Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Measurement_method”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 91 records · Page 5
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

A self pulsed laser ranging system under development at 'JPL'

The performance of large space deployable antenna reflectors to be used for broad-based communications systems is largely dependent on the accuracy with which the surface figure can be constructed and maintained. The paper examines various surface distortion tolerance and measurement requirements for various classes of communication antennas. Several surface measuring methods are described including a self-pulsed laser ranging system.

Berdahl, M.↗
NASA NTRS1980

Gigahertz analog modulation and differential delay of GaAlAs lasers - Temperature and current behavior

Gigahertz analog modulation characteristics of broad-area commercially available GaAlAs lasers have been investigated as a function of temperature and current in the vicinity of the upper frequency limit, where the resonance phenomena occur. The optimum temperature for small-signal amplitude modulation was found to be around -15 C for our particular broad-stripe geometry double-heterostructure laser. The Q was found to increase by a factor of 2 and the bandwidth by about 2%; the external quantum efficiency was maximized in this range. The optimum dc current bias was about 2% above the threshold current. Differential delays have also been measured down to a few picosecond accuracy by a unique phase-angle measurement method using a vector voltmeter. Some of the temperature effects observed may be related to mode changes and multimode and superradiance behavior.

Eng, S. T.↗
NASA NTRS1979

Grain quality inspection system

A review of grain quality indicators and measurement methods was conducted in order to assess the feasibility of using remote sensing technology to develop a continuous monitoring system for use during grain transfer operations. Most detection methods were found to be too slow or too expensive to be incorporated into the normal inspection procedure of a grain elevator on a continuous basis. Two indicators, moisture content and broken corn and foreign material, show potential for automation and are of an economic value. A microprocessor based system which utilizes commercially available electronic moisture meter was developed and tested. A method for automating BCFM measurement is described. A complete system description is presented along with performance test results.

Flood, C. A., Jr.↗
NASA NTRS1980

Active microwave water equivalence

Measurements of water equivalence using an active FM-CW microwave system were conducted over the past three years at various sites in Colorado, Wyoming, and California. The measurement method is described. Measurements of water equivalence and stratigraphy are compared with ground truth. A comparison of microwave, federal sampler, and snow pillow measurements at three sites in Colorado is described.

Boyne, H. S.↗
NASA NTRS1981

Sources of atmospheric methane - Measurements in rice paddies and a discussion

Field measurements of methane fluxes from rice paddies, fresh water lakes, and saltwater marshes have been made to infer estimates of the size of these sources of atmospheric methane. The rice-paddy measurements, the first of their kind, show that the principal means of methane escape is through the plants themselves as opposed to transport across the water-air interface via bubbles or molecular diffusion. Nitrogen-fertilized plants release much more methane than unfertilized plants but even these measured rates are only one fourth as large as those inferred earlier by Koyama (1963, 1964) and on which all global extrapolations have been based to date. Measured methane fluxes from lakes and marshes are also compared to similar earlier data and it is found that extant data and flux-measurement methods are insufficient for reliable global extrapolations.

Cicerone, R. J.↗
NASA NTRS1981

Development of a surface panel measurement system

Reflector measurement systems are studied in support of the reshaping of the 34 meter antenna at Goldstone. The requirements for measurement systems are presented. A survey is made of the surface errors of existing antennas. Reflector measurement systems are divided into three categories and representative examples of each category are illustrated and discussed. Parametric error analyses are made of selected optical systems. The existing measurement method using a theodolite at the vertex is retained. A method using a theodolite on the RF cone is a possible variant.

Jones, D. L.↗
NASA NTRS1982

Strain gage load measurement on the shuttle orbiter

This paper describes the application of the calibrated strain gage load measurement method to the shuttle orbiter. Descriptions of instrumentation and calibration are included, along with comparisons of measured results with wind tunnel and FLEXSTAB analytical predictions.

Carter, A. L.↗
NASA NTRS1982

Investigation of continuously traversing microphone system for mode measurement

The continuously Traversing Microphone System consists of a data acquisition and processing method for obtaining the modal coefficients of the discrete, coherent acoustic field in a fan inlet duct. The system would be used in fan rigs or full scale engine installations where present measurement methods, because of the excessive number of microphones and long test times required, are not feasible. The purpose of the investigation reported here was to develop a method for defining modal structure by means of a continuously traversing microphone system and to perform an evaluation of the method, based upon analytical studies and computer simulated tests. A variety of system parameters were examined, and the effects of deviations from ideal were explored. Effects of traverse speed, digitizing rate, run time, roundoff error, calibration errors, and random noise background level were determined. For constant fan operating speed, the sensitivity of the method to normal errors and deviations was determined to be acceptable. Good recovery of mode coefficients was attainable. Fluctuating fan speed conditions received special attention, and it was concluded that by employing suitable time delay procedures, satisfactory information on mode coefficients can be obtained under realistic conditions. A plan for further development involving fan rig tests was prepared.

Cicon, D. E.↗
NASA NTRS1983

Large space antenna communications systems: Integrated Langley Research Center/Jet Propulsion Laboratory technology development activities. 1: Introduction

The Jet Propulsion Laboratory and the Langley Research Center have been developing technology related to large space antennas (LSA) during the past several years. The need for a communication system research program became apparent during the recent studies for the Land Mobile Satellite System. This study indicated the need for additional research in (1) electromagnetic analysis methods, (2) design and development of multiple beam feed systems, and (3) the measurement methods for LSA reflectors.

