Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “MEASUREMENTS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 793 records · Page 44

Neutron scattering measurement of water content and chemical composition of alkali-glass powder reacted gel

Highlights: • Water absorption ability of alkali-glass powder reacted gel was largely reduced comparing other reported alkali-silica gels. • Both SAXS and SANS results showed similar internal structures of samples prepared with different H2O:D2O mixing ratios. • Neutron scattering method was developed to non-destructively determine gel water content and mass density of reacted gels. • Neutron scattering methods (based on scattering length density) on gel water content was validated with TGA measurement. - Abstract: Recent studies demonstrated that the added glass powder with high-alumina content could significantly reduce Alkali-Silica Reaction (ASR) damage in cement concrete. This paper aims to investigate the gel water content, chemical composition and expansion behavior of the alkali-glass powder reacted gel by using neutron scattering and other characterization techniques. Three types of samples were prepared with glass powder, sodium oxide and deuteroxide/hydrogen water with different molar ratios. The swelling potential of this alkali-glass powder reacted gel was much lower than that of the reported alkali-silica reacted gel. The gel water content and chemical compositions were characterized with small-angle neutron scattering (SANS) technique, supported by small-angle X-ray scattering (SAXS), prompt-gamma ray neutron activation analysis (PGAA) measurement. The SAXS test results showed the close scattering intensities, and thus similar internal microstructures among these samples. The elemental molar ratios of gels were obtained from the PGAA test results. Then the gel water molar ratio and mass density were determined by neutron scattering contrast calculation. The determined gel water content from neutron scattering analysis was validated with zero contrast analysis and TGA experimental measurement. Overall, this paper demonstrated the feasibility of using SANS technique to determine the water content of alkali-glass powder reacted gel.

36 MATERIALS SCIENCE↗

Measurement of the inclusive isolated prompt photon cross-section in pp collisions at root s=7 TeV using 35 pb(-1) of ATLAS data

A measurement of the differential cross-section for the inclusive production of isolated prompt photons in pp collisions at a center-of-mass energy {radical}s = 7 TeV is presented. The measurement covers the pseudorapidity ranges |{eta}| < 1.37 and 1.52 {le} |{eta}| < 2.37 in the transverse energy range 45 {le} E{sub T} < 400 GeV. The results are based on an integrated luminosity of 35 pb{sup -1}, collected with the ATLAS detector at the LHC. The yields of the signal photons are measured using a data-driven technique, based on the observed distribution of the hadronic energy in a narrow cone around the photon candidate and the photon selection criteria. The results are compared with next-to-leading order perturbative QCD calculations and found to be in good agreement over four orders of magnitude in cross-section.

71 CLASSICAL AND QUANTUM MECHANICS, GENERAL PHYSIC↗

Isolation of flow and nonflow correlations by two- and four-particle cumulant measurements of azimuthal harmonics in s NN = 200 GeV Au+Au collisions

A data-driven method was applied to Au+Au collisions at root S-NN = 200 GeV made with the STAR detector at RHIC to isolate pseudorapidity distance Delta eta-dependent and Delta eta-independent correlations by using two- and four-particle azimuthal cumulant measurements. We identified a Delta eta-independent component of the correlation, which is dominated by anisotropic flow and flow fluctuations. It was also found to be independent of. within the measured range of pseudorapidity vertical bar eta vertical bar < 1. In 20-30% central Au+Au collisions, the relative flow fluctuation was found to be 34% +/- 2%(stat.) +/- 3%(sys.) for particles with transverse momentum p(T) less than 2 GeV/c. The Delta eta-dependent part, attributed to nonflow correlations, is found to be 5% +/- 2%(sys.) relative to the flow of the measured second harmonic cumulant at vertical bar Delta eta vertical bar > 0.7. (C) 2015 The Authors. Published by Elsevier B.V.

74 ATOMIC AND MOLECULAR PHYSICS↗

Measuring K S 0 K ± interactions using pp collisions at s = 7 TeV

We present the first measurements of femtoscopic correlations between the K$^0_S$ and K ± particles in pp collisions at $\sqrt{s}=7$ TeV measured by the ALICE experiment. The observed femtoscopic correlations are consistent with final-state interactions proceeding solely via the a 0 (980) resonance. The extracted kaon source radius and correlation strength parameters for K$^0_S$K - are found to be equal within the experimental uncertainties to those for K$^0_S$K + . Results of the present study are compared with those from identical-kaon femtoscopic studies also performed with pp collisions at $\sqrt{s}=7$ TeV by ALICE and with a K$^0_S$K ± measurement in Pb–Pb collisions at s NN =2.76 TeV. Combined with the Pb–Pb results, our pp analysis is found to be compatible with the interpretation of the a 0 (980) having a tetraquark structure instead of that of a diquark.

Acharya, S.↗

Algal Biomass Constituent Analysis: Method Uncertainties and Investigation of the Underlying Measuring Chemistries

Algal biomass compositional analysis data form the basis of a large number of techno-economic process analysis models that are used to investigate and compare different processes in algal biofuels production. However, the analytical methods used to generate these data are far from standardized. This work investigated the applicability of common methods for rapid chemical analysis of biomass samples with respect to accuracy and precision. This study measured lipids, protein, carbohydrates, ash, and moisture of a single algal biomass sample at 3 institutions by 8 independent researchers over 12 separate workdays. Results show statistically significant differences in the results from a given analytical method among laboratories but not between analysts at individual laboratories, suggesting consistent training is a critical issue for empirical analytical methods. Significantly different results from multiple lipid and protein measurements were found to be due to different measurement chemistries. We identified a set of compositional analysis procedures that are in best agreement with data obtained by more advanced analytical procedures. The methods described here and used for the round robin experiment do not require specialized instrumentation, and with detailed analytical documentation, the differences between laboratories can be markedly reduced.

09 BIOMASS FUELS↗