Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Time History”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 847 records · Page 47
All sourcesNASA NTRSDOE OSTI
NASA NTRS1985

A cost-effective component modes analysis for Shuttle payloads using a combination of frequency domain and time domain approaches

A combination of the time and frequency domains which employs the latter only where the former is inefficient or uncertain is used in Space Shuttle payloads' component mode analyses. Attention is given to the time histories at the launch vehicle/spacecraft interface. The frequency domain allows interface acceleration to be determined without recourse to a new, merged system eigenvalue solution and subsequent 'system modal' responses. The approach has been employed in Galileo spacecraft loads analyses.

Trubert, M.↗
NASA NTRS1985

Visualization of computer-generated flow fields

Flow field variables are visualized using color representations described on surfaces that are interpolated from computational grids and transformed to digital images. The color at a point on a surface represents the magnitude of a variable, and several surfaces can be included in a single digital image. Typically the surfaces are a boundary surface, a windward surface, and a crossflow surface. Sequences of images, in pictorial form, are presented to describe an entire flow field or a time history of a flow field. Several examples are presented.

Smith, R.↗
NASA NTRS1986

Dynamic Tooth Loads for Spur Gears

Computer program developed using time-history, interactive, closed-form solution for dynamic tooth loads for both low- and high-contact-ratio spur gears. Facilitates application of high-contact-ratio spur gear concepts. Program written in FORTRAN IV.

Cornell, R.↗
NASA NTRS1985

A Numerical Method of Calculating Propeller Noise Including Acoustic Nonlinear Effects

Using the transonic flow fields(s) generated by the NASPROP-E computer code for an eight blade SR3-series propeller, a theoretical method is investigated to calculate the total noise values and frequency content in the acoustic near and far field without using the Ffowcs Williams - Hawkings equation. The flow field is numerically generated using an implicit three dimensional Euler equation solver in weak conservation law form. Numerical damping is required by the differencing method for stability in three dimensions, and the influence of the damping on the calculated acoustic values is investigated. The acoustic near field is solved by integrating with respect to time the pressure oscillations induced at a stationary observer location. The acoustic far field is calculated from the near field primitive variables as generated by NASPROP-E computer code using a method involving a perturbation velocity potential as suggested by Hawkings in the calculation of the acoustic pressure time-history at a specified far field observed location. the methodologies described are valid for calculating total noise levels and are applicable to any propeller geometry for which a flow field solution is available.

Korkan, K. D.↗
NASA NTRS1985

Large Modal Survey Testing Using the Ibrahim Time Domain Identification Technique

The ability of the ITD identification algorithm in identifying a complete set of structural modal parameters using a large number of free-response time histories simultaneously in one analysis, assuming a math model with a high number of degrees-of-freedom, has been studied. Identification results using simulated free responses of a uniform rectangular plate, with 225 measurement stations, and experimental responses from a ground vibration test of the Long Duration Exposure Facility (LDEF) Space Shuttle payload, with 142 measurement stations, are presented. As many as 300 degrees-of-freedom were allowed in analyzing these data. In general, the use of a significantly oversized math model in the identification process was found to maintain or increase identification accuracy and to identify modes of low response level that are not identified with smaller math model sizes. The concept of a Mode Shape Correlation Constant is introduced for use when more than one identification analysis of the same structure are conducted. This constant quantifies the degree of correlation between any two sets of complex mode shapes identified using different excitation conditions, different user-selectable algorithm constants, or overlapping sets of measurements.

Ibrahim, S. R.↗
NASA NTRS1985

Investigation of seismicity and related effects at NASA Ames-Dryden Flight Research Facility, Computer Center, Edwards, California

This report discusses a geological and seismological investigation of the NASA Ames-Dryden Flight Research Facility site at Edwards, California. Results are presented as seismic design criteria, with design values of the pertinent ground motion parameters, probability of recurrence, and recommended analogous time-history accelerograms with their corresponding spectra. The recommendations apply specifically to the Dryden site and should not be extrapolated to other sites with varying foundation and geologic conditions or different seismic environments.

Cousineau, R. D.↗
NASA NTRS1985

Decoupled and linear quadratic regulator control of a large, flexible space antenna with an observer in the control loop

An analysis is performed to compare decoupled and linear quadratic regulator (LQR) procedures for the control of a large, flexible space antenna. Control objectives involve: (1) commanding changes in the rigid-body modes, (2) nulling initial disturbances in the rigid-body modes, or (3) nulling initial disturbances in the first three flexible modes. Control is achieved with two three-axis control-moment gyros located on the antenna column. Results are presented to illustrate various effects on control requirements for the two procedures. These effects include errors in the initial estimates of state variables, variations in the type, number, and location of sensors, and deletions of state-variable estimates for certain flexible modes after control activation. The advantages of incorporating a time lag in the control feedback are also illustrated. In addition, the effects of inoperative-control situations are analyzed with regard to control requirements and resultant modal responses. Comparisons are included which show the effects of perfect state feedback with no residual modes (ideal case). Time-history responses are presented to illustrate the various effects on the control procedures.

