Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “STALLING”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 883 records · Page 49

Effect of wing flexibility on the experimental aerodynamic characteristics of an oblique wing

A solid-aluminum oblique wing was designed to deflect considerably under load so as to relieve the asymmetric spanwise stalling that is characteristic of this type of wing by creating washout on the trailing wing panel and washin on the leading wing panel. Experimental forces, and pitching, rolling and yawing moments were measured with the wing mounted on a body of revolution. In order to vary the dynamic pressure, measurements were made at several unit Reynolds numbers, and at Mach numbers. The wing was investigated when unswept (at subsonic Mach numbers only) and when swept 45 deg, 50 deg, and 60 deg. The wing was straight tapered in planform, had an aspect ratio of 7.9 (based on the unswept span), and a profile with a maximum thickness of 4 percent chord. The results substantiate the concept that an oblique wing designed with the proper amount of flexibility self relieves itself of asymmetric spanwise stalling and the associated nonlinear moment curves.

Hopkins, E. J.↗

Low-speed aerodynamic characteristics of a 13.1-percent-thick, high-lift airfoil

Low speed sectional characteristics of a high lift airfoil are studied and a comparison is made of those characteristics with the predictions of the theoretical methods used in the airfoil's design. The 13.1 percent-thick, UI-1720 airfoil was found to achieve the predicted maximum lift coefficient of nearly 2.0. No upper-surface, flow separation was found below the stall angle of attack of 16 degrees; it appeared that stall was due to an abrupt leading edge flow separation.

Sivier, K. R.↗

Low-speed wind-tunnel investigation of the longitudinal stability characteristics of a model equipped with a variable-speed wing, 23 May 1949

The longitudinal stability characteristics of a complete model equipped with a variable sweep wings at angles of sweepback of 45 deg, 30 deg, 15 deg, and 0 deg investigated. Various wing modifications and an extern 1 flap arrangement designed to minimize the shift in neutral point accompanying the change in sweep angle were studied. The results indicate that stability at the stall was obtained at a sweep angle of 15 deg without recourse to stall control devices. The basic neutral point movement accompanying the change in sweep angle from 45 deg to 15 deg amounted to 56 percent of the mean aerodynamic chord (at zero sweep angle) and the most effective modification investigated only reduced this change to 47 percent of the chord. It appears, therefore, that for designs in which the fuselage is the major load carrying element some relative movement between the wing and center of gravity will be required to assure satisfactory stability at all sweep angles.

Donlan, C. J.↗

Effect of slotted casing treatment with change in Reynolds number index on performance of a jet engine

A tip-treated J85-13 engine was tested at Reynolds number indices (RNI) of 0.3 and 0.7 with a clean inlet for 80- and 100-percent corrected engine speeds. This engine was equipped with a compressor case which allowed changes to the case wall over the rotor tips of six of its eight stages. For all tests, the principal effects were (1) with tip treatment, a stall pressure ratio loss of 6 percent at 100 percent corrected engine speeds for both the 0.3 and 0.7 RNI, and (2) with and without tip treatment, decreasing the RNI from 0.7 to 0.3 decreased the stall pressure ratio 3.8 percent for 100 percent corrected engine speed and 2.8 percent for 80-percent corrected engine speed.

Moss, J. E., Jr.↗

Flight evaluation of an advanced technology light twin-engine airplane (ATLIT)

Project organization and execution, airplane description and performance predictions, and the results of the flight evaluation of an advanced technology light twin engine airplane (ATLIT) are presented. The ATLIT is a Piper PA-34-200 Seneca I modified by the installation of new wings incorporating the GA(W)-1 (Whitcomb) airfoil, reduced wing area, roll control spoilers, and full span Fowler flaps. The conclusions for the ATLIT evaluation are based on complete stall and roll flight test results and partial performance test results. The Stalling and rolling characteristics met design expectations. Climb performance was penalized by extensive flow separation in the region of the wing body juncture. Cruise performance was found to be penalized by a large value of zero lift drag. Calculations showed that, with proper attention to construction details, the improvements in span efficiency and zero lift drag would permit the realization of the predicted increases in cruising and maximum rate of climb performance.

Holmes, B. J.↗

The development and flight test of an electronic integrated propulsion control system

Advanced technical features of the electronic integrated propulsion control system (IPCS) and flight evaluation tests of IPCS (F-111E with TF30-P-9 engines as test vehicle) are described. Nine baseline flight tests and 15 IPCS flight tests were conducted. Instrumentation, data acquisition and data processing systems, software maintenance procedures, flight test procedures, flight safety criteria, flight test results, and ground and flight testing of the aircraft system are described. Advantages conferred by IPCS include: faster accelerations (both gas generator and afterburner performance), better thrust and flight control, reduced flight idle thrust, reduced engine ground trim, extended service ceiling, automatic stall detection, and stall recovery detection.

