SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Intensity contour and polarization observation maps of nine supernova remnants at a microwave frequency are presented and discussed. The data provided are the highest-frequency (10.6 GHz) measurements to date for several of these sources and should therefore be useful in determining their spectra. Polarization ranges from 2 or 3% to as high as 40-50%. Integrated fluxes for the sources vary from about 3 to more than 25.
The FM radar for the coal interface detector, operating in the frequency band 2 to 4 GHz, is intended for the display of thicknesses between 2 cm and 20 cm. Because of such a short range, the thickness information is contained in the very few lowest spectral components of the output signal. To overcome this inconvenience, the Fourier series of the output signal was augmented to approximate a Fourier integral. This modification in the signal processing resulted in a higher spectral density, which in turn enabled an easier identification of the interface position in the laboratory. The orientation and spacing of the receiving and transmitting antennas is found to have an important influence on the system performance.
The thermometric capability of a two-line fluorescence technique using iodine seed molecules in air is investigated analytically and verified experimentally in a known steady compressible flow field. Temperatures ranging from 165 to 295 K were measured in the flowfield using two iodine transitions accessed with a 30-GHz dye-laser scan near 543 nm. The effect of pressure broadening on temperature measurement is evaluated.
Observations of the impulsive phase of a solar flare at microwave wavelengths and in hard X-rays are used to deduce the strength of the magnetic field and the number of energetic electrons producing the burst. The microwave observations, using the VLA at 6 cm, had spatial resolution of 8 x 8 arcsec, close to the resolution of the Hard X-ray Imaging Spectrometer on SMM which also imaged this flare. The Hard X-ray Burst Spectrometer determined the spectrum of the burst in the range 25-512 keV, and several patrol telescopes recorded the microwave time profile at frequencies from 2.8 to 19.6 GHz. The combined data show that the derived number of microwave-emitting electrons is at least three orders of magnitude fewer than the number of thick target electrons producing the hard X-rays. It is proposed that the fast electrons are highly beamed and radiate gyrosynchrotron emission less efficiently than isotropically distributed electrons.
A fine resolution polarimetric FM SAR was developed for optimization of polarimetric SARs and interpretation of SAR data via controlled experiments with surface-base sensors. The system is designed for collecting polarimetric data at 5.3 and 10 GHz over incidence angles from 0 to 60 deg. Features of the system include broad bandwidth to obtain fine range resolution, phase stabilization and linearization loop circuitry, and digital signal processing capability. The system is used in a research program to collect polarimetric backscatter data from artificial sea ice research and design trade-offs, laboratory and field evaluation, as well as results from experiments on artificial sea ice are presented.
The characteristics of nadir versus off-nadir altimetry are reviewed and contrasted and a potentially serious problem has been pointed out that has been overlooked by earlier investigators, who focused on the nongeophysical error sources in off-nadir altimetry. Spatial gradients of radar cross section on the sea surface, caused by wind or current gradients or the variation of radar cross section with incidence angle, could introduce significant range errors in off-nadir altimeter. This potentially crippling effect can be overcome by leaving the traditional 13-GHz frequency and implementing the multibeam altimeter at 36 GHz. A multibeam altimeter proposed for the EOS (Earth Observing System) is described as well as a multimode airborne radar altimeter being developed to study problems inherent in off-nadir altimetry.
Microstrip ring resonators operating at 35 GHz were fabricated from laser ablated YBCO thin films deposited on lanthanum aluminate substrates. They were measured over a range of temperatures and their performance compared to identical resonators made of evaporated gold. Below 60 Kelvin the superconducting strip performed better than the gold, reaching an unloaded Q approximately 1.5 times that of gold at 25 K. A shift in the resonant frequency follows the form predicted by the London equations. The Phenomenological Loss Equivalence Method is applied to the ring resonator and the theoretically calculated Q values are compared to the experimental results.
Microwave-heated plasmas in convergent nozzles are analyzed using a coupled Maxwell and Navier-Stokes solver to examine relevant issues associated with microwave thermal propulsion. Parametric studies are conducted to understand the effect of power, pressure, and plasma location with respect to the nozzle throat. For nozzles in the 0.5 to 3 N range with helium flow, results show that specific impulses up to 550-650 sec are possible, with further increases being limited by severe wall-heating. Coupling efficiencies of over 90 percent are consistently obtained, with overall efficiencies ranging from 40 percent to 80 percent. Size scale-up studies (done by scaling the frequency from 2.45 GHz to 0.91 GHz) indicate that plasma migration toward the walls occurs more frequently for the lower frequency. Increasing the cavity aspect ratio and detuning the cavity are found to be effective ways of keeping the plasma on-axis.
