Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Antenna array”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 811 records · Page 45

The effects of receiver tracking phase error on the performance of the concatenated Reed-Solomon/Viterbi channel coding system

Analytical and experimental results are presented of the effects of receiver tracking phase error, caused by weak signal conditions on either the uplink or the downlink or both, on the performance of the concatenated Reed-Solomon (RS) Viterbi channel coding system. The test results were obtained under an emulated S band uplink and X band downlink, two way space communication channel in the telecommunication development laboratory of JPL with data rates ranging from 4 kHz to 20 kHz. It is shown that, with ideal interleaving, the concatenated RS/Viterbi coding system is capable of yielding large coding gains at very low bit error probabilities over the Viterbi decoded convolutional only coding system. Results on the effects of receiver tracking phase errors on the performance of the concatenated coding system with antenna array combining are included.

Liu, K. Y.↗

A broadband RF continuously variable time delay device

A method for implementation of continuously variable time delay of broadband RF signals is described. The method uses Bragg Cell and optical heterodyne technology. The signal to be delayed is applied to the Bragg Cell acoustic transducer, and the delay time is the acoustic transit time from this transducer to the incident light beam. By translating the light beam, the delay is varied. Expressions describing the Bragg Cell diffraction, lens Fourier transformation, and the optical heterodyne processes are developed. Specifications for the variable delay including bandwidth, range of delay, and insertion loss are provided. Applications include radar signal processing, spread spectrum intercept, radar ECM, and adaptive array antenna processing.

Freyre, F. W.↗

Stabilizing Fiber-Optic Transmission Lines

Voltage-controlled optical phase shifter is key. Optical phase shifter stabilizes propagation delay of fiber-optic transmission line by compensating for temperature and pressure effects. Applicable to phased array antenna systems and very-long-baseline interferometer distribution systems.

Lutes, G. F.↗

Capabilities and limitations of existing MST radars: Poker Flat

Designed as a prototype system to continuously monitor the atmosphere up to approximately 100 km, the Poker Flat MST radar began operating in 1979 at a relatively low sensitivity. In almost continuous operation since then, the system is steadily increasing in sensitivity to its ultimate design characteristics. Current and final parameters are listed. The advantages of its modular design, which uses 64 transmitting modules distributed through the 200 mx 200 m antenna array include: easy maintenance, beam switching using very low power switching, air cooled transmitting tubes, lower feedline costs, and no moving parts. Continuous, uninterrupted operation ( 4 years) and less man-made interference because of the remote location) are other assets. Most disadvantages are related to its not-yet-finished status, climate, moose excursions, and operating expenses.

Balsley, B. B.↗

Design considerations for high-power VHF radar transceivers: Phase matching long coaxial cables using a cable radar

The Poker Flat 49.92-MHz MST radar uses 64 phase-controlled transmitters in individual shelters distributed throughout the antenna array. Phase control is accomplished by sampling the transmitted pulse at the directional coupler of each transmitter and sending the sample pulse back to a phase-control unit. This method requires phase matching 64 long (256 meter) coaxial cables (RG-213) to within several electrical degrees. Tests with a time domain reflectometer showed that attenuation of high frequency components in the long RG-213 cable rounded the leading edge of the reflected pulse so that the cables could only be measured to within 50 cm (about 45 deg at 49.92 MHz). Another measurement technique using a vector voltmeter to compare forward and reflected phase required a directional coupler with unattainable directivity. Several other techniques were also found lacking, primarily because of loss in the long RG-213 cables. At this point it was realized that what was needed was a simple version of the phase-coherent clear-air radar, i.e., a cable radar. The design and operation of this cable are described.

Johnson, P. E.↗

The mobile Sousy-Doppler radar: Technical design and first results

A mobile VHF Doppler system was developed. The electronic part is installed in a 20 ft container and tested using a special log periodic aerial to illuminate the 300 m dish. The system was extended by designing a mobile phased antenna array with finally 576 Yagi elements. The grouping of the single Yagis, the system of transmission lines, the phase shifters, the power splitters and the T/R switch are described. Results from the first two campaigns and a survey of future programs demonstrating the flexibility of this mobile system are summarized.

