Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “low-frequency”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 793 records · Page 44
All sourcesNASA NTRSDOE OSTI
NASA NTRS1990

The Lunar Observer Radio Astronomy Experiment (LORAE)

The paper proposes to place a simple low-frequency dipole antenna on board the Lunar Observer (LO) satellite. LO will orbit the moon in the mid-1990's, mapping the surface at high resolution and gathering new geophysical data. In its modest concept, LORAE will collect crucial data on the radio interference environment while on the near-side (to aid in planning future arrays) and will monitor bursts of emission from the sun and the Jovian planets. LORAE will also be capable of lunar occultation studies of greater than 100 of the brightest sources, gathering arcminute resolution data on sizes and measuring source fluxes. A low resolution all-sky map below 10 MHz, when combined with data from the Gamma-Ray Observatory, will uniquely determine the density of Galactic cosmic ray electrons and the strength of the Galaxy's magnetic field. LORAE also will be able to measure the density of the moon's ionosphere.

Burns, Jack O.↗
NASA NTRS1990

Low frequency propagation in the earth's magnetosphere

Using a model to simulate wave propagation, estimates were obtained on the effect of the earth's magnetosphere on the imaging potential of the Low-Frequency Space Array mission for observations above the ionosphere at frequencies below about 10 MHz. Results of this simulation show that, for imaging at 1.5 MHz, large orbital radii will be required. It is concluded that successful imaging from within the plasmasphere may depend upon the feasibility of correction schemes.

Dennison, Brian↗
NASA NTRS1990

Supernovae and supernova remnants at low frequencies

The importance of low-frequency observations of the intrinsic radio emission from supernovae and their remnants is discussed, with special attention given to an example of a peculiarity at low frequencies of the 38-MHz 'flare' observed from Cas A in the mid-1970s. It is suggested that, for explosions from supernovae in a low-density wind, it may be possible to follow the absorption over a large range of shock front radii. Absorption local to the remnants can occur in H II regions created by the supernovae or their progenitors and in the cooling layers of radiative shock fronts, or in the ionized interstellar medium. Observations of emission as well as of absorption are necessary to determine the location of the ionized gas.

Chevalier, Roger A.↗
NASA NTRS1991

Simulation of the nonlinear evolution of electron plasma waves

Electrostatic waves driven by an electron beam in an ambient magnetized plasma were studied using a quasi-1D PIC simulation of electron plasma waves (i.e., Langmuir waves). The results disclose the presence of a process for moving wave energy from frequencies and wavenumbers predicted by linear theory to the Langmuir-like frequencies during saturation of the instability. A decay process for producing backward propagating Langmuir-like waves, along with low-frequency waves, is observed. The simulation results, however, indicate that the backscattering process is not the conventional Langmuir wave decay. Electrostatic waves near multiples of the electron plasma frequency are generated by wave-wave coupling during the nonlinear stage of the simulations, confirming the suggestion of Klimas (1983).

Nishikawa, K.-I.↗
NASA NTRS1991

The temperature of the cosmic microwave background radiation at 3.8 GHz - Results of a measurement from the South Pole site

As part of an international collaboration to measure the low-frequency spectrum of the cosmic microwave background (CMB) radiation, its temperature was measured at a frequency of 3.8 GHz, during the austral spring of 1989, obtaining a brightness temperature, T(CMB), of 2.64 +/-0.07 K (68 percent confidence level). The new result is in agreement with previous measurements at the same frequency obtained in 1986-88 from a very different site and has comparable error bars. Combining measurements from all years, T(CMB) = 2.64 +/-0.06 K is obtained.

De Amici, Giovanni↗
NASA NTRS1991

Interacting and self-organized two-level states in tunnel barriers

The excess low-frequency 1/f noise and discrete two-level resistance fluctuations (TLFs) were studied in small-area NbN-MgO-NbN tunnel junctions with a high, low-temperature density of active defects. Strong and evolving interactions between large TLFs indicate that these fluctuations result from the self-organization of interacting defect elements. In the low-T tunneling regime, an unusual slowing down of the rates and a decrease in amplitude with increasing T is sometimes observed indicative of a thermally induced change in the self-organized two-level state.

Pesenson, L.↗
NASA NTRS1990

Radar polarimetry for geoscience applications

The present volume on radar polarimetry for geoscience applications discusses wave properties and polarization, scattering matrix representation for simple targets, scattering models for point and distributed targets, polarimetric scatterometer systems and measurements, polarimetric radar system design, and polarimetric SAR applications. Attention is given to plane waves in a lossless homogeneous medium-wave polarization, polarization synthesis and response, and coordinate system transformations. Topics addressed include high- and low-frequency scattering, rough-surface scattering models, radiative transfer theory and deficiencies thereof, solutions for the radiative transfer equation, and a radiative transfer model for a forest canopy. Also discussed are network analyzer-based polarimetric scatterometers, calibration of polarimetric scatterometers, synthesized polarization response of distributed targets, and measurement of the propagation parameters of a forest canopy.

