Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “STREAMS”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 739 records · Page 41
All sourcesNASA NTRSDOE OSTI
NASA NTRS1971

Analysis of Free-Flight Laminar, Transitional, and Turbulent Heat-Transfer Results at Free-Stream Mach Numbers Near 20 (Reentry F)

Laminar, transitional, and turbulent heat-transfer data were measured during a reentry flight at a Mach number of 20 on a 5 deg half-angle cone 3.962 m (13 ft) long with an initial nose tip radius of 0.254 cm (0.1 in.). The free-stream Reynolds number increased during the prime data period from 7.0 x 10(exp 6) to 51.5 x 10(exp 6) per meter (2.1 x 10(exp 6) to 15.7 x 10(exp 6) per foot) and the ratio of wall to total temperature varied from 0.053 to 0.12. The angle of attack was less than 1deg for the prime data period. The experimental laminar and turbulent heating rates are compared with results from existing flat-plate prediction methods. At conditions of minimal tip blunting and angle of attack (above 26.8 km (88 000 ft)), values from a flat-plate laminar method agreed within 20 percent with the laminar data. The Schultz-Grunow skin-friction equation with reference enthalpy; conditions, with the Reynolds number based on distance from the transition location, and with the Colburn Reynolds analogy agreed within 10 percent with the experimental turbuleiit heating data. The Van Driest n skin-friction equation with Reynolds number greater than 10(exp 7) based on distance from the peak heating point and the Colburn Reynolds analogy was also within approximately 10 percent of the experimental turbulent heating data. A data correlation jbf the extent of transition and a simple empirical transition-zone heating correlation were also presented.

Zoby, Ernest V.↗
NASA NTRS1971

Turbulent jet mixing in a supersonic stream

An experimental study of turbulent, subsonic, coaxial jet mixing of air in a supersonic air stream is presented. Data taken at five axial stations downstream of the exit of the jet supply tube, which was suspended through the nozzle throat of a supersonic wind tunnel, are given in the form of total pressure, Mach number, and velocity distributions. An investigation of the effect of swirl as a mixing aid was conducted. Swirl, produced by tangential injection of 50% of the total air mass flow leaving the jet supply tube, was examined through Schlieren photographs and total pressure surveys. From a comparison of nonswirl and swirl data, it is concluded that the swirl has no discernible effect on the mixing.

Swanson, R. C.↗
NASA NTRS1972

A study analysis of cable-body systems totally immersed in a fluid stream

A general stability analysis of a cable-body system immersed in a fluid stream is presented. The analytical portion of this analysis treats the system as being essentially a cable problem, with the body dynamics giving the end conditions. The mathematical form of the analysis consists of partial differential wave equations, with the end and auxiliary conditions being determined from the body equations of motion. The equations uncouple to give a lateral problem and a longitudinal problem as in first order airplane dynamics. A series of tests on a tethered wind tunnel model provide a comparison of the theory with experiment.

Delaurier, J. D.↗
NASA NTRS1972

Oxidation and thermal fatigue of coated and uncoated NX-188 nickel-base alloy in a high velocity gas stream

A cast nickel-base superalloy, NX-188, coated and uncoated, was tested in a high-velocity gas stream for resistance to oxidation and thermal fatigue by cycling between room temperature and 980, 1040, and 1090 C. Contrary to the behavior of more conventional nickel-base alloys, uncoated NX-188 exhibited the greatest weight loss at the lowest test temperature. In general, on the basis of weight change and metallographic observations a coating consisting of vapor-deposited Fe-Cr-Al-Y over a chromized substrate exhibited the best overall performance in resistance to oxidation and thermal fatigue.

