Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “particle data”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 829 records · Page 46

Simultaneous satellite and riometer measurements of particles during solar cosmic ray events.

The expected 30 and 50 MHz riometer absorptions have been calculated for three events in 1969 using data from the MDAC-W charged particle experiment on OGO 6. Several times during each event, the satellite passed over the MDAC-W Arctic and Antarctic Geophysical Observatories. The calculated total absorption (using 2 minute averages of the data) agrees well with the measured absorption for the overpasses. The alpha particle and electron contributions usually amount to less than a few percent of the proton absorption. During the large November 2, 1969 event, however, the electrons produced the major part of the absorption up to the peak and a significant contribution during virtually its entire duration. With the two frequencies for which simultaneous riometer data were taken, it is possible to detect the softening of the particle spectra during the events, and the relative hardness differences between events.

Baker, M. B.↗

High Z particle Apollo astronaut dosimetry with plastics

On Apollo missions, the individual astronauts' high Z particle exposure is measured by means of Lexan polycarbonate plastic. These layers form one component of the passive dosimetry packets worn in the constant wear garment. They serve as threshold type, high Z, charged particle track detectors, recording only the very highly ionizing particles. The detectors yield information on the particles' charge, energy, and direction of travel. This data, in turn, is used to obtain the track fluence, the stopping particle density as an integral Z distribution, and the particles' integral LET spectrum. Some of the data gathered on Apollo missions 8-13 is presented.

Benton, E. V.↗

Particle size, number, composition and velocity from solid rocket motors

The damage potentials to the space shuttle orbiter caused by the high velocity particles contained in the exhaust plume of an upper stage is discussed. In particular, the particle size distribution and composition, the velocity of the particles and the expected contribution from shuttle launched upper stages are addressed. Particle size estimates based on historical data are compapred with those derived from upper stage motor performance testing. The particle velocities as determined by the best available plume computational technique are presented. The shuttle is scheduled to launch approximately 135 upper-stages over its lifetime looking at the currently scheduled flights and averaging over a yearly basis yields the contribution of particulates from the uper-stages. On the average, 91,645 llbs of Al2O3 will be ejected on each launch. The analysis to determine how much of this 91,645 lbs will remain in orbit or the decay rate is yet to be accomplished.

Roberts, B. B.↗

Computer simulation of a fringe type laser velocimeter

A computer simulation of a fringe type laser velocimeter has been written to determine the theoretical characteristics of the laser velocimeter when applied to a given flow field. The program includes the effect of particle size and composition on particle lag, light scattering characteristics and signal contrast. The model of the laser velocimeter includes the laser, optical system, photomultiplier, and counter type data processing electronics. The LV particle size analyzer is also modeled and incorporated in the program. An example application of the program to a Mach 5 wind tunnel using a backscatter laser velocimeter is presented.

Meyers, J. F.↗

Noise Source Location and Flow Field Measurements on Supersonic Jets and Implications Regarding Broadband Shock Noise

An experiment was conducted in an effort to obtain data that would provide a better understanding of the origins of broadband shock noise (BBSN). Phased array noise source location and two types of flow field data (background oriented schlieren and particle image velocimetry) were acquired on unheated, single-stream jets. Results are presented for one subsonic and four supersonic operating conditions. These data show that BBSN is created primarily in the downstream portion of the shock train with peak BBSN production occurring near where the average size of the turbulent structures is equal to the shockcell spacing. These data tend to validate theories that BBSN is created by turbulent structures that are as large or larger than the shock spacing.

Podboy, Gary G.↗

Transport of charged particles in the earth's magnetosphere

A review of recent data on and conceptions of processes in which high energy particles are transported across magnetic shells in the earth's magnetosphere is presented. The processes discussed include adiabatic processes (with conservation of all three adiabatic invariants of charged particle motion in the magnetic field), diffusion processes (with violation of only the third or third and second invariants), and the so-called fast nonadiabatic processes, which appear to result from the action of strong electric fields.

