Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Modules”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 793 records · Page 44
All sourcesNASA NTRSDOE OSTI
NASA NTRS1991

The measurement system of pulse modulated carrier frequency stability and timing jitter

The definition of pulse modulated carrier frequency stability and timing jitter as well as the configuration and synchronous acquisition measurement method of its measurement system. Frequency stability of the pulse modulated carrier is measured with a discrimination technique. The pulse modulated carrier under testing is mixed with a reference frequency synthesizer. A delay line is used to convert the frequency fluctuation mixed IF signal to the voltage fluctuation. The system has the capability to make the phase noise measurement of two port devices on a pulsed carrier using a phase bridge. The noise voltage mentioned above is applied to the data acquisition and processing unit by PC to realize stability measurement. The data acquisition is in the form of pulse synchronization so that the measurement system accuracy is increased. The pulse width is more than 0.3 microseconds. The phase fluctuation variance, sigma, is less than 0.017. The time interval measuring system with high resolution is used to make interpulse timing and pulse width jitters automatic measurement. The pulse width is less than 0.2 ns. The resolution is 0.1 ns. The system is successfully applied to radar measurement.

Li Cheng-Fu↗
NASA NTRS1991

Convective stability in the Rayleigh-Benard and directional solidification problems - High-frequency gravity modulation

The effect of vertical, sinusoidal, time-dependent gravitational acceleration on the onset of solutal convection during directional solidification is analyzed in the limit of large modulation frequency. When the unmodulated state is unstable, the modulation amplitude required to stabilize the system is determined by the method of averaging. When the unmodulated state is stable, resonant modes of instability occur at large modulation amplitude. These are analyzed using matched asymptotic expansions to elucidate the boundary-layer structure for both the Rayleigh-Benard and directional solidification configurations. Based on these analyses, a thorough examination of the dependence of the stability criteria on the unmodulated Rayleigh number, Schmidt number, and distribution coefficient, is carried out.

Wheeler, A. A.↗
NASA NTRS1991

Modulation for terrestrial broadcasting of digital HDTV

The digital modulation methods used by the DigiCipher, DSC-HDTV, ADTV, and ATVA-P digital high-definition television (HDTV) systems are discussed. Three of the systems use a quadrature amplitude modulation method, and the fourth uses a vestigial sideband modulation method. The channel equalization and spectrum sharing of the digital HDTV systems is discussed.

Kohn, Elliott S.↗
NASA NTRS1992

The simulated features of heliospheric cosmic-ray modulation with a time-dependent drift model. I - General effects of the changing neutral sheet over the period 1985-1990

A time-dependent drift model is used to simulate the heliospheric modulation of galactic cosmic rays, with emphasis on the effects of the wavy heliospheric neutral sheet (HNS) as a function of time during the period 1985-1990. The model predicted a clearly defined time difference between the time when minimum modulation occurred at earth and at radial distances farther away from the sun, indicating that the HNS plays an important part in establishing this observed time delay. The movements of the Voyager 1 and 2 and Pioneer 10 spacecraft were simulated in order to calculate instantaneous radial and latitudinal gradients. The time dependencies of these gradients were found to follow the observations well. The model study indicates that the HNS cannot be ignored, especially during periods of low to moderate solar activity, when the modulation of cosmic rays is described.

Potgieter, M. S.↗
NASA NTRS1992

Intensity variations in the interplanetary magnetic field measured by Voyager 2 and the 11-year solar cycle modulation of galactic cosmic rays

New evidence is presented to support the hypothesis that the 11-yr solar cycle modulation of galactic cosmic rays is caused by strong diffusion inside long-lived merged interaction regions. To test this hypothesis, the 1D force-field approximation of the cosmic ray modulation equation is solved. It is assumed that a constant solar wind speed convects magnetic field compressions and rarefactions unchanged through a model heliosphere. The result is a reasonable simulation of the integrated high-energy cosmic ray intensity profile from about 1982 to mid-1989. This period encompasses both the full recovery portion of the last profile from about 1982 to mid-1989. This model responds to the Voyager 2 magnetic field data by correctly timing the beginning of the new modulation cycle in late 1987. It is concluded that the present hypothesis is consistent with the results of this simulation.

Perko, J. S.↗
NASA NTRS1991

The Solar Array Module Plasma Interactions Experiment (SAMPIE) - A Shuttle-based plasma interactions experiment

The Solar Array Module Plasma Interactions Experiment (SAMPIE), an approved Shuttle space flight experiment with a tentative launch date in July 1993, is intended to investigate plasma interactions of high-voltage space power systems. Solar cell modules, representing several technologies, will be biased to high voltages to characterize both arcing (negative potential) and current collection (positive potential). Other solar modules, specially modified in accordance with current theories of arcing and breakdown, will demonstrate the possibility of arc suppression. Finally, several additional test specimens will be included to study the basic nature of these interactions. The authors describe the rationale for the space flight experiment, the measurements to be made, the significance of the expected results, and the current design status of the flight hardware.