Hamer, H. A.↗
NASA NTRS1986

Helicopter tail rotor noise analyses

A study was made of helicopter tail rotor noise, particularly that due to interactions with the main rotor tip vortices, and with the fuselage separation mean wake. The tail rotor blade-main rotor tip vortex interaction is modelled as an airfoil of infinite span cutting through a moving vortex. The vortex and the geometry information required by the analyses are obtained through a free wake geometry analysis of the main rotor. The acoustic pressure-time histories for the tail rotor blade-vortex interactions are then calculated. These acoustic results are compared to tail rotor loading and thickness noise, and are found to be significant to the overall tail rotor noise generation. Under most helicopter operating conditions, large acoustic pressure fluctuations can be generated due to a series of skewed main rotor tip vortices passing through the tail rotor disk. The noise generation depends strongly upon the helicopter operating conditions and the location of the tail rotor relative to the main rotor.

George, A. R.↗
NASA NTRS1986

Identification of linearized equations of motion for the fixed wing configuration of the rotor systems research aircraft

The purpose of this report is to establish linear, decoupled models of rigid body motion for the fixed wing configuration of the Rotor Systems Research Aircraft (RSRA). Longitudinal and lateral control surface fixed linear models were created from aircraft time histories using current system identification techniques. Models were obtained from computer simulation at 160 KCAS and 200 KCAS, and from flight data at 160 KCAS. Comparisons were performed to examine modeling accuracy, variation of dynamics with airspeed and correlation of simulation and flight data results. The results showed that the longitudinal and lateral linear models accurately predicted RSRA dynamics. The flight data results showed that no significant handling qualities problems were present in the RSRA fixed wing aircraft at the flight speed tested.

Balough, D. L.↗
NASA NTRS1986

Impact data from a transport aircraft during a controlled impact demonstration

On December 1, 1984, the FAA and NASA conducted a remotely piloted air-to-ground crash test of a Boeing 720 transport aircraft instrumented to measure crash loads of the structure and the anthropomorphic dummy passengers. Over 330 time histories of accelerations and loads collected during the Full-Scale Transport Controlled Impact Demonstration (CID) for the 1-sec period after initial impact are presented. Although a symmetric 1 deg. nose-up attitude with a 17 ft/sec sink rate was planned, the plane was yawed and rolled 13 deg. at initial (left-wing) impact. The first fuselage impact occurred near the nose wheel well with the nose pitched down 2.5 deg. Peak normal (vertical) floor accelerations were highest in the cockpit and forward cabin near the nose wheel well and were approximately 14G. The remaining cabin floor received normal acceleration peaks of 7G or less. The peak longitudinal floor accelerations showed a similar distribution, with the highest (7G) in the cockpit and forward cabin, decreasing to 4G or less toward the rear. Peak transverse floor accelerations ranged from about 5G in the cockpit to 1G in the aft fuselage.

Fasanella, E. L.↗
NASA NTRS1986

Effects of model error on control of large flexible space antenna with comparisons of decoupled and linear quadratic regulator control procedures

An analysis was performed to determine the effects of model error on the control of a large flexible space antenna. Control was achieved by employing two three-axis control-moment gyros (CMG's) located on the antenna column. State variables were estimated by including an observer in the control loop that used attitude and attitude-rate sensors on the column. Errors were assumed to exist in the individual model parameters: modal frequency, modal damping, mode slope (control-influence coefficients), and moment of inertia. Their effects on control-system performance were analyzed either for (1) nulling initial disturbances in the rigid-body modes, or (2) nulling initial disturbances in the first three flexible modes. The study includes the effects on stability, time to null, and control requirements (defined as maximum torque and total momentum), as well as on the accuracy of obtaining initial estimates of the disturbances. The effects on the transients of the undisturbed modes are also included. The results, which are compared for decoupled and linear quadratic regulator (LQR) control procedures, are shown in tabular form, parametric plots, and as sample time histories of modal-amplitude and control responses. Results of the analysis showed that the effects of model errors on the control-system performance were generally comparable for both control procedures. The effect of mode-slope error was the most serious of all model errors.

Hamer, H. A.↗
NASA NTRS1986

Observational properties of cosmic gamma-ray bursts

A brief overview of the major observational results obtained in gamma-ray burst studies is presented. Also discussed is to what extent the thermonuclear model, which appears at present to be the most plausible, can account for the observed properties of the bursts. The investigation of gamma-ray bursts should cover observations of the time histories of events, energy spectra, and their variablility, source localization, and inspection of the localization regions during the active and quiescent phases of the source in other wavelengths, as well as, evaluation of the statistical distributions of the data obtained.

