SEARCH · Engineering Papers

Results for “Dynamical”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 829 records · Page 46

All sources NASA NTRS DOE OSTI

NASA NTRS1975

Requirements for implementation of Kuessner and Wagner indicial lift growth functions into the FLEXSTAB computer program system for use in dynamic loads analyses

General requirements for dynamic loads analyses are described. The indicial lift growth function unsteady subsonic aerodynamic representation is reviewed, and the FLEXSTAB CPS is evaluated with respect to these general requirements. The effects of residual flexibility techniques on dynamic loads analyses are also evaluated using a simple dynamic model.

Miller, R. D.↗

NASA NTRS1973

Dynamic characterization of solid rockets

The structural dynamics of solid rockets in-general was studied. A review is given of the modes of vibration and bending that can exist for a solid propellant rocket, and a NASTRAN computer model is included. Also studied were the dynamic properties of a solid propellant, polybutadiene-acrylic acid-acrylonitrile terpolymer, which may be used in the space shuttle rocket booster. The theory of viscoelastic materials (i.e, Poisson's ratio) was employed in describing the dynamic properties of the propellant. These studies were performed for an eventual booster stage development program for the space shuttle.

Source record↗

NASA NTRS1976

A dynamic pressure source for the calibration of pressure transducers

A dynamic pressure source is described for producing sinusoidally varying pressures of up to 34 kPa zero to peak, over the frequency range of approximately 50 Hz to 2 kHz. The source is intended for the dynamic calibration of pressure transducers. The transducer to be calibrated is mounted near the base of the thick walled aluminum tube forming the vessel so that the pressure sensitive element is in contact with the liquid in the tube. A section of the tube is filled with small steel balls to damp the motion of the 10-St dimethyl siloxane working fluid in order to extend the useful frquency range to higher frequencies than would be provided by an undamped system. The dynamic response of six transducers provided by the sponsor was evaluated using the pressure sources; the results of these calibrations are given.

Vezzetti, C. F.↗

NASA NTRS1976

Use of dynamic theory to describe experimental results from volume holography

The general applicability of dynamic theory to the description of the recording and readout characteristics of volume (thick) hologram gratings is indicated. In dynamic theory (as opposed to static theory), the volume nature of the thick holographic grating allows the interference of an incident light beam with its own diffracted beam inside the recording medium. This effect causes the continuous recording of another grating that alters the initial one, producing a resultant grating that is not uniform through the thickness of the recording material and a grating whose writing and reading characteristics may vary dramatically, depending on the recording material and the experimental conditions. A large number of diverse types of writing, reading, and angular-selectivity behavior have been reported. The dynamic theory of thick-hologram writing and reading is shown to predict qualitatively all of these various types of experimental behavior.

Magnusson, R.↗

NASA NTRS1975

The dynamic transfer function for a cavitating inducer

Knowledge of the dynamic performance of pumps is essential for the prediction of transient behavior and instabilities in hydraulic systems; the necessary information is in the form of a transfer function which relates the instantaneous or fluctuating pressure and mass flow rate at inlet to the same quantities in the discharge from the pump. The presence of cavitation within the pump can have a major effect on this transfer function since dynamical changes in the volume of cavitation contribute to the difference in the instantaneous inlet and discharge mass flow rates. The present paper utilizes results from free streamline cascade theory to evaluate the elements in the transfer function for a cavitating inducer and shows that the numerical results are consistent with the characteristics observed in some dynamic tests on rocket engine turbopumps.

Brennen, C.↗

NASA NTRS1975

Track-train dynamics

The purpose of this paper is to outline one of the serious dynamic problems involving railroad cars and to propose an orderly approach to the definition of a dynamic model through analysis and testing that can be used to investigate various fixes. The problem in question is the hunting phenomenon involving lateral instability of the car suspension (trucks). This phenomenon has been recognized as a major contributing factor in a significant number of derailments causing millions of dollars in losses. This paper expounds on the mechanics and characteristics of hunting. The planned solution is outlined as a building block approach directed at formulating a test verified dynamic model of an open hopper freight car-truck assembly. Results obtained to date are presented together with conclusions related to the program.

