Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “RECEIVER”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 829 records · Page 46

Enhanced Radio Frequency Carrier Margin Improvements for an Array of Receiving Systems with Unequal Predetection Signal-to-noise Ratios

Enhanced radio frequency carrier margin improvement for arrayed receiving systems for coherent reception which provides a significant carrier sensitivity improvement with a resultant decrease in telemetry radio loss due to reduction in rms phase noise at low carrier margins is discussed. A significant increase in doppler rate capability is realized relative to that obtained by switching to a narrower tracking loop bandwidth to obtain the same carrier sensitivity improvement. The situation for arrayed receiving systems with unequal apertures and statisically independent predetection noise is examined.

Brockman, M. H.↗

The 30-GHz monolithic receive module

Key requirements for a 30 GHz GaAs monolithic receive module for spaceborne communication antenna feed array applications include an overall receive module noise figure of 5 dB, a 30 dB RF to IF gain with six levels of intermediate gain control, a five-bit phase shifter, and a maximum power consumption of 250 mW. The RF designs for each of the four submodules (low noise amplifier, some gain control, phase shifter, and RF to IF sub-module) are presented. Except for the phase shifter, high frequency, low noise FETs with sub-half micron gate lengths are employed in the submodules. For the gain control, a two stage dual gate FET amplifier is used. The phase shifter is of the passive switched line type and consists of 5-bits. It uses relatively large gate width FETs (with zero drain to source bias) as the switching elements. A 20 GHz local oscillator buffer amplifier, a FET compatible balanced mixer, and a 5-8 GHz IF amplifier constitute the RF/IF sub-module. Phase shifter fabrication using ion implantation and a self-aligned gate technique is described. Preliminary RF results obtained on such phase shifters are included.

Sokolov, V.↗

Advanced Solar Receivers

Low thermal efficiencies in solar receivers are discussed in terms of system design. It is recommended that careful attention be given to the overall thermal systems design, especially to conductive losses about the window and areas of relatively thin insulation. If the cavity design is carefully managed to insure a small, minimally reradiating aperture, the goal of a very high efficiency cavity receiver is a realistic one.

Owen, W. A.↗

Autonomous Integrated Receive System (AIRS) requirements definition. Volume 1: Executive summary

Distributed processing in the design and operation of the augmented TDRSS and the succeeding TDAS in the 1990's is discussed with the emphasis on the development of the autonomous integrated receive system (AIRS) for the operation of the S-band single access (SSA) return link in the White Sands ground terminal. This receive system has the capability of self configuration, real-time operation, and self diagnostic. The tasks of Doppler correction, demodulation, detection, and decoding are performed in an integrated manner where useful information are shared and used by ALL portions of AIRS performing these tasks. Operating modes, maintenance, system architecture, and performance characteristics are described.

Chie, C. M.↗

Autonomous Integrated Receive System (AIRS) requirements definition. Volume 3: Performance and simulation

The autonomous and integrated aspects of the operation of the AIRS (Autonomous Integrated Receive System) are discussed from a system operation point of view. The advantages of AIRS compared to the existing SSA receive chain equipment are highlighted. The three modes of AIRS operation are addressed in detail. The configurations of the AIRS are defined as a function of the operating modes and the user signal characteristics. Each AIRS configuration selection is made up of three components: the hardware, the software algorithms and the parameters used by these algorithms. A comparison between AIRS and the wide dynamics demodulation (WDD) is provided. The organization of the AIRS analytical/simulation software is described. The modeling and analysis is for simulating the performance of the PN subsystem is documented. The frequence acquisition technique using a frequency-locked loop is also documented. Doppler compensation implementation is described. The technological aspects of employing CCD's for PN acquisition are addressed.

Chie, C. M.↗

Submillimeter-wave receivers - A status report

A development status assessment is presented for the work of U.S. and Western European research groups on heterodyne sub-mm receivers in the 300-1000 GHz frequency range. The applications driving sub-mm receiver and local oscillator source technologies are radio astronomy, atmospheric measurements, plasma diagnostics, and laboratory spectroscopy. Progress is concentrated in two areas, cooled Schottky diode mixers and solid state local oscillators employing frequency multipliers.

Wilson, W. J.↗

A comparison of geodetic Doppler satellite receivers

A great number of geodetic Doppler satellite receivers of various types have been employed since early 1970s. In October and November 1979, a comparison was conducted of three more recent types of receivers, including the CMA-751, the JMR-1A, and the MX-1502. A description of the studies involved in conducting the comparison is presented, taking into account the preliminary results obtained on the basis of the processing of the collected data. Attention is given to tracking statistics, chord difference results, range rate measurement errors, residual tests, station position repeatability, and absolute differences to ground control. Recommendations for future comparisons are also provided.

Archinal, B.↗

Communication satellite ground station receiver performance at low data rates

Performance of satellite ground station receivers at low data rates is analyzed for power-limited satellites, when various amounts of frequency dynamics are present. Specifically, the lowest data rates for which the receiver can successfully demodulate suppressed-carrier BPSK data under a wide variety of conditions are determined. Minimum data rates on the order of 100 to 1400 bits per second are achievable with a bit error probability less than 0.00001 and with a mean time to cycle slip on the order of 1/2 hour or more, when Costas loops are employed for carrier extraction.