Czechowsky, P.↗

Symbol-stream Combiner: Description and Demonstration Plans

A system is described and demonstration plans presented for antenna arraying by symbol stream combining. This system is used to enhance the signal-to-noise ratio of a spacecraft signals by combining the detected symbol streams from two or more receiving stations. Symbol stream combining has both cost and performance advantages over other arraying methods. Demonstrations are planned on Voyager 2 both prior to and during Uranus encounter. Operational use is possible for interagency arraying of non-Deep Space Network stations at Neptune encounter.

Hurd, W. J.↗

Considerations for millimeter wave printed antennas

Calculated data are presented on the performance of printed antenna elements on substrates which may be electrically thick, as would be the case for printed antennas at millimeter wave frequencies. Printed dipoles and microstrip patch antennas on polytetrafluoroethylene (PTFE), quartz, and gallium arsenide substrates are considered. Data are given for resonant length, resonant resistance, bandwidth, loss due to surface waves, loss due to dielectric heating, and mutual coupling. Also presented is an optimization procedure for maximizing or minimizing power launched into surface waves from a multielement printed antenna array. The data are calculated by a moment method solution.

Pozar, D. M.↗

Far-infrared embedding impedance measurements

A technique which allows the measurement of detector embedding impedance has been developed. By using a bismuth microbolometer as a variable resistance load the impedance of one element in a bow-tie antenna array operating at 94 GHz was inferred. The technique is frequency insensitive, and could be used throughout the far-infrared.

Neikirk, D. P.↗

A note on the proposed UK VHF radar

The proposal for the establishment of a VHF radar in the UK is still under active consideration, although for financial reasons no start has yet been made on an installation. Several changes have been made to the scheme as described and these are listed. (1) The initial installation will be suitable for stratosphere-troposphere (ST) operation only using 64 antennas and 2 power modules. (2) An existing site is being examined on the west coast of Wales, which because it is a former Loran ground station is provided with the buildings, power and communications facilities to enable a radar to be assembled much more quickly than a green field site would allow. Because the site is not within a mountain valley as originally intended, careful early attention will have to be given to the possible problems of local interference and sea-surface returns. (3) Preliminary discussions with the UK licensing authorities suggest that a frequency of 47 MHz is more likely than 50 MHz. (4) Minor changes are planned in the antenna array connection scheme of the 400-element mesosphere-stratosphere-troposphere (MST) array to allow more precise sidelobe suppression to be achieved in the receive mode.

Hall, A. J.↗

Distributed synthetic aperture radar simulation

Synthetic aperture radar (SAR) depends primarily on attainable frequency resolution rather than on large physical size of the antenna array. The distributed architecture concept (DSAR) incorporates active elements (amplifiers) at or near the elemental radiators of the array. Since SAR's are expensive to build and expensive to test, a computer modeling approach is a feasible method of predicting the quality or nature of the SAR image from the proposed system parameters. The goal of this project is to produce a DSAR simulation software package. This report describes the progress made thus far and the work which remains to be done. Extensive work on this project had been done previously by two NASA contractors. The principal task remaining involved the creation of a suitable interface between these programs and the hardware and software available at the Johnson Space Center.

Bourgeois, B. A.↗

Remote sensing of the earth with spaceborne imaging radars

Recent scientific and technological developments are reviewed in the field of earth observation with spaceborne imaging radars. Such developments, beginning with Seasat in 1978 and continuing with the Space Shuttle in 1981 and 1984, were made possible by the use of new large spaceborne lightweight planar array antennas (2 x 10 m) with printed radiating elements. Transmitters were solid-state 1-kW peak power units operating at L-band (1.2 GHz). Images were obtained to monitor sea ice, soil moisture, and geologic, biologic and oceanographic features. Optical and digital processing was done to achieve high resolution (25 to 40 m). More advanced systems are under development, including multispectral, multipolarization imaging radar systems for flight in the late 1980s. An overview of planned activities in the 1980s is given.

