Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “shading”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 847 records · Page 47

Planetary nomenclature

In fiscal 1986, names were chosen for prominent features on the five previously known Uranian satellites and for features on the largest of the 10 satellites discovered by Voyager 2. The names of the five large satellites are taken mostly from Shakespeare, and most are spirits; therefore, Shakespearean and spirit themes were used to choose names for topographic features on the satellites. Crater names and most other feature names on Miranda, Oberon, and Titania are from Shakespeare; features on Ariel are named for bright spirits and those on Umbriel for dark, all taken from universal mythology. Preliminary coordinates for these features are derived from shaded relief maps of the satellites to be published in 1987. Orbital elements have been established for the 10 new satellites, and a paper describing this work is in progress; satellite positions are under review by Commission 16 of the IAU. The moon 1985 U1 is informally designated Puck. The nine small satellites discovered in 1986 are to be named for Shakespearean heroines; these names are to be listed in the 1987 edition of the Annual Gazetteer of Planetary Nomenclature.

Strobell, M. E.↗

Temporal change of Landsat MSS albedo estimates in arid rangeland

Temporal variation in earth-atmosphere system reflectance in the 0.5-1.1 micron waveband was determined from Landsat MSS data for an area of arid rangeland in south-central New Mexico. Data were extracted from eight MSS scenes for the period 1973-1983, with four scenes from 1976. Maximum potential change between the extremes of rangeland degradation status was estimated to provide a benchmark for assessing the significance of the observed variations. Reflectance standardized for differences in sensor radiometric response by the Environmental Research Institute of Michigan coefficients increased significantly from 1973 to 1983, but standardization by Landsat Data Users Handbook coefficients resulted in little long-term change. Short-term (less than 1 year) variation was significant relative to maximum potential change. A sequence of three Landsat-2 scenes within one year showed a decrease in reflectance with increasing solar zenith angle. The effect of zenith angle on shading of the soil surface by plants was estimated and found to be about the same magnitude as the observed within-year variation in reflectance with solar zenith angle.

Musick, H. B.↗

An optimized top contact design for solar cell concentrators

A new grid optimization scheme is developed for point focus solar cell concentrators which employs a separated grid and busbar concept. Ideally, grid lines act as the primary current collectors and receive all of the current from the semiconductor region. Busbars are the secondary collectors which pick up current from the grids and carry it out of the active region of the solar cell. This separation of functions leads to a multithickness metallization design, where the busbars are made larger in cross section than the grids. This enables the busbars to carry more current per unit area of shading, which is advantageous under high solar concentration where large current densities are generated. Optimized grid patterns using this multilayer concept can provide a 1.6 to 20 percent increase in output power efficiency over optimized single thickness grids.

Desalvo, Gregory C.↗

Applications of color graphics to complex aerodynamic analysis

A variety of uses for color graphics in the display of large sets of complex aerodynamic data in two and three dimensions are summarized. These methods improve the ability of a scientific researcher to interactively review three-dimensional displays of aircraft panel geometries for the purposes of eliminating errors, and allow him to rapidly display an assortment of smooth-shaded, color-coded illustrations for his experimental and computational results.

Weston, Robert P.↗

Computer-generated imagery for 4-D meteorological data

The University of Wisconsin-Madison Space Science and Engineering Center is developing animated stereo display terminals for use with McIDAS (Man-computer Interactive Data Access System). This paper describes image-generation techniques which have been developed to take maximum advantage of these terminals, integrating large quantities of four-dimensional meteorological data from balloon and satellite soundings, satellite images, Doppler and volumetric radar, and conventional surface observations. The images have been designed to use perspective, shading, hidden-surface removal, and transparency to augment the animation and stereo-display geometry. They create an illusion of a moving three-dimensional model of the atmosphere. This paper describes the design of these images and a number of rules of thumb for generating four-dimensional meteorological displays.

Hibbard, William L.↗

Technology and the Hubble Space Telescope Satellite

The hardware components of the HST and their capabilities are examined. The free-flying satellite observatory is 13.1-m long, 4.2-m in diameter, weighs 11,000 kg, is in a 600-km orbit, and is remotely controlled. The HST is divided into four sections: (1) optical telescope assembly, (2) support system module, (3) scientific instruments, and (4) solar arrays. The optical telescope assembly contains the f24 Cassegrain primary optics. The support system module is the host spacecraft for the optical and scientific system. The scientific instruments consist of the Wide Field Planetary Camera, Faint Object Camera, High Speed Photometer, Faint Object Spectrograph, and High Resolution Spectrograph; and the 48,760 solar cells are deployed on-orbit in a window shade fashion. Consideration is given to the operation and maintenance of the HST.

