Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “determinants”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 811 records · Page 45
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

Determination of the key parameters affecting historic communications satellite trends

Data representing 13 series of commercial communications satellites procured between 1968 and 1982 were analyzed to determine the factors that have contributed to the general reduction over time of the per circuit cost of communications satellites. The model by which the data were analyzed was derived from a general telecommunications application and modified to be more directly applicable for communications satellites. In this model satellite mass, bandwidth-years, and technological change were the variable parameters. A linear, least squares, multiple regression routine was used to obtain the measure of significance of the model. Correlation was measured by coefficient of determination (R super 2) and t-statistic. The results showed that no correlation could be established with satellite mass. Bandwidth-year however, did show a significant correlation. Technological change in the bandwidth-year case was a significant factor in the model. This analysis and the conclusions derived are based on mature technologies, i.e., satellite designs that are evolutions of earlier designs rather than the first of a new generation. The findings, therefore, are appropriate to future satellites only if they are a continuation of design evolution.

Namkoong, D.↗
NASA NTRS1984

A new method for determining acoustic-liner admittance in a rectangular duct with grazing flow from experimental data

A method is developed for determining acoustic liner admittance in a rectangular duct with grazing flow. The axial propagation constant, cross mode order, and mean flow profile is measured. These measured data are then input into an analytical program which determines the unknown admittance value. The analytical program is based upon a finite element discretization of the acoustic field and a reposing of the unknown admittance value as a linear eigenvalue problem on the admittance value. Gaussian elimination is employed to solve this eigenvalue problem. The method used is extendable to grazing flows with boundary layers in both transverse directions of an impedance tube (or duct). Predicted admittance values are compared both with exact values that can be obtained for uniform mean flow profiles and with those from a Runge Kutta integration technique for cases involving a one dimensional boundary layer.

Watson, W. R.↗
NASA NTRS1983

Experimental determination of the inertia constants of an airplane or of a missile

The possibility to measure the inertia constants of an airplane or of a missile by a unique experimental set up without having to materialize axes of rotation was investigated. It is sufficient to suspend the structure appropriately, to obtain the six natural modes determined by the suspension and to introduce these results as data into a computer. If the structure is very flexible it is necessary to take into account the first natural modes of deformation. Experiments on rigid and flexible models led to precise results and allow consideration of full scale measurements. The final goal is to provide, by a standard ground vibration test completed by the measured characteristics of the suspension modes, the set of data necessary for flutter calculations and for the determination of all the inertia constants.

Loiseau, H.↗
NASA NTRS1983

On the determination of airplane model structure form flight data

A procedure based on a modified stepwise regression and several selection criteria is presented for the determination of airplane model structure from flight data. The aerodynamic force and moment coefficients in an airplane model are expresed either as polynomials in output and input variables or as a combination of splines. The procedure is demonstrated in three examples by attempting to determine a local, extended and global model. Some of the resulting models are verified by using the maximum likelihood estimation or by examining model prediction capabilities.

Klein, V.↗
NASA NTRS1984

Determining asteroid masses from perturbations on Mars

The orbit of Mars is perturbed more than 5 m, a value compatible with the accuracy of the Viking Lander ranging data, by about three dozen asteroids. In addition to larger asteroids throughout the belt, significant perturbations of long period are generated by smaller objects near commensurabilities with Mars. The largest periodic terms induced by 1 Ceres and 2 Pallas have amplitudes of 0.8 and 0.2 km, respectively, both with 10-year periods. Due to a near commensurability, 4 Vesta causes a 5-km, 52-year term. While the Viking ranges will yield significant mass determinations for the largest three asteroids, and some of the smaller bodies should be detectable, it will be difficult to separate the smaller bodies with useful accuracies. Accurate discrimination must await range data from future missions to Mars or other bodies in the neighborhood of the asteroid belt. The Viking ranges can also yield improved masses for the outer planets (except Pluto), an application which is being exploited by groups analyzing these data. Uncertainties in the asteroid masses limit the ultimate accuracy of the Viking determinations of both the long time scale motion of the system of the inner four planets with respect to an inertial frame and the rate of change of the gravitational constant.

Williams, J. G.↗
NASA NTRS1984

Definitive orbit determination for the HEAO-2 spacecraft

Precise ephemerides for the High Energy Astronomy Observatory-2 (HEAO-2) were computed to assist in the Charles Stark Draper Laboratory development of an onboard orbit determination technique. Weighted least-squares, batch orbit solutions were calculated using a high-precision earth gravity model and an approximate model for intermittent spacecraft thrusting. With these improvements, orbit solution consistencies at the 50- to 100-meter level were attained using the Goddard Trajectory Determination System and NASA S-band tracking data.

