Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “TERMINAL”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 829 records · Page 46

Economics and terminal area environmental impact of STOL transportation

The impact of short takeoff and landing aircraft in meeting the needs of short haul transportation systems is analyzed. The objectives of the short haul system are evaluated on the basis of the following criteria: (1) service to the passenger, (2) economic viability, and (3) terminal area environment conditions caused by community noise, ground and air decongestion, and air pollution. Data are presented in the forms of tables, charts, and graphs. An itemization of the conclusions reached after the preliminary investigation is included.

Stewart, E. C.↗

Spacecraft communications terminal breadboard components

The C-band translator, transmitter, and attenuator are described for the spacecraft communication terminal breadboard components. The block diagram is also included for the C-band receiver. The system performance data and the mechanical properties of the system are briefly considered.

Source record↗

Terminal-area STOL operating systems experiments program

A system study to determine the application of short takeoff aircraft for a high speed, short haul air transportation service was conducted. The study focused on developing information which will aid in choosing system concepts, design criteria, operating procedures, landing guidance systems, air traffic control systems, and airborne avionics and flight control systems. A terminal area STOL operating system experiments program was developed. The objectives, program approach, program schedule, typical experiments, research facilities to be used, and program status are discussed.

Smith, D. W.↗

Optimal horizontal guidance law for aircraft in the terminal area.

Study of the horizontal guidance of aircraft in and near the terminal area. The problem of guiding an aircraft in minimum time from an arbitrary point to the outer marker is formulated as a nonlinear optimal control problem, and the control law solution is obtained by the application of the maximum principle. It is found that for some initial states the problem is singular. Furthermore, the extremal controls for this problem are not unique. Consequently, the optimal controls must be obtained on the basis of the value of the performance index. The control law is implemented in the form of a digital computer program which computes the optimal trajectory for arbitrary initial conditions.

Pecsvaradi, T.↗

Terminal-oriented computer-communication networks.

Four examples of currently operating computer-communication networks are described in this tutorial paper. They include the TYMNET network, the GE Information Services network, the NASDAQ over-the-counter stock-quotation system, and the Computer Sciences Infonet. These networks all use programmable concentrators for combining a multiplicity of terminals. Included in the discussion for each network is a description of the overall network structure, the handling and transmission of messages, communication requirements, routing and reliability consideration where applicable, operating data and design specifications where available, and unique design features in the area of computer communications.

Schwartz, M.↗

An economic assessment of STOL aircraft potential including terminal area environmental considerations. Volume 2: Appendices

An economic assessment of short takeoff aircraft for short haul air transportation applications is presented. The economic viability and environmental compatibility of short takeoff aircraft service in high density areas were evaluated. The subjects discussed are: (1) aircraft configurations and performance, (2) airfield and terminal requirements, and (3) direct and indirect operating costs.

Solomon, H. L.↗

Rendezvous terminal phase automatic braking sequencing and targeting

The purpose of the rendezvous terminal phase braking program is to provide the means of automatically bringing the primary orbiter within desired station keeping boundaries relative to the target satellite. A detailed discussion is presented on the braking program and its navigation, targeting, and guidance functions.

Kachmar, P. M.↗

Advanced subsonic long-haul transport terminal area compatibility study. Volume 1: Compatibility assessment

An analysis was made to identify airplane research and technology necessary to ensure advanced transport aircraft the capability of accommodating forecast traffic without adverse impact on airport communities. Projections were made of the delay, noise, and emissions impact of future aircraft fleets on typical large urban airport. Design requirements, based on these projections, were developed for an advanced technology, long-haul, subsonic transport. A baseline aircraft was modified to fulfill the design requirements for terminal area compatibility. Technical and economic comparisons were made between these and other aircraft configured to support the study.

Source record↗

Advanced subsonic long-haul transport terminal area compatibility study. Volume 2: Research and technology recommendations

The Terminal Area Compatibility (TAC) study is briefly summarized for background information. The most important research items for the areas of noise congestion, and emissions are identified. Other key research areas are also discussed. The 50 recommended research items are categorized by flight phase, technology, and compatibility benefits. The relationship of the TAC recommendations to the previous ATT recommendations is discussed. The bulk of the document contains the 50 recommended research items. For each item, the potential payoff, state of readiness, recommended action and estimated cost and schedule are given.

Source record↗

An economic assessment of STOL aircraft potential including terminal area environmental considerations, volume 1

The results of an economic and environmental study of short haul airline systems using short takeoff and landing (STOL) aircraft are presented. The STOL system characteristics were optimized for maximum patronage at a specified return on investment, while maintaining noise impact compatibility with the terminal area. Supporting studies of aircraft air pollution and hub airport congestion relief were also performed. The STOL concept specified for this study was an Augmentor Wing turbofan aircraft having a field length capability of 2,000 ft. and an effective perceived noise level of 95 EPNdB at 500 ft. sideline distance. An economic and environmental assessment of the defined STOL system and a summary of the methodology, STOL system characteristics and arena characteristics are provided.

