Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Control variates”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 883 records · Page 49
All sourcesNASA NTRSDOE OSTI
NASA NTRS1994

Global circulation, thermal structure, and carbon monoxide distribution in Venus' mesosphere in 1991

Millimeter-wave observations of CO lines have provided a detailed picture of Venus' mesosphere dynamics in 1991 from simultaneous measurements of absolute wind velocities in two layers and of temperature and CO horizontal and vertical profiles at 75-115 km. Venus' circulation at 90-110 km was characterized in 1991 by the superposition of a zonal retrograde flow and a subsolar-to-antisolar flow of approximately equal velocities, increasing from about 40 +/- 15 m/sec at 95 km to 90 +/- 15 m/sec at 105 km altitude. The magnitude of the increase of the SS-AS flow is consistent with Venus thermosphere general circulation models (VTGCM). At 105 km, the data further indicate a cos(latitude) dependence of the zonal flow and marginally suggest the presence of a poleward meridional component of 35 +/- 30 m/sec. No obvious day-to-day variations of the circulation are evident in the data at the 20 m/sec level. Thermal profiles in the low-latitude region appear to be consistent with the Pioneer Venus nightside profile, except above 110 km, where they are somewhat colder. High-latitude warming is still found, but mid-latitudes appear to be colder than the equator. The atmosphere appears to be in cyclostrophic balance up to about 105 km. The horizontal distribution of CO on Venus' nightside is essentially uniform, both in latitude and in local time. This behavior agrees with VTGCM simulations in which the zonal flow velocity is prescribed to match the observations. Comparison with previous wind measurements indicates that the zonal flow experiences dramatic long-term variations. This variability, along with short-term fluctuations of the mesospheric zonal flow (evidenced by the variability in the O2 nightglow emissions), apparently controls the CO and O2 nightglow distributions. Gravity wave activity is a plausible mechanism that can drive these variations.

Lellouch, Emmanuel↗
NASA NTRS1975

A Monte Carlo analysis of the effects of instrumentation errors on aircraft parameter identification

An output error estimation algorithm was used to evaluate the effects of both static and dynamic instrumentation errors on the estimation of aircraft stability and control parameters. A Monte Carlo analysis, using simulated cruise flight data, was performed for a high performance military aircraft, a large commercial transport, and a small general-aviation aircraft. The effects of variations in the information content of the flight data, resulting from two different choices of control input maneuvers, were also determined. The results indicate that unmodeled instrumentation errors can cause inaccuracies in the estimated parameters which are comparable to their nominal values. Control input errors and angular accelerometer lags were found to be most significant of the instrumentation errors evaluated, and the perturbations they produce are much larger than those arising from the combined effects of static errors and white noise in the output response measurements.

Bryant, W. H.↗
NASA NTRSDate not supplied

Simplified Vehicle Control Concept for a Lift Plus Cruise eVTOL Vehicle

Electric Vertical Takeoff and Landing (eVTOL) vehicles have the potential to enable cost effective Urban Air Mobility (UAM) applications. These concepts may also pose several challenging handling and control problems, which must be addressed prior to safe and efficient urban operations. This paper investigates a simplified vehicle control concept that is designed to address some of these challenges for a conceptual Lift Plus Cruise vehicle. This concept also includes several variations of a transition-to-hover function, designed to assist pilots in capturing and maintaining a stabilized hover prior to landing. The different simplified control architectures for this concept are presented along with preliminary findings. Preliminary results show that the simplified control concept can be effective in assisting pilots to achieve safe and reliable hover landings, and that transition-to-hover functions have the potential of reducing workload while increasing accuracy. A follow on evaluation will be performed in the Vertical Motion Simulator (VMS) at NASA Ames Research Center. The planned tests will focus on more operationally representative scenarios, while building upon these operations with additional test cases exploring variations in glidepath angles and wind conditions.

simplified vehicle control↗
NASA NTRS1994

A simple analytical aerodynamic model of Langley Winged-Cone Aerospace Plane concept

A simple three DOF analytical aerodynamic model of the Langley Winged-Coned Aerospace Plane concept is presented in a form suitable for simulation, trajectory optimization, and guidance and control studies. The analytical model is especially suitable for methods based on variational calculus. Analytical expressions are presented for lift, drag, and pitching moment coefficients from subsonic to hypersonic Mach numbers and angles of attack up to +/- 20 deg. This analytical model has break points at Mach numbers of 1.0, 1.4, 4.0, and 6.0. Across these Mach number break points, the lift, drag, and pitching moment coefficients are made continuous but their derivatives are not. There are no break points in angle of attack. The effect of control surface deflection is not considered. The present analytical model compares well with the APAS calculations and wind tunnel test data for most angles of attack and Mach numbers.

