Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “directional”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 775 records · Page 43
All sourcesNASA NTRSDOE OSTI
NASA NTRS1991

Length minimization design considerations in photonic integrated circuits incorporating directional couplers

Because directional couplers involve channel waveguides which are very close to one another, transition regions to regions where channel waveguides are widely separated are utilized. The total length of a directional coupler and transition regions can be minimized for a particular degree of field confinement. Calculations presented for LiNbO3-, GaAlAs-, and SiO2/Si-based optical channel waveguides demonstrate the presence of a minimum total length corresponding to a particular degree of field confinement. The overall length at the minimum is shown to be significantly lower than for other values of field confinement allowing single-mode operation. This implies that either more devices can be integrated on a substrate or that less material is needed for an integrated optical circuit.

Boyd, Joseph T.↗
NASA NTRS1992

Control design of a UH-60 rotorcraft via CLTR and direct optimization

High-performance rotorcraft controller design is characterized by the need to compensate for both the longitudinal and lateral dynamics simultaneously. Rather than leaving these modes largely decoupled, one often needs for performance consideration to incorporate direct mode decoupling as a part of the controller design, especially when the system model includes high-frequency dynamics from the rotor and lag states. In addition to the usual design considerations of stability augmentation, a high-performance rotorcraft such as the UH-60 would also require a good command bandwidth and decoupling in the heave, yaw, pitch and roll command responses. In this paper, the method of closed-loop transfer recovery (CLTR) and direct optimization are applied to the control design of a UH-60 rotorcraft.

Vansteenwyk, Brett↗
NASA NTRS1992

Destination directed packet switch architecture for a geostationary communication satellite network

A major effort at NASA/Lewis is to identify and develop critical digital technologies and components that enable new commercial missions or significantly improve the performance, cost efficiency, and/or reliability of existing and planned space comunications systems. NASA envisions the need for low data rate, direct to the user communications services, for data, facsimile, voice, and video conferencing. A report that focuses on destination directed packet switching architectures for geostationary communication satellites is presented.

Ivancic, W. D.↗
NASA NTRS1993

Magnetic Direct-Current-Measuring Circuits

Two circuits measure large direct currents in main conductors by use of magnetic fields produced by currents in glassy metal toroidal ferromagnetic cores surrounding main conductors. In both circuits, direct currents to be measured deduced from transient voltages generated in multiturn windings by transitions between magnetic fields produced by measured currents and saturation magnetic fields of cores.

Sullender, Craig C.↗
NASA NTRS1992

Modelling Directional Solidification

The long range goal of this program has been to develop an improved understanding of phenomena of importance to directional solidification, in order to enable explanation and prediction of differences in behavior between solidification on Earth and in space. Current emphasis is on determining the influence of perturbations on directional solidification.

Wilcox, William R.↗
NASA NTRS1992

Cloud fraction, layer, and direction of movement results from sky cameras during the FIRE IFO, Coffeyville, Kansas, experiment for the period Nov. 12 through Dec. 9, 1991

Tables and figures are presented which show local site observations of cloud fractions, the number of cloud layers, direction of movement, and precipitation data collected during the FIRE (First ISCCP Regional Experiment) Phase 2 Cirrus Intensive Field Observations (IFO) conducted in Coffeyville, Kansas during November and December, 1991. Selected data are also presented at the times of the TIROS Operational Vertical Sounder (TOVS) satellite overpass. Several major scientific projects have used surface-based observations of clouds to compare directly with those being observed from satellites. Characterizing the physical properties of clouds is extremely useful in obtaining a more accurate analysis of the effect of clouds and their movements on weather and climate. It is the purpose of this paper to report data collected during the FIRE Phase 2 IFO experiment and to provide a brief history of such a surface-based system and the technical information required for recording local cloud parameters.

Gerald C Purgold↗
NASA NTRS1992

Microstructural development during directional solidification of peritectic alloys

Despite the widespread commercial use of peritectic alloys (e.g., steels, brass, bronze, intermetallic compounds, Co based superalloys and A3B type superconductors), the characterization of the microstructural development during directional solidification of peritectics has historically lagged behind similar efforts directed towards other types of binary invariant reactions such as eutectic or monotectic. A wide variety of possible microstructures has been shown to form in peritectics depending upon the imposed temperature gradient, G, the solidification velocity, V, as well as the presence or absence of convection in the melt. This has important technological implications since many commercially important alloys exhibit peritectics and processing methods such as casting and welding often involve widely changing conditions. It has been the aim of this project to examine, in a systematic fashion, both experimentally and theoretically, the influence of gravitationally driven convection on segregation and microstructural development during solidification in peritectic systems under terrestrial conditions. The scientific results of the project will be used to establish ground based data in support of a meaningful microgravity flight experiment.

