Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “SPACE”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 775 records · Page 43
All sourcesNASA NTRSDOE OSTI
NASA NTRS1972

Space shuttle: Directional and lateral stability and interference effects of cruise engine location on a 0.015 scale space shuttle

The results are presented that were obtained from a wind tunnel tests to improve space shuttle booster baseline lateral-directional stability, control characteristics, and cruise engine location optimization. Tests were conducted in a 7 x 10-foot transonic wind tunnel. The model employed was a 0.015-scale replica of a space shuttle booster. The three major objectives of this test were to determine the following: (1) force, static stability, and control effectiveness characteristics for varying angles of positive and negative wing dihedral and various combinations of wing tip and centerline dorsal fins; (2) force and static stability characteristics of cruise engines location on the body below the high aerodynamic canard; and (3) control effectiveness for the low-mounted wing configuration. The wing dihedral study was conducted at a cruise Mach number of 0.40 and simulated altitude of 10,000 feet. Portions of the test were conducted to determine the control surfaces stability and control characteristics over the Mach number range of 0.4 to 1.2. The aerodynamic characteristics determined are based on a unit Reynolds number of approximately 2 million per foot. Boundary layer trip strips were employed to induce boundary layer transition.

Buchholz, R. E.↗
NASA NTRS1972

Manned space flight nuclear system safety. Volume 1: Executive summary. Part 2: Space shuttle nuclear system safety

The nuclear safety integration and operational aspects of transporting nuclear payloads to and from an earth orbiting space base by space shuttle are discussed. The representative payloads considered were: (1) zirconium hydride-Brayton power module, (2) isotope-Brayton power module, and (3) small isotope power systems or heat sources. Areas of investigation also include nuclear safety related integration and packaging as well as operational requirements for the shuttle and payload systems for all phases of the mission.

Source record↗
NASA NTRS1972

Manned space flight nuclear system safety. Voluem 5: Nuclear system safety guidelines. Part 2: Space shuttle/nuclear payloads safety

The design and operations guidelines and requirements developed in the study of space shuttle nuclear system transportation are presented. Guidelines and requirements are presented for the shuttle, nuclear payloads (reactor, isotope-Brayton and small isotope sources), ground support systems and facilities. Cross indices and references are provided which relate guidelines to each other, and to substantiating data in other volumes. The guidelines are intended for the implementation of nuclear safety related design and operational considerations in future space programs.

Source record↗
NASA NTRS1972

Space shuttle: Aerodynamic characteristics of various MDAC space shuttle ascent configurations with parallel burn pressure-fed and SRM boosters. Volume 1: Tanks T1 and T2 ascent configurations

Various space shuttle ascent configurations were tested in a trisonic wind tunnel to determine the aerodynamic characteristics. The ascent configuration consisted of a NASA/MSC 040 orbiter in combination with various HO centerline tank and booster geometries. The aerodynamic interference between components of the space shuttle and the effect on the orbiter aerodynamics was determined. The various aerodynamic configurations tested were: (1) centerline HO tanks T1 and T2, (2) centerline HO tank T3, and (3) centerline HO tank H4.

Jarrett, T. W.↗
NASA NTRS1971

A method for determining the response of space shuttle to atmospheric turbulence. Volume 1: Space shuttle turbulence response

A computer program has been developed and demonstrated that can analyze the response of space shuttle to atmospheric turbulence. The method developed accounts for propellant slosh, gimballed engine, and stability augmentation system (SAS) coupling with the elastic vehicle. Statistical outputs are generated that relate vehicle loads and accelerations to level of random turbulence. For discrete turbulence descriptions, response time-histories are computed. Preliminary turbulence response analyses of space shuttle were conducted for one ascent and one booster flyback subsonic flight condition. The ascent case considered both symmetric and antisymmetric boundary conditions, while only the symmetric analysis was conducted for booster flyback. The three conditions were analyzed with SAS active and inactive, but apparent instabilities with SAS active (arising from improper gains) invalidated the results. Load and acceleration responses in all cases, however, were well within vehicle design limits.