Wald, Lawrence W.↗
NASA NTRS1993

Integrating Software Modules For Robot Control

Reconfigurable, sensor-based control system uses state variables in systematic integration of reusable control modules. Designed for open-architecture hardware including many general-purpose microprocessors, each having own local memory plus access to global shared memory. Implemented in software as extension of Chimera II real-time operating system. Provides transparent computing mechanism for intertask communication between control modules and generic process-module architecture for multiprocessor realtime computation. Used to control robot arm. Proves useful in variety of other control and robotic applications.

Volpe, Richard A.↗
NASA NTRS1991

Experiment module/support module interface specification for the reusable reentry satellite

This Interface Specification (IFS) identifies, defines, and controls the interface between the Reusable Reentry Satellite (RRS) Vehicle (RRV) Experiment Module (EM) and the Support Module (SM) equipment. Contained in this specification are the physical, functional, and environmental interface requirements for the SM and EM. This specification is tailored to the unique requirements of the EM associated with the Rodent Module. The addenda to this specification contain the requirements for alternate EM's.

Source record↗
NASA NTRS1992

ROMPS critical design review. Volume 2: Robot module design documentation

The robot module design documentation for the Remote Operated Materials Processing in Space (ROMPS) experiment is compiled. This volume presents the following information: robot module modifications; Easylab commands definitions and flowcharts; Easylab program definitions and flowcharts; robot module fault conditions and structure charts; and C-DOC flow structure and cross references.

Dobbs, M. E.↗
NASA NTRS1993

Modulation and coding for throughput-efficient optical free-space links

Optical direct-detection systems are currently being considered for some high-speed inter-satellite links, where data-rates of a few hundred megabits per second are evisioned under power and pulsewidth constraints. In this paper we investigate the capacity, cutoff-rate and error-probability performance of uncoded and trellis-coded systems for various modulation schemes and under various throughput and power constraints. Modulation schemes considered are on-off keying (OOK), pulse-position modulation (PPM), overlapping PPM (OPPM) and multi-pulse (combinatorial) PPM (MPPM).

Georghiades, Costas N.↗
NASA NTRS1993

Combinatorial pulse position modulation for power-efficient free-space laser communications

A new modulation technique called combinatorial pulse position modulation (CPPM) is presented as a power-efficient alternative to quaternary pulse position modulation (QPPM) for direct-detection, free-space laser communications. The special case of 16C4PPM is compared to QPPM in terms of data throughput and bit error rate (BER) performance for similar laser power and pulse duty cycle requirements. The increased throughput from CPPM enables the use of forward error corrective (FEC) encoding for a net decrease in the amount of laser power required for a given data throughput compared to uncoded QPPM. A specific, practical case of coded CPPM is shown to reduce the amount of power required to transmit and receive a given data sequence by at least 4.7 dB. Hardware techniques for maximum likelihood detection and symbol timing recovery are presented.

Budinger, James M.↗
NASA NTRS1993

Development of a large field-of-view KD potassium di-deuterium phosphate modulator: Center Director's Discretionary Fund

Magnetographs, which measure polarized light, allow solar astronomers to infer the magnetic field intensity on the Sun. The Marshall Space Flight Center (MSFC) Vector Magnetograph is such an imaging instrument. The instrument requires rapid modulation between polarization states to minimize seeing effects. The accuracy of those polarization measurements is dependent on stable modulators with small field-of-view errors. Although these devices are very important in ground-based telescopes, extending the field of view of electro-optical crystals such as KD*Ps (potassium di-deuterium phosphate) could encourage the development of these devices for other imaging applications. The work that was done at MSFC as part of the Center Director's Discretionary Fund (CDDF) to reduce the field-of-view errors of instruments that use KD*P modulators in their polarimeters is described.

West, E. A.↗
NASA NTRS1992

Cosmic ray modulation near the onset and maximum phases of solar activity cycle 22

Using data obtained with neutron monitors we study the cosmic-ray modulation of the five-year developmental phase of solar activity cycle (SAC) 22. The main characteristics of the observed modulation are compared with those of cycle 19. The similarities and differences between the two cycles are noted. The data indicate that the amplitude of the observed modulation is larger at higher and lower primary rigidities than that for cycle 19, which still remains the most active cycle. The lowest ever monthly-mean counting rates were obtained in June 1991. Even so, based upon our prior experience, we expect the recovery of the cosmic ray intensity in SAC 22 to follow the pattern observed for cycles 20 and 18, rather than that for cycle 19.