Lograsso, Thomas A.↗
NASA NTRS1991

Direct solar pumping of semiconductor lasers: A feasibility study

The primary goals of the feasibility study are the following: (1) to provide a preliminary assessment of the feasibility of pumping semiconductor lasers in space directly focused sunlight; and (2) to identify semiconductor laser structures expected to operate at the lowest possible focusing intensities. It should be emphasized that the structures under consideration would provide direct optical-to-optical conversion of sunlight into laser light in a single crystal, in contrast to a configuration consisting of a solar cell or battery electrically pumping a current injection laser. With external modulation, such lasers may prove to be efficient sources for intersatellite communications. We proposed to develop a theoretical model of semiconductor quantum-well lasers photopumped by a broadband source, test it against existing experimental data where possible, and apply it to estimating solar pumping requirements and identifying optimum structures for operation for operation at low pump intensities. This report outlines our progress toward these goals. Discussion of several technical details are left to the attached summary abstract.

Anderson, Neal G.↗
NASA NTRS1993

Reduced electrical bandwidth receivers for direct detection 4-ary PPM optical communication intersatellite links

One of the major sources of noise in a direct detection optical communication receiver is the shot noise due to the quantum nature of the photodetector. The shot noise is signal dependent and is neither Gaussian nor wide sense stationary. When a photomultiplier tube (PMT) or an avalanche photodiode (APD) is used, there is also a multiplicative excess noise due to the randomness of the internal photodetector gain. Generally speaking, the radio frequency (RF) communication theory cannot be applied to direct detection optical communication systems because noise in RF communication systems is usually additive and Gaussian. A receiver structure which is mathematically optimal for signal dependent shot noise is derived. Several suboptimal receiver structures are discussed and compared with the optimal receiver. The objective is to find a receiver structure which is easy to implement and gives close to optimal performance.

Davidson, Frederic M.↗
NASA NTRS1993

Flight investigation of the effect of tail boom strakes on helicopter directional control

A joint U.S. Army/NASA flight investigation was conducted utilizing a single-rotor helicopter to determine the effectiveness of horizontally mounted tail boom strakes on directional controllability and tail rotor power during low-speed, crosswind operating conditions. Three configurations were investigated: (1) baseline (strakes off), (2) single strake (strake at upper shoulder on port side of boom), and (3) double strake (upper strake plus a lower strake on same side of boom). The strakes were employed as a means to separate airflow over the tail boom and change fuselage yawing moments in a direction to improve the yaw control margin and reduce tail rotor power. Crosswind data were obtained in 5-knot increments of airspeed from 0 to 35 knots and in 30 deg increments of wind azimuth from 0 deg to 330 deg. At the most critical wind azimuth and airspeed in terms of tail rotor power, the strakes improved the pedal margin by 6 percent of total travel and reduced tail rotor power required by 17 percent. The increase in yaw control and reduction in tail rotor power offered by the strakes can expand the helicopter operating envelope in terms of gross weight and altitude capability. The strakes did not affect the flying qualities of the vehicle at airspeeds between 35 and 100 knots.

Kelly, Henry L.↗
NASA NTRS1993

Derivation of particulate directional information from analysis of elliptical impact craters on LDEF

The Long Duration Exposure Facility provided a gravity gradient stabilized platform which allowed limited directional information to be derived from particle impact experiments. The morphology of impact craters on semi-infinite materials contains information which may be used to determine the direction of impact much more accurately. We demonstrate the applicability of this technique and present preliminary results of measurements from LDEF and modelling of interplanetary dust and space debris.

