Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Numerical Simulation”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 865 records · Page 48
All sourcesNASA NTRSDOE OSTI
NASA NTRS1978

Numerical simulation of MHD shock waves in the solar wind

The effects of the interplanetary magnetic field on the propagation speed of shock waves through an ambient solar wind are examined by numerical solutions of the time-dependent nonlinear equations of motion. The magnetic field always increases the velocity of strong shocks. Although the field may temporarily slow down weak shocks inside 1 AU, it eventually also causes weak shocks to travel faster than they would without the magnetic field at larger distances. Consistent with the increase in the shock velocity, the gas pressure ratio across a shock is reduced considerably in the presence of the magnetic field. The numerical method is used to simulate (starting at 0.3 AU) the large deceleration of a shock observed in the lower corona by ground-based radio instrumentation and the more gradual deceleration of the shock in the solar wind observed by the Pioneer 9 and Pioneer 10 spacecraft.

Steinolfson, R. S.↗
NASA NTRS1986

Numerical simulation of vortical flow over an elliptical-body missile at high angles of attack

Numerical solutions to the Reynolds-averaged Navier-Stokes equations are given for the flow about an elliptical body missile (3:1 ellipse) at a Mach number of 2.5 and a unit Reynolds number of 6.56 x 10 to the 6th/m. At high angles of attack, the flow is dominated by large-scale free vortices which occur in the lee-side flow field due to crossflow boundary-layer separation. Emphasis is focused on the accurate prediction of the lee-side vortical flow. Solutions are presented for both symmetric and asymmetric (body rolled 45 deg) configurations at 10 deg and 20 deg angle of attack. The computed results are compared with experimental surface pressure coefficients and vapor-screen photographs. Excellent agreement is obtained in all cases.

Newsome, R. N.↗
NASA NTRS1991

Numerical simulation of the emission and motion of neutral and charged dust from P/Halley

The present numerical model for neutral or charged dust-particle distribution prediction in P/Halley encompasses the spatial and temporal variations of the plasma parameters and magnetic field. A significant difference is noted between results for neutral dust trajectories and the trajectories of charged dust particles with radii smaller than 0.1 micron. While most of the model and in situ mass spectra were in good agreement, there is a shortage of the lowest-mass model particles, as well as an offset of the total counting rate for two outbound mass spectra. A combination of two Lorentzian particle mass-density functions with a 100:1 ratio for the number of particles with the lower and higher density functions yielded the best agreement.

Ellis, Tracy A.↗
NASA NTRS1994

Numerical Simulation of Inlet Bleed with Circular Holes on Plate Under Shock-Wave/Boundary-Layer Interactions

A numerical study was performed to investigate the shock-wave/boundary-layer interactions on a flat plate with bleed through one or more circular holes that vent into a plenum. The bleed-hole patterns considered for the study include in-line multiple holes and staggered multiple-row holes that are configured to simulate the patterns used in inlet bleed systems of high performance aircraft. The focus of the study was to examine how the bleed through multiple holes affect bleed rate and the pressure and Mach number distributions. Since the bleed performance was found sensitive to the change in bleed conditions, a computational procedure was developed to give a good turnaround computational time for parametric studies involving changes in bleed hole geometry and the structure of shock-wave/boundary-layer flowfield. The procedure includes the grid-generation methodology and the flow simulation with solutions from the Navier-Stokes equations. The computational techniques permit analysis of complex bleed systems and make possible the investigation of a broader range of design variables associated with inlet bleed operation.

Chyu, Wei J.↗
DOE OSTI2014

GPUPEGAS: A NEW GPU-ACCELERATED HYDRODYNAMIC CODE FOR NUMERICAL SIMULATIONS OF INTERACTING GALAXIES

In this paper, a new scalable hydrodynamic code, GPUPEGAS (GPU-accelerated Performance Gas Astrophysical Simulation), for the simulation of interacting galaxies is proposed. The details of a parallel numerical method co-design are described. A speed-up of 55 times was obtained within a single GPU accelerator. The use of 60 GPU accelerators resulted in 96% parallel efficiency. A collisionless hydrodynamic approach has been used for modeling of stars and dark matter. The scalability of the GPUPEGAS code is shown.

79 ASTRONOMY AND ASTROPHYSICS↗
NASA NTRS2002

Simple Numerical Simulation of Strain Measurement

By adopting the basic principle of the reflection (and transmission) of a plane polarized electromagnetic wave incident normal to a stack of films of alternating refractive index, a simple numerical code was written to simulate the maximum reflectivity (transmittivity) of a fiber optic Bragg grating corresponding to various non-uniform strain conditions including photo-elastic effect in certain cases.

