SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Results of a simulator experiment which was conducted in order to compare pilot gamma-control performance using two display formats are reported. Pilots flew a variable flight path angle tracking task in the landing configuration. Pilot and airplane performance parameters were recorded and pilot comments noted for each case.
This report was prepared at the request of the National Advisory Committee for Aeronautics in order to supply a systematic study of the relations between the flight velocity V and its horizontal component V subscript H, in power glides. Curves of V and V subscript H plotted against the inclination of the flight path 0 are given, together with curves which show the maximum values of V subscript H and the corresponding values of 0. Curves are also given showing the effect of small departures from the horizontal in high speed performance testing.
The University of Wisconsin volume imaging lidar has been used to portray images of the three-dimensional structure of clear air convective plumes in the atmosphere surrounding the flight path of the instrumented Twin Otter aircraft operated by the National Aeronautical Establishment of Canada. Lidar images provide a context for interpretation of the aircraft measurements. The position of data points within a convective element can be determined and the temporal development of the plume can be observed to time the observation with respect to the life cycle of the plume. Plots of the vertical flux of water vapor, superimposed on lidar images clearly demonstrate the well-known sampling difficulties encountered when attempting to measure fluxes near the top of the convective layer. When loran was used to determine average aircraft velocity, flight-leg-averaged horizontal winds measured by the aircraft and area-averaged winds measured by lidar agree to within 0.2 m/s in speed and 1 deg in direction.
Parallel systolic algorithms for dynamic programming(DP) and their respective hardware implementations are presented for a problem in on-line trajectory optimization. The method is applied to a model for helicopter flight path optimization through a complex constraint region. This problem has application to an air traffic control problem and also to a terrain following/threat avoidance problem.
The importance and benefit of improved monitoring is increasingly recognized. Improved training may be a valuable intervention. Our study (conducted 2019) assessed and trained airline First Officers on flight path monitoring skills. The exploratory study assessed monitoring pre-training in a simulator session that included monitoring challenges (8 or 7 events). A 1-hour interactive training followed, based on the Sensemaking Model of Monitoring; it presented concepts and examples using a slide deck, discussion, and simple activities. Post-training assessment used scenarios with analogous monitoring challenges (7 or 8 events) but a different setting. Performance showed significant and relatively consistent improvement. Training monitoring as sensemaking merits further investigation.
The commercial aviation industry world-wide has identified a need for improved pilot monitoring (e.g., ICAO, 2016). More specifically, aviation safety data indicate that failures in pilots' monitoring for flight path management (FPM) have contributed to a range of undesired outcomes: accidents, major upsets, and non-compliance with ATC guidance. The FAA has further stated that these types of FPM failures are likely to worsen with the increasingly complex air traffic control systems and FPM concepts proposed for NextGen (https://www.faa.gov/nextgen/what_is_nextgen/) operations (e.g., see Hah et al., 2017). An important element of this additional complexity will be the introduction of new automation or artificial intelligence that is intended to work with the flight crew but can add additional monitoring burdens. One potential mitigation for this situation is to enhance pilot training for effective monitoring. NASA Ames Research Center was asked to identify and evaluate training approaches that have the potential to enhance pilots' ability to effectively monitor for FPM (with the result of improved awareness). The focus of this work is to identify, develop or validate training guidance to improve pilot monitoring/awareness regarding FPM and mitigate the recent trend of accidents and incidents, especially Loss of Control (LOC) events. The result of this work should be guidance for FAA training and standards organizations—such as the Air Carrier Training Aviation Rulemaking Committee (ACT ARC)—to aid in reducing the risk of incidents and accidents due to inadequate pilot monitoring/awareness.
An analysis is given of the oscillating motion of a ballistic missile which upon entering the atmosphere is angularly misaligned with respect to the flight path. The history of the motion for some example missiles is discussed from the point of view of the effect of the motion on the aerodynamic heating and loading. The miss distance at the target due to misalignment and to small accidental trim angles is treated. The stability problem is also discussed for the case where the missile is tumbling prior to atmospheric entry.
This paper describes the methods used to estimate the statistical deltaV requirements for the propulsive maneuvers that will deliver the spacecraft to its target landing site while satisfying planetary protection requirements. the paper presents flight path control analysis results for three different trajectories, open, middle, and close of launch period for the mission.
An analysis was made of the guidance of a space vehicle approaching the earth at supercircular velocity through an entrance corridor containing a desired perigee altitude. Random errors were assumed in the measurement of velocity and flight-path angle and in obtaining the desired thrust impulse. The method described in NASA Technical Note D-191 of scheduling corrections at different values of the angle between perigee and the vehicle's position vector and a slight modification of this method were investigated as a means of correcting perigee altitude when the vehicle's predicted position was at programmed correction points not within a specified deadband about the desired perigee altitude. The study showed that modifying the angular method of NASA Technical Note D-191 by adding another correction near the initial point did not improve the efficiency and accuracy of the angular method. It was found that in some cases the use of a correction procedure which included a deadband could be more costly in total corrective velocity than a procedure which neglected the deadband. This was especially true if a large degree of confidence was required in the total corrective velocity. It was apparent from the results that a correction with a deadband limit in the guidance scheme was more sensitive to the initial conditions, the corrective procedure, the deadband, and the degree of confidence required than a correction without a deadband limit.
