Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “carbonization”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 883 records · Page 49

Environmental carbon dioxide control

A study of environmental carbon dioxide control for NASA EVA missions found solid potassium carbonate to be an effective regenerable absorbent in maintaining low carbon dioxide levels. The supported sorbent was capable of repeated regeneration below 150 C without appreciable degradation. Optimum structures in the form of thin pliable sheets of carbonate, inert support and binder were developed. Interpretation of a new solid-gas pore closing model helped predict the optimum sorbent and analysis of individual sorbent sheet performance in a thin rectangular channel sorber can predict packed bed performance.

Onischak, M.↗

Review of electrical and thermal properties of carbon and graphite

Some of the electrical and thermal properties of ordered and partially ordered carbons are reviewed. Earlier and current research areas are discussed relative to electrical properties of pyrolytic and polycrystalline graphite; thermal, electrical, and magnetic properties of graphitizable and glassy carbon with heat treatment temperatures in the range 600-2500 C; Josephson junction-like and switching behavior in carbon films; and some high-conductivity and superconducting compounds made from carbon. Due to the newness and complexity of many of the areas examined, the results are not always completely understood, nor have these areas been completely investigated experimentally. Suggestions for future research are made.

Woollam, J. A.↗

The oxygen and carbon dioxide balance in the earth's atmosphere

The oxygen-carbon dioxide cycle is described in detail, and steps which are sensitive to perturbation or instability are identified. About half of the carbon dioxide consumption each year in photosynthesis occurs in the oceans. Phytoplankton, which are the primary producers, have been shown to assimilate insecticides and herbicides. The impact of such materials on phytoplankton photosynthesis, both direct and as the indirect result of detrimental effects higher up in the food chain, cannot be assessed. Net oxygen production is very small in comparison with the total production and occurs almost exclusively in a few ocean areas with anoxic bottom conditions and in peat-forming marshes which are sensitive to anthropogenic disturbances. The carbon dioxide content of the atmosphere is increasing at a relatively rapid rate as the result of fossil fuel combustion. Increases in photosynthesis as the result of the hothouse effect may in turn reduce the carbon dioxide content of the atmosphere, leading to global cooling.

Johnson, F. S.↗

Carbon distribution profiles in lunar fines

Radial distribution profiles of elemental carbon in lunar soils consisting of particles in the size range of 50 to 150 microns were investigated. Initial experiments on specimen preparation and the analysis of prepared specimens by Auger electron spectrometry (AES) and scanning electron microscopy (SEM) are described. Results from splits of samples 61501,84 and 64421,11, which were mounted various ways in several specimen holders, are presented. A low carbon content was observed in AES spectra from soil particles that were subjected to sputter-ion cleaning with 960eV argon ions for periods of time up to a total exposure for one hour. This ion charge was sufficient to remove approximately 70 nm of material from the surface. All of the physically adsorbed carbon (as well as water vapor, etc.) would normally be removed in the first few minutes, leaving only carbon in the specimen, and metal support structure, to be detected thereafter.

Hart, R. K.↗

Atmospheric analyzer, carbon monoxide monitor and toluene diisocyanate monitor

The purpose of the atmospheric analyzer and the carbon monoxide and toluene diisocyanate monitors is to analyze the atmospheric volatiles and to monitor carbon monoxide and toluene diisocyanate levels in the cabin atmosphere of Skylab. The carbon monoxide monitor was used on Skylab 2, 3, and 4 to detect any carbon monoxide levels above 25 ppm. Air samples were taken once each week. The toluene diisocyanate monitor was used only on Skylab 2. The loss of a micrometeoroid shield following the launch of Skylab 1 resulted in overheating of the interior walls of the Orbital Workshop. A potential hazard existed from outgassing of an isocyanate derivative resulting from heat-decomposition of the rigid polyurethane wall insulation. The toluene diisocyanate monitor was used to detect any polymer decomposition. The atmospheric analyzer was used on Skylab 4 because of a suspected leak in the Skylab cabin. An air sample was taken at the beginning, middle, and the end of the mission.

Shannon, A. V.↗

The escape of solar-wind carbon from the moon

About 8 tons of solar-wind carbon is implanted in the lunar soil each year. This inflow is adequate to supply the present regolith carbon abundance (about 100 ppm) in 1-m thickness of soil per billion years. However, the present meteor flux is only capable of mixing to a depth of 10 cm over a billion-year period. As a result, soil mixing cannot act to assimilate the total influx of carbon in the soil. It is necessary that most of the carbon influx be balanced by escape. Model atmospheres for three candidate gases, CH4, CO, and CO2, have been computed. Each model is sized to provide the needed escape rate.

