Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “seeding”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 883 records · Page 49
All sourcesNASA NTRSDOE OSTI
NASA NTRS1980

Fog dispersion

The concept of using the charged particle technique to disperse warm fog at airports is investigated and compared with other techniques. The charged particle technique shows potential for warm fog dispersal, but experimental verification of several significant parameters, such as particle mobility and charge density, is needed. Seeding and helicopter downwash techniques are also effective for warm fog disperals, but presently are not believed to be viable techniques for routine airport operations. Thermal systems are currently used at a few overseas airports; however, they are expensive and pose potential environmental problems.

Christensen, L. S.↗
NASA NTRS1980

Plants and weightlessness

The growth of two plants, wall cress and short-day red goosefoot, was traced for their entire lifetime in weightlessness. In the beginning both plants grew normally: the seeds sprouted in the normal periods, and the shoots did not differ in any way from the control plants. It is true that certain roots lost their normal orientation and did not go deeper into the nutrient medium, but rather crept over its surface. But then both the wall cress and the goosefoot slowed down their normal rate of growth, which became noticeable from the rate of formation of new leaves in the wall cress and stem development in the goosefoot. Although no disorders were successfully found in the morphology of the two plants, almost half of the experimental cress and goosefoot plants ceased growth completely, yellowed and died. The other part continued to develop normally and by the end of vegetation, differed from the control plants only in a lower height. Not all were fertile since certain experimental plants, after losing spatial orientation, became twisted and produced sterile flowers.

Karminskiy, V.↗
NASA NTRS1980

Atmospheric lidar multi-user instrument system definition study

A spaceborne lidar system for atmospheric studies was defined. The primary input was the Science Objectives Experiment Description and Evolutionary Flow Document. The first task of the study was to perform an experiment evolutionary analysis of the SEED. The second task was the system definition effort of the instrument system. The third task was the generation of a program plan for the hardware phase. The fourth task was the supporting studies which included a Shuttle deficiency analysis, a preliminary safety hazard analysis, the identification of long lead items, and development studies required. As a result of the study an evolutionary Lidar Multi-User Instrument System (MUIS) was defined. The MUIS occupies a full Spacelab pallet and has a weight of 1300 kg. The Lidar MUIS laser provides a 2 joule frequency doubled Nd:YAG laser that can also pump a tuneable dye laser wide frequency range and bandwidth. The MUIS includes a 1.25 meter diameter aperture Cassegrain receiver, with a moveable secondary mirror to provide precise alignment with the laser. The receiver can transmit the return signal to three single and multiple photomultiple tube detectors by use of a rotating fold mirror. It is concluded that the Lidar MUIS proceed to program implementation.

Greco, R. V.↗
NASA NTRS1980

Method of growing a ribbon crystal particularly suited for facilitating automated control of ribbon width

A method of growing a ribbon crystal is described wherein a meniscus of molten semiconductor material attached to vertical movable seed is lifted at a rate substantially equal to the rate at which the meniscus freezes. The method is characterized by the steps of continuously sensing the brightness of the growth region of the ribbon in selected areas across the ribbon width for detecting changes in the intensity of the brightness of the selected areas, and modifying the temperature of the meniscus and pulling speed in response to changes detected in the intensity for controlling the geometry of the ribbon.

Ciszek, T. F.↗
NASA NTRS1980

Results of duct area ratio changes in the NASA Lewis H2-O2 combustion MHD experiment

MHD power generation experiments utilizing a cesium-seeded H2-O2 working fluid have been carried out using a diverging area Hall duct having an entrance Mach number of 2. The experiments are conducted in a high-field strength cryomagnet facility at field strengths up to 5 tesla. The effects of power takeoff location, generator loading, B-field strength, and electrode breakdown voltage have been investigated. In this paper the effect of area ratio, multiple loading of the duct, and duct location within the magnetic field are considered.

