Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Dynamical”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 811 records · Page 45

Study of methods of improving the performance of the Langley Research Center Transonic Dynamics Tunnel (TDT)

A study has been made of possible ways to improve the performance of the Langley Research Center's Transonic Dynamics Tunnel (TDT). The major effort was directed toward obtaining increased dynamic pressure in the Mach number range from 0.8 to 1.2, but methods to increase Mach number capability were also considered. Methods studied for increasing dynamic pressure capability were higher total pressure, auxiliary suction, reducing circuit losses, reduced test medium temperature, smaller test section and higher molecular weight test medium. Increased Mach number methods investigated were nozzle block inserts, variable geometry nozzle, changes in test section wall configuration, and auxiliary suction.

Source record↗

Analysis of oscillatory pressure data including dynamic stall effects

The dynamic stall phenomenon was examined in detail by analyzing an existing set of unsteady pressure data obtained on an airfoil oscillating in pitch. Most of the data were for sinusoidal oscillations which penetrated the stall region in varying degrees, and here the effort was concentrated on the chordwise propagation of pressure waves associated with the dynamic stall. It was found that this phenomenon could be quantified in terms of a pressure wave velocity which is consistently much less than free-stream velocity, and which varies directly with frequency. It was also found that even when the stall region has been deeply penetrated and a substantial dynamic stall occurs during the downstroke, stall recovery near minimum incidence will occur, followed by a potential flow behavior up to stall inception.

Carta, F. O.↗

Generalized dynamic engine simulation techniques for the digital computer

Recently advanced simulation techniques have been developed for the digital computer and used as the basis for development of a generalized dynamic engine simulation computer program, called DYNGEN. This computer program can analyze the steady state and dynamic performance of many kinds of aircraft gas turbine engines. Without changes to the basic program DYNGEN can analyze one- or two-spool turbofan engines. The user must supply appropriate component performance maps and design-point information. Examples are presented to illustrate the capabilities of DYNGEN in the steady state and dynamic modes of operation. The analytical techniques used in DYNGEN are briefly discussed, and its accuracy is compared with a comparable simulation using the hybrid computer. The impact of DYNGEN and similar all-digital programs on future engine simulation philosophy is also discussed.

Sellers, J.↗

The Coanda effect in gas-dynamic noise control

The principle types of silencers are discussed for gas dynamic noise of free steam and gas expansions, as well as the results of research in gas dynamics of jets and applied acoustics. Gas dynamic noise attenuation by means of the Coanda effect is due to fluid decompression in a Coanda ejector of the external type, where a structural change takes place in the acoustic frequency spectrum and in its direction, as well as a substantial decrease in the fluid's velocity, temperature and concentration. This process is continued in the second phase with absorption of the acoustic waves by means of an active structure.

Vasilescu, G.↗

The effect of simulator dynamics on pilot response

The effects of visual display dynamics on the altitude tracking performance of a subject in a fixed base flight simulator are considered. The subject, flying the linearized longitudinal equations of motion, attempts to maintain the same altitude as two airplanes positioned three hundred feet ahead, as in level formation flying. The horizon together with the two leading aircraft are represented symbolically on a CRT display. The subject's aircraft is disturbed by atmospheric turbulence. The data indicate a relationship between the bandwidth of the display dynamics and the short period characteristics of the simulated airplane. For an airplane with a relatively fast pitch response the presence of altitude display dynamics, with a bandwidth as high as five times the short period natural frequency, causes significant degradation of altitude tracking performance.

Weener, E. F.↗

Analysis of dynamic stall using unsteady boundary-layer theory

The unsteady turbulent boundary layer and potential flow about a pitching airfoil are analyzed using numerical methods to determine the effect of pitch rate on the delay in forward movement of the rear flow reversal point. An explicit finite difference scheme is used to integrate the unsteady boundary layer equations, which are coupled at each instant of time to a fully unsteady and nonlinear potential flow analysis. A substantial delay in forward movement of the reversal point is demonstrated with increasing pitch rate, and it is shown that the delay results partly from the alleviation of the gradients in the potential flow, and partly from the effects of unsteadiness in the boundary layer itself. The predicted delay in flow-reversal onset, and its variation with pitch rate, are shown to be in reasonable agreement with experimental data relating to the delay in dynamic stall. From the comparisons it can be concluded (a) that the effects of time-dependence are sufficient to explain the failure of the boundary layer to separate during the dynamic overshoot, and (b) that there may be some link between forward movement of the reversal point and dynamic stall.

