Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “consequence”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 757 records · Page 42

Ascent Problems of Sounding Rockets

Sounding rockets are rocket vehicles designed to carry scientific payloads above the sensible level of the atmosphere. The trajectories of these rockets are very steep, and as a consequence, two important problems arise. These problems are: (1) The dynamic stability of the entire vehicle system as it leaves the atmosphere; (2) The effect of winds on the initial part of the trajectory of such an unguided vehicle. This paper will describe briefly the results of a NASA attempt to cope with these two problems on a particular rocket vehicle.

WIND PROFILE↗

Lunar Flight Study Series: Volume 7. Earth-Moon Transit Studies Based on Ephemeris Data and Using Best Available Computer Program: Principles for Reducing Earth-Moon Trajectory Analysis to Fundamentals - 2

This report presents an empirical investigation of earth-to-moon trajectories. The primary objective is to uncover relationships that result in the reduction of mission analysis or trajectory analysis problems to fundamentals. It is considered imperative that the results be accurate to the extent that any relationships that are uncovered are not brought about by simplifying or unrealistic assumptions. Consequently, the model used is as accurate as is presently available for use and the computations are performed under strict error controls. Procedures are reasonable from the engineering viewpoint. Some very helpful principles are uncovered. These may be briefly stated as follows: 1) Trajectories of constant flight time to the moon (in the 66 hour to 90 hour range), and arriving within a few minutes of the same time pass over a common point on the moon regardless of the arrival altitude and inclination, This common point of passage for such a family of trajectories is arbitrarily referred to as a VERTEX point; 2) These VERTEX points lie within a bounded region on the lunar surface as arrival time varies throughout the years, for a given flight time or flight time spread; 3) Increasing flight time results primarily in a longitude shift of the VERTEX point for a given arrival time; 4) Launch azimuth should be treated as a strong parameter regarding its influence on the vertex. Launch azimuth variations up to +/- 20 degrees about 90 degrees can shift the vertex as much as 3 degrees in latitude even when one is free to pick launch time, coast time, and S-IVB burn time appropriately with launch azimuth; and 5) The locus of periselenum, as arrival inclination takes on all possible values, is nearly circular about the vertex point for a given arrival altitude. A publication is now in preparation that applies these principles to much advantage in the solution of various trajectory analysis problems.

LUNAR FLIGHT↗

Pitfalls in thermal emission studies

Attention is called to several pitfalls that often beset investigators who make thermal emittance studies. The pitfalls mentioned include the following: (1) conflicting meanings of several frequently used terms as found in the literature, each meaning having authoritative sponsorship; (2) incomplete and hence potentially misleading descriptions of specimens on which reported data arc based; (3) reference to emissivity or remittance as a property of a surface rather than a volume property (influenced by the surface); (4) occasional omission of diffuse reflection from analyses of the optical properties of inhomogeneous bodies; (5) failure to observe the restrictions upon conditions that are required for validity of basic equations; (6)uncertainties as to the effective temperature, peculiar to specimens having low absorption indices; and (7) lack of suitable physical standards. Several suggestions are made for avoid­ing or minimizing the consequences of the pitfalls discussed.

THERMAL RADIATION↗

Tables for Supersonic Flow Around Right Circular Cones at Small Angle of Attack

The solution of supersonic flow fields by the method of characteristics requires that starting conditions be known. Ferri, in reference 1, developed a method-of-characteristics solution for axially symmetric bodies of revolution at small angles of attack. With computing machinery that is now available, this has become a feasible method for computing the aerodynamic characteristics of bodies near zero angle of attack. For sharp-nosed bodies of revolution, the required starting line may be obtained by computing the flow field about a cone at a small angle of attack. This calculation is readily performed using Stone's theory in reference 2. Some solutions of this theory are available in reference 3. However, the manner in which these results are presented, namely in a wind-fixed coordinate system, makes their use somewhat cumbersome. Additionally, as pointed out in reference 4, the flow component perpendicular to the meridian planes was computed incorrectly. The results contained herein have been computed in the same basic manner as those of reference 3 with the correct velocity normal to the meridian planes. Also, all results have been transferred into the body-fixed coordinate system. Therefore, the values tabulated herein may be used, in conjunction with the respective zero-angle-of-attack results of reference 5, as starting conditions for the method-of-characteristics solution of the flow field about axially symmetric bodies of revolution at small angles of attack. As in the zero-angle-of-attack case (ref. 5) the present results have been computed using the ideal gas value of 1.4 for the ratio of the specific heats of air. Solutions are given for cone angles from 2.5 deg to 30 deg in increments of 2.5 deg. For each cone angle, results were computed for a constant series of free-stream Mach numbers from 1.5 to 20. In addition, a solution was computed which yielded the minimum free-stream Mach number for a completely supersonic conical flow field. For cone angles of 27.5 deg and 30 deg, this minimum free-stream Mach number was above 1.5. Consequently, solutions at this Mach number were not computed for these two cone angles.

SUPERSONIC FLOW↗

Nasa research on the aerodynamics of jet vtol engine installations

This paper summarizes some of the more pertinent results of NASA investigations related to the aerodynamics of jet VTOL engine installations. It shows that there is a base loss in hovering due to suction forces creased on the underside of the fuselage by the entrainment of ambient air in the slipstream, and that the magnitude of this effect is related to the turbulence in the jet stream and its consequent rate of mixing with ambient air. It also shows that there are large lift losses and pitching moments due to jet-free-stream interference and that these characteristics can be significantly altered by proximity to the ground. And, finally, it shows that simple bellmouth inlets give good pressure recovery and low distortion for vertically mounted lift engines if the inlet lip radius is sufficiently large, but that such inlets are not suitable for windmill starting of the engines.

