Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Characteristics”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 793 records · Page 44
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Determination of two-stroke engine exhaust noise by the method of characteristics

A computational technique was developed for the method of characteristics solution of a one-dimensional flow in a duct as applied to the wave action in an engine exhaust system. By using the method, it was possible to compute the unsteady flow in both straight pipe and tuned expansion chamber exhaust systems as matched to the flow from the cylinder of a small two-stroke engine. The radiated exhaust noise was then determined by assuming monopole radiation from the tailpipe outlet. Very good agreement with experiment on an operation engine was achieved in the calculation of both the third octave radiated noise and the associated pressure cycles at several locations in the different exhaust systems. Of particular interest is the significance of nonlinear behavior which results in wave steepening and shock wave formation. The method computes the precise paths on the x-t plane of a finite number of C(sub +), C(sub -) and P characteristics, thereby obtaining high accuracy in determining the tailpipe outlet velocity and the radiated noise.

Jones, A. D.↗
NASA NTRS1980

Electrostatic charging characteristics of thermal control paints as function of temperature

The charging characteristics of paints for various uses on spacecraft under electron bombardment were studied. It was found that there is not a strong temperature dependence of the charging characteristics between -155 C and +30 C; and there is a noticeable hystereis effect as the electron beam energy is varied. Furthermore, all of the paints tested exhibit large secondary yields at low (approx. 1 keV) bombarding electron energies; and surfaces can charge either positively or negatively depending on the conditions and the paint. It was concluded that paints are not simple, will require more detailed study, and will probably act differently in multiple energy electron tests.

Robinson, P. A., Jr.↗
NASA NTRS1981

Measured and calculated characteristics of wind turbine noise

The results of an analytical and experimental investigation of wind turbine noise are presented. Noise calculations indicate that for configurations with the rotor downwind of the support tower, the primary source of noise is the rapid change in rotor loadings which occurs as the rotor passes through the tower wake. Noise measurements are presented for solid and truss type tower models with both upwind and downwind rotors. Upwind rotor configurations are shown to be significantly quieter than downwind configurations. The model data suggest that averaged noise measurements and noise calculations based on averaged tower wake characteristics may not accurately represent the impulsive noise characteristics of downwind rotor configurations.

Greene, G. C.↗
NASA NTRS1982

Longitudinal aerodynamic characteristics of an elliptical body with a horizontal tail at Mach numbers from 2.3 to 4.63

Longitudinal aerodynamic characteristics of a configuration consisting of an elliptical body with an in plane horizontal tail were investigated. The tests were conducted at Mach numbers of 2.3, 2.96, 4.0, and 4.63. In some cases, the configuration with negative tail deflections yielded higher values of maximum lift drag ratio than did the configuration with an undeflected tail. This was due to body upwash acting on the tail and producing an additional lift increment with essentially no drag penalty. Linear theory methods used to estimate some of the longitudinal aerodynamic characteristics of the model yielded results which compared well with experimental data for all Mach numbers in this investigation and for both small angles of attack and larger angles of attack where nonlinear (vortex) flow phenomena were present.

Shrout, B. L.↗
NASA NTRS1982

The impulsive phase of solar flares. 2: Characteristics of the hard X-rays

The results of an investigation into the electron distribution in the general non-thermal models of solar flares were used to calculate the characteristics of the impulsive hard X-rays. The height distribution, the spectrum, the polarization, and directivity of the X-rays were observed and how these X-ray characteristics are affected by the parameters defining the model was investigated. An expression is obtained for the X-ray intensity as a function of source height which is an excellent fit under certain constraints. Some available data with spatial resolution are examined and it is shown that it is possible to reproduce these data adequately with the non-thermal model and to determine the values of the parameters describing the flares.

Leach, J.↗
NASA NTRS1982

Characteristics of the flow in the annulus-wall region of an axial-flow compressor rotor blade passage

Three-dimensional characteristics of the mean velocity and turbulence structure in the annulus-wall region of a moderately loaded compressor rotor have been investigated experimentally by employing triaxial hot-wire probes. Results are presented which indicate that the flow within and downstream of the rotor passage is highly complex due to the interaction of the annulus-wall boundary layer, blade boundary layers, tip leakage flow, and passage secondary flow. An understanding of the reported viscous flow interactions is important for establishing improved aerodynamic design criteria and efficiency, for predicting noise levels, and for determining the stall, surge, vibration, and flutter characteristics of turbomachinery.

