SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
A coaxial switch capable of operating in a vacuum with high RF power in the 1.2 GHz range without multipactor breakdown, and without relying on pressurization with an inert gas is described. The RF carrying conductors of the switch are surrounded with a high grade solid dielectric, thus eliminating any gaps in which electrons can accelerate.
A plasma sprayed graded layered ceramic/metallic (ZrO2/CoCrAlY) seal was evaluated for JT9D turbine application by rig and engine tests. Four cyclic thermal shock rig tests were conducted during the program. Three completed 1000 simulated engine thermal cycle tests and the fourth completed 500 cycles without severe cracking or spalling. Three ceramic seals were installed in a JT9D experimental engine to evaluate the effect of the engine thermal environment on the seals. All three seals completed the test successfully without severe cracking or spalling. The three seals did have slight laminar cracks at the 85/15-40/60 ZrO2/CoCrAlY interface. The second engine test evaluated the rub capabilities of the seal. Six ceramic seals were installed in the engine with fourteen abrasive tip blades. Three of the six seals rubbed to a depth of 24 mils. Eight of the fourteen abrasive tip blades showed evidence of wear. Three of the eight blades wore a maximum of five mils. Engine rub test results demonstrated the potential of reducing turbine clearances and thereby improving engine performance by use of sprayed ceramic seals.
Zinc is a major residue impurity in the preparation of solar grade silicon material by the zinc vapor reduction of silicon tetrachloride. It was found that in order to get a 17 percent AMl cell efficiency, the concentration of the zinc recombination centers in the base region of silicon solar cells must be less than 4 x 10 to the 11th power Zn/cu cm in the p-base n+/p/p+ cell and 7 x 10 to the 11th power Zn/cu cm in the n-base p+/n/n+ cell for a base dopant impurity concentration of 5 x 10 to the 14th power atoms/cu cm. If the base dopant impurity concentration is increased by a factor of 10 to 5 x 10 to the 15th power atoms/cu cm, then the maximum allowable zinc concentration is increased by a factor of about two for a 17 percent AMl efficiency. The thermal equilibrium electron and hole recombination and generation rates at the double acceptor zinc cancers were obtained from previous high field measurements as well as new measurements at zero field. The rates were used in the exact d.c. circuit model to compute the projections.
The compatibility of 6AL-4V Ti with propellant grade GF2 and LF2 at 77 K for up to 3 years was investigated. Titanium double coupons, annealed or heat treated, with 16 or 64 RMS finishes, were immersed in F2 in individual Pyrex capsules and stored under LN2 for 29 and 39 months. Pre and post immersion tests were performed on the propellant and coupons. Chemical analysis of the propellant did not reveal any significant changes due to titanium corrosion. Gravimetric, visual, microscopic, and metallurgical examination with pitting analysis did not reveal gross corrosion of the titanium although pitting appears to be greater after 39 months exposure. The increase in pit size and number raises the possibility of unpredictable crack propagation instability. Fracture toughness tests are necessary to define this possibility.
Thermal energy storage technology and development of building heating and cooling applications in the residential and commercial sectors is outlined. Three elements are identified to undergo an applications assessment, technology development, and demonstration. Emphasis is given to utility load management thermal energy system application where the stress is on the 'customer side of the meter'. Thermal storage subsystems for space conditioning and conservation means of increased thermal mass within the building envelope and by means of low-grade waste heat recovery are covered.
Microstructural evaluation tests performed on Cu-doped, Ti-doped and Cu/Ti doped p-type silicon single crystal wafers, before and after the solar cell fabrication, and evaluation of both dark forward and reverse I-V characteristic records for the solar cells produced from the corresponding silicon wafers, show that Cu mitigates the unfavorable effects of Ti, and thus provides for higher conversion efficiency, thereby providing an economical way to reduce the deleterious effects of titanium, one of the impurities present in metallurgical grade silicon material.