Source record↗
NASA NTRS1973

Optical space astronomy and goals of the large space telescope.

Optical astronomy now means the study of EM radiation in the very near IR and vacuum UV in addition to the visible wavelengths. Practical constraints presently define the IR limit at about 11000 A, where photoemissive cathodes become ineffective, and the UV limit at 912 A, where the hydrogen of the interstellar medium limits the view to very nearby objects. Salient events of the first decade of optical space astronomy are discussed together with the orbiting astronomical observatories. Particular attention is given to the large space telescope (LST) project, taking into account the physical characteristics of the LST and the scientific program.

O'Dell, C. R.↗
NASA NTRS1973

Kennedy Space Center Space Shuttle facilities.

Description of tasks and facilities involved in the processing of Space Shuttle missions at the Kennedy Space Center. Responsibilities considered include vehicle integration and launch, recovery and refurbishment of the spent solid rocket motors, and landing and refurbishment of the Orbiter vehicles. Facility options are evaluated for transportation, on-site processing, mating, and recovery of the booster, drop tank, and Orbiter elements. Processing flow patterns are outlined for assembly, maintenance, checking, safing, refurbishment, and launch operations.

Clark, R. L.↗
NASA NTRS1974

The National Aeronautics and Space Administration interdisciplinary studies in space technology at the University of Kansas

A broad range of research projects contained in a cooperative space technology program at the University of Kansas are reported as they relate to the following three areas of interdisciplinary interest: (1) remote sensing of earth resources; (2) stability and control of light and general aviation aircraft; and (3) the vibrational response characteristics of aeronautical and space vehicles. Details of specific research efforts are given under their appropriate departments, among which are aerospace engineering, chemical and petroleum engineering, environmental health, water resources, the remote sensing laboratory, and geoscience applications studies.

Barr, B. G.↗
NASA NTRS1974

Downwind hazard calculations for space shuttle launches at Kennedy Space Center and Vandenberg Air Force Base

The quantitative estimates are presented of pollutant concentrations associated with the emission of the major combustion products (HCl, CO, and Al2O3) to the lower atmosphere during normal launches of the space shuttle. The NASA/MSFC Multilayer Diffusion Model was used to obtain these calculations. Results are presented for nine sets of typical meteorological conditions at Kennedy Space Center, including fall, spring, and a sea-breeze condition, and six sets at Vandenberg AFB. In none of the selected typical meteorological regimes studied was a 10-min limit of 4 ppm exceeded.

Susko, M.↗
NASA NTRS1975

Utility of Space Transportation System to Space Communication Community

A potentially cost effective technique was investigated of launching operational satellites into synchronous orbit using the space transportation system (STS). This technique uses an unguided spinning solid rocket motor as the means for boosting a satellite from a low altitude shuttle parking orbit into a synchronous transfer orbit. The spacecraft is then injected into a geosynchronous orbit by an apogee kick motor fired at transfer orbit apogee. The approach is essentially that used on all Delta and Atlas-Centaur launches of synchronous satellites with the shuttle orbiter performing the function of the first two stages of the Delta three stage launch vehicle and the perigee kick motor performing the function of the Delta third state. It is concluded that the STS can be useful to the space communication community as well as to other geostationary satellite system users if the recommended actions are implemented.

Bronstein, L. M.↗
NASA NTRS1972

Calculated maximum Hl ground-level concentrations downwind from launch pad aborts of the space shuttle and Titan 3 C vehicles at Kennedy Space Center