Scruggs, R. M.↗

Dynamic properties of aircraft tires

A research program has investigated the use of the von Schlippe string-type tire model for predicting the dynamic behavior of aircraft tires. The transfer-function method was used for theory evaluation. A more flexible two-constant modification to the string theory tire model is presented. Experiments were conducted on four types of scale model aircraft tires. Two types were of conventional bias construction, one type was an isotropic toroid, and one type was of unbelted radial construction. The conventional string theory and model gave predictions that were in good agreement with experimental data for bias constructed tires. The two-constant modification to string theory provided better agreement between predictions and experiment for the unconventional tires. The results indicate that the string theory tire model using static and slow-rolling tire properties predicts dynamic aircraft tire properties that have the same trends as the measured dynamic properties and, in most cases, provides good quantitative agreement.

Clark, S. K.↗

Evaluation of experimental methods for determining dynamic stiffness and damping of composite materials

Various methods potentially usable for determining dynamic stiffness and damping of composite materials are reviewed. Of these, the following most widely used techniques are singled out for more detailed discussion: free vibration, pulse propagation, and forced vibration response. To illustrate the usefulness and validity of dynamic property data, their application in dynamic analyses and comparison with measured structural response are described for the following composite-material structures: free-free sandwich beam with glass-epoxy facings, clamped-edge sandwich plate with similar facings, free-end sandwich conical shell with similar facings, and boron-epoxy free plate with layers arranged at various orientations.

Bert, C. W.↗

Measurement of dynamic cross-derivatives due to pitching and yawing

A novel wind-tunnel apparatus is described with which all the 12 static and dynamic moment derivatives due to pitching and yawing can be obtained at angles of attack up to 40 deg and in the presence of some sideslip. The experimental technique and the data reduction procedure are discussed, and preliminary data on dynamic derivatives for an aircraft-like configuration at M ? 0.70 are presented. It is shown that in the range of angle of attack investigated, some rather large variations occur in both the two direct damping derivatives and some of the dynamic cross-derivatives; the latter, however, remain small as compared to the corresponding direct damping derivatives (in general less than 10%).

Orlik-Rueckemann, K. J.↗

Generalized dynamic engine simulation techniques for the digital computer

Recently advanced simulation techniques have been developed for the digital computer and used as the basis for development of a generalized dynamic engine simulation computer program, called DYNGEN. This computer program can analyze the steady state and dynamic performance of many kinds of aircraft gas turbine engines. Without changes to the basic program, DYNGEN can analyze one- or two-spool turbofan engines. The user must supply appropriate component performance maps and design-point information. Examples are presented to illustrate the capabilities of DYNGEN in the steady state and dynamic modes of operation. The analytical techniques used in DYNGEN are briefly discussed, and its accuracy is compared with a comparable simulation using the hybrid computer. The impact of DYNGEN and similar all-digital programs on future engine simulation philosophy is also discussed.

Sellers, J.↗

Silverton Conference on Applications of the Zero Gravity Space Shuttle Environment to Problems in Fluid Dynamics

The possible utilization of the zero gravity resource for studies in a variety of fluid dynamics and fluid-dynamic related problems was investigated. A group of experiments are discussed and described in detail; these include experiments in the areas of geophysical fluid models, fluid dynamics, mass transfer processes, electrokinetic separation of large particles, and biophysical and physiological areas.

Eisner, M.↗

Generalized dynamic engine simulation techniques for the digital computers

Recently advanced simulation techniques have been developed for the digital computer and used as the basis for development of a generalized dynamic engine simulation computer program, called DYNGEN. This computer program can analyze the steady state and dynamic performance of many kinds of aircraft gas turbine engines. Without changes to the basic program, DYNGEN can analyze one- or two-spool turbofan engines. The user must supply appropriate component performance maps and design point information. Examples are presented to illustrate the capabilities of DYNGEN in the steady state and dynamic modes of operation. The analytical techniques used in DYNGEN are briefly discussed, and its accuracy is compared with a comparable simulation using the hybrid computer. The impact of DYNGEN and similar digital programs on future engine simulation philosophy is also discussed.

