SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Absorption cross sections of electronic band systems of diatomic nitrogen, oxygen, carbon, nitrogen oxide, and carbon-nitrogen molecules at high temperatures
Electron impact excitation cross section of /0,0/ first negative band of nitrogen ion from threshold to 3 keV, using photon counting techniques
The reduction of the Ku-band (13.9 GHz) normalized radar cross section (NRCS) by an artificial monomolecular surface film (oleyl alcohol) on the sea surface was measured in the North Sea during the 1975 Joint North Sea Wave Project, JONSWAP 75 experiment. The aim of the surface film experiment was to simulate natural surface films which often occur on the ocean surface and are produced by plankton or fish. NRCS measurements were obtained from an aircraft at incidence angles of 41 deg and 47 deg at vertical and horizontal polarizations. For winds between 3.5 and 4.4 m/sec the maximum measured reduction was 7.3 plus or minus 3.5 dB relative to the mean. In-situ measurements showed that the oleyl alcohol film reduced the surface tension from 74 to 43 dyne/cm.
Magnetic resonance imaging techniques were used to determine the physiological cross-sectional areas (PCSAs) of the major muscles or muscle groups of the lower leg. For 12 healthy subjects, the boundaries of each muscle or muscle group were digitized from images taken at 1-cm intervals along the length of the leg. Muscle volumes were calculated from the summation of each anatomical CSA (ACSA) and the distance between each section. Muscle length was determined as the distance between the most proximal and distal images in which the muscle was visible. The PCSA of each muscle was calculated as muscle volume times the cosine of the angle of fiber pinnation divided by fiber length, where published fiber length:muscle length ratios were used to estimate fiber lengths. The mean volumes of the major plantarflexors were 489, 245, and 140 cm3 for the soleus and medial (MG) and lateral (LG) heads of the gastrocnemius. The mean PCSA of the soleus was 230 cm2, about three and eight times larger than the MG (68 cm2) and LG (28 cm2), respectively. These PCSA values were eight (soleus), four (MG), and three (LG) times larger than their respective maximum ACSA. The major dorsiflexor, the tibialis anterior (TA), had a muscle volume of 143 cm2, a PCSA of 19 cm2, and an ACSA of 9 cm2. With the exception of the soleus, the mean fiber length of all subjects was closely related to muscle volume across muscles. The soleus fibers were unusually short relative to the muscle volume, thus potentiating its force potential.(ABSTRACT TRUNCATED AT 250 WORDS).
The present report gives a method for computing the torsion of boxes with thin shear-resistant or simply tension-resistant walls under any torsional load, support and dimension. The final stress condition is developed from that of a principal system with unconstrained sectional warping corresponding to Bredt's formula and an additional stress condition due to constrained cross-sectional warping. This is computed by means of the deflection condition of the principal system from a statically indeterminate calculation. Conformably, the torsional rigidity of the final system is derived from that of the principal system with unconstrained sectional buckling.
The material in this Section will provide the novice Flight Test Engineer (FTE) with a brief overview of the radar cross section (RCS) concept. Brief details of radar range descriptions, operations, target calibrations, and data reduction are included. It is noted that these range operations concentrate on the "static" test range rather than the much more sophisticated "dynamic" test range. The dynamic test range is what the FTE will probably work with. Radar reflectivity measurement has developed over the last two decades from a relatively simple endeavor involving the measurement of target RCS amplitude statistics to involving wide band, coherent systems that can measure high resolution images of targets as well as, in many cases, the polarization and phasing properties. This rapid growth in RCS technology has occurred because of the increased use of radar in today's commercial and military systems. In general, the goal for commercial systems is to enhance radar reflectivity, whereas the military goal is to reduce radar reflectivity. Also, classification and identification are important for military purposes because in adverse weather radar may be the only system that may be capable of separating enemy targets from friendly ones. This Section will discuss the fundamentals of RCS. Since the flight test techniques associated with RCS measurements are very similar to those of antenna pattern measurements, both will be presented at the same time in Section 19B Antenna Radiation Pattern Measurements.
Point-matching method, approximate technique for wave equations of uniform waveguides with very general cross sections
Proton irradiation on Fe and Ni targets, measuring spallation cross sections
A series of microwave measurements was conducted to determine the radar cross section of the Space Shuttle Orbiter vehicle at a frequency and at aspect angles applicable to re-entry radar acquisition and tracking. The measurements were performed in a microwave anechoic chamber using a 1/15th scale model and a frequency applicable to C-band tracking radars. The data were digitally recorded and processed to yield statistical descriptions useful for prediction of orbiter re-entry detection and tracking ranges.
This paper reports measurements of absolute scattering cross sections, differential in angle, for collisions of ground-state oxygen atoms with He, N2, and O2. Data are presented for scattering of 0.5-, 1.5-, and 5.0-keV oxygen-atom projectiles in the range of laboratory frame angles between 0.06 and 5 deg. These measurements provide information relevant to calculations of the aeronomic consequences of O(+) precipitation in the earth's upper atmosphere.
We report high-resolution laboratory measurements of photoabsorption cross sections of CO, N2, and SO2 in the wavelength range 80 to 320 nm. The motivation is to provide the quantitative data that are needed to analyze observations of absorption by, and to model photochemical processes in, the interstellar medium and a number of planetary atmospheres. Because of the high resolution of the spectrometers used, we can minimize distortion of the spectrum that occurs when instrument widths are greater than the widths of spectral features being measured. In many cases, we can determine oscillator strengths of individual rotational lines - a unique feature of our work.
Drag measurements at low lift of four-nacelle aircraft configuration with longitudinal distribution of cross-sectional area conducive to low transonic drag rise
Phase diagram cross section of aluminum copper cadmium manganese system with constant manganese concentration at 500 C
Least squares representation of inelastic cross sections and particle emission spectra from nucleon-nucleus collisions
Excitation cross sections for upper electron states of neon and krypton lasers, obtaining wave functions
Charge transfer cross sections for slow ion production in nitrogen molecular ion beams incident on hydrogen and deuterium
Evaluated Be-9 /n,2n/ cross sections tested by measuring flux distributions in water for Am-Be source enclosed in Be spheres
Comparison of integrated scattering cross sections of 3/2 states in Mg-25/d, alpha/Na-23 and Al-23/d, alpha/Mg-25 reactions