Odom, James B.↗

LONGLIB Graphics-Library Program

LONGLIB computer program is set of subroutines designed for plotting vectors of cathode-ray tubes, plotting machines, and dot-matrix and laser printers. Contains extensive set of routines to enable viewport clipping, extended character sets, graphic input shading, polar plots, and three-dimensional plotting with or without removal of hidden lines. Written in FORTRAN 77.

Long, David G.↗

Test of the Hipparcos payload in the Liege vacuum facility focal

The Liege thermal vacuum optical bench (FOCAL) was used to control the mechanical stability of the structure of the European Space Agency's HIPPARCOS astrometry payload. The payload is designed to measure angles of .001 arcsec between stars during 2.5 years and this accuracy can only be reached with the extreme stability of the device. The structure of the payload is made of carbon fiber; it is thermally stabilized with an accuracy of .01 degrees C. During the test, the payload is enclosed in a shell made of shrouds having a geometry close to the shading structure of the spacecraft. The shroud temperatures are defined by the conditions in orbit, e.g., the spacecraft is spinning in front of the Sun with a period of two hours and the temperature of the shrouds is cycled around the payload with a 2 hour period. In order to avoid disturbances by vibrations, the payload is put on an adapter interfaced with the optical bench and the seismic block; the shrouds are supported by a carrier with no direct interface with the table. This method avoids perturbances brought about by the cooling fluid of the shrouds.

Jamar, C.↗

A near-earth optical communications terminal with a corevolving planetary sun shield

The umbra of a planet may serve as a sun shield for a space based optical communications terminal or for a space based astronomical observatory. An orbit that keeps the terminal or observatory within the umbra is desirable. There is a corevolution point behind every planet. A small body stabilized at the planet corevolution point will revolve about the sun at the same angular velocity as the planet, always keeping the planet between itself and the sun. This corevolution point is within the umbra of Mars but beyond the end of the umbra for Mercury, Venus, and earth. The Mars corevolution point is an ideal location for an astronomical observatory. There Mars obstruct less than 0.00024 percent of the sky at any time, and it shades the observatory completely from the sun. At the earth corevolution point, between 51 and 84 percent of the solar disk area is blocked, as is up to 92 percent of the sunlight. This provides a reduction from 3 dB to 11 dB in sunlight that could interfere with optical communications if scattered directly into the detectors. The variations is caused by revolution of the earth about the earth-moon barycenter.

Kerr, E. L.↗

Calibrating AIS images using the surface as a reference

A method of evaluating the initial assumptions and uncertainties of the physical connection between Airborne Imaging Spectrometer (AIS) image data and laboratory/field spectrometer data was tested. The Tuscon AIS-2 image connects to lab reference spectra by an alignment to the image spectral endmembers through a system gain and offset for each band. Images were calibrated to reflectance so as to transform the image into a measure that is independent of the solar radiant flux. This transformation also makes the image spectra directly comparable to data from lab and field spectrometers. A method was tested for calibrating AIS images using the surface as a reference. The surface heterogeneity is defined by lab/field spectral measurements. It was found that the Tuscon AIS-2 image is consistent with each of the initial hypotheses: (1) that the AIS-2 instrument calibration is nearly linear; (2) the spectral variance is caused by sub-pixel mixtures of spectrally distinct materials and shade, and (3) that sub-pixel mixtures can be treated as linear mixtures of pure endmembers. It was also found that the image can be characterized by relatively few endmembers using the AIS-2 spectra.

Smith, M. O.↗

Solid modelling for the manipulative robot arm (power) and adaptive vision control for space station missions

The structure of a flexible arm derived from concatenation of the Stewart-Table-based links were studied. Solid modeling provides not only a realistic simulation, but is also essential for studying vision algorithms. These algorithms could be used for the adaptive control of the arm, using the well-known algorithms such as shape from shading, edge detection, orientation, etc. Details of solid modeling and its relation to vision based adaptive control are discussed.

Harrand, V.↗

Telerobotic truss assembly

The ACCESS truss was telerobotically assembled in order to gain experience with robotic assembly of hardware designed for astronaut extravehicular (EVA) assembly. Tight alignment constraints of the ACCESS hardware made telerobotic assembly difficult. A wider alignment envelope and a compliant end effector would have reduced the problem. The manipulator had no linear motion capability, but many of the assembly operations required straight line motion. The manipulator was attached to a motion table in order to provide the X, Y, and Z translations needed. A programmable robot with linear translation capability would have eliminated the need for the motion table and streamlined the assembly. Poor depth perception was a major problem. Shaded paint schemes and alignment lines were helpful in reducing this problem. The four cameras used worked well for only some operations. It was not possible to identify camera locations that worked well for all assembly steps. More cameras or movable cameras would have simplified some operations. The audio feedback system was useful.