Solomon, H. L.↗

Terminal-shock and restart control of a Mach 2.5, mixed compression inlet coupled to a turbofan engine

Results of an experimental program conducted on a mixed-compression inlet coupled to a turbofan engine are presented. Open-loop frequency response data are presented that show the response of shock position (as measured by an average inlet static pressure) to sinusoidal airflow disturbances produced at the compressor face station. Also presented are results showing the effect of different passive terminations (a choke plate or a long duct) on the characteristics of the inlet. Transfer functions obtained by using experimental data are presented and compared to the experimental data. Closed-loop frequency response of shock position (with a proportional-plus-integral controller) is presented. In addition, transient data are presented that show the unstart-restart characteristics of the inlet.

Baumbick, R. J.↗

A flight investigation of a terminal area navigation and guidance concept for STOL aircraft

A digital avionics system referred to as STOLAND has been test-flown in the NASA CV-340 to obtain performance data for time-controlled guidance in the manual flight director mode. The advanced system components installed in the cockpit included an electronic attitude director indicator and an electronic multifunction display. Navigation guidance and control computations were all performed in the digital computer. Approach paths were flown which included a narrow 180-deg turn and a 1-min, 5-deg straight-in approach to the 30-m altitude go-around point. Results are presented for 20 approaches: (1) blended radio/inertial navigation using TACAN and a microwave scanning beam landing guidance system (MODILS) permitted a smooth transition from area navigation (TACAN) to precision terminal navigation (MODILS), (2) guidance system (flight director) performance measured at an altitude of 30.5 m was within that prescribed for category II CTOL operations on a standard runway, and (3) time of arrival at a point about 2 mi from touchdown was about 4 sec plus or minus sec later than the computed nominal arrival time.

Smith, D. W.↗

Solar electric propulsion for terminal flight to rendezvous with comets and asteroids

A guidance algorithm that provides precise rendezvous in the deterministic case while requiring only relative state information is developed. A navigation scheme employing only onboard relative measurements is built around a Kalman filter set in measurement coordinates. The overall guidance and navigation procedure is evaluated in the face of measurement errors by a detailed numerical simulation. Results indicate that onboard guidance and navigation for the terminal phase of rendezvous is possible with reasonable limits on measurement errors.

Bennett, A.↗

Discrete optimal control approach to a four-dimensional guidance problem near terminal areas

Description of a computer-oriented technique to generate the necessary control inputs to guide an aircraft in a given time from a given initial state to a prescribed final state subject to the constraints on airspeed, acceleration, and pitch and bank angles of the aircraft. A discrete-time mathematical model requiring five state variables and three control variables is obtained, assuming steady wind and zero sideslip. The guidance problem is posed as a discrete nonlinear optimal control problem with a cost functional of Bolza form. A solution technique for the control problem is investigated, and numerical examples are presented. It is believed that this approach should prove to be useful in automated air traffic control schemes near large terminal areas.

Nagarajan, N.↗

Termination of the solar wind in the hot, partially ionized interstellar medium

Theoretical foundations for understanding the problem of the termination of the solar wind are reexamined in the light of most recent findings concerning the states of the solar wind and the local interstellar medium. The investigation suggests that a simple extention of Parker's (1961) analytical model provides a useful approximate description of the combined solar wind, interstellar wind plasma flowfield under conditions presently thought to occur. A linear perturbation solution exhibiting both the effects of photoionization and charge exchange is obtained for the supersonic solar wind. A numerical algorithm is described for computing moments of the non-equilibrium hydrogen distribution function and associated source terms for the MHD equations. Computed using the algorithm in conjunction with the extended Parker solution to approximate the plasma flowfield, profiles of hydrogen number density are given in the solar wind along the upstream and downstream axes of flow with respect to the direction of the interstellar wind. Predictions of solar Lyman-alpha backscatter intensities to be observed at 1 a.u. have been computed, in turn, from a set of such hydrogen number density profiles varied over assumed conditions of the interstellar wind.

Lombard, C. K.↗

Continuous-output terminal-shock-position sensor for mixed-compression inlets evaluated in wind tunnel tests of YF-12 aircraft inlet

An electronic sensor was built to measure the position of the terminal shock in a supersonic inlet. The sensor uses several static-pressure taps in the inlet wall. The sensor output is continuously proportional to shock position. When the sensor was installed in a YF-12 aircraft flight inlet during wind tunnel tests, it indicated shock position within + or - 5 percent of the total distance covered by the static-pressure-tap region. The maximum error caused by an angle of attack change of 4 deg was less than 25 percent. In the region of normal inlet operation, the angle of attack error is negligible. Frequency-response tests show the amplitude ratio is constant out to 60 Hz, and decreases to about 50 percent at 100 Hz, with a phase lag of 50 deg.

Dustin, M. O.↗

Application of modern control theory to scheduling and path-stretching maneuvers of aircraft in the near terminal area

A design concept of the dynamic control of aircraft in the near terminal area is discussed. An arbitrary set of nominal air routes, with possible multiple merging points, all leading to a single runway, is considered. The system allows for the automated determination of acceleration/deceleration of aircraft along the nominal air routes, as well as for the automated determination of path-stretching delay maneuvers. In addition to normal operating conditions, the system accommodates: (1) variable commanded separations over the outer marker to allow for takeoffs and between successive landings and (2) emergency conditions under which aircraft in distress have priority. The system design is based on a combination of three distinct optimal control problems involving a standard linear-quadratic problem, a parameter optimization problem, and a minimum-time rendezvous problem.

Athans, M.↗