Ion plating is a plasma deposition technique where ions of the gas and the evaporant have a decisive role in the formation of a coating in terms of adherence, coherence, and morphological growth. The range of materials that can be ion plated is predominantly determined by the selection of the evaporation source. Based on the type of evaporation source, gaseous media and mode of transport, the following will be discussed: resistance, electron beam sputtering, reactive and ion beam evaporation. Ionization efficiencies and ion energies in the glow discharge determine the percentage of atoms which are ionized under typical ion plating conditions. The plating flux consists of a small number of energetic ions and a large number of energetic neutrals. The energy distribution ranges from thermal energies up to a maximum energy of the discharge. The various reaction mechanisms which contribute to the exceptionally strong adherence - formation of a graded substrate/coating interface are not fully understood, however the controlling factors are evaluated. The influence of process variables on the nucleation and growth characteristics are illustrated in terms of morphological changes which affect the mechanical and tribological properties of the coating.
Total carbon and sulfur abundances have been measured in five Antarctic meteorites. Two C2 carbonaceous chondrites Yamato 74662 and Allan Hills 77306 have sulfur abundances (3.490 plus or minus .040% and 3.863 plus or minus 0.050% respectively) similar to other C2 chondrites but their carbon abundances (1.514 plus or minus 0.050% and 1.324 plus or minus .040% respectively) are lower than previously measured C2 chondrites. The decreased carbon abundances may reflect the effects of weathering in cold environments. Carbon and sulfur abundances for one C4 carbonaceous chondrite, one E4 enstatite chondrite and one ureilite are similar to values reported previously for meteorites of the same petrologic grades.
The paper presents spectrophotometric observations of the nucleus and nine H II regions in the spiral arms of the Sbc galaxy NGC 1566. The emission line spectra of the H II regions are characterized by a low grade of ionization, and most of the line intensities do not show radial gradients; the N II/O II forbidden line ratio appears to increase toward the nucleus, and the forbidden O III/H-beta ratio may decrease in the same direction. This is explained by the increase of the oxygen abundance and decrease of the electron temperature toward the nucleus; the spectra confirm the presence of the weak, broad emission wings at H-alpha, and the nuclear spectrum of NGC 1566 resembles that of a giant H II region rather than that of a Seyfert galaxy.
Hermitian elements are used in a finite element solution for the eigenvalue problem in lined ducts with flow. These elements give significantly greater accuracy for reduced dimensionality when compared with Lagrangian elements. Spurious mode generation associated with the Lagrangian formulation is eliminated. A dramatic improvement in the ratio of the number of reliable eigenvalues to the total number of computed eigenvalues is effected by the use of a condensation scheme based on the no-flow eigenvectors. Results are presented for two dimensional and axisymmetric ducts. In the axisymmetric case good resolution is obtained even for high order, high frequency modes by the use of continuously graded meshes.
Atmospheric burner rig tests have been conducted to evaluate the corrosion resistance of present-day thermal barrier coatings. The coatings are primarily plasma-sprayed and zirconia-based. Both duplex and graded coating systems were tested at a gas temperature of 2100 F and metal temperatures that range from 1475 F to 1650 F. The fuels ranged from clean GT No. 2 to that doped with impurity levels which simulate water-washed residual fuels. Results to date suggest that liquid sulfate condensates play an important role in the coating degradation mechanisms, whereas the role of vanadium and its salts is less clear.
It is noted that currently available reaction bonded silicon nitride (RBSN) materials are limited by relatively low strength (up to 300 MPa) and oxidation resistance, primarily due to open porosity. Attention is given to technology that was developed and used to produce an improved grade of injection molded RBSN having a density of 2.8 g/cc, with significantly decreased open porosity and a strength exceeding 350 MPa. It is shown that these results are primarily due to advances in two areas: silicon powder processing, and nitriding technique. A comparison of room temperature strength and oxidation resistance of the new material with that of state-of-the-art RBSN, showed significant improvements. It is concluded that turbine stator vanes were produced to show that this improved RBSN technology has been reduced to engineering practice.