Smith, R. L.↗
NASA NTRS1984

Determining highly elliptical earth orbits with VLBI and Delta-VLBI

This paper shows the feasibility of using Very Long Baseline Interferometric (VLBI) data acquired by the Deep Space Network to navigate highly elliptical earth orbiting satellites. The planned mission orbit of the Ion Release Module of the Active Magnetospheric Particle Tracer Explorers is used as a reference for developing strategies and provides the first opportunity for a possible flight demonstration with a spacecraft in a highly elliptical orbit. The navigation accuracy improvements achievable with VLBI and Delta-VLBI data types are determined for comparison with the capabilities of a reference Doppler strategy. The results show that strategies using wideband Delta-VLBI measurements taken near periapse perform best, determining apoapse position to an order of magnitude better than conventional Doppler, while also substantially reducing the required antenna support.

Frauenholz, R. B.↗
NASA NTRS1984

Feasibility of determining cloud-top heights using the backscattered ultraviolet satellite observation technique

A technique for determining cloud-top height by means of backscattered ultraviolet (BUV) solar radiation is presented. Cloud-top heights can be inferred using this technique of both the BUV radiance and its degree of polarization are measured by a spacecraft and compared with theoretical values. The cases of satellites with high-inclination orbits and geosynchronous satellites are discussed here. Based on calculations of radiance and polarization, the resolutions of cloud-top height determinations are roughly estimated in both cases. The estimates show that inference is possible as long as the angle between the direction of the sun and the satellite from the point of interest in the atmosphere is larger than about 10 deg. The estimates also indicate that the cloud-top-height resolution depends on solar zenith angle theta(0) in the case of nadir observation by satellites in nonequatorial orbits: The resolution is about 0.5 km for theta(0) = 30 and about 0.3 km for larger theta(0). On the other hand, when observations are made by geosynchronous satellites, the resolution depends strongly on the latitude of the point of interest, alpha(1); a resolution within 0.4 km can be achieved for alpha(1) less than or equal to 65 deg (0.2 km resolution can be obtained for middle latitudes). Resolution becomes rapidly worse with increasing latitude, and alpha(1) = about 70 deg seems to be the limit of observations with this technique.

Aruga, T.↗
NASA NTRS1985

Doubly-Differenced Measurements for Orbit Determinations

Report describes accurate method of determining orbit of low-altitude Earth satellite. Method insensitive to clock errors and provides continuous determination of orbit. Report examines effects of employing fewer ground stations, applying different solution strategies, and introducing fictitious thrust parameters to minimize geopotential modeling error - one of major error sources.

Wu, S. C.↗
NASA NTRS1986

Determining Calibration Constants for Attitude Measurements

Algorithm based on method of least squares determines calibration constants of seismic instruments for precise attitude measurements. Algorithm programed and run successfully on commercially available desk-top computer. Simplifies determinations of accelerometer calibration constants, and used in field to verify accelerometer stability.

Tcheng, P.↗
NASA NTRS1984

Section 1. Method of determining mode shapes and natural frequencies of the NASA unmodified test structure. Section 2. Continuous beam closed from solution to the NASA-LSS astromast torsional vibration, appendix E

The methods used to determine the lower natural frequencies and their corresponding mode shapes of the NASA-LSS Astromast (Unmodified Test Structure), and the mass integrals associated with the mode shapes are illustrated. The test structure is modeled as a cantilever beam with 91 lumped masses and without the tip mass on the free end of the bram. This uncouples the torsion and bending modes and allows for them to be determined separately. The frequency range was limited to an upper bound of 100 rad/sec (15.92 Hz.). In this range from 0.-100. rad/sec, three bending frequencies and one torsion frequency was found.

Source record↗
NASA NTRS1985

Determining Mineral Types and Abundances from Reflectance Measurements

Mineral types and their abundances were quantitatively determined from laboratory reflectance spectra using principal components analysis (PCA). PCA reduced the measured spectral dimensionality and allowed testing the uniqueness and validity of spectral mixing models. In addition to interpreting absorption bands, in this new approach we interpreted variations in the overall spectral curves in terms of physical processes, namely changes in mixtures of minerals, in particle size and in illumination geometry. Application of this approach to reflectances of planetary surfaces allows interpretation to be extended to quantitative determinations of mineral types and abundances.

