SEARCH · Engineering Papers

Results for “Demonstration”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 757 records · Page 42

All sources NASA NTRS DOE OSTI

NASA NTRS1990

The JPL/KSC telerobotic inspection demonstration

An ASEA IRB90 robotic manipulator with attached inspection cameras was moved through a Space Shuttle Payload Assist Module (PAM) Cradle under computer control. The Operator and Operator Control Station, including graphics simulation, gross-motion spatial planning, and machine vision processing, were located at JPL. The Safety and Support personnel, PAM Cradle, IRB90, and image acquisition system, were stationed at the Kennedy Space Center (KSC). Images captured at KSC were used both for processing by a machine vision system at JPL, and for inspection by the JPL Operator. The system found collision-free paths through the PAM Cradle, demonstrated accurate knowledge of the location of both objects of interest and obstacles, and operated with a communication delay of two seconds. Safe operation of the IRB90 near Shuttle flight hardware was obtained both through the use of a gross-motion spatial planner developed at JPL using artificial intelligence techniques, and infrared beams and pressure sensitive strips mounted to the critical surfaces of the flight hardward at KSC. The Demonstration showed that telerobotics is effective for real tasks, safe for personnel and hardware, and highly productive and reliable for Shuttle payload operations and Space Station external operations.

Mittman, David↗

NASA NTRS1989

Establishing viable task domains for telerobot demonstrations

A suite of telerobotic tasks has been compiled and assessed for the purpose of selecting viable tasks for near and far term laboratory demonstrations. The primary intent of developing the task is to provide some technical guidelines, with supporting data, for focusing laboratory demonstrations toward application domains that address a wide array of potential telerobot tasks and required technologies. This wide application would then result in a rich technology development environment to meet the broad task requirements of a system such as the Flight Telerobot Servicer. The methodology and results of the telerobot task assessment are described, including a ranking of the final select suite of major tasks. The presented along with guidelines for both interpreting the task ranking results and setting programmatic objectives based on these results. Detailed data about the task candidates and their respective levels of complexity, task primitive actions, and the actual relative measures of task worth as associated with key tradeoff variables such as cost, available research resources, technology availability, and importance to the user community are also presented.

Zimmerman, Wayne↗

NASA NTRS1989

Dexterous manipulator flight demonstration

The Dexterous Manipulator Flight Experiment, an outgrowth of the Dexterous End Effector project, is an experiment to demonstrate newly developed equipment and methods that make for a dexterous manipulator which can be used on the Space Shuttle or other space missions. The goals of the project, the objectives of the flight experiment, the experiment equipment, and the tasks to be performed during the demonstration are discussed.

Carter, Edward L.↗

NASA NTRS1988

NASA telerobot testbed development and core technology demonstration

In 1985, NASA initiated a major program of technology development and demonstration for robotics applications to space servicing, assembly, repair, and remote exploration. A ground-based telerobot testbed at the Jet Propulsion Laboratory has been the focal point within this program. Designed to prove technology concepts for supervised automation of increasingly unstructured and complex tasks, the testbed has reached an initial stage of integration. Several significant testbed experiments have been performed, including visual tracking and grapple of a satellite, dual-arm spatial coordination and manipulator control, force-reflecting teleoperations, and simulated task planning for a satellite servicing scenario. The current NASA plans for continuing testbed development and demonstration are also described.

Schenker, Paul S.↗

NASA NTRS1988

The Systems Autonomy Demonstration Project - Catalyst for Space Station advanced automation

The Systems Autonomy Demonstration Project (SADP) was initiated by NASA to address the advanced automation needs for the Space Station program. The application of advanced automation to the Space Station's operations management system (OMS) is discussed. The SADP's future goals and objectives are discussed with respect to OMS functional requirements, design, and desired evolutionary capabilities. Major technical challenges facing the designers, developers, and users of the OMS are identified in order to guide the definition of objectives, plans, and scenarios for future SADP demonstrations, and to focus the efforts on the supporting research.

Healey, Kathleen J.↗

NASA NTRS1989

Demonstrating system for servicing satellites

NASA has initiated a program to demonstrate a Satellite Servicer System prototype in a series of flight tests with the Space Shuttle. When the commitment to an operational system has been demonstrated, it is anticipated that a variety of missions will develop that can productively use the servicing capability. Rendezvous and proximity operations contain key enabling technologies needed for an effective operational system. Guidance, navigation and control hardware and operational techniques must be integrated into the program. Supporting sensor technology may limit or enhance the capability of the system depending on its readiness. Requirements for docking the spacecraft in the system concept development and technology requirements are reviewed. Examples of the initial assessment of technology readiness and applications opportunities are discussed. The degree of autonomy is of particular interest.