Johnson, J. R.↗
NASA NTRS1972

Atomization, drop size, and penetration for cross-stream water injection at high-altitude reentry conditions with application to the RAM C-1 and C-3 flights

Atomization, drop size, and penetration data are presented for cross stream water injection at conditions simulating high altitude reentry (low Weber number, high static temperature, high Knudsen number, and low static pressure). These results are applied to the RAM C-1 and C-3 flights. Two primary breakup modes are considered, vapor pressure or flashing and aerodynamic atomization. Results are given for breakup boundaries and mean drop size for each of these atomization mechanisms. Both standard and flight orifice geometries are investigated. The data were obtained in both a static environment and in conventional aerodynamic facilities at Mach numbers of 4.5 and 8. The high temperature aspects of reentry were simulated in a Mach 5.5 cyanogen-oxygen tunnel with total temperature of 4500 K.

Gooderum, P. B.↗
NASA NTRS1972

A probe for measuring temperature and pressure at the same points in a gas stream

Design features and characteristics of a means for measuring total temperature and total pressure at a single point in a gas stream are presented. A rake that provides five such combination measurements is described. Experimental data are included for the aerodynamic recovery and time response of the temperature sensor and for the flow-angle sensitivity of both the temperature and pressure sensors. Data were obtained over a subsonic Mach number range of 0.3 to 0.9 as well as at a Mach number of 1.4.

Krause, L. N.↗
NASA NTRS1971

Thin electrostatically self-focusing electron streams.

Study of 30 to 380 microampere, 50 to 550 V, 1 to 2 mm, electrostatically self-focusing electron streams (50 cm long) drifting through mercury vapor (at 50 microtorr to 2 millitorr) in a tube with a radius of 6.6 cm. The inside surface of the tube is coated with a transparent layer whose resistivity is 50 ohm-cm per centimeter. In order to determine the charged-particle densities and the potential profile in and around the beam without disturbing the system, a multigrid electrostatic charged particle energy analyzer was used to study separately the energy distributions of both ions and electrons ejected radially from the beam. The results show two energy groupings for electrons. The energy distribution of the high-energy group is produced by ionizing collisions between beam electrons and neutral gas atoms; a group of flow-energy electrons becomes trapped in the potential well within and around the beam, subsequently escaping by collisional mechanisms.

Mccorkle, R. A.↗
NASA NTRS1971

Hot corrosion of TD nickel and TD nickel chromium in a high velocity gas stream.

Results of cyclical tests of TD nickel (2% thoria-dispersed nickel) and TD nickel chromium (2% thoria-dispersed nickel-20% chromium alloy) 1.5 mm (60 mil) sheet specimens for susceptibility to hot corrosion in a Mach 0.5 gas stream of Jet A-1 fuel combustion products containing 2 ppm sea salt. Tests as long as 500 one-hour cycles between room temperature and specimen hot zone temperatures of 899 C (1650 F), 982 C (1800 F), and 1149 C (2100 F) were performed. Evidence of hot corrosion was found for both materials in the 899 C (1650 F) and 982 C (1800 F) tests, but not at 1149 C (2100 F). It was concluded that because of high metal thickness losses neither alloy in sheet form is suitable for long-time engine application in a hot corrosion environment at temperatures of 982 C (1800 F) or above.

Sanders, W. A.↗
NASA NTRS1972

A space maintainability experiment aboard the Ben Franklin submersible during the 30-day Gulf Stream drift mission.

In the summer of 1969, a deep submersible drifted for 30 days below the surface of the Gulf Stream, while operated by a six man crew. The main purpose of the mission was oceanographic research. The crew's activities and completely self-contained environment resembled those of a space station such as Skylab. Because of these similarities aspects of onboard vehicle maintenance during the actual conduct of a scientific mission were investigated. The maintainability study was accomplished in six distinct phases. Two useful plots of manpower distribution were developed. A maintenance action summary is presented in a table.

Kappler, J. R.↗
NASA NTRS1972

Atomization of liquid droplets in a convective gas stream.

New experimental results are reported for the atomization of liquid droplets by a high-speed air stream. A series of experiments are described in which water droplets, ranging in diameter from 1000 to 2700 microns, were introduced into the test section of a shock tube and allowed to interact with the convective flow established by the passage of a propagating shock front. A rotating drum camera system was employed to obtain a collection of streak photographs of the atomization process from which the breakup time, the breakup distance, and the ultimate atomized particle size were determined.

Ranger, A. A.↗