SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Method of reducing sulfur and nitrogen oxides released during combustion of fossil fuels is described. Fuel is burned in fluidized bed of solids with simultaneous feeding of crushed or pulverized limestone to control emission. Process also offers high heat transfer rates and efficient contacting for gas-solid reactions.
A hybrid computer program is presented which can process as many as 10 channels of sweep frequency data simultaneously. The program needs only the sine sweep signal used to drive the system, and its correponding quadrature component, to process the data. It can handle a maximum frequency range of 0.5 to 500 hertz. Magnitude and phase are calculated at logarithmically spaced points covering the frequency range of interest. When the sweep is completed, these results are stored in digital form. Thus, a tabular listing and/or a plot of any processed data channel or the transfer function relating any two of them is immediately available.
The ultraviolet dayglow in the wavelength region 750-1050 A was investigated over the altitude range 100-800 km using a thin film filter photometer. From the airglow spectrum obtained by Carruthers and Page, one of the dominant features in this wavelength range is OII 834 A. It is pointed out that the major excitation mechanism for this transition is photoionization excitation of atomic oxygen. Solution of the radiative transfer problem for this excitation process shows good agreement with the observed dayglow in the 300-800 km region. At lower altitudes additional componets are present and are interpreted as the N2, OI and possibly HI emissions observed by Carruthers and Page.
The development of spacecraft with electrical loads that require high voltage power is discussed. The high voltage solar array has been considered for supplying d.c. power directly to high voltage loads such as ion thrusters and communication tubes without intermediate power processing. Space power stations for transferring solar power to earth are being studied in the 40 kilovolt, multikilowatt regime. Analytical and experimental studies have determined that with the advent of high voltage power, new problems will arise through the interaction of the high voltage surfaces with the charged particle environment of space. The interactive environment has been identified and duplicated to some extent in simulation facilities at NASA-Lewis Research Center and at several contractor locations.
The interactions of control system and distributed flexible structural dynamics is explored for mechanical arms. A modeling process using 4 x 4 transfer matrices is described which permits the closed loop response of many current arm configurations to be evaluated. Root locus, frequency response, modal shapes, and time impulse response have all been obtained from the digital computer implementation of this model, which is oriented to arm design and allows for easy variation of the arm configuration through data cards. The model corresponds with experimentally observed natural frequencies with an average error of less than 5% in the first three flexible modes in the seven cases considered. The model was used to explore the limits imposed by structural flexibility on a nondimensionalized two link arm with one and two joints for planar motion.
The article examines several aspects of electric propulsion. It is shown that because the process and rate of energy transfer in electric systems are quite different from those of chemical propulsion systems, performance and orbit mechanics are intimately related. Attention is given to the several discrete subelements of an electric primary propulsion system, showing that while they have straightforward operating principles, they present challenges in implementation as working hardware. Finally, discussion covers applications which include a range of interplanetary and near-earth missions.
The organizational structure and facilities available at the Marshall Space Flight Center are described and the role of the Center in NASA program management is demonstrated in a review of the Center's past history and current development projects. Particular attention is given to space shuttle and the space transportation system; the preparation of experiments and management of Spacelab missions; and the development of the space telescope. Energy related activities discussed include the automatic guidance and control of the longwall shearing machine for coal extraction, systems for the solar heating and cooling of buildings, and the design of the solar power satellite. Products developed by Center personnel highlighted include the power factor controller to reduce electrical consumption by motors and the image enhancement process being used to restore early historical photographs. A free flying solar power source to increase mission duration of the orbiter and its payloads; techniques for the orbital assembly of large space structures; facilities for materials processing in space; the orbit transfer vehicle, solar electric propulsion systems; and the preparation of science and applications payloads are also described.
The operation of a silicon production technique was demonstrated. The essentials of the method comprise chemical vapor deposition of silicon, by hydrogen reduction of chlorosilanes, on the inside of a quartz reaction vessel having large internal surface area. The system was designed to allow successive deposition-melting cycles, with silicon removal being accomplished by discharging the molten silicon. The liquid product would be suitable for transfer to a crystal growth process, casting into solid form, or production of shots. A scaled-down prototype reactor demonstrated single pass conversion efficiency of 20 percent and deposition rates and energy consumption better than conventional Siemens reactors, via deposition rates of 365 microns/hr. and electrical consumption of 35 Kwhr/kg of silicon produced.