Jenkins, Lyle M.↗

NASA NTRS1990

Navigation accuracies for GPS demonstration on Topex/Poseidon

When Topex/Poseidon, is launched in June 1992, the joint United States/French oceanographic satellite mission will carry a developmental Global Positioning System (GPS) receiver on board to support the planned GPS demonstration experiment. The navigation operations aspect of the demonstration will develop software and operational procedures for the GPS Data Processing Facility (GDPF) at NASA's Jet Propulsion Laboratory. This paper presents simulations and covariance analysis of operational scenarios in support of the GDPF. Multi-orbit filter techniques using GPS carrier phase and P-code pseudo-range are studied both to tune the filter parameters and to determine feasible arc lengths for use in operations. In addition, a baseline operational scenario is presented with performance results given in terms of end-to-end processing times and computational loading based on a prototype version of the operational software.

Williams, B. G.↗

NASA NTRS1990

Technical aspects of a demonstration tape for three-dimensional sound displays

This document was developed to accompany an audio cassette that demonstrates work in three-dimensional auditory displays, developed at the Ames Research Center Aerospace Human Factors Division. It provides a text version of the audio material, and covers the theoretical and technical issues of spatial auditory displays in greater depth than on the cassette. The technical procedures used in the production of the audio demonstration are documented, including the methods for simulating rotorcraft radio communication, synthesizing auditory icons, and using the Convolvotron, a real-time spatialization device.

Begault, Durand R.↗

NASA NTRS1991

A space servicing telerobotics technology demonstration

Supervised telerobotic controls provide the key to successful remote servicing, as demonstrated in the telerobot testbed of the jet propulsion laboratory. Such advanced techniques and systems are specially applicable to ground-remote operations for servicing tasks, which are to be performed remotely in space and to be operated under human supervision from the ground. Laboratory demonstrations have successfully proven the utility of such techniques and systems. Instrumental to the success of supervised robotic operations are the techniques called object designate and relative target. In addition, a technique called universal camera calibration was also applied in the telerobot testbed. Generalized compliant control techniques were used in the robotic removal and insertion operations. These techniques were proven successful in task situations where preprogrammed automation cannot be adequately exercised due to errors, changes, or omission in the worksite data base.

Kan, Edwin P.↗

NASA NTRS1991

Detonation duct gas generator demonstration program

The feasibility of the generation of detonation waves moving periodically across high speed channel flow is experimentally demonstrated. Such waves are essential to the concept of compressing requirements and increasing the engine pressure compressor with the objective of reducing conventional compressor requirements and increasing the engine thermodynamic efficiency through isochoric energy addition. By generating transient transverse waves, rather than standing waves, shock wave losses are reduced by an order of magnitude. The ultimate objective is to use such detonation ducts downstream of a low pressure gas turbine compressor to produce a high overall pressure ratio thermodynamic cycle. A 4 foot long, 1 inch x 12 inch cross-section, detonation duct was operated in a blow-down mode using compressed air reservoirs. Liquid or vapor propane was injected through injectors or solenoid valves located in the plenum or the duct itself. Detonation waves were generated when the mixture was ignited by a row of spark plugs in the duct wall. Problems with fuel injection and mixing limited the air speeds to about Mach 0.5, frequencies to below 10 Hz, and measured pressure ratios of about 5 to 6. The feasibility of the gas dynamic compression was demonstrated and the critical problem areas were identified.

Wortman, Andrew↗

NASA NTRS1990

Results of the Systems Autonomy Demonstration Project

The Systems Autonomy Demonstration Project (SADP) produced a knowledge-based real-time control system for real-time control and fault detection, isolation and recovery (FDIR) of a prototype two-phase Space Station Freedom external control system (TCS). The Thermal Expert System (TEXSYS) was demonstrated in recent tests to be capable of reliable fault anticipation and detection, as well as nominal control of the thermal bus. Performance requirements were addressed by adopting a hierarchical symbolic control approach, layering model-based expert system software on a conventional numerical data acquisition and control system. The model-based capabilities of TEXSYS were shown to be advantageous, particularly for detection of unforeseen faults and sensor failures.

Glass, B. J.↗

NASA NTRS1989

In flight demonstration of mass property identification and jet plume interaction on the AeroAssist Flight Experiment

Algorithms have been developed for in-flight demonstration of spacecraft mass, center of mass, and inertia matrix which autonomously measure mass properties as they change in-flight due to consumable expenditures, payload deployment/retrieval, and docking. The testing of these algorithms can be conducted by means of a mass-properties estimator, which is a second-order nonlinear filter resembling an extended Kalman filter. The AeroAssist Flight Experiment, which will demonstrate the use of the earth's atmosphere to assist orbital changes, will carry the Rarefied-flow Aerodynamic Measurement Experiment (RAME); data taken by RAME will be used by the mass-properties estimator to ascertain spacecraft mass properties, and estimates from this filter will be compared to predicted values of the mass properties to validate the estimator.

Bergmann, Edward V.↗

NASA NTRS1991

Turbofan engine demonstration of sensor failure detection

In the paper, the results of a full-scale engine demonstration of a sensor failure detection algorithm are presented. The algorithm detects, isolates, and accommodates sensor failures using analytical redundancy. The experimental hardware, including the F100 engine, is described. Demonstration results were obtained over a large portion of a typical flight envelope for the F100 engine. They include both subsonic and supersonic conditions at both medium and full, nonafter burning, power. Estimated accuracy, minimum detectable levels of sensor failures, and failure accommodation performance for an F100 turbofan engine control system are discussed.

