Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “delays”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 829 records · Page 46

Phase and group delay calibration of a very long baseline interferometer by East Coast VLBI Group

Precisely timed pulses injected into the input of each receiver are used to calibrate the phase and group delay through each interferometer terminal. The short duration pulses are generated at a 1 MHz rate directly from the output of the frequency standard. The pulses are injected into the receiver at a level low enough to produce less than one percent increase in system temperature, yet can be extracted during processing with a high enough signal to noise ratio to determine the phase of the calibration rails within 1 degree in 1 second of integration. The calibration system also includes precise cable measurement electronics and a pulse echo for clock synchronization.

Rogers, A. E. E.↗

Microwave radiometry as a tool to calibrate tropospheric water-vapor delay

Microwave radiometers were used to measure the emission line due to the water vapor molecules of atmospheric emission. Four separate field tests were completed which compared radiometers to other techniques which measure water vapor. It is shown that water vapor induced delay can be estimated with an accuracy of plus or minus 2 cm for elevation angles above 17 degrees.

Resch, G. M.↗

Phase delay astrometry and its geodetic applications

The accuracy inherent in the fringe phase in the determination of source positions was calculated. It is shown that accuracy can be utilized by applying differencing techniques in order to circumvent such systematic effects as clock drift and delay due to the propagation media.

Wittels, J. J.↗

Gigahertz analog modulation and differential delay of GaAlAs lasers - Temperature and current behavior

Gigahertz analog modulation characteristics of broad-area commercially available GaAlAs lasers have been investigated as a function of temperature and current in the vicinity of the upper frequency limit, where the resonance phenomena occur. The optimum temperature for small-signal amplitude modulation was found to be around -15 C for our particular broad-stripe geometry double-heterostructure laser. The Q was found to increase by a factor of 2 and the bandwidth by about 2%; the external quantum efficiency was maximized in this range. The optimum dc current bias was about 2% above the threshold current. Differential delays have also been measured down to a few picosecond accuracy by a unique phase-angle measurement method using a vector voltmeter. Some of the temperature effects observed may be related to mode changes and multimode and superradiance behavior.

Eng, S. T.↗

Time delay and integration detectors using charge transfer devices

An imaging system comprises a multi-channel matrix array of CCD devices wherein a number of sensor cells (pixels) in each channel are subdivided and operated in discrete intercoupled groups of subarrays with a readout CCD shift register terminating each end of the channels. Clock voltages, applied to the subarrays, selectively cause charge signal flow in each subarray in either direction independent of the other subarrays. By selective application of four phase clock voltages, either one, two or all three of the sections subarray sections cause charge signal flow in one direction, while the remainder cause charge signal flow in the opposite direction. This creates a form of selective electronic exposure control which provides an effective variable time delay and integration of three, six or nine sensor cells or integration stages. The device is constructed on a semiconductor sustrate with a buried channel and is adapted for front surface imaging through transparent doped tin oxide gates.

Mccann, D. H.↗

Estimation of the propagation delay through the troposphere from microwave radiometer data

Microwave propagation delay through the troposphere is studied as a means of estimating the adverse effect of atmospheric water vapor on the accuracy of measurements made with very long baseline interferometry. Vertical profiles of temperature and water vapor density were obtained from a total of 240 radiosonde launches taken simultaneously at three New England locations in 1974; all studies were made at the 19 and 22.2 GHz frequency operating range of the radiometers. The wet path length in the zenith direction could be estimated from the surface water vapor density to an accuracy of 5 cm for the summer data and 2 cm for winter data, and with the brightness temperatures, it could be estimated to an accuracy of 0.3 cm. Two dual-frequency radiometers were also used to determine the accuracy of prediction of the path length from real radiometry data. The rms error for the estimation of wet path length from surface meteorological parameters was 3.2 cm, and for the radiometer brightness temperatures the rms error was 1.5 cm.

Moran, J. M.↗

Polyploidization delay in rat hepatocytes under liver growth inhibition by hypokinesia

A study of young rats, weighing 55 to 59 g, after being for 10 days in conditions of limited mobility, shows a retardation of body growth as well as that of liver growth. The decrease in the rate of growth is accompanied by a reduction of cell proliferation and by delay polyploidization of hepatocytes in the liver of experimental rats. The materials, methods, and results of research are discussed.

Faktor, V. M.↗

The vertical propagation of waves in the solar atmosphere. II Phase delays in the quiet chromosphere and cell-network distinctions

The differences in the phase of the velocity oscillations between a pair of chromospheric Ca II lines was measured using the Vacuum Tower Telescope at the Sacramento Peak Observatory. The observed phase differences indicate that the acoustic modes are trapped or envanescent, rather than propagating, in the chromosphere. Systematic distinctions are found in the phase delays between quiet network and cell interior regions for both intensity and velocity oscillations in photospheric and chromospheric lines. The theory of linear perturbations in an isothermal atmosphere is invoked to interpret these differences. From this analysis it is found that one or more of the following explanations is possible: (1) the radiative damping is more effective in the network than in the cell interior; (2) the network features exclude oscillations of large horizontal wavenumber; or (3) the scale height of the chromosphere is larger in the network than in the cell interior.