Ulaby, Fawwaz T.↗
NASA NTRS1991

Rapid oscillations in cataclysmic variables. VII - GK Persei

The discovery of a stable short-period oscillation in the UV light curve of the old nova GK Persei during 1989-91 is reported. The period is consistent with the 351.34-second pulse period seen in hard X-rays, due to the rotation of the white dwarf. In blue light, a quasi-periodic signal appears in the low-frequency wings of the coherent signal. There is evidence for long-term spin-up of the white dwarf; the most probable mean rate is 0.0008 sec/yr.

Patterson, Joseph↗
NASA NTRS1991

Krylov model reduction algorithm for undamped structural dynamics systems

Krylov vectors furnish an efficient basis for eigenvalue analysis and model reduction of structural dynamics systems. The reduced-order model obtained by the present Krylov model-reduction algorithm for an undamped structural-dynamics system is found to match low-frequency moments. The transformed system equation in Krylov coordinates reflects the structure of a tandem system.

Craig, Roy R., Jr.↗
NASA NTRS1991

Passive control of supersonic cavity flowfields

A computational investigation has been conducted to study the effect and mechanisms of the passive control of a supersonic flow over a rectangular two-dimensional cavity. The passive control was included through the use of a porous surface over a vent chamber in the floor of the cavity. The passive control effectively suppressed the low-frequency pressure oscillations for the open type cavity, (length-to-depth ratio = 6.0). The mechanism for the suppression was observed to be the stabilization of the motion of the free shear layer. For the closed type cavity flow, (length-to-depth ratio = 17.5), the passive control modified the flowfield to nearly that of an open type cavity flow; further the cavity drag was reduced by a factor of four. The computational results of both cases showed good agreement with the available experimental data and the predictions of a semiempirical formula. This study demonstrates that the passive control concept can be used to improve the aerodynamic characteristics of open and closed cavity flowfields.

Chokani, N.↗
NASA NTRS1987

NDE of Space Shuttle Solid Rocket Motor field joint

One of the most critical areas for inspection in the Space Shuttle Solid Rocket Motors is the bond between the steel case and rubber insulation in the region of the field joints. The tang-and-clevis geometry of the field joints is sufficiently complex to prohibit the use of resonance-based techniques. One approach we are investigating is to interrogate the steel-insulation bondline in the tang and clevis regions using surface-travelling waves. A low-frequency contact surface wave transmitting array transducer is under development at our laboratory for this purpose. The array is placed in acoustic contact with the steel and surface waves are launched on the inside surface or the clevis leg which propagate along the steel-insulation interface. As these surface waves propagate along the bonded surface, the magnitude of the ultrasonic energy leaking into the steel is monitored on the outer surface of the case. Our working hypothesis is that the magnitude of energy received at the outer surface of the case is dependent upon the integrity of the case-insulation bond, with less attenuation for propagation along a disbond due to imperfect acoustic coupling between the steel and rubber. Measurements on test specimens indicate a linear relationship between received signal amplitude and the length of good bend between the transmitter and receiver, suggesting the validity of this working hypothesis.

Patrick H. Johnston↗
NASA NTRS1983

Improved fabrication techniques for infrared bolometers

Techniques are described for producing improved infrared bolometers from doped germanium. Ion implantation and sputter metalization have been used to make ohmic electrical contacts to Ge:Ga chips. This method results in a high yield of small monolithic bolometers with very little low-frequency noise. When one of these chips is used as the thermometric element of a composite bolometer, it must be bonded to a dielectric substrate. The thermal resistance of the conventional epoxy bond has been measured and found to be undesirably large. A procedure for soldering the chip to a metalized portion of the substrate is described which reduced this resistance. The contribution of the metal film absorber to the heat capacity of a composite bolometer has been measured. The heat capacity of a NiCr absorber at 1.3 K can dominate the bolometer performance. A Bi absorber has significantly lower heat capacity. A low temperature blackbody calibrator has been built to measure the optical responsivity of bolometers. A composite bolometer system with a throughput of approx. 0.1 sr sq cm was constructed using the new techniques. In negligible background it has an optical NEP of 3.6 10((exp -15) W/sq root of Hz at 1.0 K with a time constant of 20 ms. The noise in this bolometer is white above 2.5 Hz and is somewhat below the value predicted by thermodynamic equilibrium theory. It is in agreement with calculations based on a recent nonequilibrium theory.