Tai, H.↗
DOE OSTI2019

Generalized, Energy-conserving Numerical Simulations of Particles in General Relativity. II. Test Particles in Electromagnetic Fields and GRMHD

Observations of compact objects, in the form of radiation spectra, gravitational waves by LIGO/Virgo, and direct imaging with the Event Horizon Telescope, are currently the main information sources on plasma physics in extreme gravity. Modeling such physical phenomena Requires numerical methods that allow for the simulation of microscopic plasma dynamics in the presence of both strong gravity and electromagnetic fields. In Bacchini et al. (2018), we presented a detailed study of numerical techniques for the integration of free geodesic motion. In this paper, we extend the study by introducing electromagnetic forces in the simulation of charged particles in curved spacetimes. We extend the Hamiltonian energy-conserving method presented in Bacchini et al. to include the Lorentz force, and we test its performance compared to that of standard explicit Runge–Kutta and implicit midpoint rule schemes against analytic solutions. Then, we show the application of the numerical schemes to the integration of test particle trajectories in general relativistic magnetohydrodynamic (GRMHD) simulations by modifying the algorithms to handle grid-based electromagnetic fields. We test this approach by simulating ensembles of charged particles in a static GRMHD configuration obtained with the black hole accretion code (BHAC).

79 ASTRONOMY AND ASTROPHYSICS↗
NASA NTRS1986

Real gas effects on the numerical simulation of a hypersonic inlet

The present use of a parabolized Navier-Stokes solver to accurately simulate the flowfield in a supersonic inlet yields good agreement between numerical analysis and experiment for a Mach 7.4 inlet under cruise conditions, with an internal compression ratio of 8. The significance of real gas effects on the performance calculation of a hypersonic inlet is demonstrated, with small changes in the ratio of specific heats resulting in a substantial change in the calculated pitot pressure ratio.

Ng, W.-F.↗
NASA NTRS1990

Numerical simulation of turbulent flows around airfoil and wing

During the last years the simulation of compressible viscous flows has received much attention. While the numerical methods were improved drastically, a satisfactory modeling of the Reynolds stresses is still missing. In this paper, after a short description of the numerical procedure used for solving the Reynolds equations, experiments with a promising simple turbulence model are discussed.

Marx, Yves P.↗
DOE OSTI2015

Numerical simulation of porosity and permeability evolution of Mount Simon sandstone under geological carbon sequestration conditions

A numerical model was developed with the use of reactive transport code CrunchFlow to estimate porosity, permeability and mineral composition changes of Mount Simon sandstone under typical geological carbon sequestration conditions (P = 23.8 MPa and T = 85 °C). The model predicted a permeability decrease from 1.60 mD to 1.02 mD for the Mount Simon sandstone sample in a static batch reactor after 180 days of exposure to CO 2 -saturated brine, which is consistent with measured permeability results. Model-predicted solution chemistry results were also consistent with laboratory-measured solution chemistry data. SiO 2 (am) was the primary mineral that causes permeability decrease, followed by kaolinite. Both SiO 2 (am) formation and kaolinite formation were attributed to the dissolution of quartz and feldspar. This article shows that the formation of SiO 2 (am) and kaolinite in the pore space of host rock is possible under typical CO2 sequestration conditions. SiO 2 (am) and kaolinite precipitation at the CO 2 plume extent could reduce the permeability of host rock and improve lateral containment of free-phase CO 2 , contributing to overall security of CO 2 storage.

37 INORGANIC, ORGANIC, PHYSICAL, AND ANALYTICAL CH↗
NASA NTRS1978

A numerical simulation of seasonal stratospheric climate. II - Energetics

The paper analyzes the energetics involved in the two numerical experiments described in Part I, concerning a longwave radiative transfer model and a simple Newtonian cooling (or heating) model. A three-dimensional quasi-geostrophic model is developed and used over the entire annual cycle to test the climatic responses of the stratospheric circulation to the cited two different longwave radiative heating models. It is shown that the eddy energy parameters (eddy kinetic energy, eddy available potential energy, generation of the latter, and vertical propagation of eddy geopotential energy) undergo annual variations with maximum values in winter and minimum values in summer. The zonal energy parameters exhibit semiannual variations with major maximum values in winter, minor maxima in summer and minima in spring and fall. Analysis of the energy cycle reveals that the vertical propagation of eddy geopotential energy and the generation of eddy available potential energy are the energy sources for energetics in the upper stratosphere. Ways in which the longwave radiative processes may affect the stratospheric energetics are identified.

Chen, T.-C.↗
NASA NTRS1987

Numerical simulation of three-dimensional unsteady vortex flow using a compact vorticity-velocity algorithm

A numerical algorithm is presented which is used to solve the unsteady, fully three-dimensional, incompressible Navier-Stokes equations in vorticity-velocity variables. A discussion of the discrete approximation scheme is presented as well as the solution method used to solve the resulting algebraic set of difference equations. Second order spatial and temporal accuracy is verified through solution comparisons with exact results obtained for steady three-dimensional stagnation point flow and unsteady axisymmetric vortex spin-up. In addition, results are presented for the problem of unsteady bubble-type vortex breakdown with emphasis on internal bubble dynamics and structure.