To aid state/local agencies in starting effective programs to apply Landsat and other remote sensing data, NASA's Eastern Regional Remote Sensing Applications Center (ERRSAC) has developed a comprehensive training program as part of its technology transfer mission. Skills in data processing and interpretation are produced through 'hands-on' experience with computer techniques used to conduct practical applications involving state-oriented projects, conducted jointly by agencies and ERRSAC. In time, ERRSAC will shift much of these training activities to universities where future agency personnel can obtain a broader foundation in remote sensing.
The utilization potential of the point focusing parabolic dish is identified. Its main design parameters are summarized. Performance tests and the utilization of the collector as primary energy source in a food-water-power complex are described. Process heat, heat storage, heat transfer, and cogeneration are discussed.
Four observations of Scorpius X-1 with the Objective Grating Spectrometer of the Einstein Observatory have provided high-resolution spectra (lambda/Delta lambda = approximately 20-50) in the wavelength range 7-46 A. The spectra reveal the presence of absorption structure due to oxygen, nitrogen, and iron, and variable emission structure associated with ionized iron and nitrogen. The strengths of these features suggest that the N/O abundance ratio in the absorbing and line emitting gas is anomalously high, which might indicate that these spectral components are associated with processed material, probably accreting matter transferred from the surface of an evolved companion. Constraints on the inclination of the system, however, imply that this cool, dense, accreting material must be well out of the plane of the binary system. Possible models for the origin and nature of this circumsource medium are discussed. An extensive discussion of the calibration of the Objective Grating Spectrometer and of the analysis of spectra acquired by that instrument is also provided.
New concepts for engine performance improvement are seen through the adoption of heat regeneration techniques; advanced methods to enhance the combustion; and higher efficiency air handling machinery, such as the positive displacement helical screw expander and compressor. Each of these concepts plays a particular role in engine performance improvement. First regeneration has a great potential for achieving higher engine thermal efficiency through the recovery of waste energy. Although the concept itself is not new (this technique is used in the gas turbine), the application to reciprocating internal combustion engines is quite unusual and presents conceptual difficulties. The second important area is better control of the combustion process in terms of heat transfer characteristics, combustion products, and heat release rate. The third area for performance improvement is in the adoption of high efficiency air handling machinery. In particular, positive displacement helical expander and compressor exhibit an extremely high efficiency over a wide range of operating conditions.
As part of a general review of recent high-resolution seismological data, constraints are established for the distribution of mass in the continental crust and upper mantle of the earth. It is shown that the densities of mantle magmas such as MORB-like tholeiites, oicrites, and komatites at 10 kilobars are greater than densities in the continental crust. In order to explain the deviation, a mechanism is proposed for the control of mass transfer during igneous and metamorphic processes throughout geological time. Within the context of a description of the mechanism, the continental crust is characterized as a density filter through which only highly evolved magmas with H2O may pass. It is shown that the removal of less evolved magmas can lead to an over accretion (penetration) or an under accretion (underplating) of magmas in the continental Moho. Some implications of the proposed mechanism for current theoretical models of crust formation are discussed in detail.
Requirements for the IUE archive, and how the signal/noise (S/N) ratio in photometrically corrected images can be enhanced considerably by cross-correlating the fixed pattern in a data image with that in a suitable flat-field image are described. From these cross-correlations it is feasible to derive an accurate geometrical correction to apply to the data image before applying the intensity transfer functions. The standard IUE processing software does not generate a sufficiently accurate geometric correction so that typical spatial errors of 1 to 2 pixels conspire with the large fixed pattern in raw images to produce significant misregistration noise. Tests on flat-field images demonstrate that an explicit geometric correction procedure can avoid most of the misregistration noise and can thereby improve the S/N ratio of IUE data by factors of 1.5 to 2.4.