Pamadi, Bandu N.↗
NASA NTRS1974

On spatial variations in the intensity of chromospheric H-alpha

Investigation of the formation of patterns in H-alpha spectroheliograms and filtergrams. Introducing a source-sink-control diagram, it is concluded that the H-alpha line source function in the quiet solar chromosphere is indirectly controlled by the photospheric radiation fields in the Balmer and Paschen continua. It is demonstrated that in producing the observed patterns, horizontal spatial variations in the shape of the absorption profile are extremely effective compared to changes in the source and sink terms. Applying this mechanism, asymptotic values are computed for the contrasts and visibilities in chromospheric H-alpha.

Gebbie, K. B.↗
NASA NTRS1992

Performance of thermal control tape in the protection of composite materials

The selection of materials for construction of long duration mission spacecraft has presented many challenges to the aerospace design community. After nearly six years in low earth orbit, NASA's Long duration Exposure Facility (LDEF), retrieved in January of 1990, has provided valuable information on both the nature of the space environment as well as the effects of the space environment on potential spacecraft materials. Composites, long a favorite of the design community because of a high strength-to-weight ratio, were flown in various configurations on LDEF in order to evaluate the effects of radiation, atomic oxygen, vacuum, micrometeoroid debris, and thermal variation on their performance. Fiberglass composite samples covered with an aluminum thermal control tape were flown as part of the flight experiment A0171, the Solar Array Materials Passive LDEF Experiment (SAMPLE). Visual observations and test results indicate that the thermal control tape suffered little degradation from the space exposure and proved to be a reliable source of protection from atomic oxygen erosion and UV radiation for the underlying composite material.

Kamenetzky, Rachel R.↗
NASA NTRS1993

A high accuracy sequential solver for simulation and active control of a longitudinal combustion instability

A high accuracy convection scheme using a sequential solution technique has been developed and applied to simulate the longitudinal combustion instability and its active control. The scheme has been devised in the spirit of the Total Variation Diminishing (TVD) concept with special source term treatment. Due to the substantial heat release effect, a clear delineation of the key elements employed by the scheme, i.e., the adjustable damping factor and the source term treatment has been made. By comparing with the first-order upwind scheme previously utilized, the present results exhibit less damping and are free from spurious oscillations, offering improved quantitative accuracy while confirming the spectral analysis reported earlier. A simple feedback type of active control has been found to be capable of enhancing or attenuating the magnitude of the combustion instability.

Shyy, W.↗
NASA NTRS2014

Flight Deck Robustness/Conformance Testing with a Surface Management System: An Integrated Pilot-Controller Human-in-the-Loop Surface Operations Simulation

An integrated flight deck and controller human-in-the-loopsimulation was conducted with a total of 120 Dallas-Ft.Worth (DFW) taxi-out operations. In this first integratedPilot-Controller Spot and Runway Departure Advisor(SARDA) simulation, ATC Ground and Local Controllersused the SARDA decision support tool to plan and issuespot release clearances and departure clearances. TheAirport and Terminal Area Simulator (ATAS), a simulatedB737NG piloted, in turn, by 10 commercial transportparticipant pilots, was integrated into the realisticsimulation traffic environment. In the simulation,controllers used SARDA advisories to issue spot release,taxi route, and runway/departure radio voice clearances toall aircraft on the airport surface. Simulation resultsindicated that under a variety of observed pilot/aircraftperformance variations, SARDA yielded controlleradvisories that were: Supportive of current-day time-basedoperations; Compatible with controllers’ expectations;Predictive of actual take-off times; and, Adaptable to offnominalevents. An Information Sharing Display, thatpresented SARDA sequence and timing information on theflight deck, was considered useful for both NextGenoperations and current-day time-based Traffic ManagementInitiative (TMI) operations.

Foyle, David C.↗
NASA NTRS1975

The 7.5 kW solar array simulator

A high power solar array simulator capable of providing the input power to simultaneously operate two 30 cm diameter ion thruster power processors was designed, fabricated, and tested. The maximum power point is set to between 150 and 7500 watts representing an open circuit voltage from 50 to 300 volts and a short circuit current from 4 to 36 amps. Illuminated solar cells are used as the control element to provide a true solar cell characteristic and permit the option of simulating changes in this characteristic due to variations in solar intensity and/or temperature of the solar array. This is accomplished by changing the illumination and/or temperature of the control cells. The response of the output to a step change in load closely approximates that of an actual solar array.

Robson, R. R.↗
NASA NTRS1985

Electron densities and temperatures in the Venus ionosphere Effects of solar EUV, solar wind pressure and magnetic field

The Venus ionosphere is influenced by variations in both solar EUV flux and solar wind conditions. On the dayside the location of the topside of the ionosphere, the ionopause, is controlled by solar wind dynamic pressure. Within the dayside ionosphere, however, electron density is affected mainly by solar EUV variations, and is relatively unaffected by solar wind variations and associated magnetic fields induced within the ionosphere. The existence of a substantial nightside ionosphere of Venus is thought to be due to the rapid nightward transport of dayside ionospheric plasma across the terminator. Typical solar wind conditions do not strongly affect this transport and consequently have little direct influence on nightside ionospheric conditions, except on occasions of extremely high solar wind dynamic pressure. However, both nightside electron density and temperature are affected by the presence of magnetic field, as in the case of ionospheric holes.