Hodges, R. R., Jr.↗

Investigation of low temperature carbon monoxide oxidation catalysts

Carbon monoxide generation rates related to the use of commerical equipment in Spacelab, added to the normal metabolic and subsystem loads, will produce carbon monoxide levels in excess of the maximum allowable concentration. In connection with the sensitivity of carbon monoxide oxidation catalysts to poisoning at room temperature, catalysts for an oxidation of carbon monoxide at low temperatures have been investigated. It was found that platinum and palladium are the only effective room temperature catalysts which are effective at 333 K. Hopcalite was ineffective at ambient temperatures, but converted CO with 100 percent efficiency at 333 K. Poisoning tests showed the noble metal catalysts to be very sensitive, and Hopcalite to be very resistant to poisoning.

Jagow, R. B.↗

Transport properties of monatomic carbon

Transport collision integrals for each of the 18 molecular C2 states that dissociate into ground state carbon atoms are presented. The integrals are obtained by fitting two-body semiempirical interaction potentials, for which the collision integrals are tabulated, to experimental and/or accurate theoretical calculations for each of these states. The collision integrals are applied to calculate the diffusion coefficient, viscosity, and translational contribution to the thermal conductivity of monatomic carbon at 1-atm pressure from 1000 K to 25,000 K. Because of ablation injection, monatomic carbon is an important flow field constituent of ablative flow during planetary entry, and knowledge of the transport properties for carbon species is required for calculating the flow field properties and surface heating.

Biolsi, L.↗

Direct measurement of surface carbon concentrations

Measurements of surface concentrations of carbon in lunar soils and soil breccias provide information on the origin of carbon in the regolith. The reaction C-12 (d, p sub zero) is used to measure 'surface' and 'volume' concentrations in lunar samples. This method has a depth resolution of 1 micron, which permits only a 'surface' and a 'volume' component to be measured. Three of four Apollo 16 double drive tube samples show a surface carbon concentration of about 8 by 10 to the 14th power/sq cm, whereas the fourth sample gave 4 by 10 to the 14th power/sq cm. It can be convincingly shown that the measured concentration does not originate from fluorocarbon or hydrocarbon contaminants. Surface adsorbed layers of CO or CO2 are removed by a sputter cleaning procedure using a 2-MeV F beam. It is shown that the residual C concentration of 8 by 10 to the 14th power/sq cm cannot be further reduced by increased F fluence, and it is therefore concluded that it is truly lunar. If one assumes that the measured surface C concentration is a steady-state concentration determined only by a balance between solar-wind implantation and sputtering, a sputter erosion rate of 0.1 A/yr is obtained. However, it would be more profitable to use an independently derived sputter erosion rate to test the hypothesis of a solar-wind origin of the surface carbon.

Filleux, C.↗

Nuclear fusion and carbon flashes on neutron stars

This paper reports on detailed calculations of the thermal evolution of the carbon-burning shells in the envelopes of accreting neutron stars for mass-accretion rates of 1 hundred-billionth to 2 billionths of a solar mass per yr and neutron-star masses of 0.56 and 1.41 solar masses. The work of Hansen and Van Horn (1975) is extended to higher densities, and a more detailed treatment of nuclear processing in the hydrogen- and helium-burning regions is included. Results of steady-state calculations are presented, and results of time-dependent computations are examined for accretion rates of 3 ten-billionths and 1 billionth of solar mass per yr. It is found that two evolutionary sequences lead to carbon flashes and that the carbon abundance at the base of the helium shell is a strong function of accretion rate. Upper limits are placed on the accretion rates at which carbon flashes will be important.

Taam, R. E.↗

Carbon scrubber

Inorganic carbon is removed from samples to be analyzed for "total organic carbon". In automated water analysis systems, semipermeable membrane separates two sample streams, one treated with acid, other with base. Carbonate and bicarbonated ions are converted to dissolved CO2 by acid; reverse process occurs in basic stream. Only CO2 is passed by membrane, from acid treated stream to base treated stream. Acidic stream emerges free of all inorganic carbon.

Frant, M. S.↗

Risk Assessment of Carbon Fiber Composite in Surface Transportation

The vulnerability of surface transportation to airborne carbon fibers and the national risk associated with the potential use of carbon fibers in the surface transportation system were evaluated. Results show airborne carbon fibers may cause failure rates in surface transportation of less than one per year by 1995. The national risk resulting from the use of carbon fibers in the surface transportation system is discussed.

