Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “FEEDING”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 829 records · Page 46

Conditioned feeding suppression in rats produced by cross-coupled and simple motions

Results are presented of an experiment on the induction of motion sickness in rats by the use of cross-coupled accelerations of magnitudes similar to those used in human experiments. Accelerations were produced in a seesaw apparatus with rotating disks supporting the animal cages mounted on each seesaw arm, and motion sickness was assessed according to the consumption of a sweet food previously offered to the animals immediately before the motion treatment. During a 1-hour test session 72 h after motion treatment and after a 24-h fast, rats having undergone cross-coupled vertical sinusoidal and rotational motion are observed to consume less food than those having experienced either type of motion alone, or no motion. The ordering of the conditioned suppressive feeding effects is consistent with the amounts of vestibular stimulation produced by the respective motions. The results support the existence of motion sickness effects in rats, even though they are unable to vomit.

Fox, R. A.↗

Estimating Waveguide Feed Directivity and Spacing

Approximate curves simplify initial steps of antenna design. Maximum achievable directivity exponents plotted as functions of element spacing in wavelengths for equilateral triangular array of rectangular waveguides. Directivities and exponents calculated for circular waveguides, pyramidal horns, and other standard feeds. Designer quickly estimates element spacing necessary to achieve required directivity or directivity achievable.

Rahmat-Samii, Y.↗

A hardware demonstration of distributed control for a flexible offset-feed antenna

A fully instrumented hardware model of a flexible offset-feed antenna has been constructed for laboratory tests. Three rate gyros, four angular position laser sensors, and a set of ten distributed accelerometers are used to rconstruct the antenna state. Three control moment gyros are used to simultaneously orient the antenna, and to maintain a stable line of sight. A description is presented of the distributed antenna control system and experimental results.

Schaechter, D. B.↗

Aircraft automatic digital flight control system with inversion of the model in the feed-forward path

A full-flight-envelope automatic trajectory control system concept is being investigated at Ames Research Center. This concept was developed for advanced aircraft configurations with severe nonlinear characteristics. A feature of the system is an inverse of the complete nonlinear aircraft model as part of the feed-forward control path. Simulation and flight tests have been reported at previous Digital Avionics Systems conferences. A new method for the continuous real-time inversion of the aircraft model using a Newton-Raphson trim algorithm instead of the original inverse table look-up procedure has been developed. The results of a simulation study of a vertical attitude takeoff and landing aircraft using the new inversion technique are presented. Maneuvers were successfully carried out in all directions in the vertical-attitude hover mode. Transition runs from conventional flight through the region of lift-curve-slope reversal at an angle of attack of about 32 deg and to hover at zero speed in the vertical attitude showed satisfactory transient response. Simulations were also conducted in conventional flight at high subsonic speed in steep climb and with turns up to 4 g. Successful flight tests of the system with the new model-inversion technique in a UH-1H helicopter have recently been carried out.

Smith, G. A.↗

Calculating Directivities of Planar-Array Antenna Feeds

Design of planar-array antennas and antenna feeds aided by new approach to calculation of array directivity. Technique takes into account polarizations, asymmetries in element patterns, nonuniform element spacings, and arbitrary excitations. Gives numerical results faster than previous integration methods, and results agree with those obtained by older methods.

Rahmat-Samii, Y.↗

A New Integrated Slot Element Feed Array for Multi-beam Systems

A feed array consisting of constant width slot antennas (CWSA's), fed from a block containing fin-line transitions, has been developed. The array has a two-dimensional configuration, with five elements each on five parallel substrates. Beam-widths are compatible with use in f/D-1.0 multi-beam systems, with optimum taper. Array element spacings are close to a factor of two smaller than for other typical arrays, and spill-over efficiency is about 65%.

Yngvesson, K. S.↗

A conceptual 34-meter antenna feed configuration for joint DSN/SETI use from 1 to 10 GHz

The very satisfactory performance of a conceptual 34-m DSS-12 type HA-Dec antenna feed sysem over the frequency range of 1 to 10 GHz is demonstrated. A seven-feedhorn baseline design is developed which will allow Search for Extra-Terrestrial Intelligence (SETI) investigations using each horn over a 1.4:1 frequency range. A gain/system noise temperature (G/T) figure of merit is calculated for the frequency range of each horn; it is found that system performance down to 20 deg elevation is possible with a G/T degradation of less than 3 dB at every frequency. The design presented here will allow shared but independent antenna use by the Deep Space Network (DSN) and SETI with a minimum of operational impacts to DSN functions and no intrusions into the DSN microwave equipment configuration.

