SEARCH · Engineering Papers

Results for “drops”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 739 records · Page 41

All sources NASA NTRS DOE OSTI

NASA NTRS1986

Drop testing and analysis of six-foot diameter graphite-epoxy frames

Graphite-epoxy frames were drop tested onto a concrete floor to simulate crash loadings. The frames have Z-shaped cross-sections typical of designs often proposed for fuselage structure of advanced composite transports. The 6-foot diameter of the frames was chosen to reduce specimen fabrication costs and to facilitate testing. Response of the frames from accelerometer, strain gage, and photographic measurements are presented which characterize the behavior under 25-30 fps vertical impact velocity onto concrete. Failure of the graphite-epoxy frames involved a complete separation through the cross section near the impact point. All damage to the composite frame was confined to an area close to the impact point. Failure of aluminum frames tested for comparison were different from the composite specimens. The aluminum frames yielded (plastic hinges formed) at several locations around the lower portion of the frame without failing completely across the section.

Boitnott, R. L.↗

NASA NTRS1986

Evaluation of the importance of the relative velocity during evaporation of drops in sprays

The importance of relative velocity past individual drops composing a burning spray with an envelope flame is estimated by applying the Bellan and Cuffel (1983) spray evaporation model to an ambient flow going around the spray without penetrating it. The model assumes a spherical spray composed of monodisperse uniformly distributed droplets which all move at the same speed, and relative gas/spray velocities, and spray radii used were representative of boiler and furnace operations. Numerical calculations indicate that the spray is more prone to ambient flow penetration for leaner mixtures (particularly for n = 1/cu cm), lower initial temperatures of gas phase and droplet, and more dilute spray configurations.

Bellan, J.↗

NASA NTRS1986

Measurement of heat transfer and pressure drop in rectangular channels with turbulence promoters

Periodic rib turbulators were used in advanced turbine cooling designs to enhance the internal heat transfer. The objective of the present project was to investigate the combined effects of the rib angle of attack and the channel aspect ratio on the local heat transfer and pressure drop in rectangular channels with two opposite ribbed walls for Reynolds number varied from 10,000 to 60,000. The channel aspect ratio (W/H) was varied from 1 to 2 to 4. The rib angle of attack (alpha) was varied from 90 to 60 to 45 to 30 degree. The highly detailed heat transfer coefficient distribution on both the smooth side and the ribbed side walls from the channel sharp entrance to the downstream region were measured. The results showed that, in the square channel, the heat transfer for the slant ribs (alpha = 30 -45 deg) was about 30% higher that of the transverse ribs (alpha = 90 deg) for a constant pumping power. However, in the rectangular channels (W/H = 2 and 4, ribs on W side), the heat transfer at alpha = 30 -45 deg was only about 5% higher than 90 deg. The average heat transfer and friction correlations were developed to account for rib spacing, rib angle, and channel aspect ratio over the range of roughness Reynolds number.

Han, J. C.↗

NASA NTRS1987

Use of the updated NASA Langley radio-controlled drop-model technique for high-alpha studies of the X-29A configuration

This paper presents an overview of the radio-controlled drop-model technique used for low-speed flight dynamics research at the NASA Langley Research Center. The overall test methodology is reviewed and the major elements of the system are discussed including model construction and equipment, the closed-loop control system, and the flight test facility. To illustrate the capabilities of the technique, selected results from an ongoing program to study the high-angle-of-attack flight dynamics of the X-29A configuration are reviewed. Three research areas are highlighted: motion prediction, control system effects, and motion analysis and modeling. Finally, several current upgrades to the overall technique are discussed along with the enhanced test capability that they will provide.

Fratello, David J.↗

NASA NTRS1987

Analysis of lateral stability of X-29 drop model using system identification methodology

A 22-percent dynamically scaled replica of the X-29 forward-swept-wing aircraft is currently being flown in radio-controlled drop tests at NASA Langley's Plumtree Test Site. Flight data were recorded from early flights in the test program, which consisted mainly of large amplitude maneuvers over wide angle-of-attack ranges with several uncontrolled wing rock episodes. A system identification study of the recorded data was undertaken to examine the stability and control derivatives which influence the lateral behavior of this vehicle with particular emphasis on the wing rock phenomenon. All major lateral stability derivatives and the damping-in-roll derivative were identified for 5-80 deg angle-of-attack by using a data partitioning methodology and a modified stepwise regression algorithm. No control effectiveness derivatives could be identified from the flights conducted so far.

