SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Fabrication and testing of honeycomb sandwich aircraft panels are discussed. Also described is the use of the following instruments: thermogravimetric analyzer, differential scanning calorimeter, limiting oxygen index, and infrared spectrometer.
The results of a one-year effort to determine the applicability of laser-calorimetric spectroscopy to the study of deep-level impurities in silicon are presented. Critical considerations for impurity analysis by laser-calorimetric spectroscopy are discussed, the design and performance of a cryogenic laser calorimeter is described, and measurements of background absorption in high-purity silicon are presented.
The result of the direct measurement of the fragmentation region will be presented. The result will be obtained at the CERN proton-antiproton collider, being exposured the Silicon calorimeters inside beam pipe. This experiment clarifies a long riddle of cosmic ray physics, whether the Feynman scaling does villate at the fragmentation region or the Iron component is increasing at 10 to the 15th power eV.
With the use of Akeno calorimeter, the attenuation of particles in concrete is analyzed as the function of the shower size of 10 to the 5th power to 10 to the 7th power. The attenuation length does not depend much on the shower size but depends a little on the shower age. The average value is approx. 150 g/sq cm for s = 0.5 to 0.85 and approx. 40 g/sq cm for s = 0.85 to 1.15. These values and their fluctuations are consistent with the equi-intensity curves of extensive air showers (EAS).
For a long time two anomalies are observed in cosmic rays at energies E approx. = 100 TeV: (1) the generation of long-flying cascades in the hadron calorimeter (the so-called Tien-Shan effect) and; (2) the enhancement of direct muon yield as compared with the accelerator energy region. The aim is to discuss the possibility that both anomalies have common origins arising from production and decays of the same particles. the main conclusions are the following: (1) direct muons cannot be generated by any new particles with mass exceeding 10+20 GeV; and (2) if both effects are originated from the charmed hadrons, then the needed charm hadroproduction cross section is unexpectedly large as compared with the quark-gluon model predictions.
Registration and identification of muons and muon groups penetrating into the ocean depth, can be performed using a modular multilayer detector with high resolution bidimensional readout - deep underwater calorimeter (project NADIR). Laboratory testing of a prototype sensor cell with liquid scintillator in light-tight casing, testifies to the practicability of the full-scale experiment within reasonable expences.
A search experiment for cosmic ray magnetic monopoles was performed by means of atomic induction mechanism by using He mixture gas proportional counters of the calorimeter (130 square meters sr) at the center of the Akeno air shower array. In 3,482 hours operation no monopole candidate was observed. The upper limit of the monopole flux is 1.44 x 10 to the minus 13th power cm-z, sec -1, sr-1 (90% C.L.) for the velocity faster than 7 x 0.0001 c.
A search for monopoles and tachyons at ground level was carried out using an arrangement consisting of an ionization calorimeter and two hodoscope detectors. No clear evidence for these particles was obtained. The flux of monopoles with velocities beta approximately 0.01 is found to be less than 5.1 x 10 to the minus 13th power square centimeters s(-1) sr(-1) (95% cl.). The upper limit on the tachyon flux density is set as a 6 x 10 the minus 9th power particle/square centimeter event.
The status of the Frejus experiment and the preliminary results obtained in the search for nucleon decay are discussed. A modular, fine grain tracking calorimeter was installed in the Frejus laboratory in the period extending from October 1983 to May 1985. The 3300 cubic meter underground laboratory, located in the center of the Frejus tunnel in the Alps, is covered in the vertical direction by 1600 m of rocks (4400 m w.e.). The average number of atmospheric muons in the lab is 4.2 square meters per day. The 912 ton detector is made of 114 modules, each one including eight flash chamber and one Geiger vertical planes of (6 x 6) square meters dimensions. The flash chamber (and Geiger) planes are alternatively crossed to provide a 90 deg. stereo reconstruction. No candidate for the nucleon decay into charged lepton is found in the first sample of events.
It is pointed out that the JACEE-3 experiment combined electronic counters and an emulsion chamber to study nucleus-nucleus interactions between 20 and 100 GeV/n. In the present paper, a description is given of the use of the passive detector stack. The electronic position detectors facilitate the event location, taking into account a determination of the incident angles. CR-39 plastic plates were placed just below the proportional counters to enhance tracking accuracy. The JACEE-3 emulsion chamber consists of three parts, including the charge module, the target module, and the calorimeter module. The charge module is mainly used in track identification. The obtained results are also discussed, giving attention to event number and tracking efficiency, interaction measurements, and the inelasticity distribution.
Technique development and the application of electromagnetic levitation to thermophysical property measurement, including determining heats of fusion, heat capacities, and enthalpy increment functions for extremely refractory materials are discussed. Tungsten properties and the development of an apparatus employing electromagnetic levitation and electron beam heating capable of melting levitating tungsten high temperature heat content measurements by drop calorimetry are emphasized. The development of a prototype microcomputer data acquisition system suitable for controlling the ground based system, with consequent improvement in system handling, which can serve as a model for the system needed for flight experiments is described, which include the development of techniques for imaging pyrometry at temperatures above 3500 K, a semiautomatic calorimeter system capable of handling liquid tungsten, and development of a two color imaging pyrometer system.