Smith, M. O.↗
NASA NTRS1984

FTIR-spectrometer-determined absorption coefficients of seven hydrazine fuel gases - Implications for laser remote sensing

The absorption spectra of three hydrazines and four of their air-oxidation products were measured in the 9-12-micron spectral region with a Fourier transform infrared (FTIR) spectrometer with a 0.05-kayser resolution to determine absorption coefficients at CO2 and tunable diode laser wavelengths. The measurements agreed well with published CO2 laser determinations for many of the absorption coefficients, except where the published values are thought to be in error. The coefficients were then used to estimate the sensitivity for remote detection of these gases using CO2 and tunable diode lasers in long-path differential absorption measurements.

Molina, L. T.↗
NASA NTRS1984

Practical flight test method for determining reciprocating engine cooling requirements

It is pointed out that efficient and effective cooling of air-cooled reciprocating aircraft engines is a continuing problem for the general aviation industry. Miley et al. (1981) have reported results of a study regarding the controlling variables for cooling and installation aerodynamics. The present investigation is concerned with experimental methods which were developed to determine cooling requirements of an instrumented prototype or production aircraft, taking into account a flight test procedure which has been refined and further verified with additional testing. It is shown that this test procedure represents a straightforward means of determining cooling requirements with minimal instrumentation. Attention is given to some background information, the development history of the NACA cooling correlation method, and the proposed modification of the NACA cooling correlation.

Ward, D. T.↗
NASA NTRS1983

Orbiter spacecraft weight and center of gravity determination

This paper describes the procedure for determination of the weight and the location of the center of gravity (c.g.) of a Space Shuttle Orbiter Spacecraft, at the Kennedy Space Center, Florida. This task is performed at the completion of the horizontal processing of each Orbiter in conjunction with jack down and preparation for vertical mating to the Shuttle launch vehicle. The operation is performed in the Orbiter Processing Facility. The paper contains a brief description of the general characteristics and physical dimensions of the Orbiter spacecraft, the program requirements and test procedure for weight and c.g. determination, data evaluation and a summary.

Fraley, J. G.↗
NASA NTRS1985

A homotopy continuation method for general preliminary orbit determination and special application to the Tracking and Data Relay Satellite System

A recent mathematical technique for solving systems of equations is applied in a very general way to the orbit determination problem. The use of this technique, the homotopy continuation method, was motivated by the possible need to perform preliminary orbit determination in the Tracking and Data Relay Satellite System (TDRSS), using range and Doppler tracking alone. In the formulation studied here, a set of six tracking observations is continuously transformed from a set with known solutions to the given set with unknown solutions, and the corresponding orbit state vector is followed from the a priori orbit state to the solution orbit states. A modular numerical algorithm is developed to follow the state vector. The technique is formulated and then tested, using both real and simulated tracking, with positive results. Direct comparisons show that the basic method has a much larger radius of convergence than standard or simply modified Newton-Raphson methods. An extension of the basic method is formulated that is expected to produce a global method.

Smith, R. L.↗
NASA NTRS1985

An evaluation of Global Positioning System data for Landsat-4 orbit determination

The Navstar Global Positioning System (GPS) navigation data obtained from an experimental GPS receiver/processor package (GPSPAC) onboard the Landsat-4 spacecraft are evaluated for their accuracy and reliability for use in Landsat-4 orbit determination. Different orbit determination scenarios and methods are considered. The parameters estimated include a subset of three Landsat-4 clock parameters and an atmospheric drag coefficient, in addition to the orbital elements. It is found that Landsat-4 orbit solutions based on delta pseudorange data generally agree with the definitive solutions to the 50-meter level.

Fang, B. T.↗
NASA NTRS1983

A large area experiment to determine cosmic ray isotopic abundances

Measurements of the isotopic composition of cosmic rays have shown that the cosmic ray isotope ratios, Ne-22/Ne-20 and (Mg-25 + Mg-26)/Mg-24, exceed the solar abundance ratios by factors of 2.7 and 1.8, respectively. There are several processes which could be responsible for the observed excess of neutron-rich isotopes. The considered models imply neutron enrichment in the case of other, less abundant species, and a measurement of the involved isotopic abundances could provide a basis for the determination of the dominating processes occurring in cosmic ray sources. However, an experiment utilizing special equipment is necessary to conduct the required measurements. Such an experiment, the Aluminum Isotopic Composition Experiment (Alice), is being designed in a joint effort involving NASA and a West German university. Alice uses a Cherenkov-range technique to determine the isotopic composition of elements from oxygen through argon.

Mauger, B. G.↗