostic data show consistent plasma results. The relative effectiveness of water and Freon E-3 is discussed.

Schroeder, L. C.↗

Electron density measurements of an inhomogeneous plasma using millimeter wave Fabry-Perot interferometers.

The electron density of a laboratory generated inhomogeneous plasma was measured using 60-90, GHz flat-plate and 150 GHz semi-confocal Fabry-Perot interferometers. The plasma was a negative glow-type and had a measured parabolic electron density profile. An analytical comparison between the derived equations of electron density for an assumed homogeneous plasma slab and an inhomogeneous plasma with parabolic distribution showed that the slab approximation was valid for such a profile. Comparison of measured values of electron density with those using X-band and K-band interferometers for the same plasma indicated good agreement.

Kendall, B. M.↗

Low noise microwave receiving systems on a 64 m antenna.

Review of the performance capability at S-, X- and K-band of the NASA/JPL 64-m Cassegrain antenna at Goldstone, California. The multiple feed system allows X- and K-band atmospheric research studies to be conducted simultaneously with mission directed S-band spacecraft tracking. A description of the antenna system and its multiple operation is followed by gain and efficiency comparisons at the three frequencies. The total operating system temperature and its frequency dependence are discussed. Antenna gain and efficiency, and zenith system operating temperature are summarized at S- and X-band, respectively, by 62 dB, 63%, 16K; and 72 dB, 52%, 24K. Preliminary measurements for K-band are 76 dB, 39%, 29K.

Reid, M. S.↗

Electron paramagnetic resonance studies of a viscous nematic liquid crystal: Evidence counter to a second-order phase change

The ordering in a viscous, nematic, liquid crystal was studied using vanadyl acetyl acetonate and several nitroxides as paramagnetic probes. The ordering curve for VAAC at both K-band and X-band shows a slope discontinuity at a reduced temperature of 0.85. This discontinuity is caused by the tumbling time of the VAAC becoming comparable with the hyperfine splitting. The slope discontinuity is not present in the ordering curves of the nitroxides. The results are taken as evidence counter to the presence of a second-order phase transition.

Shutt, W. E.↗

Design, construction and evaluation of a 12.2 GHz, 4.0 kW-CW coupled-cavity traveling wave tube

An analytical and experimental program to study design techniques and to utilize these techniques to optimize the performance of an X-band 4 kW, CW traveling wave tube ultimately intended for satellite-borne television broadcast transmitters is described. The design is based on the coupled-cavity slow-wave circuit with velocity resynchronization to maximize the conversion efficiency. The design incorporates a collector which is demountable from the tube. This was done to facilitate multistage depressed collector experiments employing a NASA designed axisymmetric, electrostatic collector for linear beam microwave tubes after shipment of the tubes to NASA.

Ayers, W. R.↗

Virginia precipitation scatter experiment: Experiment description

A year's statistical data were acquired for the purposed of refining existing coordination procedures for the sharing of common frequency allocations between terrestrial and space services. The measurement program was conducted between October 3, 1970 and October 2, 1971, to empirically determine the cumulative distributions of scattering cross section per unit volume of hydrometeors at heights up to 9 km above the surface and of rain rate at the surface. The measurements were made in southeastern Virginia using a bistatic, continuous-wave, vertically polarized radar system operating at S- and X-band frequencies and tipping-bucket rain gages. The bistatic radar system was configured to represent an interference situation between a radio-relay system and a space communication system Earth terminal; the results may be interpreted as measured distributions of transmission loss for interference due to rain. A description of the experiment and equipment is included.

Levine, E.↗

Application of SLAR for monitoring Great Lakes total ice cover

A series of X-band SLAR images is presented showing the development and disintegration of the entire ice cover on Lake Erie during the winter of 1972-1973. Simultaneous ground truth observations and ERTS-1 photography establish accurate correlations of radar responses with ice conditions. The all-weather, broad areal mapping capability of SLAR is seen to be the means for obtaining the repeated coverage needed for winter navigation on the Great Lakes.