Smith, J. M.↗
NASA NTRS1979

Xenon from intermediate zones of supernovae

The paper examines the photodisintegration and neutron capture in massive stars which show that the bulk of the p-isotopes of Xe is formed during the gamma-process of Woosley and Howard (1978) by stripping of the Xe + Be seeds. The environments in which the chondrites can be formed were determined by the neutron-capture calculations; they show that the Xe-124-rich gas must be associated at the sources with anomalously large overabundances of Nd-142, Sm-144, and possibly Ba-130, and with anomalously small overabundances of the p-isotopes of Se, Kr, Sr, and Mo.

Heymann, D.↗
NASA NTRS1980

Thermal history, chemical composition and relationship of comets to the origin of life

The role of thermal processes in determining the chemical composition of comets is considered, and implications of possible cometary constituents for the origin and evolution of life on earth are discussed. It is shown that the inclusion of short-lived Al-26 from a nearby supernova explosion into cometary nuclei could lead to comets with surfaces cool enough to retain H2O and interiors warm enough for thermal processing to occur, with the production of complex organic molecules such as amino acids and nucleic acid bases. It is thus suggested that comets may have played a part in seeding the primitive earth with biological polymers capable of self-replication or of evolving towards that capability, and may even be responsible for the subsequent introduction of organic material capable of infecting already existing cells.

Irvine, W. M.↗
NASA NTRS1980

Stratospheric aerosol modification by supersonic transport and space shuttle operations - Climate implications

The potential effects on stratospheric aerosols of supersonic transport emissions of sulfur dioxide gas and submicron soot granules, and space shuttle rocket emissions of aluminum oxide particulates are estimated. An interactive particle-gas model of the stratospheric aerosol layer is used to calculate changes due to exhaust emissions, and an accurate radiation transport model is employed to compute the effect of aerosol changes on the earth's average surface temperature. It is concluded that the release of large numbers of small particles (soot or aluminum oxide) into the stratosphere should not lead to a corresponding significant increase in the concentration of large, optically active aerosols, but that the increase in large particles is severely limited by the total mass of sulfate available to make large particles in situ, and by the rapid loss of small seed particles via coagulation. We find that a fleet of several hundred advanced supersonic aircraft operating daily at 20 km, or the launch of one space shuttle rocket per week, could produce roughly a 20% increase in the large-particle concentration of the stratosphere. We find, in addition, that aerosol increases of this magnitude would reduce the global surface temperature by less than 0.01 K.

Turco, R. P.↗
NASA NTRS1979

Application of laser velocimetry to an unsteady transonic flow

Measurements of mean velocity, turbulent kinetic energy, and turbulent shear stress have been obtained in an unsteady but periodic flow. Polystyrene spheres, 0.35-0.55 microns in diameter, were injected into the tunnel settling chamber to seed the flow for a laser velocimeter. Synchronized counters together with an encoding interface and digital-to-analog converters were used to record the data on an analog tape recorder. Profiles of velocity and turbulence quantities are presented for several times during the periodic flow.

Seegmiller, H. L.↗
NASA NTRS1980

A process of stellar nucleosynthesis which mimicks mass fractionation in P-xenon

The combination of the O-shell theory of Heymann and Dziczkaniec and the supernova theory of Woosley and Howard clearly identifies the astrophysical sites for the formation of the anomalous light Xe component in carbonaceous chondrites. These sites are the O- and Ne-shells, and possibly C-shell of a massive star. Most of the Xe-124 and Xe-126 are formed in the O-shell during hydrostatic core silicon-burning, when a seed of heavy nuclei is exposed to an effective temperature near T9 = 2.0. Xe-128 is formed via Ba-128 in the O-shell, but the amounts appear too small to satisfy the deduced Xe-128/Xe-124 and Xe-128/Xe-126 yield ratios from the chondrites. However, substantial amounts of Xe-128 can be formed in the adjacent Ne- and C-shells during the explosion. The formation of Ba-128 in the O-shell would increase if the (gamma, alpha) photodisintegration rate in Ba-128 is actually smaller than calculated by Woosley and Howard. Lewis et al. have proposed that the anomalous light Xe component is mass-fractionated normal Xe. It is in this sense that the process of stellar nucleosynthesis of the present paper mimicks mass-fractionation.