Raney, David L.↗

NASA NTRS1988

Characterization of fatigue crack initiation and propagation in Ti-6Al-4V with electrical potential drop technique

Electrical potential methods have been used in the past primarily to monitor crack length in long crack specimens subjected to fatigue loading. An attempt was made to develop test procedures for monitoring the fatigue crack initiation and the growth of short fatigue cracks in a turbine disk alloy with the electrical potential drop technique (EPDT). In addition, the EPDT was also applied to monitor the fatigue crack growth in long crack specimens of the same alloy. The resolution of the EPDT for different specimen geometries was determined. Factors influencing the EPDT are identified and the applicability of EPDT in implementing damage tolerant design concepts for turbine disk materials is discussed. The experimental procedure adopted and the results obtained is discussed. No substantial differences were observed between the fatigue crack growth data of short and long crack specimens.

Kalluri, Sreeramesh↗

NASA NTRS1988

General equations for the motions of ice crystals and water drops in gravitational and electric fields

General equations for the Reynolds number of a variety of types of ice crystals and water drops are given in terms of the Davies, Bond, and Knudsen numbers. The equations are in terms of the basic physical parameters of the system and are valid for calculating velocities in gravitational and electric fields over a very wide range of sizes and atmospheric conditions. The equations are asymptotically matched at the bottom and top of the size spectrum, useful when checking large computer codes. A numerical system for specifying the dimensional properties of ice crystals is introduced. Within the limits imposed by such variables as particle density, which have large deviations, the accuracy of velocities appears to be within 10 percent over the entire range of sizes of interest.

Nisbet, John S.↗

NASA NTRS1985

Undercooling of niobium-germanium alloys in a 100 meter drop tube

The undercoolings of pure Nb and Nb-Ge alloys are examined using the 100-m drop tube of the Marshall Space Flight Center. The temperatures of the samples prior to release were measured, and IR detectors were utilized to monitor recalescence from solidification. It is observed that the Nb and Nb-Ge samples undercooled to the homogeneous nucleation limit. The data reveal that all the samples displayed a dendritic primary phase, except for alloys nucleating in the beta-phase field, which had a cellular phase. The composition of these phases are studied using EDXA; it is detected that the composition of the phases corresponds to the Jorda (1978) phase diagram.

Hofmeister, W. H.↗

NASA NTRS1987

Third-order resonance effects and the nonlinear stability of drop oscillations

The three-dimensional nonlinear oscillations of an isolated, inviscid drop with surface tension are studied by a multiple timescale analysis and pre-averaging applied to the variational principle for the appropriate Lagrangian. Amplitude equations are derived which describe the generic cubic resonance caused by the spatial degeneracy of the eigenfrequencies of the linear normal modes. This resonant coupling leads to the instability of the finite amplitude axisymmetric oscillations to small nonaxisymmetric perturbations, as is demonstrated here for the three- and four-lobed normal modes. Solutions to the interaction equations that describe finite amplitude, nonaxisymmetric traveling-wave solutions are also obtained and their stability is investigated. A nongeneric cubic resonance between the two-lobed and four-lobed oscillatory modes leads to quasi-periodic motions.

Natarajan, Ramesh↗

NASA NTRS1988

Pressure drop and temperature rise in He II flow in round tubes, Venturi flowmeters and valves

Pressure drops in highly turbulent He II flow were measured in round tubes, valves, and Venturi flowmeters. Results are in good agreement with single-phase flow correlations for classical fluids. The temperature rise in flow in a round tube was measured, and found to agree well with predictions for isenthalpic expansion. Cavitation was observed in the venturis under conditions of low back pressure and high flow rate. Metastable superheating of the helium at the venturi throat was observed before the helium made a transition to saturation pressure.

Walstrom, P. L.↗

NASA NTRS1988

The dynamics of free liquid drops

The behavior of rotating and oscillating free liquid drops was studied by many investigators theoretically for many years. More recent numerical treatments have yielded predictions which are yet to be verified experimentally. The purpose is to report the results of laboratory work as well as that of the experiments carried out in space during the flight of Spacelab 3, and to compare it with the existing theoretical studies. Ground-based experiments were attempted as a first approximation to the ideal boundary conditions used by the theoretical treatments by neutralizing the overwhelming effects of the Earth's gravitational field with an outside supporting liquid and with the use of levitation technology. The viscous and inertial loading of such a suspending fluid was found to profoundly effect the results, but the information thus gathered has emphasized the uniqueness of the experimental data obtained in the low-gravity environment of space.