Gatski, T. B.↗
NASA NTRS1990

Numerical Simulation Of Buckling In Waffle Plants

Accurate results obtained when fillet radii considered. Two reports describe numerical and experimental study of application of PASCO and WAFFLE computer programs to analysis of buckling in integrally machined, biaxially stiffened panel. PASCO (Panal Analysis and Sizing Code) is finite-element stress-and-strain code written for analysis and sizing of uniaxially stiffened panels. WAFFLE program provides comprehensive stress analysis of waffle panel, used to determine bending moments at interfaces.

Yin, Dah N.↗
NASA NTRS1996

A Numerical Simulation of Scattering from One-Dimensional Inhomogeneous Dielectric Random Surfaces

In this paper, an efficient numerical solution for the scattering problem of inhomogeneous dielectric rough surfaces is presented. The inhomogeneous dielectric random surface represents a bare soil surface and is considered to be comprised of a large number of randomly positioned dielectric humps of different sizes, shapes, and dielectric constants above an impedance surface. Clods with nonuniform moisture content and rocks are modeled by inhomogeneous dielectric humps and the underlying smooth wet soil surface is modeled by an impedance surface. In this technique, an efficient numerical solution for the constituent dielectric humps over an impedance surface is obtained using Green's function derived by the exact image theory in conjunction with the method of moments. The scattered field from a sample of the rough surface is obtained by summing the scattered fields from all the individual humps of the surface coherently ignoring the effect of multiple scattering between the humps. The statistical behavior of the scattering coefficient sigma(sup 0) is obtained from the calculation of scattered fields of many different realizations of the surface. Numerical results are presented for several different roughnesses and dielectric constants of the random surfaces. The numerical technique is verified by comparing the numerical solution with the solution based on the small perturbation method and the physical optics model for homogeneous rough surfaces. This technique can be used to study the behavior of scattering coefficient and phase difference statistics of rough soil surfaces for which no analytical solution exists.

Sarabandi, Kamal↗
NASA NTRS1984

Numerical simulation of boundary-layer transition

The transition to turbulence in boundary layers was investigated by direct numerical solution of the nonlinear, three-dimensional, incompressible Navier-Stokes equations in the half-infinite domain over a flat plate. Periodicity was imposed in the streamwise and spanwise directions. A body force was applied to approximate the effect of a nonparallel mean flow. The numerical method was spectra, based on Fourier series and Jacobi polynomials, and used divergence-free basis functions. Extremely rapid convergence was obtained when solving the linear Orr-Sommerfeld equation. The early nonlinear and three-dimensional stages of transition, in a boundary layer disturbed by a vibrating ribbon, were successfully simulated. Excellent qualitative agreement was observed with either experiments or weakly nonlinear theories. In particular, the breakdown pattern was staggered or nonstaggered depending on the disturbance amplitude.

Spalart, P. R.↗
DOE OSTI2017

Numerical Simulation of Measurements during the Reactor Physical Startup at Unit 3 of Rostov NPP

The results of numerical calculations and measurements of some reactor parameters during the physical startup tests at unit 3 of Rostov NPP are presented. The following parameters are considered: the critical boron acid concentration and the currents from ionization chambers (IC) during the scram system efficiency evaluation. The scram system efficiency was determined using the inverse point kinetics equation with the measured and simulated IC currents. The results of steady-state calculations of relative power distribution and efficiency of the scram system and separate groups of control rods of the control and protection system are also presented. The calculations are performed using several codes, including precision ones.

21 SPECIFIC NUCLEAR REACTORS AND ASSOCIATED PLANTS↗
NASA NTRS2013

Combined Experimental and Numerical Simulations of Thermal Barrier Coated Turbine Blades Erosion

A combined experimental and computational study was conducted to investigate the erosion of thermal barrier coated (TBC) blade surfaces by alumina particles ingestion in a single stage turbine. In the experimental investigation, tests of particle surface interactions were performed in specially designed tunnels to determine the erosion rates and particle restitution characteristics under different impact conditions. The experimental results show that the erosion rates increase with increased impingement angle, impact velocity and temperature. In the computational simulations, an Euler-Lagrangian two stage approach is used in obtaining numerical solutions to the three-dimensional compressible Reynolds Averaged Navier-Stokes equations and the particles equations of motion in each blade passage reference frame. User defined functions (UDF) were developed to represent experimentally-based correlations for particle surface interaction models which were employed in the three-dimensional particle trajectory simulations to determine the particle rebound characteristics after each surface impact. The experimentally based erosion UDF model was used to predict the TBC erosion rates on the turbine blade surfaces based on the computed statistical data of the particles impact locations, velocities and angles relative to the blade surface. Computational results are presented for the predicted TBC blade erosion in a single stage commercial APU turbine, for a NASA designed automotive turbine, and for the NASA turbine scaled for modern rotorcraft operating conditions. The erosion patterns in the turbines are discussed for uniform particle ingestion and for particle ingestion concentrated in the inner and outer 5 percent of the stator blade span representing the flow cooling the combustor liner.

Hamed, Awate↗