Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “beam model”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 775 records · Page 43

Computation of Nonlinear Backscattering Using a High-Order Numerical Method

The nonlinear Schrodinger equation (NLS) is the standard model for propagation of intense laser beams in Kerr media. The NLS is derived from the nonlinear Helmholtz equation (NLH) by employing the paraxial approximation and neglecting the backscattered waves. In this study we use a fourth-order finite-difference method supplemented by special two-way artificial boundary conditions (ABCs) to solve the NLH as a boundary value problem. Our numerical methodology allows for a direct comparison of the NLH and NLS models and for an accurate quantitative assessment of the backscattered signal.

Fibich, G.↗

A comparison of the height distributions of solar flare hard X-rays in thick target and thermal models

The height structure of hard X-ray bremsstrahlung emission in solar flares is computed for two different models of bremsstrahlung production: emission from a descending beam of nonthermal electrons, and thermal emission from a coronally confined hot plasma. It is shown how these models give rise to hard X-ray spatial distributions which are distinguishable by current instrumentation, and that, therefore, the models may be distinguished by such spatially resolved hard X-ray measurements.

Emslie, A. G.↗

Energetic ion beam in the earth's magnetotail lobe

IMP-8 high time resolution measurement of energetic particles in the earth magnetotail indicated prominent peaks in the proton energy at 0.1-0.7 MeV. A drifting Kappa distribution was fitted to the spectra and a 15-45 keV, proton beam, with densities of 4/10 million to 5/10,000 cu cm jetting tailward at 3500-7000 km/sec, was modelled. It is noted that extension of the beam from 1-5 earth radii would require an energy flux of 1.7 x 10 to the 17th ergs/sec, close to observed values of magnetospheric substorms. However, acceleration of the plasma sheet population, which has a density of 0.1/cu cm, would result in only a small fraction of the protons being accelerated to the higher energies. Candidates for the acceleration mechanisms are discussed

Lui, A. T. Y.↗

Test Cases for Modeling and Validation of Structures with Piezoelectric Actuators

A set of benchmark test articles were developed to validate techniques for modeling structures containing piezoelectric actuators using commercially available finite element analysis packages. The paper presents the development, modeling, and testing of two structures: an aluminum plate with surface mounted patch actuators and a composite box beam with surface mounted actuators. Three approaches for modeling structures containing piezoelectric actuators using the commercially available packages: MSC/NASTRAN and ANSYS are presented. The approaches, applications, and limitations are discussed. Data for both test articles are compared in terms of frequency response functions from deflection and strain data to input voltage to the actuator. Frequency response function results using the three different analysis approaches provided comparable test/analysis results. It is shown that global versus local behavior of the analytical model and test article must be considered when comparing different approaches. Also, improper bonding of actuators greatly reduces the electrical to mechanical effectiveness of the actuators producing anti-resonance errors.

Reaves, Mercedes C.↗

Quenching of the beam-plasma instability by 3-D spectra of large scale density fluctuations

A model is presented to explain the highly variable yet low level of Langmuir waves measured in situ by spacecraft when electron beams associated with Type III solar bursts are passing by; the low level of excited waves allows the propagation of such streams from the Sun to well past 1 AU without catastrophic energy losses. The model is based, first, on the existence of large scale density fluctuations that are able to efficiently diffuse small k beam unstable Langmuir waves in phase space, and, second, on the presence of a significantly isotropic nonthermal tail in the distribution function of the background electron population, which is capable of stabilizing larger k modes. The strength of the model lies in its ability to predict various levels of Langmuir waves depending on the parameters. This feature is consistent with the high variability actually observed in the measurements.

Muschietti, L.↗

Buckling of imperfect periodic lattice structures

A simplified buckling analysis is presented for a family of periodic lattice structures such as those proposed for large space structures. A transcendental 6 x 6 matrix of eigenvalues is shown to be sufficient for modeling buckling behavior because member stiffnesses are based on an exact solution of the beam-column equation. Exact stiffnesses are derived for a curved member, thus allowing modeling of imperfect lattice structures. Comparisons of predictions of the lattice model with those available from shell and beam theory underscore the inaccuracies introduced by treating the lattice structure as a continuum. Sample calculations are provided for an isogrid cylinder and a three element double-laced truss.

Anderson, M. S.↗

Structural performance of space station trusses with missing members

Structural performance of orthogonal tetrahedral and Warren-type full truss beams and platforms are compared. In addition, degradation of truss structural performance is determined for beams, platforms and a space station when individual struts are removed from the trusses. The truss beam, space station, and truss platform analytical models used in the studies are described. Stiffness degradation of the trusses due to single strut failures is determined using flexible body vibration modes. Ease of strut replacement is assessed by removing a strut and examining the truss deflection at the resulting gap due to applied forces. Finally, the reduction in truss beam strength due to a missing longeron is determined for a space station transverse boom model.