Ahluwalia, H. S.↗
NASA NTRS1993

An analysis of the frequency limitations of an Al(x)Ga(1-x)As/GaAs optical modulator

An analysis is made of the frequency response of an Al(x)Ga(1-x)As/GaAs optical modulator operating at a wavelength of 0.83 micron and utilizing the linear-optic effect in a Mach-Zehnder configuration. It is shown that, in semiconductor modulators, electroabsorption should be taken into account in optimizing the frequency response of the device. It is also shown that, by incorporating an insulator (a semiconductor with a large band gap) between the metallic electrode and the channel, the capacitance of the electroabsorptive modulator can be kept low at a reasonable value under the worst conditions.

Tabib-Azar, M.↗
NASA NTRS1991

Coherent optical modulation for antenna remoting

A coherent fiber optic link employing wideband frequency modulation (FM) of the optical carrier is used to transfer radio frequency (RF) or microwave signals. This system is used to link a remotely located antenna to a conveniently located electronics processing site. The advantages of coherent analog fiber optic systems over non-coherent intensity modulated fiber optic analog transmission systems are described. An optical FM link employing an indirect transmitter to frequency modulate the optical carrier and a microwave delay line discriminator receiver is described. Measured performance data for a video signal centered at 60 MHz is presented showing the use of wideband FM in the link.

Fitzmartin, D. J.↗
NASA NTRS1992

A cryogenic multichannel electronically scanned pressure module

Consideration is given to a cryogenic multichannel electronically scanned pressure (ESP) module developed and tested over an extended temperature span from -184 to +50 C and a pressure range of 0 to 5 psig. The ESP module consists of 32 pressure sensor dice, four analog 8 differential-input multiplexers, and an amplifier circuit, all of which are packaged in a physical volume of 2 x 1 x 5/8 in with 32 pressure and two reference ports. Maximum nonrepeatability is measured at 0.21 percent of full-scale output. The ESP modules have performed consistently well over 15 times over the above temperature range and continue to work without any sign of degradation. These sensors are also immune to repeated thermal shock tests over a temperature change of 220 C/sec.

Shams, Qamar A.↗
NASA NTRS1992

Flight-qualification of a wideband laser diode transmitter module

A diffraction-limited laser diode transmitter module suitable for wideband direct detection laser communication is described. The transmitter module incorporates a high power semiconductor diode laser, collimating lens, thermal control, and driver circuit in a hermetic enclosure. The module has undergone environmental testing which demonstrates its suitability for space application, and accelerated lifetesting of the laser diode suggests an operational lifetime of nearly ten years.

Holcomb, Terry L.↗
NASA NTRS1990

Space Station module Power Management And Distribution (PMAD) system

This project consists of several tasks which are unified toward experimentally demonstrating the operation of a highly autonomous, user-supportive power management and distribution system for Space Station Freedom (SSF) habitation/laboratory modules. This goal will be extended to a demonstration of autonomous, cooperative power system operation for the whole SSF power system through a joint effort with NASA's Lewis Research Center, using their Autonomous Power System. Short term goals for the space station module power management and distribution include having an operational breadboard reflecting current plans for SSF, improving performance of the system communications, and improving the organization and mutability of the artificial intelligence (AI) systems. In the middle term, intermediate levels of autonomy will be added, user interfaces will be modified, and enhanced modeling capabilities will be integrated in the system. Long term goals involve conversion of all software into Ada, vigorous verification and validation efforts and, finally, seeing an impact of this research on the operation of SSF. Conversion of the system to a DC Star configuration is now in progress, and should be completed by the end of October, 1989. This configuration reflects the latest SSF module architecture. Hardware is now being procured which will improve system communications significantly. The Knowledge-Based Management System (KBMS) is initially developed and the rules from FRAMES have been implemented in the KBMS. Rules in the other two AI systems are also being grouped modularly, making them more tractable, and easier to eventually move into the KBMS. Adding an intermediate level of autonomy will require development of a planning utility, which will also be built using the KBMS. These changes will require having the user interface for the whole system available from one interface. An Enhanced Model will be developed, which will allow exercise of the system through the interface without requiring all of the power hardware to be operational. The functionality of the AI systems will continue to be advanced, including incipient failure detection. Ada conversion will begin with the lowest level processor (LLP) code. Then selected pieces of the higher level functionality will be recorded in Ada and, where possible, moved to the LLP level. Validation and verification will be done on the Ada code, and will complete sometimes after completion of the Ada conversion.

Walls, Bryan↗