Newman, P. J.↗
NASA NTRS1992

The anomalous extinction curve in the direction of Rho Ophiuchi from 950 to 1180 A

We report the interstellar extinction from 950 to 1180 A in the direction of Rho Oph. These data were obtained with a moderate-resolution sounding rocket observation of Ro Oph, and two lightly reddened B stars of identical spectral type. Unlike Voyager observations in this wavelength region, our spectral resolution is sufficient to directly measure the contribution of molecular hydrogen along the line of sight and unambiguously identify the dust contribution. The derived curves compare favorably with the extrapolation of functional fits to the Rho Oph derived from longer wavelengths. In addition, we have fitted a model of dust extinction to the derived curve and find that the best fits indicate that the line of sight exhibits a larger than average grain size and a preferential concentration of graphite relative to silicates. The sharp rise seen at the shortest wavelengths (below 1000 A) cannot be explained by standard silicate-graphite dust models and may be indicative of a nonstandard grain shape or a missing component in the extinction models.

Green, James C.↗
NASA NTRS1992

Effects of laser source parameters on the generation of narrow band and directed laser ultrasound

Predictive and prescriptive modeling of laser arrays is performed to demonstrate the effects of the extension of array elements on laser array performance. For a repetitively pulsed laser source (the temporal laser array), efficient frequency compression is best achieved by detecting longitudinal waves off-epicenter in plates where the source size and shape directly influence the longitudinal wave shape and duration; the longitudinal array may be tailored for a given repetition frequency to yield efficient overtone energy compression into the fundamental frequency band. For phased arrays, apparent array directivity is heavily influenced by array element size.

Spicer, James B.↗
NASA NTRS1992

Helicopter noise prediction - The current status and future direction

The paper takes stock of the progress, assesses the current prediction capabilities, and forecasts the direction of future helicopter noise prediction research. The acoustic analogy approach, specifically, theories based on the Ffowcs Williams-Hawkings equations, are the most widely used for deterministic noise sources. Thickness and loading noise can be routinely predicted given good plane motion and blade loading inputs. Blade-vortex interaction noise can also be predicted well with measured input data, but prediction of airloads with the high spatial and temporal resolution required for BVI is still difficult. Current semiempirical broadband noise predictions are useful and reasonably accurate. New prediction methods based on a Kirchhoff formula and direct computation appear to be very promising, but are currently very demanding computationally.

Brentner, Kenneth S.↗
NASA NTRS1993

Two-directional skin friction measurement utilizing a compact internally mounted thin-liquid-film skin friction meter

A new, compact oil film skin friction meter capable of measuring skin friction in two directions has been designed and constructed. The instrument allows the thin liquid film technique to now be applied in flight and in a wider variety of laboratory conditions. The instrument was tested by comparing measurements with those given by a floating element gage in laminar, transitional, and turbulent boundary layers with zero pressure gradient. Both instruments agreed satisfactorily with each other and with the expected curves for the laminar and turbulent boundary layers. Significant differences were at first seen between the oil film meter and two floating element gages in the case of a favorable pressure gradient, but when a correction is applied to account for the normal force acting on the pendulum-type gage, the three instruents are much closer. The directional sensitivity of the oil film gage is also demonstrated.

Seto, Jeffrey A.↗
NASA NTRS1993

The effects of shrinkage flow and gravity level on the onset of convection during vertical directional dendritic solidification of NH4Cl-H2O

A numerical investigation of the conditions influencing the onset of convection during Bridgman vertical directional solidification of NH4Cl- 72 wt percent H2O has been made using a linear stability model. The effects of shrinkage flow and gravity level on the transition from diffusion-dominated to convection-dominated solidification are shown to be significant. Both shrinkage flow opposite the direction of growth and increased gravity levels tend to decrease the stability limits defining the onset of convection for the solidifying NH4Cl-H2O system.

Hopkins, J. A.↗
NASA NTRS1992

Using qualitative maps to direct reactive robots

The principal advantage of mobile robots is that they are able to go to specific locations to perform useful tasks rather than have the tasks brought to them. It is important therefore that the robot be used to reach desired locations efficiently and reliably. A mobile robot whose environment extends significantly beyond its sensory horizon must maintain a representation of the environment, a map, in order to attain these efficiency and reliability requirements. We believe that qualitative mapping methods provide useful and robust representation schemes and that such maps may be used to direct the actions of a reactively controlled robot. In this paper we describe our experience in employing qualitative maps to direct, through the selection of desired control strategies, a reactive-behavior based robot. This mapping capability represents the development of one aspect of a successful deliberative/reactive hybrid control architecture.

Bertin, Randolph↗