Abbott, P. W.↗

NASA NTRS1976

Matrix perturbation for structural dynamic analysis

The objective of the effort was to investigate methodologies to reduce the cost of evaluating changes in dynamic loads when small modifications are made in the structure. A matrix perturbation technique has been developed to calculate the dynamic responses of a structural system that has been modified from the original design. The calculation is based on the results of the original design and the assumption that the structural modification is small. The advantage of the method is an update of the dynamic response due to design changes without performing an entire analysis. This procedure can be used in a design load analysis cycle in which the structural design is subject to frequent changes. A sample problem is given to demonstrate the validity of the technique.

Chen, J. C.↗

NASA NTRS1976

Application of a novel finite difference method to dynamic crack problems

A versatile finite difference method (HEMP and HEMP 3D computer programs) was developed originally for solving dynamic problems in continuum mechanics. It was extended to analyze the stress field around cracks in a solid with finite geometry subjected to dynamic loads and to simulate numerically the dynamic fracture phenomena with success. This method is an explicit finite difference method applied to the Lagrangian formulation of the equations of continuum mechanics in two and three space dimensions and time. The calculational grid moves with the material and in this way it gives a more detailed description of the physics of the problem than the Eulerian formulation.

Chen, Y. M.↗

NASA NTRS1976

Comparisons of several aerodynamic methods for application to dynamic loads analyses

The results of a study are presented in which the applicability at subsonic speeds of several aerodynamic methods for predicting dynamic gust loads on aircraft, including active control systems, was examined and compared. These aerodynamic methods varied from steady state to an advanced unsteady aerodynamic formulation. Brief descriptions of the structural and aerodynamic representations and of the motion and load equations are presented. Comparisons of numerical results achieved using the various aerodynamic methods are shown in detail. From these results, aerodynamic representations for dynamic gust analyses are identified. It was concluded that several aerodynamic methods are satisfactory for dynamic gust analyses of configurations having either controls fixed or active control systems that primarily affect the low frequency rigid body aircraft response.

Kroll, R. I.↗

NASA NTRS1977

Analysis of dynamic inlet distortion applied to a parallel compressor model

An investigation of surge was conducted by using a parallel compressor model of the J85-13 compressor implement on an analog computer. Surges were initiated by various types of dynamic disturbances in inlet pressure. The compressor model was less sensitive to disturbances of short duration, high frequency, and long duration where the compressor discharge pressure could react. Adding steady distortion to dynamic disturbances reduced the amount of dynamic disturbance required to effect surge. Steady and unsteady distortions combined linearly to reduce surge margin.

Wenzel, L. M.↗

NASA NTRS1977

Application of system identification to analytic rotor modeling from simulated and wind tunnel dynamic test data, part 2

An introduction to aircraft state and parameter identification methods is presented. A simplified form of the maximum likelihood method is selected to extract analytical aeroelastic rotor models from simulated and dynamic wind tunnel test results for accelerated cyclic pitch stirring excitation. The dynamic inflow characteristics for forward flight conditions from the blade flapping responses without direct inflow measurements were examined. The rotor blades are essentially rigid for inplane bending and for torsion within the frequency range of study, but flexible in out-of-plane bending. Reverse flow effects are considered for high rotor advance ratios. Two inflow models are studied; the first is based on an equivalent blade Lock number, the second is based on a time delayed momentum inflow. In addition to the inflow parameters, basic rotor parameters like the blade natural frequency and the actual blade Lock number are identified together with measurement bias values. The effect of the theoretical dynamic inflow on the rotor eigenvalues is evaluated.

Hohenemser, K. H.↗

NASA NTRS1977

Calculated Dynamic Characteristics of a Soft-Inplane Hingeless Rotor Helicopter

Calculated dynamic characteristics of a representative soft-inplane hingeless rotor helicopter are presented. The flight dynamics as a function of speed and gross weight are given. The requirements for accurate analytical modelling of this helicopter are established. The influence of the horizontal tail size, the rotor precone, the blade sweep, and the blade center of gravity/aerodynamic center offset on the calculated flight dynamics and aeroelastic stability are examined. The calculations show no evidence of an air resonance stability problem with this aircraft.