Hathaway, W. T.↗

Evaluation of micron size carbon fibers released from burning graphite composites

Quantitative estimates were developed of micron carbon fibers released during the burning of graphite composites. Evidence was found of fibrillated particles which were the predominant source of the micron fiber data obtained from large pool fire tests. The fibrillation phenomena were attributed to fiber oxidation effects caused by the fire environment. Analysis of propane burn test records indicated that wind sources can cause considerable carbon fiber oxidation. Criteria estimates were determined for the number of micron carbon fibers released during an aircraft accident. An extreme case analysis indicated that the upper limit of the micron carbon fiber concentration level was only about half the permissible asbestos ceiling concentration level.

Sussholz, B.↗

An investigation of possible electrical hazards of carbon fiber composites

Results of an assessment of the public risk associated with the release of carbon fibers from crash-fire accidents of civil aircraft having carbon composite structures are presented. The overall national impact is shown to be extremely low in 1993. Personal injury is found to be extremely unlikely. Based on these findings, the risk of electrical failure from carbon fibers should not prevent the exploitation of composites in aircraft, and additional protection of aircraft avionics to guard aginst carbon fibers is unnecessary.

Huston, R. J.↗

Combustion of solid carbon rods in zero and normal gravity

In order to investigate the mechanism of carbon combustion, normal and zero gravity experiments were conducted in which spectroscopic carbon rods were resistance ignited and burned in an oxygen environment. Direct mass spectrometric sampling was used in the normal gravity tests to measure gas phase concentrations. The gas sampling probe was positioned near the circumference of the horizontally mounted carbon rods, either at the top or at angles of 45 or 90 deg from the top, and yielded concentration profiles of CO2, CO, and O2 as a function of distance from the carbon surface. The experimental concentrations were compared to those predicted by a stagnant film model. Zero gravity droptower tests were conducted in order to assess the effect of convection on the normal gravity combustion process. The ratio of flame diameter to rod diameter as a function of time for oxygen pressures of 5, 10, 15, and 20 psia was obtained for three different diameter rods. It was found that this ratio was inversely proportional to both the oxygen pressure and the rod diameter.

Spuckler, C. M.↗

Circumpolar measurements of ozone, particles, and carbon monoxide from a commercial airliner

Trace constituent data are presented from the unique flight of an airliner around the world over both poles. Relatively high resolution and simultaneous measurements of ozone, carbon monoxide, light-scattering particles, condensation nuclei, and meteorological parameters were obtained. The mutual variations of the data in the polar stratospheres, and in the tropical upper troposphere, are discussed in their meteorological setting. The data from the Arctic lower stratosphere are consistent with a tropospheric source of condensation nuclei, but not of carbon monoxide. Carbon monoxide mixing ratios in the Antarctic stratosphere averaged 44 ppbv. In the tropical troposphere they averaged 66 ppbv over the Pacific versus 89 ppbv over Africa. A local area of higher concentration (115 ppbv) was encountered over tropical Africa; its possible relation to carbon monoxide production by vegetation and deep convection is discussed. Evidence was found in the tropical upper troposphere of distinct boundaries between air masses of different temperature, ozone content, and particle content.

Pratt, R.↗

Total carbon and sulfur abundances in Antarctic meteorites

Total carbon and sulfur abundances have been measured in five Antarctic meteorites. Two C2 carbonaceous chondrites Yamato 74662 and Allan Hills 77306 have sulfur abundances (3.490 plus or minus .040% and 3.863 plus or minus 0.050% respectively) similar to other C2 chondrites but their carbon abundances (1.514 plus or minus 0.050% and 1.324 plus or minus .040% respectively) are lower than previously measured C2 chondrites. The decreased carbon abundances may reflect the effects of weathering in cold environments. Carbon and sulfur abundances for one C4 carbonaceous chondrite, one E4 enstatite chondrite and one ureilite are similar to values reported previously for meteorites of the same petrologic grades.

Gibson, E. K., Jr.↗

The potential for damage from the accidental release of conductive carbon fibers from aircraft composites

The paper considers the potential for damage from the accidental release of conductive carbon fibers from aircraft composites. The electrical conductivity of carbon and graphite fibers has led to electrical equipment damage from the inadvertent release of virgin fibers into the atmosphere; an accidental release of carbon fibers from filamentary composites from the burning of crashed commercial airliners could damage electrical and electronic equipment. The experimental and analytical results by NASA of the methods of assessing the extent of potential damage in terms of costs is presented; the NASA materials research program to provide alternate or modified composites to overcome electrical hazards of carbon composites in aircraft structures is described.

Bell, V. L.↗