Generalized predictive control describes an algorithm for the control of dynamic systems in which a control input is generated that minimizes a quadratic cost function consisting of a weighted sum of errors between desired and predicted future system output and future predicted control increments. The output predictions are obtained from an internal model of the plant dynamics. A design technique is discussed for applying the single-input/single-output generalized predictive control algorithm to a problem of longitudinal/vertical terrain-following flight of a rotorcraft. By using the generalized predictive control technique to provide inputs to a classically designed stability and control augmentation system, it is demonstrated that a robust flight-path control system can be created that exhibits excellent tracking performance.
This paper presents a partial evaluation on the use of singular perturbation methods for developing computer algorithms for on-line optimal control of aircraft. The evaluation is based on a study of the minimum time intercept problem using F-4 aerodynamic and propulsion data as a base line. The extensions over previous work on this subject are that aircraft turning dynamics (in addition to position and energy dynamics) are included in the analysis, the algorithm is developed for a moving end point and is adaptive to unpredictable target maneuvers, and short range maneuvers that do not have a cruise leg are included. Particular attention is given to identifying those quantities that can be precomputed and stored (as a function of aircraft total energy), thus greatly reducing the onboard computational load. Numerical results are given that illustrate the nature of the optimal intercept flight paths, and an estimate is given for the execution time and storage requirements of the control algorithm.
Explore the source record for details and available documents.
Explore the source record for details and available documents.
Data from decoupled flight maneuvers have been collected and analyzed for four AFTI-F-16 pilots operating this aircraft's highly augmented fly-by-wire control system, in order to obtain spectral density, cross spectra, and Bode amplitude data, as well as coherences and phase angles for the two longitudinal axis control functions of each of 50 20-sec epochs. The analysis of each epoch yielded five distinct plotted parameters for the left hand twist grip and right hand sidestick controller output time series. These two control devices allow the left hand to generate vertical translation, direct lift, or pitch-pointing commands that are decoupled from those of the right hand. Attention is given to the control patterns obtained for decoupled normal flight, air-to-air gun engagement decoupled maneuvering, and decoupled air-to-surface bombing run maneuvering.
Explore the source record for details and available documents.
Researchers within the eXternal Visibility System (XVS) element of the High-Speed Research (HSR) program developed and evaluated display concepts that will provide the flight crew of the proposed High-Speed Civil Transport (HSCT) with integrated imagery and symbology to permit path control and hazard avoidance functions while maintaining required situation awareness. The challenge of the XVS program is to develop concepts that would permit a no-nose-droop configuration of an HSCT and expanded low visibility HSCT operational capabilities. This study was one of a series of experiments exploring the 'design space' restrictions for physical placement of an XVS display. The primary experimental issues here was 'conformality' of the forward display vertical position with respect to the side window in simulated flight. 'Conformality' refers to the case such that the horizon and objects appear in the same relative positions when viewed through the forward windows or display and the side windows. This study quantified the effects of visual conformality on pilot flight path control and hazard avoidance performance. Here, conformality related to the positioning and relationship of the artificial horizon line and associated symbology presented on the forward display and the horizon and associated ground, horizon, and sky textures as they would appear in the real view through a window presented in the side window display. No significant performance consequences were found for the non-conformal conditions.
Explore the source record for details and available documents.
NASA's Jet Propulsion Laboratory is currently implementing a reconfigurable polarimetric L-band synthetic aperture radar (SAR), specifically designed to acquire airborne repeat track interferometric (RTI) SAR data, also know as differential interferometric measurements. Differential interferometry can provide key displacement measurements, important for the scientific studies of Earthquakes and volcanoes. Using precision real-time GPS and a sensor controlled flight management system, the system will be able to fly predefined paths with great precision. The radar will be designed to operate on a UAV (Unmanned Arial Vehicle) but will initially be demonstrated on a minimally piloted vehicle (MPV), such as the Proteus build by Scaled Composites. The application requires control of the flight path to within a 10 meter tube to support repeat track and formation flying measurements. The design is fully polarimetric with an 80 MHz bandwidth (2 meter range resolution) and 16 kilometer range swath. The antenna is an electronically steered array to assure that the actual antenna pointing can be controlled independent of the wind direction and speed. The system will nominally operate at 45,000 ft. The program started out as a Instrument Incubator Project (IIP) funded by NASA Earth Science and Technology Office (ESTO).