Wang, T. G.↗

NASA NTRS1989

Lateral stability analysis for X-29A drop model using system identification methodology

A 22-percent dynamically scaled replica of the X-29A forward-swept-wing airplane has been flown in radio-controlled drop tests at the NASA Langley Research Center. A system identification study of the recorded data was undertaken to examine the stability and control derivatives that influence the lateral behavior of this vehicle with particular emphasis on an observed wing rock phenomenon. All major lateral stability derivatives and the damping-in-roll derivative were identified for angles of attack from 5 to 80 degrees by using a data-partitioning methodology and a modified stepwise regression algorithm.

Raney, David L.↗

NASA NTRS1988

Oscillations of drops in zero gravity with weak viscous effects

Nonlinear oscillations and other motions of large axially symmetric liquid drops in zero gravity are studied numerically by a boundary-integral method. The effect of small viscosity is included in the computations by retaining first-order viscous terms in the normal stress boundary condition. This is accomplished by making use of a partial solution of the boundary-layer equations which describe the weak vortical surface layer. Small viscosity is found to have a relatively large effect on resonant mode coupling phenomena.

Lundgren, T. S.↗

NASA NTRS1989

General equations for the motions of ice crystals and water drops in gravitational and electric fields

Nisbet, John S.↗

NASA NTRS1988

Undercooling studies on Nb-Pt and Nb-Si alloys using the 105 meter drop tube

Niobium-platinum samples of compositions ranging from 16 to 32 at. pct have been undercooled to as much as 540 K in the low gravity, containerless environment of a 105 meter drop tube. Undercooling was terminated in the Nb-Pt samples by the nucleation and growth of the Nb3Pt phase. In the 16-18 at. pct Pt samples, this resulted in samples which are completely Nb3Pt, in contrast to both the equilibrium phase diagram and the nonundercooled samples which formed with Nb dendrites and interdendritic Nb3Pt. Undercoolings for the Nb-Si samples were up to 670 K, which corresponds to 27 percent of the liquidus temperature or 80 percent of the estimated hypercooling limit. In the Nb-Si system, a coupled zone was identified as well as a metastable extension of the solubility limit of Si in Nb due to deep undercooling.

Robinson, M. B.↗

NASA NTRS1990

Predicting Pressure Drop In Porous Materials

Theory developed to predict drop in pressure based on drag of individual fibers. Simple correlation method for data also developed. Helps in predicting flow characteristics of many strain-isolation pad (SIP) glow geometries in Shuttle Orbiter tile system. Also helps in predicting venting characteristics of tile assemblies during ascent and leakage of hot gas under tiles during descent. Useful in study of mechanics of flows through fibrous and porous media, and procedures applicable to purged fiberglass insulation, dialysis filters, and other fibrous and porous media.

Lawing, Pierce L.↗

NASA NTRS1990

Behavior Of Evaporating Liquid Drops In Clusters

Report presents critical analysis of methods, developed for calculating behavior of evaporating liquid drops in dense and dilute clusters. Essential to understanding variety of physical and chemical phenomena occurring in combustion of sprayed fuels and in sprays used in agriculture, food industry, and painting. Presents insights on important aspects of two-phase flow.

Bellan, Josette↗

NASA NTRS1990

Comparison of drop size distributions from two droplet sizing systems

A comparison between the Phase Doppler Particle Analyzer and the combined measurements from Particle Measuring Systems' Forward Scattering Spectrometer Probe and the Optical Array Probe was conducted in an icing wind tunnel using NASA Icing Research Tunnel spray nozzles to produce the supercooled water droplet cloud. Clouds having a range of volume median diameters from 10 to greater than 50 microns were used for the instrument comparisons. A volume median diameter was calculated from combining the droplet distributions of the Optical Array Probe and the Forward Scattering Spectrometer Probe. A comparison of the combined volume median diameters and the Phase Doppler Particle Analyzer volume median diameters showed agreement from 10 microns up to 30 microns. Typical drop size distributions from the Phase Doppler Particle Analyzer, the Forward Scattering Spectrometer Probe, and Optical Array Probe are presented for several median volume diameters. A comparison of the distributions illustrates regions of the distributions where there is good agreement and other regions where there are discrepancies between the Phase Doppler Particle Analyzer and the Particle Measuring Systems' droplet size instruments.

Oldenburg, John R.↗