Dorsey, J. T.↗

Ly-alpha and H-alpha emission by superthermal proton beams

Simnett and Harrison (1984) have presented a model in which 100-1000 keV protons are an energy transfer agent linking coronal mass ejections and solar flares. Orrall and Zirker (1976) suggested that such protons, incident upon the chromosphere, would produce nonthermal Ly-alpha emission after charge exchange with ambient chromospheric hydrogen atoms. The present investigation is concerned with a study of the charge-exchange mechanism proposed by Orral and Zirker. The physical theory of the formation of nonthermal Ly-alpha (and H-alpha) emission is considered, taking into account photon emission, atomic transitions, atomic equilibrium, the dominant atomic processes, and the stopping of superthermal protons. Computational results presented by Orrall and Zirker are extended.

Canfield, R. C.↗

Theoretical studies of a molecular beam generator

The following is a proposed baseline model that is being developed for the simulation of hydrodynamic generator, which can be converted at a later date to magnetohydrodynamic MHD thruster by adding the necessary electric and magnetic fields. The following development will include the electric and magnetic terms, however, the initial computer program will not include these terms. The analysis that follows is a one species, single temperature model constructed over a domain that is defined by an enclosed region.

Heinbockel, John H.↗

Input Files and Procedures for Analysis of SMA Hybrid Composite Beams in MSC.Nastran and ABAQUS

A thermoelastic constitutive model for shape memory alloys (SMAs) and SMA hybrid composites (SMAHCs) was recently implemented in the commercial codes MSC.Nastran and ABAQUS. The model is implemented and supported within the core of the commercial codes, so no user subroutines or external calculations are necessary. The model and resulting structural analysis has been previously demonstrated and experimentally verified for thermoelastic, vibration and acoustic, and structural shape control applications. The commercial implementations are described in related documents cited in the references, where various results are also shown that validate the commercial implementations relative to a research code. This paper is a companion to those documents in that it provides additional detail on the actual input files and solution procedures and serves as a repository for ASCII text versions of the input files necessary for duplication of the available results.

Turner, Travis L.↗

Resonant interactions between cometary ions and low frequency electromagnetic waves

The conditions for resonant wave amplification in a plasma with a ring-beam distribution which is intended to model pick-up ions in a cometary environment are investigated. The inclination between the interplanetary field and the solar wind is found to play a crucial role in governing both the resonant frequency and the growth rate of any unstable mode. It is suggested that the low-frequency MHD mode should experience the most rapid amplification for intermediate inclination. In the frame of the solar wind, such waves should propagate along the field in the direction upstream toward the sun with a phase speed lower than the beaming velocity of the pick-up ions. This mechanism may account for the presence of the interior MHD waves noted by satellites over a region surrounding comets Giacobini-Zinner and Halley.

Thorne, Richard M.↗

The design, analysis and experimental evaluation of an elastic model wing

An elastic orbiter model was developed to evaluate the effectiveness of aeroelasticity computer programs. The elasticity properties were introduced by constructing beam-like straight wings for the wind tunnel model. A standard influence coefficient mathematical model was used to estimate aeroelastic effects analytically. In general good agreement was obtained between the empirical and analytical estimates of the deformed shape. However, in the static aeroelasticity case, it was found that the physical wing exhibited less bending and more twist than was predicted by theory.

Cavin, R. K., III↗

Kinetic Theory and Fast Wind Observations of the Electron Strahl

We develop a model for the strahl population in the solar wind - a narrow, low-density and high-energy electron beam centred on the magnetic field direction. Our model is based on the solution of the electron drift-kinetic equation at heliospheric distances where the plasma density, temperature and the magnetic field strength decline as power laws of the distance along a magnetic flux tube. Our solution for the strahl depends on a number of parameters that, in the absence of the analytic solution for the full electron velocity distribution function (eVDF), cannot be derived from the theory. We however demonstrate that these parameters can be efficiently found from matching our solution with observations of the eVDF made by the Wind satellite's SWE strahl detector. The model is successful at predicting the angular width (FWHM) of the strahl for the Wind data at 1 au, in particular by predicting how this width scales with particle energy and background density. We find that the strahl distribution is largely determined by the local temperature Knudsen number γ ∼ |T dT/dx|/n, which parametrizes solar wind collisionality. We compute averaged strahl distributions for typical Knudsen numbers observed in the solar wind, and fit our model to these data. The model can be matched quite closely to the eVDFs at 1 au; however, it then overestimates the strahl amplitude at larger heliocentric distances. This indicates that our model may be improved through the inclusion of additional physics, possibly through the introduction of 'anomalous diffusion' of the strahl electrons.