Jirberg, R. J.↗

A preliminary investigation of bird classification by Doppler radar

A preliminary study of the application of Doppler radar to the classification of birds is reported. The desirability for improvements in bird classification stems primarily from the hazards they present to jet aircraft in flight and in the vicinity of airports. A secondary need exists in the study of bird migration. The wing body and tail motion of a bird in flight reflect signals which, when analyzed properly present a signature of wing beat pattern which is unique for each bird species. Although the results of this investigation did not validate the feasibility of classifying bird species, they do indicate that a more thorough investigation is warranted. Certain gross characteristics such as wing beat rates, multiple bird patterns, and bird maneuverability, were indicated clearly in the results. Large birds with slow wing beat rates appear to be the most optimum subject for further study with the X-band Doppler radar used in this investigation.

Martinson, L. W.↗

A multisensor system for airborne surveillance of oil pollution

The U.S. Coast Guard is developing a prototype airborne oil surveillance system for use in its Marine Environmental Protection Program. The prototype system utilizes an X-band side-looking radar, a 37-GHz imaging microwave radiometer, a multichannel line scanner, and a multispectral low light level system. The system is geared to detecting and mapping oil spills and potential pollution violators anywhere within a 25 nmi range of the aircraft flight track under all but extreme weather conditions. The system provides for false target discrimination and maximum identification of spilled materials. The system also provides an automated detection alarm, as well as a color display to achieve maximum coupling between the sensor data and the equipment operator.

Edgerton, A. T.↗

A note on deep space optical communication link parameters

Topical communication in the context of a deep space communication link. Communication link analysis at the optical frequencies differs significantly from that at microwave frequencies such as the traditional S and X-bands used in deep space applications, due to the different technology of transmitter, antenna, modulators, and receivers. In addition, the important role of quantum noise in limiting system performance is quite different than that of thermal noise. The optical link design is put in a design control table format similar to a microwave telecom link design. Key considerations unique to the optical link are discussed.

Dolinar, S. J.↗

Science Results from the Spaceborne Imaging Radar-C/X-Band Synthetic Aperture Radar (SIR-C/X-SAR): Progress Report

The Spaceborne Imaging Radar-C/X-band Synthetic Aperture Radar (SIR-C/X-SAR) is the most advanced imaging radar system to fly in Earth orbit. Carried in the cargo bay of the Space Shuttle Endeavour in April and October of 1994, SIR-C/X-SAR simultaneously recorded SAR data at three wavelengths (L-, C-, and X-bands; 23.5, 5.8, and 3.1 cm, respectively). The SIR-C/X-SAR Science Team consists of 53 investigator teams from more than a dozen countries. Science investigations were undertaken in the fields of ecology, hydrology, ecology, and oceanography. This report contains 44 investigator team reports and several additional reports from coinvestigators and other researchers.

Diane L Evans↗

Application of Energy-efficient Electromagnetic Melt-Processing for the Upcycling of Recycled Polyphenylene Sulfide into Multifunctional Segregated Nanocomposites

Polyphenylene sulfide (PPS) is widely used in structural and functional composites because of its thermal stability, chemical resistance, and mechanical strength. As circular manufacturing becomes increasingly important, extending the service life of recycled PPS (rPPS) is essential. However, conventional high-temperature reprocessing accelerates thermo-oxidative degradation, reducing recycled composite performance. This study proposes a rapid and potentially energy-saving upcycling strategy for rPPS using electromagnetic (EM) melt-processing to form segregated carbon nanotube (CNT) networks and produce EM-responsive nanocomposites. The aim was to determine whether CNT-assisted EM heating could reduce polymer degradation while improving multifunctional properties at ultralow filler loadings. rPPS micropellets were coated with CNTs by ball milling to create conductive shells, then compacted into green bodies (GBs) and selectively melted by rapid EM irradiation. Structural, electrical, mechanical, rheological, and electromagnetic interference (EMI) shielding properties were evaluated. Electrical percolation occurred at an ultralow CNT loading of 0.08 wt%, with conductivity reaching (1.24 ± 0.74) × 10 -5 S⋅m -1 at 0.1 wt%. At this concentration, tensile strength and modulus increased by 72% and 99%, respectively. At ~ 0.7 mm thickness, X-band EMI shielding effectiveness reached 6 dB for GBs and 3 dB after EM processing. This shows that EM melt-processing upcycles rPPS into high-performance multifunctional nanocomposites with minimum thermal degradation.

recycled↗