Johnson, H. J.↗

Aerodynamic characteristics of airplanes at high angles of attack

An introduction to, and a broad overiew of, the aerodynamic characteristics of airplanes at high angles of attack are provided. Items include: (1) some important fundamental phenomena which determine the aerodynamic characteristics of airplanes at high angles of attack; (2) static and dynamic aerodynamic characteristics near the stall; (3) aerodynamics of the spin; (4) test techniques used in stall/spin studies; (5) applications of aerodynamic data to problems in flight dynamics in the stall/spin area; and (6) the outlook for future research in the area. Although stalling and spinning are flight dynamic problems of importance to all aircraft, including general aviation aircraft, commercial transports, and military airplanes, emphasis is placed on military configurations and the principle aerodynamic factors which influence the stability and control of such vehicles at high angles of attack.

Chambers, J. R.↗

The role of time-history effects in the formulation of the aerodynamics of aircraft dynamics

The scope of any aerodynamic formulation proposing to embrace a range of possible maneuvers is shown to be determined principally by the extent to which the aerodynamic indicial response is allowed to depend on the past motion. Starting from the linearized formulation, in which the indicial response is independent of the past motion, two successively more comprehensive statements about the dependence on the past motion are assigned to the indicial response: (1) dependence only on the recent past and (2) dependence additionally on a characteristic feature of the distant past. The first enables the rational introduction of nonlinear effects and accommodates a description of the rate dependent aerodynamic phenomena characteristic of airfoils in low speed dynamic stall; the second permits a description of the double valued aerodynamic behavior characteristic of certain kinds of aircraft stall. An aerodynamic formulation based on the second statement, automatically embracing the first, may be sufficiently comprehensive to include a large part of the aircraft's possible maneuvers. The results suggest a favorable conclusion regarding the role of dynamic stability experiments in flight dynamics studies.

Tobak, M.↗

Water-tunnel experiments on an oscillating airfoil at RE equals 21,000

Flow visualization experiments were performed in a water tunnel on a modified NACA 0012 airfoil undergoing large amplitude harmonic oscillations in pitch. Hydrogen bubbles were used to: (1) create a conveniently striated and well preserved set of inviscid flow markers; and (2) to expose the succession of events occurring within the viscous domain during the onset of dynamic stall. Unsteady effects were shown to have an important influence on the progression of flow reversal along the airfoil surface prior to stall. A region of reversed flow underlying a free shear layer was found to momentarily exist over the entire upper surface without any appreciable disturbance of the viscous-inviscid boundary. A flow protuberance was observed to develop near the leading edge, while minor vortices evolve from an expanding instability of the free shear layer over the rear portion of the airfoil. The complete breakdown of this shear layer culminates in the successive formation of two dominant vortices.

Mcalister, K. W.↗

Study of aerodynamic technology for VSTOL fighter/attack aircraft, phase 1

A conceptual design study was performed of a vertical attitude takeoff and landing (VATOL) fighter/attack aircraft. The configuration has a close-coupled canard-delta wing, side two-dimensional ramp inlets, and two augmented turbofan engines with thrust vectoring capability. Performance and sensitivities to objective requirements were calculated. Aerodynamic characteristics were estimated based on contractor and NASA wind tunnel data. Computer simulations of VATOL transitions were performed. Successful transitions can be made, even with series post-stall instabilities, if reaction controls are properly phased. Principal aerodynamic uncertainties identified were post-stall aerodynamics, transonic aerodynamics with thrust vectoring and inlet performance in VATOL transition. A wind tunnel research program was recommended to resolve the aerodynamic uncertainties.

Driggers, H. H.↗

The role of time-history effects in the formulation of the aerodynamics of aircraft dynamics

The scope of any aerodynamic formulation proposing to embrace a range of possible maneuvers is shown to be determined principally by the extent to which the aerodynamic indicial response is allowed to depend on the past motion. Starting from the linearized formulation, in which the indicial response is independent of the past motion, two successively more comprehensive statements about the dependence on the past motion are assigned to the indicial response (1) dependence only on the recent past and (2) dependence additionally on a characteristic feature of the distant past. The first enables the rational introduction of nonlinear effects and accommodates a description of the rate-dependent aerodynamic phenomena characteristic of airfoils in low-speed dynamic stall; the second permits a description of the double-valued aerodynamic behavior characteristic of certain kinds of aircraft stall. An aerodynamic formulation based on the second statement, automatically embracing the first, may be sufficiently comprehensive to include a large part of the aircraft's possible maneuvers. The results suggest a favorable conclusion regarding the role of dynamic stability experiments in flight dynamics studies.