Horaites, Konstantinos↗

Laser beam scintillation beyond the turbulent atmosphere A numerical computation

The extended Huygens-Fresnel formulation for propagation through turbulence is used to examine scintillation of a finite laser beam. The method is demonstrated analytically for propagation beyond a weak Gaussian phase screen. A numerical integration technique is used to extend the results to a more realistic turbulence model. Results are compared with existing Gaussian beam propagation theory.

Bufton, J. L.↗

Electron-beam flow visualization - Applications in the definition of configuration aerothermal characteristics.

Comparisons between flow visualization systems using electron-beam fluorescence, schlieren, and shadowgraph techniques illustrate the advantages associated with the electron beam. Specific applications of this method as an aid in defining the origin of erosion on a heat-transfer model are cited. Results of combined electron-beam oil-flow studies on configurations illustrate that the simultaneous definition of the external flow field and its surface flow can be obtained. Comparisons between the electron-beam oil-flow visualization method and phase-change coating heat-transfer tests on a shuttle ascent configuration indicate the complementary nature of these two testing techniques. Potential methods for improving the electron-beam technique are included.

Woods, W. C.↗

X-ray spectrum and variability of 3C 120

The X-ray luminosity of 3C 120 is variable by a factor of 2.5 on time scales of days to months. The spectral slope of the 2-10 keV X-rays changes systematically in the sense that the higher intensity states are steeper. Simple power laws fitted to the data are consistent with an energy index alpha of 0.51 + or - 0.13 at minimum intensity and 0.83 + or - 0.03 at maximum, with a continuous variation in between. A more complicated spectral shape cannot be ruled out, but changes in absorbing column density alone cannot explain the data. The results are interpreted in terms of beamed synchrotron emission from a relativistic jet, a model which has been invoked previously for the spectra of BL Lac objects. The spectral variability is in marked contrast to the behavior of 3C 273, another superluminal source in which the X-ray spectral index is constant to a high degree of accuracy despite variability in time scales and amplitudes which are quite similar to those of 3C 120. The difference may be due to the degree of beaming of the respective core components. Another model which is consistent with the data involves thermal emission from isothermal shocks in a hot (approximately 10 to the 8th K) medium. Thermal Compton and spherical accretion X-ray source models do not reproduce the correct behavior of alpha versus flux.

Halpern, J. P.↗

Self-consistent inclusion of space-charge in the traveling wave tube

It is shown how the complete field of the electron beam may be incorporated into the transmission line model theory of the traveling wave tube (TWT). The fact that the longitudinal component of the field due to the bunched beam is not used when formulating the beam-to-circuit coupling equation is not well-known. The fundamental partial differential equation for the traveling wave field is developed and compared with the older (now standard) one. The equation can be solved numerically using the same algorithms, but now the coefficients can be updated continuously as the calculation proceeds down the tube. The coefficients in the older equations are primarily derived from preliminary measurements and some trial and error. The newer coefficients can be found by a recursive method, since each has a well defined physical interpretation and can be calculated once a reasonable first trial solution is postulated. The results of the new expression were compared with those of the older forms, as well as to a field theory model to show the ease in which a reasonable fit to the field prediction is obtained. A complete summary of the existing transmission line modeling of the TWT is given to explain the somewhat vague ideas and techniques in the general area of drifting carrier-traveling circuit wave interactions. The basic assumptions and inconsistencies of the existing theory and areas of confusion in the general literature are examined and hopefully cleared up.

Freeman, Jon C.↗

Grid Gap Measurement for an NSTAR Ion Thruster

The change in gap between the screen and accelerator grids of an engineering model NSTAR ion optics assembly was measured during thruster operation with beam extraction. The molybdenum ion optics assembly was mounted onto an engineering model NSTAR ion thruster. The measurement technique consisted of measuring the difference in height of an alumina pin relative to the downstream accelerator grid surface. The alumina pin was mechanically attached to the center aperture of the screen grid and protruded through the center aperture of the accelerator grid. The change in pin height was monitored using a long distance microscope coupled to a digital imaging system. Transient and steady-state hot grid gaps were measured at three power levels: 0.5, 1.5 and 2.3 kW. Also, the change in grid gap was measured during the transition between power levels, and during the startup with high voltage applied just prior to discharge ignition. Performance measurements, such as perveance, electron backstreaming limit and screen grid ion transparency, were also made to confirm that this ion optics assembly performed similarly to past testing. Results are compared to a prior test of 30 cm titanium ion optics.

Diaz, Esther M.↗