The Annual Report presents the fiscal year (FY) 1988 research activities and accomplishments, for the Biocatalysis Project of the U.S. Department of Energy, Energy Conversion and Utilization Technologies (ECUT) Division. The ECUT Biocatalysis Project is managed by the Jet Propulsion Laboratory, California Institute of Technology. The Biocatalysis Project is a mission-oriented, applied research and exploratory development activity directed toward resolution of the major generic technical barriers that impede the development of biologically catalyzed commercial chemical production. The approach toward achieving project objectives involves an integrated participation of universities, industrial companies and government research laboratories. The Project's technical activities were organized into three work elements: (1) The Molecular Modeling and Applied Genetics work element includes research on modeling of biological systems, developing rigorous methods for the prediction of three-dimensional (tertiary) protein structure from the amino acid sequence (primary structure) for designing new biocatalysis, defining kinetic models of biocatalyst reactivity, and developing genetically engineered solutions to the generic technical barriers that preclude widespread application of biocatalysis. (2) The Bioprocess Engineering work element supports efforts in novel bioreactor concepts that are likely to lead to substantially higher levels of reactor productivity, product yields and lower separation energetics. Results of work within this work element will be used to establish the technical feasibility of critical bioprocess monitoring and control subsystems. (3) The Bioprocess Design and Assessment work element attempts to develop procedures (via user-friendly computer software) for assessing the energy-economics of biocatalyzed chemical production processes, and initiation of technology transfer for advanced bioprocesses.
The multicellular flow between two vertical parallel plates is numerically simulated using a time-splitting pseudospectral method. The steady flow of air and the time-periodic flow of oil are investigated, and descriptions of these flows using both physical and spectral approaches are presented. The time dependence of the flow and temperature fields of oil are shown, and the dynamics of the process is discussed. The spectral transfer of energy among the axial modes comprising the flow is explored. The three-dimensional linear stabiltiy of the multicellular air flow is parametrically studied. The domain of stable two-dimensional cellular motion is found to be constrained by the Eckhaus instability and by two types of monotone instability. The two-dimensional multicellular flow is unstable above a Grashof number of about 8550.
Laser-generated interference in the laser-induced fluorescence detection of tropospheric hydroxyl is addressed by a detailed photochemical model. This phenomenon arises through photolysis of ozone by the detection laser and subsequent reaction of O(1D) with H2O to form OH. The approach is direct time integration of the coupled differential equations describing the pertinent chemical reactions, collisional energy transfer, and photolytic and spectroscopic processes, including an assessment of limitations due to uncertainties in the input parameters. The goal is to use the model to quantitatively design OH detection methods so that the experimental results need not rely on such a model for interpretation. Previously reported measurements of tropospheric OH appear to have been contaminated by ozone interference effects and by optical saturation of the monitoring transition. However, suggested improvements can reduce the problem to interference levels below 200,000 OH molecules/cu cm, permitting measurements useful for testing theories of fast tropospheric photochemistry.
Tidal interaction between the galaxies in binary systems leads to important consequences. Some peculiarities in galactic morphology as well as the transfer of matter from one galaxy to another may be due to this factor. In particular, gas flows in intergalactic space may be formed. Such flows enriching one component with gas from the other may play a substantial role in the evolution of mixed (S-E) pairs. One can mention several facts corroborating the possibility of the gas transfer from the spiral to the elliptical galaxy. High HI content (10(exp 7) to 10(exp 9) solar mass) is detected in nearly 40 E galaxies (Bottinelli and Gougenheim, 1979; Knapp et al., 1985). Such galaxies are often members of pairs or of multiple systems including an S galaxy, which may be the source of gas (Smirnov and Komberg, 1980). Moreover, the gas kinematics and its distribution also indicate an external origin for this gas (Knapp et al., 1985). In many cases there is an outer gaseous disk. The directions of the disk and of stellar rotation don't always coincide (van Gorkom et al., 1985; Varnas et al., 1987). The galaxy colors in S-E pairs are correlated (the Holmberg effect): bluer ellipticals have spiral components that are usually bluer (Demin et al., 1984). The fraction of E galaxies with emission lines (N sub em) in S-E pairs showing traces of tidal interaction is twice as large (N sub em approx. equals 0.24) as in pairs without interaction (N sub em approx. equals 0.12) (Sotnikova, 1988b). Since the presence of emission lines in a galaxy spectrum strongly depends on gas content, this fact also leads to the conclusion that ellipticals in interacting S-E pairs are enriched with gas. These facts may be considered as a serious indication of the existence of gas transfer. Hence, investigation of this process is of interest.