Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Reserves”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 865 records · Page 48

Group 3: Performance evaluation and assessment

Line-oriented flight training provides a unique learning experience and an opportunity to look at aspects of performance other types of training did not provide. Areas such as crew coordination, resource management, leadership, and so forth, can be readily evaluated in such a format. While individual performance is of the utmost importance, crew performance deserves equal emphasis, therefore, these areas should be carefully observed by the instructors as an rea for discussion in the same way that individual performane is observed. To be effective, it must be accepted by the crew members, and administered by the instructors as pure training-learning through experience. To keep open minds, to benefit most from the experience, both in the doing and in the follow-on discussion, it is essential that it be entered into with a feeling of freedom, openness, and enthusiasm. Reserve or defensiveness because of concern for failure must be inhibit participation.

Frink, A.↗

Monte Carlo studies of ocean wind vector measurements by SCATT: Objective criteria and maximum likelihood estimates for removal of aliases, and effects of cell size on accuracy of vector winds

The scatterometer on the National Oceanic Satellite System (NOSS) is studied by means of Monte Carlo techniques so as to determine the effect of two additional antennas for alias (or ambiguity) removal by means of an objective criteria technique and a normalized maximum likelihood estimator. Cells nominally 10 km by 10 km, 10 km by 50 km, and 50 km by 50 km are simulated for winds of 4, 8, 12 and 24 m/s and incidence angles of 29, 39, 47, and 53.5 deg for 15 deg changes in direction. The normalized maximum likelihood estimate (MLE) is correct a large part of the time, but the objective criterion technique is recommended as a reserve, and more quickly computed, procedure. Both methods for alias removal depend on the differences in the present model function at upwind and downwind. For 10 km by 10 km cells, it is found that the MLE method introduces a correlation between wind speed errors and aspect angle (wind direction) errors that can be as high as 0.8 or 0.9 and that the wind direction errors are unacceptably large, compared to those obtained for the SASS for similar assumptions.

Pierson, W. J.↗

Positive electrode processing for Hughes NiH2 cells

The basic procedures were developed for the manufacture of nickel cadmium batteries. An electrochemical impregnation in an aqueous ethanol solution is used in this process. Several additional controls were instituted for production of flight electrodes, including a Hughes controlled MCD, a solution reserved exclusively for the impregnation of Hughes positive electrodes a system of complete traceability for individual electrodes, an electrical characterization test to provide information on weight and capacity at the plaque level, and a stress test to provide data on capacity, weight, and physical parameters at the electrode level.

Bleser, C. A.↗

Effect of wind turbine generator model and siting on wind power changes out of large WECS arrays

Methods of reducing the WECS generation change through selection of the wind turbine model for each site, selection of an appropriate siting configuration, and wind array controls are discussed. An analysis of wind generation change from an echelon and a farm for passage of a thunderstorm is presented. Reduction of the wind generation change over ten minutes is shown to reduce the increase in spinning reserve, unloadable generation and load following requirements on unit commitment when significant WECS generation is present and the farm penetration constraint is satisfied. Controls on the blade pitch angle of all wind turbines in an array or a battery control are shown to reduce both the wind generation change out of an array and the effective farm penetration in anticipation of a storm so that the farm penetration constraint may be satisfied.

Schleuter, R. A.↗

Forest Resource Information System. Phase 3: System transfer report

Transfer of the forest reserve information system (FRIS) from the Laboratory for Applications of Remote Sensing to St. Regis Paper Company is described. Modifications required for the transfer of the LARYS image processing software are discussed. The reformatting, geometric correction, image registration, and documentation performed for preprocessing transfer are described. Data turnaround was improved and geometrically corrected and ground-registered CCT LANDSAT 3 data provided to the user. The technology transfer activities are summarized. An application test performed in order to assess a Florida land acquisition is described. A benefit/cost analysis of FRIS is presented.

Mroczynski, R. P.↗

Real-time simulation of helicopter IFR approaches into major terminal areas using RNAV, MLS, and CDTI

Helicopter IFR routes at hub airports have been investigated in an air-traffic-control system simulation involving a piloted helicopter simulator, computer-generated air traffic, and air traffic controllers. Problems studied included: (1) pilot acceptance of the approach procedure and tracking accuracy; (2) ATC procedures for handling a mix of helicopter and fixed-wing traffic; and (3) utility of the Cockpit Display of Traffic Information (CDTI) for the helicopter. Results indicate that the helicopter routes were pilot acceptable and were noninterfering with fixed-wing traffic. Merging and spacing maneuvers using CDTI were successfully carried out by the pilots, but controllers had some reservations concerning CDTI.