Shalimov, V. P.↗

Studies of acceleration processes in the corona using ion measurements on the solar probe mission

The energy spectra and composition of particles escaping from the Sun provide essential information on mechanisms responsible for their acceleration, and may also be used to characterize the regions where they are accelerated and confined and through which they propagate. The suprathermal energy range, which extends from solar wind energies (approximately 1 KeV) to about 1 MeV/nucleon, is of special interest to studies of nonthermal acceleration processes because a large fraction of particles is likely to be accelerated into this energy range. Data obtained from near earth observations of particles in the suprathermal energy range are reviewed. The necessary capabilities of an a ion composition experiment in the solar probe mission and the required ion measurements are discussed. A possible configuration of an instrument consisting of an electrostatic deflection system, modest post acceleration, and a time of flight versus energy system is described as well as its possible location on the spacecraft.

Gloeckler, G.↗

Toroidal wave frequency at L=6-10: AMPTE/CCE Observations and Comparison with Theoretical Model

Magnetospheric standing Alfven waves are guided along the ambient magnetic field and their frequency depends on the mass density of the plasma distributed along the field lines. These properties allow us to use Alfen waves to map time-dependent phenomena between space and ground and to estimate the mass density. In this paper we present a statistical study of the spatial variation of the fundamental frequency f(sub T1) of toroidal-mode standing Alfen waves in the L range from 6 to 10, where L indicates the maximum geocentric distance on the field line. The data used for this analysis are energetic particle flux anisotropy (proxy of transverse electric field) and magnetic field measurements from the Active Magnetospheric Particle Tracer Explorers Charge Composition Explorer (CCE) spacecraft. Using CCE data covering 4 years we obtained approximately 5000 20-min intervals containing a clear signature of toroidal waves. The median f(sub T1), is 6-10 mHz at L=7 and decreases to 4-8 mHz at L = . The frequency tends to be lower at noon than at midnight. The observed frequencies are compared with numerically derived frequencies using an empirical mass density model and a magnetic field model. We found a good agreement for 12-24 MLT but a large discrepancy near MLT= 3. This may indicate that the flux tubes at this local time are more heavily loaded than specified in the Gallagher et al. model.

Takahashi, Kazue↗

Status of Solar Sail Material Characterization at NASA's Marshall Space Flight Center

Near term solar sail propelled science missions are targeting the Lagrange point 1 (Ll) as well as locations sunward of L1 as destinations. These near term missions include the Solar Polar Imager' and the L1 Diamond '. The Environmental Effects Group at NASA's Marshall Space Flight Center (MSFC) continues to actively characterize solar sail material in preparation for these near term solar sail missions. Previous investigations indicated that space environmental effects on sail material thermo-optical properties were minimal and would not significantly affect the propulsion efficiency of the sail. These investigations also indicated that the sail material mechanical stability degrades with increasing radiation exposure. This paper will further quantify the effect of space environmental exposure on the mechanical properties of candidate sail materials. Candidate sail materials for these missions include Aluminum coated Mylar(TradeMark), Teonex(TraeMark), and CP1 (Colorless Polyimide). Experimental data will be presented on sail material response to charged particle radiation and subsequent Hypervelocity Impact (HVI). Data will also be presented indicating mechanical property variations in sail material resulting from electron exposure, proton exposure, and a combined electron and proton exposure. Tabular data consisting of areal density, thickness, thermo-optical, mechanical, and electrical properties, vacuum stability and outgassing will be presented.

Edwards, David L.↗

Dynamics of Dust Particles Released from Oort Cloud Comets and Their Contribution to Radar Meteors