Davino, R. M.↗
NASA NTRS1981

Ground effect hover characteristics of a large-scale twin tilt-nacelle V/STOL model

This paper is a summary of an analysis of the ground-effect characteristics of a large-scale twin-engine, tilt-nacelle V/STOL model. The analysis considers data from the flow field beneath the full-scale model, as well as small-scale model test data, and makes comparisons with jet-ground interactions predicted by a computer code. The data from the large-scale test comprise ground-plane surface temperatures, static pressure distribution and wall-jet total-pressure profiles, fuselage undersurface static pressures, and model forces and moments. The results indicate that the near-field flow is more complex than is indicated by either the small-scale uniform jet studies or the computer predictions. The far-field flow characteristics do show some similarity for these three cases.

Dudley, M. R.↗
NASA NTRS1982

High angle-of-attack characteristics of three-surface fighter aircraft

As part of a research program aimed at providing information on the high angle-of-attack characteristics of three-surface fighter concepts incorporating a close-coupled canard, an investigation is being conducted on two specific configurations based on the F-18 and F-15 designs. The study configurations are being subjected to a wide range of tests including wind-tunnel tests, dynamic model tests, and piloted simulation. This paper summarizes the results obtained to date in this study. High-alpha results in the areas of static stability, damping, and control characteristics are reviewed and some of the more significant aerodynamic phenomena are identified.

Croom, M. A.↗
NASA NTRS1982

Some statistical performance characteristics of the 'ITD' modal identification algorithm

Performance characteristics of the Ibrahim time-domain algorithms are examined on a statistical basis. The method uses multiple free-response measurements from a test structure directly in the time domain, and displays varying accuracy, with the strongly excited modes identified most accurately and the weakly excited modes least accurately. Sets of computer-generated free-response functions for a simple 1-mode model are used to study the identification performance for several basic changes in the modal characteristics of the data, the user-selectable analysis constants, and the level of superimposed noise. Results indicate the existence of a direct and often linear effect of noise on the scatter of identified parameters, and good identification is maintained at the 1% noise level down to the point in frequency when only 1/4-cycle of data is analyzed.

Pappa, R. S.↗
NASA NTRS1982

Pulsed plasma thruster ignitor plug ignition characteristics

The operating characteristics of the semiconductor spark gap ignitor plug used to initiate the discharge in a pulsed plasma thruster are investigated. Current and voltage waveform measurements for the ignitor plug alone, and for the plug mounted in the thruster cathode indicate an average dynamic impedance of 0.2 ohms for a wide range of operating conditions, and a trigger circuit energy transfer efficiency to the plug on the order of 25%. Two modes of trigger ignition are found which are related to the rise time of the applied voltage pulse. Analysis of plasma characteristics reveals plug erosion to occur primarily in the semiconductor and anode regions, by mechanisms including plug metal embrittlement, plasma sputtering and vaporization caused by the discharge current pulse. Measurements also indicate a plume velocity on the order of 1580,000 cm/sec which increases with trigger circuit stored energy. The results establish levels of performance for future applications of semiconductor spark gap ignitor plugs in plasma devices.

Brady, M. E.↗
NASA NTRS1982

Engine dynamic analysis with general nonlinear finite element codes. II - Bearing element implementation, overall numerical characteristics and benchmarking

Second-year efforts within a three-year study to develop and extend finite element (FE) methodology to efficiently handle the transient/steady state response of rotor-bearing-stator structure associated with gas turbine engines are outlined. The two main areas aim at (1) implanting the squeeze film damper element into a general purpose FE code for testing and evaluation; and (2) determining the numerical characteristics of the FE-generated rotor-bearing-stator simulation scheme. The governing FE field equations are set out and the solution methodology is presented. The choice of ADINA as the general-purpose FE code is explained, and the numerical operational characteristics of the direct integration approach of FE-generated rotor-bearing-stator simulations is determined, including benchmarking, comparison of explicit vs. implicit methodologies of direct integration, and demonstration problems.

Padovan, J.↗
NASA NTRS1982

High angle-of-attack characteristics of a forward-swept wing fighter configuration

The NASA-Langley Research Center is currently investigating the high angle-of-attack characteristics of a forward-swept wing fighter technology demonstrator in a cooperative program with the Defense Advanced Research Projects Agency. The program includes static and dynamic wind-tunnel force tests, free-flight model tests, spin-tunnel tests, and piloted simulation. Particular emphasis is placed on identifying the contributions of the forward-swept wing to the configuration aerodynamics at high angles of attack. Results are presented to illustrate the wing contributions in terms of aerodynamic stability, flow visualization, and observation of free-flight characteristics.