Tobias, L.↗

Baseband-processed SS-TDMA communication system architecture and design concepts

The architecture and system design for a commercial satellite communications system planned for the 1990's was developed by Motorola for NASA's Lewis Research Center. The system provides data communications between individual users via trunking and customer premises service terminals utilizing a central switching satellite operating in a time-division multiple-access (TDMA) mode. The major elements of the design incorporating baseband processing include: demand-assigned multiple access reservation protocol, spectral utilization, system synchronization, modulation technique and forward error control implementation. Motorola's baseband processor design, which is being proven in a proof-of-concept advanced technology development, will perform data regeneration and message routing for individual users on-board the spacecraft.

Attwood, S.↗

Long term compatibility of nitrogen tetroxide with metals - Results at the ten-year milestone

Analyses and results are reported of a test program to establish the effects of long-term (10 years or more) contact of materials with nitrogen textroxide MON-1 for the purpose of designing chemical propulsion system components which can be used for current as well as future planetary spacecraft. The test materials included aluminum alloy, corrosion-resistant steel, titanium alloy, and nickel. The weight and appearance of each specimen were observed, including the presence of deposits, etching, pitting, and cracking. Aluminum alloy and steel were rated satisfactory with minor reservations, titanium alloy was satisfactory, and nickel was unsatisfactory. Criteria for ratings are shown.

Moran, C. M.↗

The flux ejection dynamo effect

The mean-field effects of cyclonic convection become increasingly complex when the cyclonic rotation exceeds 1/2 pi. Net helicity is not required, with negative turbulent diffusion for instance, appearing in mirror symmetric turbulence. This paper points out a new dynamo effect arising in convective cells with strong asymmetry in the rotation of updrafts as against downdrafts. The creation of new magnetic flux arises from the ejection of reserve flux through the open boundary of the dynamo region. It is unlike the familiar alpha-effect in that individual components of the field may be amplified independently. Several formal examples are provided to illustrate the effect. Occurrence in nature depends upon the existence of fluid rotations of the order of pi in the convective updrafts. The flux ejection dynamo may possibly contribute to the generation of field in the convective core of earth and in the convective zone of the sun and other stars.

Parker, E. N.↗

Basic investigation into the electrical performance of solid electrolyte membranes

The electrical performance of solid electrolyte membranes was investigated analytically and the results were compared with experimental data. It is concluded that in devices that are used for pumping oxygen the major power losses have to be attributed to the thin film electrodes. Relations were developed by which the effectiveness of tubular solid electrolyte membranes can be determined and the optimum length evaluated. The observed failure of solid electrolyte tube membranes in very localized areas is explained by the highly non-uniform current distribution in the membranes. The analysis points to a possible contact resistance between the electrodes and the solid electrolyte material. This possible contact resistance remains to be investigated experimentally. It is concluded that film electrodes are not appropriate for devices which operate with current flow, i.e., pumps though they can be employed without reservation in devices that measure oxygen pressures if a limited increase in the response time can be tolerated.

Richter, R.↗

The minimization of pylon-mounted store effects on air combat capability

Some effects of pylon-mounted missiles on aft-tail delta wing supersonic fighter concepts have been investigated. Whereas minimum drag penalties do occur with the addition of missiles, the effects at higher lifts, corresponding to maneuvering flight, are less severe and often favorable. Lower speeds and altitudes enhance the maneuvering capability and one-on-one air combat would probably tend to degenerate to subsonic speeds even though the combatants may be flying supersonic fighters. Higher speed (supersonic) flight might best be reserved for interceptors with long-range missiles where the weapon carriage effects at low angles of attack are of prime importance.

Spearman, M. L.↗

GIS Integration for Quantitatively Determining the Capabilities of Five Remote Sensors for Resource Exploration

To assist the U.S. Geological Survey in carrying out a Congressional mandate to investigate the use of side-looking airborne radar (SLAR) for resources exploration, a research program was conducted to define the contribution of SLAR imagery to structural geologic mapping and to compare this with contributions from other remote sensing systems. Imagery from two SLAR systems and from three other remote sensing systems was interpreted, and the resulting information was digitized, quantified and intercompared using a computer-assisted geographic information system (GIS). The study area covers approximately 10,000 square miles within the Naval Petroleum Reserve, Alaska, and is situated between the foothills of the Brooks Range and the North Slope. The principal objectives were: (1) to establish quantitatively, the total information contribution of each of the five remote sensing systems to the mapping of structural geology; (2) to determine the amount of information detected in common when the sensors are used in combination; and (3) to determine the amount of unique, incremental information detected by each sensor when used in combination with others. The remote sensor imagery that was investigated included real-aperture and synthetic-aperture radar imagery, standard and digitally enhanced LANDSAT MSS imagery, and aerial photos.