The Oort Cloud Comets (OCCs), exemplified by the Great Comet of 1997 (Hale-Bopp), are occasional visitors from the heatless periphery of the solar system. Previous works hypothesized that a great majority of OCCs must physically disrupt after one or two passages through the inner solar system, where strong thermal gradients can cause phase transitions or volatile pressure buildup. Here we study the fate of small debris particles produced by OCC disruptions to determine whether the imprints of a hypothetical population of OCC meteoroids can be found in the existing meteor radar data. We find that OCC particles with diameters D < or approx. 10 microns are blown out from the solar system by radiation pressure, while those with D > or approx. 1 mm have a very low Earth-impact probability. The intermediate particle sizes, D approx. 100 microns represent a sweet spot. About 1% of these particles orbitally evolve by Poynting-Robertson drag to reach orbits with semimajor axis a approx. 1 AU. They are expected to produce meteors with radiants near the apex of the Earth s orbital motion. We find that the model distributions of their impact speeds and orbits provide a good match to radar observations of apex meteors, except for the eccentricity distribution, which is more skewed toward e approx. 1 in our model. Finally, we propose an explanation for the long-standing problem in meteor science related to the relative strength of apex and helion/antihelion sources. As we show in detail, the observed trend, with the apex meteors being more prominent in observations of highly sensitive radars, can be related to orbital dynamics of particles released on the long-period orbits.

Nesvorny, David↗

Macro-Scale Findings of the DebriSat Debris Field Obtained from X-Rays of the Catch Panels

The DebriSat project analyzes the debris from a hypervelocity impact test conducted on a 56 kg-simulated satellite target in 2014. Its purpose is to generate a comprehensive database of the size, mass, material, shape, and the radar and optical properties of fragments generated from orbital collisions of modern-built spacecraft. Three hundred ninety-one foam catch panels from the DebriSat test have been X-rayed to locate the particles within them for subsequent extraction and assessment. The data from the tens of thousands of extracted particles has heretofore been the focus of the debris assessment. The work presented here connects the X-ray sample location images to reconstruct the 3D distribution of the entire fragment cloud. Although some errors are inherent to the process, this 3D database is valuable for qualitative studies of size and energy distributions. Further, the 3D database can indicate the extent of bending or breaking of the fragments as they decelerated to full capture. By virtue of its full sphere perspective, the 3D database allows graphical insight to the physics of the collision and breakup. This 3D representation has been developed as a “point and click” graphical interface to retrieve the full data set on individual recovered and assessed fragments within the growing database. Overall, this macro-level screening technique has added enormous insight to the experiment in unexpected ways.

Allen, Anthony↗

Auroral vector electric field and particle comparisons. I - Preliminary convection topology

Data obtained by Polar 3, launched from northern Norway January 27, 1974, are interpreted. The rocket, which traversed nearly 3 deg of latitude, crossed over a stable IBC II auroral arc in the positive bay region and continued north to a convection boundary which has been identified as the Harang discontinuity. Measurements of the complete electric field vector, of energetic electrons, and of auroral emissions were used to study the convection topology in the premagnetic midnight region. The inverted V nature of the electron precipitations at the convection boundary, compared with the lack of such structure over the arc which was within the positive bay region, is thought to indicate that auroral arcs are likely to be associated with inverted V type precipitation only at or poleward of convection boundaries and their eddy structures.

Maynard, N. C.↗

Spray drop size and velocity measurements using the Phase/Doppler Particle Analyzer

Detailed measurements of the drop size and velocity distributions were obtained for a swirl chamber pressure atomizer. These data were obtained with the Phase/Doppler Particle Analyzer manufactured by Aerometrics, Inc. Direct measurements of the size distributions revealed the evolving characteristics of the spray. Size velocity correlations were used to evaluate the effect of velocity relaxation on the size distributions. The simultaneous measurement of drop size and velocity was of major importance in accurately describing the changes in the local drop size distributions and mass flux.

Bachalo, W. D.↗

Coagulation of particles in Saturn's rings - Measurements of the cohesive force of water frost

Experimental data are presented on the sticking force of water ice particles which are indicative of the role that the cohesive properties of such particles could play in the dynamics of Saturn ring particles. Sticking forces are dependent on particle impact velocities; a 'Velcro' model is devised to describe the surface structure involved in sticking. The data indicate that below the critical impact velocity of about 0.03 cm/sec, particle cohesion always occurs. Due to the optical depth of micron-sized grains in the Saturn rings, particles are hypothesized to be coated with a layer of frost which will render cohesion an important ring-dynamics process.

Hatzes, A. P.↗