Elachi, C.↗

Middle Atmosphere Program. Handbook for MAP, volume 20

Various topics related to investigations of the middle atmosphere are discussed. Numerical weather prediction, performance characteristics of weather profiling radars, determination of gravity wave and turbulence parameters, case studies of gravity-wave propagation, turbulence and diffusion due to gravity waves, the climatology of gravity waves, mesosphere-stratosphere-troposphere radar, antenna arrays, and data management techniques are among the topics discussed.

Bowhill, S. A.↗

Recent progress in the Urbana MST radar

The Urbana radar, which operates at 40.92 MHz with a peak power of about 1.2 MW into a 100 x 120 m phased array antenna was improved. An accelerated data-acquisition system, a beam-steering system, and a transmit/receive switch were installed. With these changes, the radar is in regular operations for two hours every day around local noon gathering stratospheric and mesospheric data. Special campaigns are mounted in addition under severe weather conditions.

Bowhill, S. A.↗

HISCAT: A proposed new scatter facility in Northern Scandinavia

It is proposed that a new versatile ionospheric and atmospheric scatter radar be constructed in northern Scandavia through a multinational collaborative effort. The new facility tentatively named HISCAT (High frequency, High power, High latitude, Heating and Ionospheric Scatter facility), should be used for scientific investigations of: the physics of the neutral (middle) atmosphere; fundamental plasma phenomena, natural or artificially induced in the ionosphere; electrodynamic conditions at high altitudes above the auroral region and in the polar cap ionosphere; plasma waves in the solar atmosphere. The system should thus be able to operate as a mesosphere-stratosphere-troposphere (MST) radar, a so-called ionospheric modification facility, incoherent-scatter radar, coherent-scatter radar, and solar radar. Basically, the new facility should be a device that can operate simultaneously on several frequencies in the frequency range 5 to 50 MHz not covered by other instruments. It should comprise: powerful transmitters, capable of delivering a total average power of several megawatts; an advanced phased antenna array of high gain forming one or two steerable and well collimated beams; and an advanced data collection and analysis system.

Bostrom, R.↗

Detection of radio-frequency modulated optical signals by two and three terminal microwave devices

An interdigitated photoconductor (two terminal device) on GaAlAs/GaAs heterostructure was fabricated and tested by an electro-optical sampling technique. Further, the photoresponse of GaAlAs/GaAs HEMT (three terminal device) was obtained by illuminating the device with an optical signal modulated up to 8 GHz. Gain-bandwidth product, response time, and noise properties of photoconductor and HEMT devices were obtained. Monolithic integration of these photodetectors with GaAs microwave devices for optically controlled phased array antenna applications is discussed.

Bhasin, K. B.↗

Radiation characteristics of a source in a thin substrate mounted over a dielectric medium

The radiation pattern of a line source is calculated for the case in which the source is lying on the top or the bottom surface of a lossless dielectric substrate that is mounted on the top of semiinfinite dielectric medium. It is found that in both cases the pattern along the interfaces has a null; that the pattern in the upper semiinfinite medium has a single lobe; and that the pattern in the lower semiinfinite medium has many lobes, the number of which varies with the substrate thickness. In both cases, the power radiated into the lower medium is more than that radiated into the upper medium. Applications of this calculation to remote sensing, microstrip antenna technology, and antenna arrays are discussed.

Engheta, Nader↗

Detection of radio-frequency modulated optical signals by two and three terminal microwave devices

An interdigitated photoconductor (two terminal device) on GaAlAs/GaAs heterostructure was fabricated and tested by an electro-optical sampling technique. Further, the photoresponse of GaAlAs/GaAs HEMT (three terminal device) was obtained by illuminating the device with an optical signal modulated up to 8 GHz. Gain-bandwidth product, response time, and noise properties of photoconductor and HEMT devices were obtained. Monolithic integration of these photodetectors with GaAs microwave devices for optically controlled phased array antenna applications is discussed.

Bhasin, K. B.↗