Lites, B. W.↗

Delay-Doppler radar observations of Saturn's rings

Delay-Doppler observations at 12.6 cm which have been used to estimate the relative radar reflectivities of Saturn's classical ring sections show that the A and B rings are responsible for most of the radar echo, and that the average radar reflectivity per unit of projected area of the A ring is 90% as large as the B ring. No firm evidence is found for radar backscattering from particles interior to the B ring, exterior to the A ring, of from the planet itself. Unexpectedly large amounts of power at Doppler shifts near the center of the echo spectrum, which had been reported at 3.5 and 12.6 cm for ring plane tilt angles greater than 24.4 deg are not apparent in spectra for those wavelengths obtained at ring plane tilt angles smaller than 21.4 deg.

Ostro, S. J.↗

Near optimum delay-line detection filters for serial detection of MSK signals

A method for designing transversal delay-line filter approximations to the matched filter for the serial detection of minimum-shift keyed (MSK) modulated signals is given. Two configurations are characterized in terms of signal-to-noise ratio degradation at a bit error rate (BER) of 10 to the -6th. One is shown to depart less than 0.3 dB from the ideal matched filter performance when its parameter values are optimized. A lumped-element equivalent is also given and shown to provide a degradation of less than 0.4 dB at a BER of 10 to the -6th

Ziemer, R. E.↗

Internal variability of an energy-balance model with delayed albedo effects

A simple, deterministic energy-balance model with possible relevance to climatic variations on the time scale of glaciation cycles, is presented. The lag between ice-sheet extent and zonally-averaged temperature is modeled as a time delay in the ice-albedo feedback. The model exhibits self-sustained oscillations which are quasi-periodic or aperiodic in character. Fourier spectra of solutions have the features of many paleoclimatic records: peaks of variable height and width superimposed on a continuous, red-noise type background.

Bhattacharya, K.↗

Effect of Temperature on Fiber-Optic Delay

Fiber/jacket interactions affect performance. Attenuation and phase measurements made to assess effect of temperature on signal delay and attenuation in two fiber-optic cable samples.

Bergman, L. A.↗

Measuring Delay in Lasers

Technique measures delay, i.e., response time of modulated diode laser as function of temperature by comparing excitation signal to laser output signal with vector voltmeter.

Bergman, L. A.↗

Description and overview of an instrument designed to measure line-of-sight delay due to water vapor

Eight dual channel microwave radiometers were constructed as a research and development effort for the Crustal Dynamics Project and the Deep Space Network. These instruments, known as water vapor radiometers, are primarily intended to demonstrate that the variable path delay imposed by atmospheric water vapor can be calibrated in microwave tracking and distance measuring systems but could also be used in other applications involving moist air meteorology and propagation studies. They are being deployed to various stations and observatories that participate in Very Long Baseline Interferometry experiments. The development history of these instruments are reviewed, the theory of operation and overall design considerations are outlined, and the instrumental parameters and performance characteristics are described.

Resch, G. M.↗

Delay line and mutual coupling considerations for MST radar antenna arrays

Basic antenna theory which states that the field radiated from an antenna array is equal to the sum of the currents flowing in each element of the array is discussed. The feedline distribution system guarantees the proper amplitude and phase of the current for each element of an array. The difference in electrical lengths of the feedlines to the elements has to equal the desired phase angle. The current for voltage delay in a transmission line is equal to the transmission line electrical length in only a few special cases, when the transmission line is terminated in its characteristic impedance or when the transmission line's electrical length is a multiple of 90 degrees.

Brosnahan, J. W.↗

Tropospheric Delay Effects in Radio Interferometry

A new tropospheric mapping function is derived which is more accurate than previous mapping functions above elevations of 4 degrees. The error due to the given analytic approximation is estimated to be less than 0.02% for elevation angles larger than 6 degrees, (less than 0.4 cm at 6 degrees, and approximately 0.004% or 0.03 cm at 20 degrees). The mathematical expansion used in the derivation is valid for any laterally homogeneous atmospheric model of refractivity. The new mapping function, computer generated ray tracing tables and other mapping functions are compared. The results can be used in correcting for tropospheric delays of radio signals.

Lanyi, G.↗

Temperature stability of transit time delay for a single-mode fibre in a loose tube cable

The effect of temperature on the transit-time delay of a loose-tube-type single-mode optical-fiber cable is investigated experimentally. A 1058-m length of cable was placed loosely coiled in an oven and used to connect a 820-nm single-mode laser diode to a high-speed avalanche-photodiode detector feeding a vector voltmeter; the signal was provided by a high-stability frequency-synthesized generator. Measurements were made every 2 C from -50 to 60 C and compared to those obtained with a 200-m lacquered bare fiber. The phase change of both fibers varied with temperature at a positive slope of 6-7 ppm/C. This value is significantly better than those reported for other cable types, suggesting the application of loose-fiber cables to long-haul gigabit digital transmissions or precision time-base distribution for VLBI.

Bergman, L. A.↗