Campbell, T. G.↗
NASA NTRS1982

Analysis and evaluation in the production process and equipment area of the low-cost solar array project

It was found that the Solarex metallization design and process selection should be modified to yield substantially higher output of the 10 cm x 10 cm cells, while the Westinghouse design is extremely close to the optimum. In addition, further attention to the Solarex pn junction and base high/low junction formation processes could be beneficial. For the future efficiency improvement, it was found that refinement of the various minority carrier lifetime measurement methods is needed, as well as considerably increased sophistication in the interpretation of the results of these methods. In addition, it was determined that further experimental investigation of the Auger lifetime is needed, to conclusively determine the Auger coefficients for the direct Auger recombination at high majority carrier concentrations.

Wolf, M.↗
NASA NTRS1982

Advanced sensors for spaceborne measurements of the earth's atmosphere

Concepts involved in remote sensing from space are reviewed, together with performance requirements of proposed and planned equipment. Attention is focused on measurements of the troposphere, particularly meteorological variables and chemical species. The principles of absorption, using either passive or active sensors, emission detection, fluorescence measurements, and EM radiation scattering are outlined. The proposed NASA Windsat, using a CO2 laser from the Orbiter or from an 800 km orbit spacecraft to measure low-level wind speeds is described, as are the uses of the AMTS atmospheric sounder instrument for IR atmospheric temperature sensing and a 20-channel microwave radiometer to detect moisture profiles in the water vapor bands. Additionally, a microwave pressure sounder to detect backscattered signals at 60 GHz is outlined, along with lidar pressure and wind speed measurement methods.

Hinkley, E. D.↗
NASA NTRS1982

Near-wall similarity in the three-dimensional turbulent boundary layers. III - Shear-driven flow results

Ten of eleven proposed three-dimensional similarity models identified in the literature are evaluated with direct wall shear, velocity field, and pressure gradient data from a three-dimensional shear-driven boundary layer flow. Results define an upper limit on velocity vector skewing for each model's predictive ability. When combined with earlier results for pressure-driven flows, each model's predictive ability with and without pressure gradients is summarized. The utility of some two-dimensional type indirect wall shear measurement methods and wall shear inference methods from near-wall velocity measurements for three-dimensional flows is also discussed.

Pierce, F. J.↗
NASA NTRS1983

Line strength measurements using diode lasers - The nu2 band of H2S

The strengths of 94 lines in the nu2 band of H2S have been measured with an average accuracy of 3 percent using a tunable diode laser. The line strengths are determined from the peak absorption of nearly Doppler-shaped lines. A detailed error analysis of this measurement method is given. Ratios of the measured line strengths to strengths calculated assuming no vibration-rotation interactions are shown to range from as low as 0.057 to as high as 4.71.

Strow, L. L.↗
NASA NTRS1984

Aeronautical propulsion: Present status and future directions

The advancement of aeropropulsion systems continues to provide technology to various portions of the gas turbine field. It is recognized that this area is undergoing considerale change, which will result in substantially improved gas turbine components and systems. These changes are occurring in a number of technical areas including advanced analytical and physical measurement methods, the application of large scientific computers, the dynamic modeling of components and systems, the application of integrated control systems that optimize and improve performance and system condition monitoring, and the development of new and unique materials and structures. As these areas evolve, the ways in which technology will advance, and factors affecting the design and development of new systems, will probably be considerably different than those of today. It is also anticipated that the necessary skilled work force will be different. Certainly there will be changes, but the nature, extent, and rate of those changes can only be surmised at this time.

Hartmann, M. J.↗
NASA NTRS1984

Fuel spray diagnostics

Several laser measurement methods are being studied to provide the capability to make droplet size and velocity measurements under a variety of spray conditions. The droplet sizing interferometer (DSI) promises to be a successful technique because of its capability for rapid data acquisition, compilation and analysis. Its main advantage is the ability to obtain size and velocity measurements in air-fuel mixing studies and hot flows. The existing DSI at NASA Lewis is a two-color, two-component system. Two independent orthogonal measurements of size and velocity components can be made simultaneously. It also uses an off-axis large-angle light scatter detection. The fundamental features of the system are optics, signal processing and data management system. The major component includes a transmitter unit, two receiver units, two signal processors, two data management systems, two Bragg cell systems, two printer/plotters, a laser, power supply and color monitor.

Bosque, M. A.↗
NASA NTRS1983

Muscle and the physiology of locomotion

NASA's past, current, and planned research on muscle deterioration at zero gravity and development of countermeasures are reviewed; Soviet studies are discussed as well. A definition of muscle mass and strength regulation factors, and improved measurement methods of muscle atrophy are needed. Investigations of tissue growth factors and their receptors, endogenous and exogenous anabolic protein synthesis stimulation, and a potential neurotropic factor are among the projects in progress or planned. At present, vigorous physical exercise during spaceflight is recommended as the most effective countermeasure against skeletal muscle atrophy.

Rambaut, P. C.↗
NASA NTRS1984

Turbo fluid machinery and diffusers

The general theory behind turbo devices and diffusers is explained. Problems and the state of research on basic equations of flow and experimental and measuring methods are discussed. Conventional centrifugation-type compressor and fan diffusers are considered in detail.

Sakurai, T.↗
NASA NTRS1984

Analysis of terrestrial conditions and dynamics

Land spectral reflectance properties for selected locations, including the Goddard Space Flight Center, the Wallops Flight Facility, a MLA test site in Cambridge, Maryland, and an acid test site in Burlington, Vermont, were measured. Methods to simulate the bidirectional reflectance properties of vegetated landscapes and a data base for spatial resolution were developed. North American vegetation patterns observed with the Advanced Very High Resolution Radiometer were assessed. Data and methods needed to model large-scale vegetation activity with remotely sensed observations and climate data were compiled.

Goward, S. N.↗