Merrill, Walter C.↗

NASA NTRS1991

Experimental demonstration of a classical approach for flexible structure control - The ACES testbed

This paper describes the results of an active structural control experiment performed for the Advanced Control Evaluation for Structures (ACES) testbed at NASA-Marshall as part of the NASA Control-Structure Interaction Guest Investigator Program. The experimental results successfully demonstrate the effectiveness of a 'dipole' concept for line-of-sight control of a pointing system mounted on a flexible structure. The simplicity and effectiveness of a classical 'single-loop-at-a-time' approach for the active structural control design for a complex structure, such as the ACES testbed, are demonstrated.

Wie, Bong↗

NASA NTRS1991

KBS Demonstration

The Knowledge Based System (KBS) demonstration included five different items: the executive program, three of the industrial codes, and graphical display capability using current MYI MS-DOS programs. The graphics capability included two and three dimensional plots viewed from different angles. This capability will be ported to OS/2 and made an integral part of the KBS executive program. The three codes demonstrated included Spiral Groove Gas Seals (SPIRAL), Gas Cylindrical Seals (GCYL), and Incompressible Seals (ICYL). The SPIRAL and GCYL interface has the standard PM interface, while the ICYL interface was designed using ToolBook.

Aggarwal, Bharat↗

NASA NTRS1992

Real-time demonstration hardware for enhanced DPCM video compression algorithm

The lack of available wideband digital links as well as the complexity of implementation of bandwidth efficient digital video CODECs (encoder/decoder) has worked to keep the cost of digital television transmission too high to compete with analog methods. Terrestrial and satellite video service providers, however, are now recognizing the potential gains that digital video compression offers and are proposing to incorporate compression systems to increase the number of available program channels. NASA is similarly recognizing the benefits of and trend toward digital video compression techniques for transmission of high quality video from space and therefore, has developed a digital television bandwidth compression algorithm to process standard National Television Systems Committee (NTSC) composite color television signals. The algorithm is based on differential pulse code modulation (DPCM), but additionally utilizes a non-adaptive predictor, non-uniform quantizer and multilevel Huffman coder to reduce the data rate substantially below that achievable with straight DPCM. The non-adaptive predictor and multilevel Huffman coder combine to set this technique apart from other DPCM encoding algorithms. All processing is done on a intra-field basis to prevent motion degradation and minimize hardware complexity. Computer simulations have shown the algorithm will produce broadcast quality reconstructed video at an average transmission rate of 1.8 bits/pixel. Hardware implementation of the DPCM circuit, non-adaptive predictor and non-uniform quantizer has been completed, providing realtime demonstration of the image quality at full video rates. Video sampling/reconstruction circuits have also been constructed to accomplish the analog video processing necessary for the real-time demonstration. Performance results for the completed hardware compare favorably with simulation results. Hardware implementation of the multilevel Huffman encoder/decoder is currently under development along with implementation of a buffer control algorithm to accommodate the variable data rate output of the multilevel Huffman encoder. A video CODEC of this type could be used to compress NTSC color television signals where high quality reconstruction is desirable (e.g., Space Station video transmission, transmission direct-to-the-home via direct broadcast satellite systems or cable television distribution to system headends and direct-to-the-home).

Bizon, Thomas P.↗

NASA NTRS1992

A demonstration of an intelligent control system for a reusable rocket engine

An Intelligent Control System for reusable rocket engines is under development at NASA Lewis Research Center. The primary objective is to extend the useful life of a reusable rocket propulsion system while minimizing between flight maintenance and maximizing engine life and performance through improved control and monitoring algorithms and additional sensing and actuation. This paper describes current progress towards proof-of-concept of an Intelligent Control System for the Space Shuttle Main Engine. A subset of identifiable and accommodatable engine failure modes is selected for preliminary demonstration. Failure models are developed retaining only first order effects and included in a simplified nonlinear simulation of the rocket engine for analysis under closed loop control. The engine level coordinator acts as an interface between the diagnostic and control systems, and translates thrust and mixture ratio commands dictated by mission requirements, and engine status (health) into engine operational strategies carried out by a multivariable control. Control reconfiguration achieves fault tolerance if the nominal (healthy engine) control cannot. Each of the aforementioned functionalities is discussed in the context of an example to illustrate the operation of the system in the context of a representative failure. A graphical user interface allows the researcher to monitor the Intelligent Control System and engine performance under various failure modes selected for demonstration.

Musgrave, Jeffrey L.↗

NASA NTRS1992

In orbit demonstration of a H-maser clock system

The ESA/NASA technology demonstration flight of a pair of hydrogen masers on the EURECA 3 mission is planned for 1998. The ESA part of the experiment will have a maser built by Neuchatel Observatory and a microwave time and frequency transfer system derived from the existing Precise Range and Range Rate Equipment (PRARE) system. The NASA part of the experiment will have a maser built by the Smithsonian Astrophysical Observatory and a laser time transfer system. The technology demonstration experiment is described with its expected outcomes and applications.

Busca, Giovanni↗