Johnson, W.↗

NASA NTRS1977

Experimental and analytical dynamic flow characteristics of an axial-flow fan from an air cushion landing system model

An investigation was conducted to compare the steady-state and dynamic flow characteristics of an axial-flow fan which had been used previously as the air supply fan for some model air cushion landing system studies. Steady-state flow characteristics were determined in the standard manner by using differential orifice pressures for the flow regime from free flow to zero flow. In this same regime, a correlative technique was established so that fan inlet and outlet pressures could be used to measure dynamic flow as created by a rotating damper. Dynamic tests at damper frequencies up to 5 Hz showed very different flow characteristics when compared with steady-state flow, particularly with respect to peak pressures and the pressure-flow relationship at fan stall and unstall. A generalized, rational mathematical fan model was developed based on physical fan parameters and a steady-state flow characteristic. The model showed good correlation with experimental tests at damper frequencies up to 5 Hz.

Thompson, W. C.↗

NASA NTRS1977

Comparison of dynamic stall phenomena for pitching and vertical translation motions

Test data for vertical translation motions of the V0012 and V23010-1.58 airfoils were compared with force pitch and oscillation data to determine qualitative differences in dynamic stall behavior. Chordwise differential pressure variations were examined in detail for the test conditions displaying dynamic stall. The comparison revealed a number of differences both in the onset of stall and in the progression separation as a function of the type of motion. The evidence of secondary stall events following the recovery from initial stall were found to be dependent on the type of motion, but additional data will be needed to incorporate vertical translation effects into the empirical approximation of dynamic stall.

Fukushima, T.↗

NASA NTRS1976

On a finite dynamic element method for free vibration analysis of structures

This paper explores the concept of finite dynamic elements involving higher order dynamic correction terms in the associated stiffness and mass matrices. Such matrices are then developed for a rectangular prestressed membrane element. Next, efficient analysis techniques for the eigenproblem solution of the resulting quadratic matrix equations are described in detail. These are followed by suitable numerical examples which indicate that employment of such dynamic elements in conjunction with an efficient quadratic matric solution technique will result in a most significant economy in the free vibration analysis of structures.

Gupta, K. K.↗

NASA NTRS1976

Upper tropospheric dynamics as reflected in Nimbus 4 THIR 6.7-micron data

An investigation was conducted of the spatial and temporal relationships existing between the radiometrically observed water vapor patterns in cloud free areas and the conventionally derived water vapor patterns. The upper and middle tropospheric water vapor budget and the associated dynamics were examined to obtain a basis for a more definite evaluation of the significance of the Nimbus 4 radiometric 6.7-micrometer observations for the study of tropospheric dynamics in cloud free areas. A large-amplitude trough situated to the lee of the Rocky Mountains over the central U.S. between April 30 and May 1, 1970, was selected for the investigation because it best illustrated large upper tropospheric dynamic variations.

Rodgers, E. B.↗

NASA NTRS1976

Cardiorespiratory deconditioning with static and dynamic leg exercise during bed rest

Results are presented for an experimental study designed to compare the effects of heavy static and dynamic exercise training during 14 days of bed rest on the cardiorespiratory responses to submaximal and maximal exercise performed by seven healthy men aged 19-22 yr. The parameters measured were submaximal and maximal oxygen uptake, minute ventilation, heart rate, and plasma volume. The results indicate that exercise alone during bed rest reduces but does not eliminate the reduction in maximal oxygen uptake. An additional positive hydrostatic effect is therefore necessary to restore maximal oxygen uptake to ambulatory control levels. The greater protective effect of static exercise on maximal oxygen uptake is probably due to a greater hydrostatic component from the isometric muscular contraction. Neither the static nor the dynamic exercise training regimes are found to minimize the changes in all the variables studied, thereby suggesting a combination of static and dynamic exercises.

Stremel, R. W.↗

NASA NTRS1977

The effects of flow separation on shuttle dynamics and aeroelastic stability

The effects of flow separation on the dynamic and aeroelastic stability of various shuttle configurations have been investigated. Flow separation is shown to affect the aeroelastic stability of the 747/Orbiter yaw modes, the orbiter dynamic stability and possibly the aeroelastic stability of the wing torsional mode, and to dominate both the dynamic and aeroelastic stability of the launch configuration. Limit cycle oscillations of certain launch configuration modes are the result of sudden flow separation. The limit cycle oscillations threaten the structural integrity in two ways: (1) by outright overstressing of the structure due to large modal deflection, (2) by fatigue due to the continued flexing of the structure. Fatigue is a more significant consideration for the reusable (100 flights) shuttle than it has been for previous space boosters.

Reding, J. P.↗