A study of the possibility that chondrules may have had an independent existence in space was made by searching for unusual track densities in chondrules and by an investigation of the compositions of chondrule rims from thirteen unequilibrated ordinary chondrites. No unusual radiation was found; observed track densities can be explained in terms of cosmic ray exposure ages of the respective meteorites. Fine-grained rims that surround chondrules in unequilibrated ordinary chondrites are heterogeneous in composition consisting of iron sulfide and a silicate phase; fine-grained rims of the kind observed in primitive type 3 ordinary chondrites are absent in higher petrographic grades, but more crystalline, coarse-grained, and lacy sulfide rims are observed. This can be explained by chondrules having had an independent existence in space during which they acquired rims by condensation on their surfaces or by accretion of fine particles.
The paper describes the heat exchanger method (HEM) for growing silicon crystals. The problem of ingot cracking was solved by using a graded structure silica crucible, and vacuum processing eliminated expensive high-purity argon. Solar cells fabricated from HEM silicon demonstrated conversion efficiencies up to 15% (AM1) at low cost, using square cross-section, single crystal silicon. A modified multiblade slurry machine was adapted for multiwire fixed abrasive slicing of silicon which uses a diamond attached to wires; this method provides a conversion ratio of 1.08 sq m of wafer per kg of silicon ingot, and produces wafers free of edge chipping with a surface damage of 3-5 microns.
The reaction of SO2 and NO2 with soot has been studied experimentally by gravimetric determination of chemisorption with subsequent analysis of the chemisorbed species by various techniques. When samples of commercially available carbon black (used as soot surrogate) are exposed to SO2 or NO2 in dry air or N2 as carrier gas, no quantitative chemisorption (less than 5 micrograms per mg of substrate) is observed. However, exposure of the same grade of carbon to a combination of SO2 and NO2 in dry air of N2 results in significant chemisorption (180-200 micrograms/mg), a major fraction of which is analyzed as sulfate.
The viability of mobile communications is examined within the context of a frequency division multiple access, single channel per carrier satellite system emphasizing digital techniques to serve a large population of users. The intent is to provide the mobile users with a grade of service consistant with the requirements for remote, rural (perhaps emergency) voice communications, but which approaches toll quality speech. A traffic model is derived on which to base the determination of the required maximum number of satellite channels to provide the anticipated level of service. Various voice digitalization and digital modulation schemes are reviewed along with a general link analysis of the mobile system. Demand assignment multiple access considerations and analysis tradeoffs are presented. Finally, a completed configuration is described.
Results for process system properties, chemical engineering and economic analyses of the new technologies and processes being developed for the production of lower cost silicon for solar cells are presented. Analyses of process system properties are important for chemical materials involved in the several processes under consideration for semiconductor and solar cell grade silicon production. Major physical, thermodynamic and transport property data are reported for silicon source and processing chemical materials.
An experiment with NASA's ATS-6 satellite, that demonstrates the practicality of satellite-aided land mobile communications is described. Satellite communications equipment for the experiment was designed so that it would be no more expensive, when mass produced, than conventional two-way mobile radio equipment. It embodied the operational features and convenience of present day mobile radios. Vehicle antennas 75 cm tall and 2 cm in diameter provided good commercial quality signals to and from trucks and jeeps. Operational applicability and usage data were gathered by installing the radio equipment in five long-haul tractor-trailer trucks and two Air Force search and rescue jeeps. Channel occupancy rates are reported. Air Force personnel found the satellite radio system extremely valuable in their search and rescue mission during maneuvers and actual rescue operations. Propagation data is subjectively analyzed and over 4 hours of random data is categorized and graded as to signal quality on a second by second basis. Trends in different topographic regions are reported. An overall communications reliability of 93% was observed despite low satellite elevation angles ranging from 9 to 24 degrees.