Grafton, S. B.↗
NASA NTRS1974

Aerodynamic characteristics of two 10-percent-thick NASA supercritical airfoils with different upper surface curvature distributions

In order to assess the degree to which the characteristic region of low curvature of the supercritical airfoil can be practically extended on the upper surface, the aerodynamic characteristics of two supercritical airfoils with different upper surface curvature distributions were measured at Mach numbers from 0.60 to 0.81. Integrated section force and moment data, surface pressure distributions, and typical wake survey profiles are presented.

Harris, C. D.↗
NASA NTRS1972

Low-speed aerodynamic characteristics of a model having a 42 deg swept low wing with a supercritical airfoil, double-slotted flaps, and a T-tail

A low speed wind tunnel test was conducted in the Langley V/STOL tunnel to determine the static longitudinal and lateral stability characteristics of a general research model which simulated an advance configuration for a commercial transport airplane with a T tail. The model had a 42 deg swept, aspect ratio 6.78 wing with a supercritical airfoil and a high lift system which consisted of a leading edge slat and a double slotted flap. Various slat and flap deflection combinations represented clean, take off, and landing configurations. Effects on the longitudinal and lateral aerodynamic characteristics were determined for two flow through, simulated engine nacelles located on the sides of the fuselage near the rear of the model.

Fournier, P. G.↗
NASA NTRS1975

Static longitudinal aerodynamic characteristics of a model with a modified 17 percent thick supercritical wing

The static longitudinal stability characteristics of a 0.09 scale model of an airplane with a modified 17 percent thick supercritical wing were investigated. Modifications were made to the wing to reduce a gradual buildup of boundary layer shock loss preceding drag divergence (drag creep) noted in an earlier investigation. The longitudinal aerodynamic characteristics were determined over a Mach number range from 0.30 to 0.76 at angles of attack that generally provided a lift coefficient range from 0 to buffet onset. Results indicate that the modifications to the airfoil essentially eliminated the drag creep associated with the airfoil that occurs between the critical Mach number and the drag divergence Mach number.

Ferris, J. C.↗
NASA NTRS1980

Wind-tunnel investigation of longitudinal and lateral-directional stability and control characteristics of a 0.237-scale model of a remotely piloted research vehicle with a thick, high-aspect-ratio supercritical wing

A 0.237-scale model of a remotely piloted research vehicle equipped with a thick, high-aspect-ratio supercritical wing was tested in the Langley 8-foot transonic tunnel to provide experimental data for a prediction of the static stability and control characteristics of the research vehicle as well as to provide an estimate of vehicle flight characteristics for a computer simulation program used in the planning and execution of specific flight-research mission. Data were obtained at a Reynolds number of 16.5 x 10 to the 6th power per meter for Mach numbers up to 0.92. The results indicate regions of longitudinal instability; however, an adequate margin of longitudinal stability exists at a selected cruise condition. Satisfactory effectiveness of pitch, roll, and yaw control was also demonstrated.

Byrdsong, T. A.↗
NASA NTRS1980

Low-speed aerodynamic characteristics of a 17-percent-thick medium speed airfoil designed for general aviation applications

Wind tunnel tests were conducted to determine the low speed two dimensional aerodynamic characteristics of a 17 percent thick medium speed airfoil (MS(1)-0317) designed for general aviation applications. The results were compared with data for the 17 percent thick low speed airfoil (LS(1)-0417) and the 13 percent thick medium speed airfoil (MS(1)-0313). Theoretical predictions of the drag rise characteristics of this airfoil are also provided. The tests were conducted in the Langley low turbulence pressure tunnel over a Mach number range from 0.10 to 0.32, a chord Reynolds number range from 2 million to 12 million, and an angle of attack range from about -8 to 20 deg.

Mcghee, R. J.↗
NASA NTRS1983

Effect of external stores on the stability and control characteristics of a delta wing fighter model at Mach numbers from 0.60 to 2.01

An investigation has been made to determine the effects of external stores on the stability and control characteristics of a delta wing fighter airplane model at Mach numbers from 0.60 to 2.01 for a Reynolds number of 3.0 X 1 million per foot. The angle-of-attack range was from about -4 degrees to 20 degrees at a sideslip angle of 0 degrees for the transonic tests, and from about -4 degrees to 10 degrees at sideslip angles of 0 degrees and 3 degrees for the supersonic tests. In general, the results of the tests indicated no seriously detrimental effects of the stores on the stability and control characteristics of the model but did show an increase in the minimum drag level throughout the Mach number range. However, the drag-due-to-lift was such that for subsonic/transonic speeds, the drag at higher lifts was essentially unaffected and the indications are that the maneuvering capability may not be impaired by the stores.

Spearman, M. L.↗