A quantitative assessment is described of the potential environmental hazard posed by the atmospheric release of HCl resulting from the burning of solid propellant during two hypothetical on-pad aborts of the Titan 3 C and space shuttle vehicles at Kennedy Space Center. In one pad-abort situation, it is assumed that the cases of the two solid-propellant engines are ruptured and the burning propellant falls to the ground in the immediate vicinity of the launch pad where it continues to burn for 5 minutes. In the other pad-abort situation considered, one of the two solid engines on each vehicle is assumed to ignite and burn at the normal rate while the vehicle remains on the launch pad. Calculations of maximum HCl ground-level concentration for the above on-pad abort situations were made using the computerized NASA/MSFC multilayer diffusion models in conjunction with appropriate meteorological and source inputs. Three meteorological regimes are considered-fall, spring, and afternoon sea-breeze. Source inputs for the hazard calculations were developed. The principal result of the calculations is that maximum ground-level HCl concentrations at distances greater than 1 kilometer from the launch pad are less than 3 parts per million in all cases considered.

Dumbauld, R. K.↗
NASA NTRS1976

The 0.040-scale space shuttle orbiter base heating model tests in the Lewis Research Center space power facility

Space shuttle base heating tests were conducted using a 0.040-scale model in the Plum Brook Space Power Facility of The NASA Lewis Research Center. The tests measured heat transfer rates, pressure distributions, and gas recovery temperatures on the orbiter vehicle 2A base configuration resulting from engine plume impingement. One hundred and sixty-eight hydrogen-oxygen engine firings were made at simulated flight altitudes ranging from 120,000 to 360,000 feet.

Dezelick, R. A.↗
NASA NTRS1976

Experiment Definition Using the Space Laboratory, Long Duration Exposure Facility, and Space Transportation System Shuttle

Candidate experiments designed for the space shuttle transportation system and the long duration exposure facility are summarized. The data format covers: experiment title, Experimenter, technical abstract, benefits/justification, technical discussion of experiment approach and objectives, related work and experience, experiment facts space properties used, environmental constraints, shielding requirements, if any, physical description, and sketch of major elements. Information was also included on experiment hardware, research required to develop experiment, special requirements, cost estimate, safety considerations, and interactions with spacecraft and other experiments.

Sheppard, Albert P.↗
NASA NTRS1976

Space Processing Applications - Designing the initial space transportation system payloads capability

A review is presented of the broad objectives identified by the U.S. Space Processing Applications program. A description is given of the types of materials to be considered, taking into account aspects of crystal growth, questions of purification and separation, mixing, solidification, and processes in fluids. The program requirements are discussed, giving attention to time in space, energy, research and development payload equipment design efforts, design payloads, early mission automated payloads, and early mission manned payloads.

Hammel, R. L.↗
NASA NTRS1976

Space-based solar power conversion and delivery systems study. Volume 3: Economic analysis of space-based solar power systems

A variety of economic and programmatic issues are discussed concerning the development and deployment of a fleet of space-based solar power satellites (SSPS). The costs, uncertainties and risks associated with the current photovoltaic SSPS configuration, and with issues affecting the development of an economically viable SSPS development program are analyzed. The desirability of a low earth orbit (LEO) demonstration satellite and a geosynchronous (GEO) pilot satellite is examined and critical technology areas are identified. In addition, a preliminary examination of utility interface issues is reported. The main focus of the effort reported is the development of SSPS unit production, and operation and maintenance cost models suitable for incorporation into a risk assessment (Monte Carlo) model (RAM). It is shown that the key technology area deals with the productivity of man in space, not, as might be expected, with some hardware component technology.

Hazelrigg, G. A., Jr.↗
NASA NTRS1976

Space Shuttle Orbiter crash and rescue information - Basic characteristics of the Space Shuttle system

Major fire and rescue activity procedures developed for the Space Shuttle Orbiter are reproduced, together with diagrams of the Orbiter's ejection seat and of emergency egress-ingress hatches and blowout panels. Duties assigned to the Manager of the Fire, Crash and Rescue division of the Space Shuttle Program are discussed, including training of both ground and flight personnel in accordance with the Orbiter Crash Rescue Information manual. The special problem of providing a means of egress and rescue for the flight and ground crews of the Orbiter while it is in the piggyback configuration on top the Boeing 747 carrier was solved by use of a modified 85-foot articulated boom.

Gray, N. C.↗