Slobin, S. D.↗

An aperture-matched compact range feed horn design

The moment method and the uniform geometrical theory of diffraction are used to obtain two separate solutions for the E-plane far field pattern of an aperture-matched horn antenna. This particular horn antenna consists of a standard pyramidal horn with the following modifications: a rolled edge section attached to the aperture edges and a curved throat section. The resulting geometry provides significantly better performance in terms of the pattern, impedance, and frequency characteristics than normally obtainable. The moment method is used to calculate the E-plane pattern and voltage standing-wave ratio (VSWR) of the antenna. However, at higher frequencies, the moment method requires large amounts of computation time. On the other hand, the uniform geometrical theory of diffraction provides a quick and efficient high frequency solution for the E-plane field pattern. This procedure has been successfully applied to design a compact range feed horn.

Heedy, D. J.↗

A new integrated slot element feed array for multibeam systems

A feed array consisting of constant width slot antennas (CWSA), fed from a block containing fin-line transitions, has been developed. The array has a two-dimensional configuration, with five elements each on five parallel substrates. Beamwidths are compatible with use in f/D = 1.0 multibeam systems, with optimum taper. Array element spacings are close to a factor of two smaller than for other typical arrays, and spillover efficiency is about 65 percent.

Yngvesson, K. Sigfrid↗

New simple feed network for an array module of four microstrip elements

A simple microstripline feed network for an array module comprising four microstrip elements is described. The advantages and disadvantages of the network are discussed as well as a theoretical explanation for the radiation characteristics of array modules using the network.

Oberhart, M. L.↗

Trickle water and feeding system in plant culture and light-dark cycle effects on plant growth

Rockwool, as an inert medium covered or bagged with polyethylene film, can be effectively used for plant culture in space stations. The most important machine is the pump adjusting the dripping rate in the feeding system. Hydro-aeroponics may be adaptable to a space laboratory. The shortening of the light-dark cycles inhibits plant growth and induces an abnormal morphogenesis. A photoperiod of 12 hr dark may be needed for plant growth.

Takano, T.↗

Case study of active array feed compensation with sidelobe control for reflector surface distortion

The feasibility of electromagnetically compensating for reflector surface distortions has been investigated. The performance characteristics (gain, sidelobe levels, etc.) of large communication antenna systems degrade as the reflector surface distorts mainly due to thermal effects from a varying solar flux. The techniques described in this report can be used to maintain the design performance characteristics independently of thermal effects on the reflector surface. With the advent of monolithic microwave integrated circuits (MMIC), a greater flexibility in array-fed reflector system design can be achieved. MMIC arrays provide independent control of amplitude and phase for each of many radiating elements of the feed array. It is assumed that the surface characteristics (x,y,z, its first and second derivatives) under distorted conditions are known.

Acosta, R. J.↗

Flow Analysis of Space Shuttle Feed Line 17-inch Disconnect Valve

A steady incompressible three-dimensional viscous flow analysis has been conducted for the Space Shuttle External Tank/Orbiter propellant feed line disconnect flapper valves with upstream elbows. The full Navier-Stokes code, INS3D, is modified to handle interior obstacles. Grids are generated by SVTGD3D code. Two dimensional initial grids in the flow cross section with and without the flappers are improved by elliptic smoothing to provide better orthogonality, clustering and smoothness to the three dimensional grid. The flow solver is tested for stability and convergence in the presence of interior flappers. An under-relaxation scheme has been incorporated to improve the solution stability. Important flow characteristics such as secondary flows, recirculation, vortex and wake regions, and separated flows are observed. Computed values for forces, moments, and pressure drop are in satisfactory agreement with water flow test data covering a maximum tube Reynolds number of 3.5 x 10(exp 6). The results will serve as a guide to improved design and enhanced testing of the disconnect.

Kandula, Max↗

Feasibility study of a synthesis procedure for array feeds to improve radiation performance of large distorted reflector antennas

Surface errors on parabolic reflector antennas degrade the overall performance of the antenna. The errors are in the form of roughness on the surface, distortions in the shape, or structural design details. They cause amplitude and phase errors in the aperture field which lower the gain, raise the sidelobes, and fill in the nulls. These are major problems in large space reflector antennas. Planned mobile satellite communications systems having limited signal margin need high gain from the space reflectors. Future multiple beam antenna systems requiring spatial isolation to allow frequency reuse could be rendered useless if high sidelobes are present. High sidelobes are also responsible for noise. Ways of compensating for surface errors by pattern synthesis using an array of feed antennas are examined. Pattern corrections are directed specifically toward portions of the pattern requiring improvements. The pattern synthesis does not require knowledge of the surface errors. Both the amplitude and phase of the high side lobes caused by the distortion are required.

Stutzman, W. L.↗

Reflector antenna distortion compensation by array feeds - An experimental verification

Reflector antennas are subject to surface distortions which may result from thermal or gravitational effects. Surface distortions degrade antenna performance by reducing gain and introducing high sidelobe levels. In the letter, results of an experimental study are presented to demonstrate how effectively a properly excited array feed in the focal plane of the reflector antenna can compensate for the undesirable effects of slowly varying surface distortions. The application of the array compensation concept could prove to be very useful for future large space or ground antennas.

Rahmat-Samii, Y.↗