A program was conducted to investigate ignition, combustion and heat transfer characteristics of liquid oxygen and RP-1 fuel applicable to large gas generator cycle booster engines. The program was part of a broad effort intended to generate a combustion devices technology base for both RP-1 and methane fuels and both gas generator and staged combustion engine cycles. Two gas generator injector designs were tested over a chamber pressure range of 1500 to 3100 psia and a gas temperature range of 1500 to 2300 R. Both configurations were evaluated for combustion efficiency, gas temperature profile and combustion stability. Thrust chamber firings were conducted using a platelet type main injector and a water cooled calorimeter combustion chamber. Test conditions ranged from 1700 to 2200 psia chamber pressure and from 2.0 to 2.8 mixture ratio. A program goal to reduce previously measured nozzle heating rates was achieved, but at the expense of combustion efficiency.
The present conference ranges over topics in high energy physics instrumentation, detectors, nuclear medical applications, health physics and environmental monitoring, reactor instrumentation, nuclear spacecraft instrumentation, the 'Fastbus' data acquisition system, circuits and systems for nuclear research facilities, and the development status of nuclear power systems. Specific attention is given to CCD high precision detectors, a drift chamber preamplifier, a Cerenkov ring imaging detector, novel scintillation glasses and scintillating fibers, a modular multidrift vertex detector, radial wire drift chambers, liquid argon polarimeters, a multianode photomultiplier, the reliability of planar silicon detectors, the design and manufacture of wedge and strip anodes, ultrafast triode photodetectors, photomultiplier tubes, a barium fluoride plastic scintillator, a fine grained neutron hodoscope, the stability of low leakage silicon photodiodes for crystal calorimeters, and X-ray proportional counters. Also considered are positron emission tomography, single photon emission computed tomography, nuclear magnetic resonance imaging, Geiger-Muller detectors, nuclear plant safeguards, a 32-bit Fastbus computer, an advanced light water reactor, and nuclear plant maintenance.
The results of direct measurements of the energy distribution and elemental composition of cosmic rays are reviewed. Consideration is given to early calorimeter, Cerenkov-counter, and superconducting-magnet data; HEAO-3 results; balloon-borne measurements beyond 30 GeV/nucleon, and the balloon-borne emulsion-chamber data obtained in the JACEE experiments (Burnett et al., 1982 and 1983). The potential of Space Station observations to extend the data to energies as high as 10 PeV is discussed.
The scientific aims and design concept of a High-Energy Space Station (HESS) cosmic-ray detector array are discussed. The current state of knowledge on cosmic-ray acceleration and high-energy interactions is briefly reviewed, and the need for observations yielding elemental composition and spectra in the 10-10,000-TeV/nucleon range is demonstrated. It is predicted that 2 yr of observations with a space-borne detector of geometry factor 30 sq m sr would provide adequate data to determine the acceleration mechanism (by comparing the energy level at which the spectra of He nuclei and protons break). A modular HESS array comprising W/scintillator/PM-tube calorimeter modules and Cerenkov charge-sensitive detector modules and weighing about 30 tonnes is described. The array could be assembled on orbit after transport in the Space Shuttle cargo bay, and data could be taken as soon as one or two layers of modules had been attached to the mounting-frame/support-electronics unit.
Analytical and experimental studies are being conducted for NASA to evaluate means of increasing the heat extraction capability and service life of a liquid rocket combustor. This effort is being conducted in conjunction with other tasks to develop technologies for an advanced, expander cycle, oxygen/hydrogen engine planned for upper stage propulsion applications. Increased heat extraction, needed to raise available turbine drive energy for higher chamber pressure, is derived from combustion chamber hot gas wall ribs that increase the heat transfer surface area. Life improvement is obtained through channel designs that enhance cooling and maintain the wall temperature at an accepatable level. Laboratory test programs were conducted to evaluate the heat transfer characteristics of hot gas rib and coolant channel geometries selected through an analytical screening process. Detailed velocity profile maps, previously unavailable for rib and channel geometries, were obtained for the candidate designs using a cold flow laser velocimeter facility. Boundary layer behavior and heat transfer characteristics were determined from the velocity maps. Rib results were substantiated by hot air calorimeter testing. The flow data were analytically scaled to hot fire conditions and the results used to select two rib and three enhanced coolant channel configurations for further evaluation.
The thermal protection systems for the shuttle/Centaur would have had to provide fail-safe thermal protection during prelaunch, launch ascent, and on-orbit operations as well as during potential abort. The thermal protection systems selected used a helium-purged polyimide foam beneath three rediation shields for the liquid-hydrogen tank and radiation shields only for the liquid-oxygen tank (three shields on the tank sidewall and four on the aft bulkhead). A double-walled vacuum bulkhead separated the two tanks. The liquid-hydrogen tank had one 0.75-in-thick layer of foam on the forward bulkhead and two layers on the larger area sidewall. Full scale tests of the flight vehicle in a simulated shuttle cargo bay that was purged with gaseous nitrogen gave total prelaunch heating rates of 88,500 Btu/hr and 44,000 Btu/hr for the liquid-hydrogen and -oxygen tanks, respectively. Calorimeter tests on a representative sample of the liquid-hydrogen tank sidewall thermal protection system indicated that the measured unit heating rate would rapidly decrease from the prelaunch rate of approx 100 Btu/hr/sq ft to a desired rate of less than 1.3 Btu/hr/sq ft once on orbit.
A novel device is described which combines the high quantum efficiency of a photoelectric detector with the high energy resolution of a dispersive spectrometer in a system that operates simultaneously over the whole AXAF bandpass. It is basically an X-ray calorimeter, in which the temperature rise of an X-ray absorber following the deposition of energy from a single X-ray photon can be measured to an accuracy expected to be of order one part in 1000 at 6 keV.