Lange, A. E.↗
NASA NTRS1948

Transonic-flutter Investigation of Wings Attached to Two Low-acceleration Rocket-propelled Vehicles

Two low-acceleration transonic-flutter vehicles were launched and flown. The first carried two test wings, one of which fluttered at M = 0.92 at a frequency of 61.4 cycles per second. The reference flutter speed determined from two-dimensional theory for an unswept wing in incompressible flow is conservative when compared to the experimental flutter speed. The second vehicle carried two test wings, one of which failed at M = 0.71 because of low-frequency divergent oscillation. Since this failure was not caused by conventional flexure-torsion flutter, no comparison with a reference flutter speed can be made.

MISSILES, SPECIFIC TYPES↗
NASA NTRS1991

Challenges to the successful implementation of 3-D sound

The major challenges for the successful implementation of 3-D audio systems involve minimizing reversals, intracranially heard sound, and localization error for listeners. Designers of 3-D audio systems are faced with additional challenges in data reduction and low-frequency response characteristics. The relationship of the head-related transfer function (HRTF) to these challenges is shown, along with some preliminary psychoacoustic results gathered at NASA-Ames.

Begault, Durand R.↗
NASA NTRS1961

Balancing Vanguard Satellites

The Vanguard satellites and component parts were balanced within the specified limits by using a Gisholt Type-S balancer in combination with a portable International Research and Development vibration analyzer and filter, with low-frequency pickups. Equipment and procedures used for balancing are described; and the determination of residual imbalance is accomplished by two methods: calculation, and graphical interpretation. Between-the-bearings balancing is recommended for future balancing of payloads.

Simkovich, A.↗
NASA NTRS1959

Analysis of of Injection-Velocity Effects on Rocket Motor Dynamics and Stability

A concept of combustion time lag that includes dependency on injection velocity is introduced. The concept is used in the formulation of chamber transfer functions and in an analysis of low-frequency combustion instability. Theoretical frequency responses and stability boundaries are compared with those obtained when the injection-velocity effect on the time lag to be an important consideration, in the theory of chamber dynamics and combustion instability

Hurrell, Herbert G.↗
NASA NTRS1961

Near-Field and Far-Field Noise Measurements for a Blowdown-Wind-Tunnel Supersonic Exhaust Jet having about 475,000 Pounds of Thrust

Near-field and far-field noise surveys were made of the supersonic The exhaust jet of the Langley 9- by 6-foot thermal structures tunnel. The jet had a thrust rating of approximately 475,000 pounds. The sound power radiated was found to be about 3.6 x 10(exp 6) watts, and on an acoustical-mechanical efficiency basis this value is in reasonable agreement with data for smaller supersonic jets and for rocket engines of other investigations. Octave-band analyses of the near-field noise show that the maximum sound pressure levels in the low-frequency bands are greatest downstream, whereas maximum sound pressure levels in the high-frequency bands were greatest near the jet exit. A comparison of near-field noise measurements is made with data previously obtained for rocket engines. Noise survey measurements of the original jet are compared with similar data obtained after the addition of a 97-foot-long exit diffuser section, and an example of the application of this facility to the problem of acoustic environmental testing of a large space capsule is cited.

Mayes, William H.↗
DOE OSTI2026

Fermilab PIP II machine protection system digitized data noise elimination scheme and its FPGA implementation

In Fermilab's PIP-II machine protection system, beam loss signals from various detectors are digitized at 125 MS/s. Noise from both high-frequency sources and low-frequency 60 Hz AC power equipment can contaminate the data. To suppress noise across these ranges especially 60 Hz and its harmonics, which overlap with beam loss signal frequencies advanced digital processing beyond standard filtering is required. Several real-time functional blocks were simulated and tested on an FPGA: (1) a dual time-constant discharging integrator filter, (2) a de-ripple baseline extraction and storage block, and (3) a fast-recovery discharging integrator. The nonlinear IIR integrator filter removes high-frequency noise and feeds into the baseline extractor. Upon detecting abrupt beam loss, it switches to a longer time constant to prevent baseline distortion. The de-ripple block calculates a valid baseline by averaging over multiple 60 Hz periods, storing results in a 4096-word FPGA RAM. This baseline is subtracted from raw data before integration by the fast-recovery block, which resets quickly after use. All blocks achieved expected performance.

Wu, J. [Fermilab] (ORCID:0000000344329521)↗