VTOL AIRCRAFT↗

A Technique for Simulating Conditions of Walking and Performing Other Self-Locomotive Activities on the Lunar Terrain

One of the most important and probably the most interesting phase of a manned lunar mission will be the time the astronauts spend outside their vehicle on the moon's surface taking scientific measurements, exploring the surface features, surveying possible sites for a lunar base, inspecting their vehicle and preparing it for their return trip. Because the lunar gravity is only one-sixth that of the earth gravity, the explorers undoubtedly will have to adjust their accustomed methods of walking, climbing, jumping and performing other self-locomotive activities in order to carry out these various tasks. In as much as the over-all success of the lunar mission will depend to a large extent upon the self-reliance of the explorers, it will be necessary to have extensive knowledge of the effects of the moon's reduced gravity on the physical capabilities of man and of man's ability to adopt to the new environment prior to the planning and execution of the mission. At the present time there is a dearth of information on this subject due primarily to the lack of a practical technique for simulating the reduced gravity. Several techniques such as immersion in water and riding in an airplane flying a Keplerian trajectory have been used for zero-g or weightlessness studies to determine the physical capabilities of man but these techniques are limited in their usefulness either by restrictions imposed by the viscous effect of the water or by the short duration and small test area available in an airplane. Consequently, an effort was made at the NASA Langley Research Center to devise a new technique that would provide a realistic simlation of a reduced gravity for unlimited periods of time and allow freedom of movement over considerable distances. This paper concerns itself with a discussion of the newly developed simulation technique and a presentation of some preliminary results which were obtained utilizing a working model based on this scheme.

Hewes, Donald E.↗

Descent capability of two-propeller tilt-wing configurations

The wing stall problem encountered with tilt-wing V/STOL designs during low-powered descent flight conditions has led to buffeting which adversely affects both performance and handling qualities. The results of tests conducted in the Langley full-scale wind tunnel with a large semi­span model of a two-propeller tilt-wing configuration have indicated that three important factors provide substantial improvement in in the wing stall characteristics with consequent improvement in descent capability: down­-at-center propeller rotation resulted in delayed inboard stalling and pro­vided far better descent capability than the up-at-center rotation, moderate lowering of the propeller position relative to the wing chord provided further improvement in descent capability, and some flap deflec­tion was absolutely essential in order to have any descent capability for low-powered flight conditions. Use of all three factors should provide good descent capability even without the complexity of other sophisticated stall control devices.

WING STALL↗

Concave-convex growth spirals.

The simple model for introduction of a screw dislocation into a crystal leaves a step in those surfaces of the crystal that intersect the axis of the screw dislocation such that the Burgers vector has a finite component perpendicular to the surfaces. When two parallel surfaces of a crystal intersect the same screw dislocation, the resultant step, on opposite sides of the crystal, face in opposite directions. Consequently, when two such surfaces grow by accretion of the molecules at the steps, the steps wind themselves into spirals that appear to have opposite senses of rotation when viewed along the axis of the screw dislocation. Furthermore, the growth structure that results is a plano convex cone or pyramid centered on the screw dislocation. When growth occurs simultaneously on both sides of a crystal, a doubly convex structure will develop under the control of a singe screw dislocation.

Crystal growth↗

The rotation of the planet Mercury.

Mercury rotational period as consequence of solar torques and equatorial asymmetry, based on radar data and model developing superharmonic resonance

RADAR OBSERVATION↗

Study made of ductility limitations of aluminum-silicon alloys

Study of the relation between microstructure and mechanical properties of aluminum-silicon alloys determines the cause of the variations in properties resulting from differences in solidification rate. It was found that variations in strength are a consequence of variations in ductility and that ductility is inversely proportional to dendrite cell size.

Bailey, W. A.↗

Investigation to define the propagation characteristics of a finite amplitude acoustic pressure wave

A theoretical analysis of the propagation characteristics of a finite amplitude pressure wave is presented. The analysis attempts to study the contribution of entropy-producing regions to the mechanism of aerodynamic noise generation. It results in a nonlinear convective wave equation in terms of entropy and a thermodynamic 'J' function. A direct analogy between the derived governing equation and those used in classical literature is obtained. An idealization of the processes considered permits the uncoupling of the equations of motion with a consequent construction of an acoustic analogy treating shock wave emission of finite amplitude acoustic waves. An engineering approach is reflected in the concept of an extended plug nozzle whose function is to facilitate aerodynamic noise attenuation by modifying the entropy-producing regions.

Peter, A. C.↗

Quasiparticle-ensemble theory for a normal Fermi liquid.

A quasiparticle ensemble ( Q ensemble) is constructed in which the number of quasiparticles with momentum k in the ensemble is conserved. The thermodynamic properties of this ensemble are related to those of the grand canonical ensemble. By comparison with explicit microscopic predictions of the theory, it is shown that this formulation is necessary if the third law of thermodynamics is to be satisfied, and that in this case, the Landau theory of a Fermi liquid follows as a natural consequence.

Quantum mechanics↗

On the decoupling of multivariable systems.

Necessary and sufficient conditions for decoupling time-invariant linear multivariable system by state variable feedback, discussing transfer matrix consequences

MATRIX ALGEBRA↗