Sheridan, Philip L.↗

Studies of the vestibulo-ocular reflex on STS 4, 5 and 6

The vestibulo-ocular reflex (VOR) may be altered by weightlessness. Since this reflex plays a large role in visual stabilization, it was important to document any changes caused by space flight. This is a report on findings on STS-4 through 6 and is part of a larger study of neurosensory adaptation done on STS-4 through 8. Voluntary horizontal head oscillations at 1/3 Hz with amplitude of 30 deg right and left of center were recorded by a potentiometer and compared to eye position recorded by electroculography under the following conditions: eyes open, head fixed, tracking horizontal targets switched 0, 15, and 30 degrees right and left (optokinetic reflex - OKR - and calibration); eyes open and fixed on static external target with oscillation, (vestibulo ocular reflex, eyes closed - VOR EC); eyes open and wearing opaque goggles with target fixed in imagination (vestibulo-ocular reflex, eyes shaded - VOR ES); and eyes open and fixed on a head synchronized target with head oscillation (VOR suppression). No significant changes were found in voluntary head oscillation frequency or amplitude in those with (n=5), and without (n=3), space motion sickness (SMS), with phase of flight or test condition. Variations in head oscillation were too small to have produced detectable changes in test results.

Thornton, William E.↗

Graphics software tool for VT terminals (VTGRAPH)

VTGRAPH is a graphics software tool for using DEC/VT or VT compatible terminals. It allows the user to deal with computer environments which use VT terminals for window management and graphics systems. VTGRAPH was developed using the Re'Gis Graphics set and it was written in FORTRAN language. It provides window management and a PLOT10-like package plus color or shade capability.

Wang, Caroline↗

Surface composition of Mars: A Viking multispectral view

A new method of analyzing multispectral images takes advantage of the spectral variation from pixel to pixel that is typical for natural planetary surfaces, and treats all pixels as potential mixtures of spectrally distinct materials. For Viking Lander images, mixtures of only three spectral end members (rock, soil, and shade) are sufficient to explain the observed spectral variation to the level of instrumental noise. It was concluded that a large portion of the Martian surface consists of only two spectrally distinct materials, basalt and palgonitic soil. It is emphasized, however, that as viewed through the three broad bandpasses of Viking Orbiter, other materials cannot be distinguished from the mixtures.

Adams, John B.↗

STRAY - An interactive program for the computation of stray radiation in infrared telescopes

The STRAY program to model the amount of stray radiation reaching the focal plane of a well-baffled telescope is described. The STRAY telescope model is addressed, including the aperture shade, barrel baffle, optics, mirror sectioning and chopping, and off-axis points in focal plane. The possible illumination paths are shown, and calculation options using STRAY are discussed. The stored data and computational aspects of STRAY are addressed. STRAY is compared to the MINI-APART model, and applications of STRAY are described.

St. Clair Dinger, Ann↗

Determination of vegetated fraction of surface from satellite measurements

One input to the ground hydrology component of general circulation models is the fraction of gridbox covered (i.e., shaded) by vegetation. The FV is needed in order to specify the partitioning of evaporation between vegetated and nonvegetated surfaces. Satellite data could provide global and seasonally varying specification of FV. In this work, FV is derived from Landsat data for a site in western Kenya; the accuracy of the estimate is evaluated and then compared to the accuracy requirements of a ground hydrology model. Results show that the accuracy of Landsat estimation of FV is + or - 5 percent and that transpiration, evaporation from bare soil and the seasonality of evapotranspiration are strongly dependent on FV.

Cary, Ernestine↗

Possible breakup of dark terrain on Ganymede by large-scale shear faulting

The questions of relative motions of large segments of Ganymede's lithosphere and of the effect of any motions on grooved terrain formation are reexamined. Resolvable furrows in both hemispheres were mapped in great detail using Voyager 1 and 2 images and U.S. Geological Survey controlled shaded-relief quadrangle maps. Estimates of the Galileo Regio and Marius Regio poles of furrow concentricity indicate a considerable westward offset of the Galileo Regio pole, suggesting the possibility of about 500-km of left-lateral offset of the two areas. There is evidence that shear deformation was concentrated along a major structural lineament which follows a small circle and encloses Galileo Regio, and that a smaller amount of distributed shear occurred across an adjacent 500- to 1500-km-wide band. The results indicate that either widespread shear strain or the shear's driving mechanism may have had a long-term effect on patterns of deformation of Ganymede's lithosphere.

Murchie, Scott L.↗