We present new heterodyne receiver results obtained at 100 GHz using resistively-shunted Nb and NbN tunnel junctions. In addition, we have carried out accurate measurements of the available noise power of these devices at the L-band (1.5 GHz) IF (infrasonic) frequency. Both the heterodyne and the output noise measurements show that the noise of these devices can be a factor of five or more higher than that predicted by the simple current-biased RSJ model. The noise approaches the appropriate thermal or thermal and shot noise limits for bias voltages where the nonlinearity is not strong (i.e., V greater than I(sub C)R(sub N)), but as expected from the RSJ model, can be significantly higher at the low voltages where the mixers are typically biased. The bias voltage dependence of the noise shows structure which is associated with resonances in the RF embedding circuit. Surprisingly, we find that changes in the high-frequency (100 GHz) impedance presented to the junction can dramatically affect the magnitude and voltage dependence of the low-frequency (1.5 GHz) noise. This emphasizes the necessity of very closely matching the junction to free space over a wide frequency range.
We report on the results of a search for a radio counterpart to the strong gamma-ray burst GRB 940301. Observations with the Westerbork Synthesis Radio Telescope of the Compton Telescope error box region of GRB 940301 began on March 4, 1994, at 21 cm and April 2, 1994, at 92 cm. No flux density variations were detected at 92 cm above S= 10 mJy (5 (sigma)) within a period of 1 to 4 months after the burst. However, when we compared the field with Westerbork Northern Sky Survey data, taken two years prior to GRB 940301, we found two radio sources with significantly increased flux densities. These sources, only 17 min. apart, are located at the 2.3 and 2.6(sigma) Compton Telescope confidence contours. Their separation from the Inter Planetary Network annulus virtually excludes association with GRB 940301. Further observations in January 1996 reveal that the sources continued to change in flux density. The relatively large flux density variations at 92 cm, compared to those at higher frequencies, and the inverted spectra in the frequency range from 325-38O MHz make the sources somewhat unusual. Because the sources were already detected at 5 GHz in 1986 most, if not all, of the radio emission is probably associated with activity in Active Galactic Nuclei in distant galaxies.
The Time Digitizer capable of covering a range of 0.34 sec in 9.76 psec increments is described. The time interval between a pair of start-stop pulses is digitized coarsely in 20 nsec periods by a very accurate 50 MHz reference clock. The residual fractions of a clock period at the start and the stop end of the measured interval are stretched in two interpolators and digitized in 9.76 psec increments. An equivalent digitizing frequency of 102.4 GHz is thus achieved. The digitizer is built in a minicrate and communicates via a standard crate controller. It is intended for use in the laser ranging between ground stations and the Laser Geodetic Satellite (LAGEOS). It is shown that the distribution in any two adjacent 9.76 psec channels of a small number of identical test time intervals is essentially binomial. The performance of the digitizer and test results are given.
Diamond field-emitter arrays (DFEAs) are arrays of diamond pyramids with exquisitely sharp tips and micrometer-scale bases that produce high current densities. These arrays can be fabricated in arbitrary shapes, ranging from single tips to many millions of tips, so that they produce an inherently shaped electron beam. Each tip emits a modest current, but the large dense array can produce many Amps. We are investigating these cathodes for use in dielectric wakefield accelerators; however, they may also be applicable to vacuum microwave tubes. Recently, shaped beam production and transport have been demonstrated in the 1.3-GHz RF gun at the Argonne Cathode Test Stand at the Argonne National Laboratory. The charge was measured on a Faraday cup and the beam imaged on a YAG screen with peak electric field gradients on the cathode ranging from 12 to 35 MV/m. Three cathode geometries were tested: one 1-mm equilateral triangle with 7-mu m base pyramids and 10-mu m pitch, one 1-mm equilateral triangle with 10-mu m base and 25-mu m pitch, and one sparse 5 x 5 square array with 20-mu m base and 400-mu m pitch. The two triangular arrays emitted 35 nC in an RF macropulse at 35 MV/m and 13-nC charge at 27 MV/m, respectively, while the sparse array emitted 0.060-nC charge at 15 MV/m. This article presents the results of the triangular array experiments, including damage due to breakdown in the RF gun and initial models of tip-to-tip shielding.