Heymann, D.↗
NASA NTRS1980

Efficient laser anemometer for intra-rotor flow mapping in turbomachinery

Innovative features of the anemometer include: (1) a rapid and efficient data acquisition process, (2) a detailed real-time graphic display of the data being accumulated, and (3) input laser beam positioning that maximizes the size of the intra-rotor region being mapped. Results demonstrate the anemometer's capability in flow mapping within a transonic axial-flow compressor rotor. The use of fluorescent seed particles allows flow measurements near the rotor hub and the casing window.

Powell, J. A.↗
NASA NTRS1980

Experiments on H2-O2 MHD power generation

MHD power generation experiments utilizing a cesium-seeded H2-O2 working fluid have been carried out using a diverging area Hall duct having an entrance Mach number of 2. The experiments are conducted in a high-field strength cryomagnet facility at field strengths up to 5 tesla. The effects of power takeoff location, axial duct location within the magnetic field, generator loading, B-field strength, and electrode breakdown voltage were investigated. For the operating conditions of these experiments it is found that the power output increases with the square of the B-field and can be limited by choking of the channel or interelectrode voltage breakdown which occurs at Hall fields greater than 50 volts/insulator.

Smith, J. M.↗
NASA NTRS1980

Ice nucleus concentrations measured during the 1975 Florida Area Cumulus Experiment /FACE/

Ice nuclei measurements were made aboard a cloud-base aircraft during the 1975 Florida Area Cumulus Experiment. Two techniques were used to obtain the ice nuclei concentrations; membranes were collected and analyzed using the NCAR membrane development chamber and continuous ice nuclei concentrations were obtained using the NCAR acoustical counter. Results showed that the membrane technique failed to effectively detect ice nuclei in this maritime tropical area. However, the concentrations recorded by the acoustical counter showed natural afternoon diurnal increases which may have ramifications on cloud development and seeding potential within the particular study area.

Wisniewski, J.↗
NASA NTRS1982

High-Speed Laser Anemometer

New high-speed laser anemometer system rapidly and efficiently maps gas-flow velocities within rotating blade rows of turbomachinery. Small seed particles entrained in gas flow fluoresce when they pass through probe volume, which is the fringe pattern formed by intersecting laser beams. Transit time of particles is obtained by use of suitable optics, photomultiplier tube and electronic signal processor. Data are then sent to a minicomputer.

Powell, J. A.↗
NASA NTRS1982

Capacitively-Heated Fluidized Bed

Fluidized-bed chamber in which particles in bed are capacitively heated produces high yields of polycrystalline silicon for semiconductor devices. Deposition of unrecoverable silicon on chamber wall is reduced, and amount of recoverable silicon depositing on seed particles in bed is increased. Particles also have a size and density suitable for direct handling without consolidation, unlike silicon dust produced in heated-wall chambers.

Mchale, E. J.↗
NASA NTRS1982

Monitoring Crystal Growth From Solution

Experimental system for monitoring growth of triglycine sulfate (TGS) crystals from solution is being studied. System consists of outer cell containing distilled water heated and stirred to maintain constant temperature to within plus or minus 0.1 degrees C, inner (growth) cell containing supersaturated solution of TGS, and seed crystal mounted in plastic-covered stainless-steel sting equiped with controlled cooling mechanism and temperature sensors.

Lal, R. B.↗
NASA NTRS1980

New methods to detect particle velocity and mass flux in arc-heated ablation/erosion facilities

Arc-heated flow facilities with injected particles are used to simulate the erosive and ablative/erosive environments encountered by spacecraft re-entry through fog, clouds, thermo-nuclear explosions, etc. Two newly developed particle diagnostic techniques used to calibrate these facilities are discussed. One technique measures particle velocity and is based on the detection of thermal radiation and/or chemiluminescence from the hot seed particles in a model ablation/erosion facility. The second technique measures a local particle rate, which is proportional to local particle mass flux, in a dust erosion facility by photodetecting and counting the interruptions of a focused laser beam by individual particles.

Brayton, D. B.↗