Tobak, M.↗

Application of the laser velocimeter to airfoil research

A laser velocimeter (LV) was installed in the Langley V/STOL tunnel to measure the velocity field about a wing with a NACA 0012 airfoil section. These measurements were compared at low angle of attack with a two dimensional, viscous flow prediction program. The velocity field over the wing in a fully stalled condition was also measured by the LV. The unique ability of the LV to measure absolute flow magnitude and direction without prior knowledge of general flow direction was demonstrated in the complex separated reverse flows near the wing upper surface at the high angle of attack. The general characteristics of the flow field over the stalled wing were substantiated by a vapor screen flow visualization technique.

Hoad, D. R.↗

Improved prediction of laminar leading edge separation

Research was conducted to provide a definite criterion for the prediction of the bubble burst on airfoils typical of those used for fighter wings. The approach taken was to correlate existing airfoil bubble burst data using various parameters at the laminar separation point. The method due to Weber was modified to provide a continuous analytic solution for the velocity distribution around the airfoil leading edge. Coupling the modified Weber method with the Stratford laminar separation prediction method leads to a universal chart giving the conditions at separation as a function of stagnation location and leading edge radius. Application of the combined method to available two-dimensional airfoil data resulted in an empirical criterion presenting the limiting local velocity gradient at separation as a function of the boundary layer momentum thickness at separation for bubble burst. The correlation leads as well to the qualitative explanation of two types of laminar stall: thin airfoil and leading edge. The validity of the correlation is demonstrated by predicting the lift coefficient and angle of attack for stall on airfoils with leading edge or trailing edge flaps.

Herring, R. N.↗

Aerodynamic performance of 1.38-pressure-ratio, variable-pitch fan stage

The performance of a variable pitch fan stage tested over a range of blade setting angles, speeds, and flows is presented. The fan was designed for a tip speed of 289.6 m/sec and a flow of 29.6 kg/sec. The measured performance agreed reasonably well with the design point. The stall margin was only 5 percent. Static thrust values along an operating line ranged from less than 15 to over 115 percent of that at design angle as the blade setting angle was varied from 25 degrees (closed) to -8 degrees (opened). The use of casing treatment increased the stall margin to 20.6 percent but decreased efficiency by 4 percentage points.

Moore, R. D.↗

An elliptic representation of coupled boundary layers and inviscid core for computation of separated internal flows

This report presents a viscous-inviscid calculation method for the prediction of turbulent incompressible flows in diffusers with small regions of stall. Integral turbulent boundary layer equations (BLE) are used to provide boundary conditions for a finite difference representation of the inviscid core. The BLE are applied at the floating displacement-thickness line, resulting in a simulataneous set of nonlinear block tridiagonal equations which are solved iteratively using a sucessive line-relaxation technique. Results of the method have been applied to calculate the performance of a variety of asymmetric stalled diffusers.

Ghose, S.↗

Simulator study of stall/post-stall characteristics of a fighter airplane with relaxed longitudinal static stability

A real-time piloted simulation was conducted to evaluate the high-angle-of-attack characteristics of a fighter configuration based on wind-tunnel testing of the F-16, with particular emphasis on the effects of various levels of relaxed longitudinal static stability. The aerodynamic data used in the simulation was conducted on the Langley differential maneuvering simulator, and the evaluation involved representative low-speed combat maneuvering. Results of the investigation show that the airplane with the basic control system was resistant to the classical yaw departure; however, it was susceptible to pitch departures induced by inertia coupling during rapid, large-amplitude rolls at low airspeed. The airplane also exhibited a deep-stall trim which could be flown into and from which it was difficult to recover. Control-system modifications were developed which greatly decreased the airplane susceptibility to the inertia-coupling departure and which provided a reliable means for recovering from the deep stall.

Nguyen, L. T.↗

A parametric wing design study for a modern laminar flow wing

The results of a parametric wing design study using a modern laminar flow airfoil designed to exhibit desirable stall characteristics while maintaining high cruise performance are presented. It was found that little is sacrificed in cruise performance when satisfying the stall margin requirements if a taper ratio of 0.65 or greater is used.

Koegler, J. A., Jr.↗

Description of an experimental (hydrogen peroxide) rocket system and its use in measuring aileron and rudder effectiveness of a light airplane

A hydrogen peroxide fueled rocket system, which is to be used as a research tool in flight studies of stall and spin maneuvers, was installed on a light, four place general aviation airplane. The pilot controlled rocket system produces moments about either the roll or the yaw body axis to augment or oppose the aerodynamic forces and inertial moments acting on the airplane during various flight maneuvers, including the spin. These controlled moments of a known magnitude can be used in various ways to help analyze and interpret the importance of the various factors which influence airplane maneuvers. The rocket system and its installation in the airplane are described, and the results of flight rests used to measure rudder and aileron effectiveness at airspeeds above the stall are presented. These tests also serve to demonstrate the operational readiness of the rocket system for future research operations.

Obryan, T. C.↗