The design of the ITER low-field side reflectometer (LFSR) has matured to a complete end-to-end preliminary design. LFSR will supply three key plasma measurements: (1) electron density profile, (2) electron density fluctuations, and (3) poloidal rotation. Simultaneous measurements of the three quantities are enabled by an array of six monostatic antennas which inject from an equatorial port on the outboard side of the ITER vessel. Low-loss transmission lines, consisting of corrugated, overmoded waveguide and miter bends, transmit the 30–165 GHz, O- and X-mode signals to and from the ITER plasma. Integrated transmission-line components serve a range of purposes, such as protection from high-power stray radiofrequency radiation, accommodation of transmission-line displacement, and simultaneous measurement of reference and plasma phases during the discharge. Broadband transmission signals are realized by full-band microwave transceivers combined with quasi-optical multiplexing. A field-programmable gate array (FPGA) processor demodulates the profile reflectometer signals, enabling real-time density profile measurements for plasma control system feedback. A full-scale transmission line test facility provides an integrated environment to assess the performance of critical LFSR components. Theoretical modeling together with insertion loss measurements provide the basis for a comprehensive power budget, which accounts for transmitted output power, transmission-line losses, antenna coupling, and plasma effects. Results indicate that high signal-to-noise ratios are achievable with the current design. A synthetic reflectometer model, using real design parameters and baseline ITER profiles, has been developed to estimate the return signal. With evolving microwave and data acquisition technologies, full-band, ultrafast sweeps (<1 μs) will be realizable for ITER.
Measurements at 2.653 GHz of the dielectric properties of seawater samples collected over the world's oceans and NaCl solutions over the concentration range from 0.3 to 0.7 N have been made over the temperature range from 5.5 to 24 C to an accuracy of 0.2% in the real part of epsilon and 0.4% in the imaginary part of epsilon. The measurements demonstrate that the dielectric properties of seawater can be determined from its chlorinity alone but are substantially different from those of the 3.35 wt % NaCl solution, which has been taken in all previous work as a model for seawater. The data are presented in a form that is well fitted by a linear dependence on chlorinity. The accuracy of the measurements removes the uncertainty in the dielectric properties of seawater as a significant source of error in S-band radiometric determination of ocean surface temperature.
Image simulation techniques were employed to establish the relationship between spatial resolution and the accuracy of soil moisture estimated by an imaging radar. A spaceborne synthetic aperture radar at an orbital altitude of 600 km, operating at 4.5 GHz with HH polarization configuration and covering a ground swath width of 143 km corresponding to an angle of incidence range extending between 7-22 degrees relative to the vertical, provided the images simulated by a 17.7 km x 19.3 km test site. The role of resolution was evaluated by simulating various sets of images with resolutions ranging from 20 m x 20 m to 1 km x 1 km. Each simulated image was subjected to a soil moisture prediction algorithm whose input is limited to the image intensity level. Results show that the 1 km x 1 km resolution provides the best prediction accuracy for most soil moisture distributions except for drought-like conditions for which the 100 m x 100 m resolution is found to be preferred. In general it was found that the soil moisture of about 90% of the pixels is predicted with an error of + or - 20% of field capacity or less.
A ridge waveguide distributed feedback laser was developed in InGaAsP. These devices have demonstrated CW output powers over 7 mW with threshold currents as low as 60 mA at 25 C. Measurements of the frequency response of these devices show a 3 dB bandwidth of about 2 GHz, which may be limited by the mount. The best devices have a single mode spectra over the entire temperature range tested with a side mode suppression of about 20 dB in both CW and pulsed modes. The design of this device, including detailed modeling of the ridge guide structure, effective index calculations, and a discussion of the grating configuration are presented. Also, the fabrication of the devices is presented in some detail, especially the fabrication of and subsequent growth over the grating. In addition, a high frequency fiber pigtailed package was designed and tested, which is a suitable prototype for a commercial package.
Features include ease of fabrication and wide range of operating frequencies. Planar antennas on thick dielectric substrates built for use at millimeter wavelengths from 40 to 400 GHZ. Antennas of this type quasi-optical structures, for which expensive, precisely machined waveguides not required. Made easily by standard photolithography and integrated with planar mixers or detectors to form arrays.
A 35 GHz millimeter-wave radar system has been studied for space debris tracking. The objective is to track the particles ranging in size from 4 mm to 80 mm up to a range of 25 km. The system requires various state-of-the-art technologies including phased arrays, monopulse tracking, pulse compression, high power transmitters, low noise receivers, and pulse integration signal processing techniques.