Sellers, J.↗

Some aspects of control of a large-scale dynamic system

Techniques of predicting and/or controlling the dynamic behavior of large scale systems are discussed in terms of decentralized decision making. Topics discussed include: (1) control of large scale systems by dynamic team with delayed information sharing; (2) dynamic resource allocation problems by a team (hierarchical structure with a coordinator); and (3) some problems related to the construction of a model of reduced dimension.

Aoki, M.↗

Comparison of human driver dynamics in simulators with complex and simple visual displays and in an automobile on the road

As part of a comprehensive program exploring driver/vehicle system response in lateral steering tasks, driver/vehicle system describing functions and other dynamic data have been gathered in several milieu. These include a simple fixed base simulator with an elementary roadway delineation only display; a fixed base statically operating automobile with a terrain model based, wide angle projection system display; and a full scale moving base automobile operating on the road. Dynamic data with the two fixed base simulators compared favorably, implying that the impoverished visual scene, lack of engine noise, and simplified steering wheel feel characteristics in the simple simulator did not induce significant driver dynamic behavior variations. The fixed base vs. moving base comparisons showed substantially greater crossover frequencies and phase margins on the road course.

Mcruer, D. T.↗

Chordwise propagation of dynamic stall cells on an oscillating airfoil

The dynamic stall phenomenon was examined in detail by analyzing a set of unsteady pressure data obtained on an airfoil oscillating in pitch. These data were for sinusoidal oscillations which penetrated the stall region in varying degrees, and here the effort was concentrated on the chordwise propagation of pressure waves associated with the dynamic stall. It was found that this phenomenon could be quantified in terms of a pressure wave velocity which is consistently much less than free-stream velocity, and which varies directly with frequency. It was also found that even when the stall region has been deeply penetrated and a substantial dynamic stall occurs during the downstroke, stall recovery near minimum incidence will occur, followed by a potential flow behavior up to stall inception.

Carta, F. O.↗

The solar wind and magnetospheric dynamics

The dynamic processes involved in the interaction between the solar wind and the earth's magnetosphere are reviewed. The evolution of models of the magnetosphere is first surveyed. The existence of the auroral substorm and the cyclical polar magnetic substorm is evidence that the magnetosphere is a dynamic system. The dynamic changes occurring in the magnetosphere, including erosion of the magnetopause, changes in the size of the polar cap, variations in the flaring angle of the tail, neutral point formation, plasma sheet motions, and the inward collapse of the midnight magnetosphere, are discussed. The cyclical variations of geomagnetic activity are explained in terms of the control of the solar wind-magnetosphere interaction by the north-south component of the interplanetary magnetic field. Present phenomenological models allow prediction of geomagnetic activity from interplanetary measurements, but modeling of detailed magnetospheric processes is still in its infancy.

Russell, C. T.↗

Dynamic stall experiments on oscillating airfoils

Dynamic stall and unsteady boundary layer separation have been studied in incompressible flow at moderately large Reynolds numbers. By varying the leading-edge geometry of an NACA 0012 airfoil, three different types of stall were produced. For most of the configurations studied, including the basic NACA 0012 profile, dynamic stall was found not to originate with the bursting of a leading-edge laminar separation bubble, as is commonly believed. Instead, the vortex shedding phenomenon, which is the predominant feature of dynamic stall, appears to be fed its vorticity by the breakdown of the turbulent boundary layer.

Mccroskey, W. J.↗

Dynamic sampling of laser-induced vapor plumes by mass spectrometry

Mass spectrometric techniques and instrumentation for the dynamic sampling of laser-induced vapor clouds during their submillisecond expansion periods are discussed. Illustrations are drawn primarily from the results of pulsed-laser heating of some oxides and graphites; these include comparisons of incident laser beam pulses with the resultant pulses of positive ions and selected neutral species. Observed characteristics of vapor pulses from graphite are shown to correlate with calculated surface temperature response. Dynamic velocity measurements of individual vapor species are described and, from these velocities, vaporization temperatures are derived and compared using four gas dynamic models for vapor expansion into vacuum. Additional measurements indicate that the laser beam may interact directly with the neutral vapors to produce ions.

Lincoln, K. A.↗