Elphic, R. C.↗
NASA NTRS1989

Dynamics and control of the tether elevator/crawler system

This paper investigates the dynamics and acceleration levels of a new tethered system for micro- and variable-gravity applications. The system consists of two platforms tethered on opposite sides to the Space Station. A fourth platform, the elevator, is placed in between the Space Station and the upper platform. Variable-g levels on board the elevator are obtained by moving this facility along the upper tether, while microgravity experiments are carried out on board the Space Station. By controlling the length of the lower tether the position of the system center of mass can be maintained on board the Space Station despite variations of the system's distribution of mass. The paper illustrates the mathematical model, the environmental perturbations and the control techniques which have been adopted for the simulation and control of the system dynamics. Two sets of results from two different simulation runs are shown. The first set shows the system dynamics and the acceleration spectra on board the Space Station and the elevator during station-keeping. The second set of results demonstrates the capability of the elevator to attain a preselected g-level.

Lorenzini, E. C.↗
NASA NTRS1930

Balanced and servo control surfaces

Many reports on various control systems are available, but the results cannot be generally applied since the effect of particular changes of surface-form and mounting are subject to variations depending upon airfoil section and influences of airplane layout. This report presents a simple analysis of several control systems in more general use. Elevators, ailerons, and rudders are all discussed.

Source record↗
NASA NTRS1974

Microwave power transmission system wherein level of transmitted power is controlled by reflections from receiver

A microwave, wireless, power transmission system is described in which the transmitted power level is adjusted to correspond with power required at a remote receiving station. Deviations in power load produce an antenna impedance mismatch causing variations in energy reflected by the power receiving antenna employed by the receiving station. The variations in reflected energy are sensed by a receiving antenna at the transmitting station and used to control the output power of a power transmitter.

Robinson, W. J., Jr.↗
NASA NTRS1983

On families of systems and deformations

Until recently, there has not been any systematic effort towards a theory of systems with parameter variations. It is presently suggested that the concept of families of systems is basic to such an effort, and entails the techniques of Lie theory, differential geometry, and algebraic geometry. Attention is given to the geometric characterization of certain families of systems that appear in control and identification problems. The ways in which families of systems degenerate as parameter variations become large are isolated, using the topological rather than algebraic geometric case.

Krishnaprasad, P. S.↗
NASA NTRS1977

Modeling and parameter uncertainties for aircraft flight control system design

Values of plant dynamic uncertainties for some recent aircraft design and development programs are given. Histories of pertinent aerodynamic, inertial, and structural parameter variations are given for a period of time from program initiation to aircraft certification. These data can be used as typical of future vehicles so that control system design concepts are evaluated with due consideration to their sensitivity to uncertainties in plant dynamics.

Mcdonnell, J. D.↗
NASA NTRS1988

Creep rupture analysis of a beam resting on high temperature foundation

A simplified uniaxial strain controlled creep damage law is deduced with the use of experimental observation from a more complex strain dependent law. This creep damage law correlates the creep damage, which is interpreted as the density variation in the material, directly with the accumulated creep strain. Based on the deduced uniaxial strain controlled creep damage law, a continuum mechanical creep rupture analysis is carried out for a beam resting on a high temperature elastic (Winkler) foundation. The analysis includes the determination of the nondimensional time for initial rupture, the propagation of the rupture front with the associated thinning of the beam, and the influence of creep damage on the deflection of the beam. Creep damage starts accumulating in the beam as soon as the load is applied, and a creep rupture front develops at and propagates from the point at which the creep damage first reaches its critical value. By introducing a series of fundamental assumptions within the framework of technical Euler-Bernoulli type beam theory, a governing set of integro-differential equations is derived in terms of the nondimensional bending moment and the deflection. These governing equations are subjected to a set of interface conditions at the propagating rupture front. A numerical technique is developed to solve the governing equations together with the interface equations, and the computed results are presented and discussed in detail.

Gu, Randy J.↗
NASA NTRS1991

High pressure water jet cutting and stripping

High pressure water cutting techniques have a wide range of applications to the American space effort. Hydroblasting techniques are commonly used during the refurbishment of the reusable solid rocket motors. The process can be controlled to strip a thermal protective ablator without incurring any damage to the painted surface underneath by using a variation of possible parameters. Hydroblasting is a technique which is easily automated. Automation removes personnel from the hostile environment of the high pressure water. Computer controlled robots can perform the same task in a fraction of the time that would be required by manual operation.

Hoppe, David T.↗