Riddle, L. P.↗

Natural interference phenomena affecting spaceborne receivers

Earth orbiting microwave receivers which are vulnerable to the interference from natural sources, mainly, the Sun and the Moon, are discussed. The irradiance from the Sun affects microwave receivers in two ways: (1) the infrared component of the irradiance causes nonuniform heating in metal structures and produces distortions that affect electrical performance; and (2) the graybody radiation component of the solar irradiance enters the collecting aperture of the antenna and the feed ports of the calibration circuits. The graybody radiation operates to degrade the signal to noise ratios and vitiate the internal calibration accuracy. The magnitudes of interference from the Sun and the Moon are analyzed and mathematical expressions are derived which serve to quantify the expected interference levels.

Stacey, J. M.↗

International time transfer and portable clock evaluation using GPS timing receivers: Preliminary results

The overall experiment was designed to test the positioning and navigation capabilities of the GPS timing receivers developed by the Naval Research Laboratory (NRL) for the NASA Goddard Laser Tracking Network (GITN). To perform this experiment, a reliable and redundant time scale was set up onboard the ship, and a back-up on shore. This situation provided the opportunity to perform simultaneously a timing experiment ideally divided into two parts, the main objectives of the experimentation being: (1) To test GPS timing receiver synchronization capabilities on a moving platform, and to perform an intercontinental synchronization via GPS between participating international timing laboratories in Europe and in the United States. (2) To evaluate the performance of cesium portable clocks in the field.

Wardrip, S. C.↗

Optical receivers using rough reflectors

This report examines the possible use of rough, or nondiffraction-limited, reflectors for collecting optical signals. It is shown that in the absence of background radiation, the reflector's surface quality has little effect on the performance of a properly designed receiver, but that the presence of even small amounts of background radiation can lead to severe performance degradation. Techniques are suggested for improving receiver performance in high-background environments, and bounds and approximations to the exact error-probability expressions are derived.

Vilnrotter, V. A.↗

Interference susceptibility of a typical deep space network receiving system

The Deep Space Network (DSN), operated by the Jet Propulsion Laboratory for NASA, is used primarily for communication with interplanetary spacecraft. The high sensitivity required to achieve communication with distant spacecraft makes the DSN very susceptible to radio frequency interference (RFI). In this article a comprehensive description of the interference susceptibility of a typical DSN receiving system is given. Specifically, the effects of interference on the carrier tracking loop, the telemetry receiving subsystem, and the saturation effect on the maser, are presented.

Sue, M. K.↗

A comparison of four precise global positioning system geodetic receivers

Four precise global positioning system (GPS) geodetic receivers were operated simultaneously in January and February 1984 over ten baselines ranging in distance from 13 to 1304 km. Several of the baselines had been previously measured using very long baseline interferometry and, therefore, provide very good standards to which the satellite results can be compared. Results of these experiments are presented along with a brief description of each receiver and the associated analysis techniques.

Goad, C. C.↗

Performance characteristics for an array of two receiving systems with unequal predetection signal-to-noise ratios and enhanced radio frequency carrier margin improvement

Enhanced radio frequency carrier margin improvement for arrayed receiving systems for coherent reception of phase modulated signals with residual carrier provides a significant reduction in carrier loop phase noise and increase in signal to noise ratio in the RF carrier tracking loop with an attendant reduction in telemetry radio loss. A significant increase in Doppler frequency rate capability is also realized relative to operating at a narrower tracking loop bandwidth to obtain the same carrier sensitivity improvement. These performance characteristics are examined for an array of two receiving systems with unequal apertures and statistically independent predetection noise.

Brockman, M. H.↗

Performance characteristics for an array of two receiving systems with equal apertures and enhanced radio frequency carrier margin improvement

Enhanced radio frequency carrier margin improvement for arrayed receiving systems for coherent reception of phase modulated signals with residual carrier provides a significant reduction in carrier loop phase noise and an increase in the signal to noise ratio in the RF carrier tracking loop with an attendant in telemetry radio loss. A significant increase in doppler frequency rate capability is also realized relative to operating at a narrower tracking loop bandwidth to obtain the same carrier sensitivity improvement. These performance characteristics are examined for an array of two receiving sysems with equal apertures and statistically independent prediction noise.

Brockman, M. H.↗

Solar Stirling receiver alternatives for the terrestrial solar application

Concept studies have been completed for four dish-Stirling receivers, i.e., solar only and thermal storage receiver, each of which is either directly coupled or indirectly (heat pipe) coupled to the Stirling engine. The results of these studies are to be applied to systems benefit/cost analysis to determine the most desirable development approach.

Stearns, J.↗

Received optical power calculations for optical communications link performance analysis

The factors affecting optical communication link performance differ substantially from those at microwave frequencies, due to the drastically differing technologies, modulation formats, and effects of quantum noise in optical communications. In addition detailed design control table calculations for optical systems are less well developed than corresponding microwave system techniques, reflecting the relatively less mature state of development of optical communications. Described below are detailed calculations of received optical signal and background power in optical communication systems, with emphasis on analytic models for accurately predicting transmitter and receiver system losses.

Marshall, W. K.↗

A cost-performance model for ground-based optical communications receiving telescopes

An analytical cost-performance model for a ground-based optical communications receiving telescope is presented. The model considers costs of existing telescopes as a function of diameter and field of view. This, coupled with communication performance as a function of receiver diameter and field of view, yields the appropriate telescope cost versus communication performance curve.

Lesh, J. R.↗