Pascucci, R. F.↗

Reliability considerations in the placement of control system components

This paper presents a methodology, along with applications to a grid type structure, for incorporating reliability considerations in the decision for actuator placement on large space structures. The method involves the minimization of a criterion that considers mission life and the reliability of the system components. It is assumed that the actuator gains are to be readjusted following failures, but their locations cannot be changed. The goal of the design is to suppress vibrations of the grid and the integral square of the grid modal amplitudes is used as a measure of performance of the control system. When reliability of the actuators is considered, a more pertinent measure is the expected value of the integral; that is, the sum of the squares of the modal amplitudes for each possible failure state considered, multiplied by the probability that the failure state will occur. For a given set of actuator locations, the optimal criterion may be graphed as a function of the ratio of the mean time to failure of the components and the design mission life or reservicing interval. The best location of the actuators is typically different for a short mission life than for a long one.

Montgomery, R. C.↗

Landsat-D, about to be reality

The space and ground segments of the Landsat-D thematic mapper (TM) for remote sensing of a 185 km swath with 30 m resolution are described. Scanning the full earth once every 16 days from its 705 km sunsynchronous orbit, Landsat-D will relay its data on the ku-band through the TDRSS satellite to a ground station. The X-band will also be used to transmit data directly to foreign and domestic ground stations; the S-band will be reserved for MSS data only. Landsat-D comprises the multimission modular spacecraft and the instrument module, which features the MSS and TM, a wideband communication subsystem, a solar array, and an L-band global positioning system. Three computers on the ground provide a high degree of automation for reception, storage, retrieval, back-up, and transmission of data and commands. Additionally, a van is equipped with transportable equipment, including an antenna. Procedures followed for image generation from the MSS and TM are detailed, noting storage at Goddard until dispersal of tapes under the direction of the EROS data center.

Aepli, T. C.↗

ISEE-3 - A late entry in the great comet chase

The ISEE-3 spacecraft, currently in a figure-8 traverse of the geomagnetic tail between 80-220 earth radii, is being redirected to a flyby of the Giacobini-Zinner comet in 1985. The satellite carries experiments for the solar wind plasma, magnetic field data, plasma wave and composition, radio waves, and energetic protons, and can gather data on the solar wind-comet interaction. A double lunar swingby will be employed to establish the intercept trajectory, yielding a total velocity change of 100 m/sec, with a reserve of 100 m/sec for midcourse corrections. The comet will be encountered at a distance of 3000 km in September 1985, followed by passage through the Halley's comet tail 5000 km from the nucleus in March 1986.

Farquhar, R.↗

Study of effects of fuel properties in turbine-powered business aircraft

Increased interest in research and technology concerning aviation turbine fuels and their properties was prompted by recent changes in the supply and demand situation of these fuels. The most obvious change is the rapid increase in fuel price. For commercial airplanes, fuel costs now approach 50 percent of the direct operating costs. In addition, there were occasional local supply disruptions and gradual shifts in delivered values of certain fuel properties. Dwindling petroleum reserves and the politically sensitive nature of the major world suppliers make the continuation of these trends likely. A summary of the principal findings, and conclusions are presented. Much of the material, especially the tables and graphs, is considered in greater detail later. The economic analysis and examination of operational considerations are described. Because some of the assumptions on which the economic analysis is founded are not easily verified, the sensitivity of the analysis to alternates for these assumptions is examined. The data base on which the analyses are founded is defined in a set of appendices.

Powell, F. D.↗

Digitally controlled sonars

Sonars are usually designed and constructed as stand alone instruments. That is, all elements or subsystems of the sonar are provided: power conditioning, displays, intercommunications, control, receiver, transmitter, and transducer. The sonars which are a part of the Advanced Ocean Test Development Platform (AOTDP) represent a departure from this manner of implementation and are configured more like an instrumentation system. Only the transducer, transmitter, and receiver which are unique to a particular sonar function; Up, Down, Side Scan, exist as separable subsystems. The remaining functions are reserved to the AOTDP and serve all sonars and other instrumentation in a shared manner. The organization and functions of the common AOTDP elements were described and then the interface with the sonars discussed. The techniques for software control of the sonar parameters were explained followed by the details of the realization of the sonar functions and some discussion of the performance of the side scan sonars.

Hansen, G. R.↗