Mazets, E. P.↗
NASA NTRS1985

Shock evolution in the outer heliosphere - Voyager and Pioneer observations

Observations are reported of 35 interplanetary shocks detected at heliocentric distances between 6.5 and 9.4 AU in mid-1980 by the Voyager 1, Voyager 2, and Pioneer 11 spacecraft. These shocks were all evidently generated by the interaction of corotating streams. Measurements of the pre- and postshock plasma parameters are used to determine the shock normals and speeds for each shock. Twelve of these 35 events are observed at all three spacecraft. The shock parameters at each spacecraft are compared to determine the time history for the 12 shocks. The single-spacecraft determinations of shock normal and speed are compared wih the results of several techniques for determining shock velocities using all three spacecraft. It is found that shocks undergo significant evolution as they travel past the three spacecraft. Every shock seen by both end spacecraft was also seen by the middle spacecraft. Shock formation possibly may be occurring at a heliocentric distance as great as 7 AU. It appears that the shock surfaces have a complex three-dimensional structure with 'ripples' on a scale of 0.001-1.0 AU.

Gazis, P. R.↗
NASA NTRS1985

Performance analysis of a fault inferring nonlinear detection system algorithm with integrated avionics flight data

This paper presents the performance analysis results of a fault inferring nonlinear detection system (FINDS) using integrated avionics sensor flight data for the NASA ATOPS B-737 aircraft in a Microwave Landing System (MLS) environment. First, an overview of the FINDS algorithm structure is given. Then, aircraft state estimate time histories and statistics for the flight data sensors are discussed. This is followed by an explanation of modifications made to the detection and decision functions in FINDS to improve false alarm and failure detection performance. Next, the failure detection and false alarm performance of the FINDS algorithm are analyzed by injecting bias failures into fourteen sensor outputs over six repetitive runs of the five minutes of flight data. Results indicate that the detection speed, failure level estimation, and false alarm performance show a marked improvement over the previously reported simulation runs. In agreement with earlier results, detection speed is faster for filter measurement sensors such as MLS than for filter input sensors such as flight control accelerometers. Finally, the progress in modifications of the FINDS algorithm design to accommodate flight computer constraints is discussed.

Caglayan, A. K.↗
NASA NTRS1985

Orbital motion, nucleus precession, and splitting of periodic Comet Brooks 2

Results of ten nongravitational orbital solutions are given for Comet Brooks 2, based on observations from the apparitions 1889-1980. The time history of the nongravitational parameters, including the transverse component A-sub-2, is vital for modeling the nucleus precession. The comet is obviously a fragment of a once larger object that split during a close encounter with Jupiter in 1886. Factors possibly responsible for the breakup are examined. A similarity between the orbital histories of P/Brooks 2 and P/Wild 2 is noted.

Sekanina, Z.↗
NASA NTRS1986

A numerical study of shock wave diffraction by a circular cylinder

The nonstationary shock wave diffraction patterns generated by a blast wave impinging on a circular cylinder are numerically simulated using a second-order hybrid upwind method for solving the two-dimensional inviscid compressible Euler equations of gasdynamics. The complete diffraction patterns, including the transition from regular to Mach reflection, trajectory of the Mach triple point and the complex shock-on-shock interaction at the wake region resulting from the Mach shocks collision behind the cylinder are reported in detail. Pressure-time history and various contour plots are also included. Comparison between the work of Bryson and Gross (1961) which included both experimental schlieren pictures and theoretical calculations using Whitham's ray-shock theory and results of the present finite difference computation indicate good agreement in every aspect except for some nonideal gas and viscous effects which are not accounted for by the Euler equations.

Yang, J.-Y.↗
NASA NTRS1985

Acceleration of interplanetary solar electrons in the 1982 August 14 flare

The solar flare on August 14, 1982 (about 0507 UT) produced hard X-rays, gamma-rays, and an electron-rich interplanetary particle event. Because of its location (N11, W61), the flare site was magnetically well connected to the ISEE 3 spacecraft. The ISEE 3 observations have provided a detailed time history of 15 keV-1.9 MeV photon emission from the flare and the relativistic (greater than 3 MeV) solar electrons in interplanetary space. These observations indicate that a significant fraction of the relativistic electrons escaping from the sun were accelerated during the impulsive phase simultaneously with the energetic electrons producing the hard X-ray and gamma-ray continuum at the sun.

Kane, S. R.↗
NASA NTRS1986

Numerical evaluation of propeller noise including nonlinear effects

Propeller noise in the acoustic near field is presently determined through the integration of the pressure-time history in the tangential direction of a numerically generated flowfield around a propfan of SR-3 type, including the shock wave system in the vicinity of the propeller tip. This acoustic analysis yields overall sound pressure levels, and the associated frequency spectra, as a function of observer location.

Korkan, K. D.↗