SEARCH · Engineering Papers

Results for “transitivity”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

SourceResearch connectionFrom yearThrough year

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 721 records · Page 40

All sources NASA NTRS DOE OSTI

NASA NTRS1980

Pressure measurements on an ogive-cylinder at high angles of attack with laminar, transitional, or turbulent separation

This paper reports results from pressure tests on an ogive-cylinder in the low-turbulence 12-foot pressure wind tunnel. The results consist of pressure distributions over a wide range of Reynolds numbers and angles of attack. The tests encompassed a complete coverage of different roll orientations shown to be essential in order to fully define all the possible flow conditions. When the various roll-angle results are combined, it is possible to interpret the effects of changing angle of attack or Reynolds number. Two basic mechanisms for producing asymmetric flow are identified. One mechanism operates in both the laminar and the fully turbulent separation regimes; this mechanism is the one qualitatively described by the impulsive flow analogy. The other mechanism occurs only in the transitional separation regime. This asymmetric flow has the same form as that in the two-dimensional crossflow on a circular cylinder in the transitional flow regime. Finally, these results make it possible to draw up critical Reynolds number boundaries between the laminar, transitional, and fully turbulent separation regimes throughout the angle-of-attack range from 20 to 90 deg.

Lamont, P. J.↗

NASA NTRS1980

Subcritical transition to turbulence in plane channel flows

A linear three dimensional mechanism for the transition of plane Poiseuille flows to turbulence is presented which provides good agreement with experimental observations. The mechanism is based on the evolution of states within a band of quasi-equilibria which slowly approach the stable upper branch solutions for the evolution of flow energy but which are strongly unstable to infinitesimal three-dimensional disturbances. Numerical simulation has shown that if two-dimensional flow persists long enough for the three-dimensional perturbations to attain finite amplitude, the resulting three dimensional flow quickly develops a turbulent character with nonperiodic behavior, and thus transition can be predicted from knowledge of the initial two- and three-dimensional energies and time scales. The mechanism predicts transition to turbulence at Reynolds numbers greater than 1000, as observed in experiments, and implies higher threshold three-dimensional energies in plane Couette flow.

Orszag, S. A.↗

NASA NTRS1980

Experimental analysis of the boundary layer transition with zero and positive pressure gradient

The influence of a positive pressure gradient on the boundary layer transition is studied. The mean velocity and turbulence profiles of four cases are examined. As the intensity of the pressure gradient is increased, the Reynolds number of the transition onset and the length of the transition region are reduced. The Tollmein-Schlichting waves disturb the laminar regime; the amplification of these waves is in good agreement with the stability theory. The three dimensional deformation of the waves leads finally to the appearance of turbulence. In the case of zero pressure gradient, the properties of the turbulent spots are studied by conditional sampling of the hot-wire signal; in the case of positive pressure gradient, the turbulence appears in a progressive manner and the turbulent spots are much more difficult to characterize.

Arnal, D.↗

NASA NTRS1981

Effects of a modified leading edge on noise and boundary-layer transition in a rod-wall sound shield at Mach 5

A version of a rod wall sound shield was tested in the Mach 5 pilot quiet tunnel over a range of unit Reynolds numbers from 10 to 35 million per meter. The model was modified by inclining the leading edge plates to produce an initial 2 deg expansion to ascertain the sensitivity of boundary layer transition to leading edge disturbances. Rod surface pitot pressures, mean free stream pitot pressures, and static pressures on the rods and plenum walls were measured. Hot-wire measurements were also made in the model and nozzle free stream at a unit Reynolds number of 15 million per meter. The surface pitot pressures indicated that transition was much farther forward than for the previous tests due to the leading edge modification and minor fabrication flaws in the model. Early boundary layer transition on the rods was confirmed by hot-wire measurements which showed much higher noise levels in the free stream shield flow when compared with results from previous tests. Mean pitot pressure surveys within the shielded region inside the model indicated that there was an overexpansion and recompression that would limit the streamwise length of undisturbed flow to about 13 cm along the centerline.

Creel, T. R., Jr.↗

NASA NTRS1981

The chromospheric and transition layer emission of stars with different metal abundances

Preliminary results on observations of chromospheric and transition layer emission of stars with different metal abundances are reported. Metal deficient stars generally show reduced emission in the Mg II resonance lines and also in the other chromospheric and transition layer emission lines. This is interpreted as showing that energy fluxes other than acoustic fluxes must at least be coresponsible for the coronal and transition layer heating.

Boehm-Vitense, E.↗

NASA NTRS1981

Significance of turbulence and transition location on radiative heating with ablation injection

This paper presents forebody flowfield solutions for Jupiter entry conditions where the ablation injection rate is coupled with the surface heating rate. The calculations are made with a time-dependent viscous-shock-layer analysis where the flow is assumed to be in chemical equilibrium. Both laminar and turbulent solutions are presented to describe the impact of turbulence on surface mass loss rates for flow conditions where the heating is due primarily to radiation. Results are also presented where the transition location to turbulent flow is arbitrarily varied. Results show that the radiative heating rate values based on several downstream transition locations adjust quickly to the corresponding values based on transition near the stagnation point.

Moss, J. N.↗

NASA NTRS1981

Comparison of correlations of Shuttle boundary-layer transition due to distributed roughness

The transition criteria for the windward surface of the Shuttle Orbiter, which is composed of a large number of thermal protection tiles, must include the effect of distributed roughness arising from joints and possible tile misalignments. Theoretical flow-field parameters and heat-transfer distributions were used to analyze boundary-layer transition data. Data were obtained for Mach numbers from 8 to 12 over a Reynolds number range from 1.8 million to 17.6 million with surface temperatures from 0.114 to 0.435 T sub t. The transition correlations were approximately the same both for the misaligned-tile models and for the grit-roughened model. The incipient value Re sub K, tr was 15, the critical value was 85, the effective value was 190.

Bertin, J. J.↗

NASA NTRS1981

An assessment of the impact of transition on advanced winged entry vehicle thermal protection system mass

This study examines the impact of turbulent heating on thermal protection system (TPS) mass for advanced winged entry vehicles. Four basic systems are considered: insulative, metallic hot structures, metallic standoff, and hybrid systems. TPS sizings are performed using entry trajectories tailored specifically to the characteristics of each TPS concept under consideration. Comparisons are made between systems previously sized under the assumption of all laminar heating and those sized using a baseline estimate of transition and turbulent heating. The relative effect of different transition criteria on TPS mass requirements is also examined. Also investigated are entry trajectories tailored to alleviate turbulent heating. Results indicate the significant impact of turbulent heating on TPS mass and demonstrate the importance of both accurate transition criteria and entry trajectory tailoring.

Wurster, K. E.↗

NASA NTRS1981

Thermodynamic properties and phase transitions in CO2 molecular clusters

The thermodynamic properties of (CO2)N molecular aggregates of size N between 2 and 13 have been investigated. These crystallites exhibit well defined orientational order-disorder rotational transitions accompanied by a structural transition into a plastic crystallite phase. In addition, they exhibit melting and disassociation transitions. It is shown that the interpretation of experimental data, based upon dimer properties, depends crucially on these results. Equilibrium structures and orientations are also given.

Etters, R. D.↗

NASA NTRS1982

The two-photon absorptivity of rotational transitions in the A2 Sigma hyperon + (v prime = O) - X-2 pion (v prime prime = O) gamma band of nitric oxide

A predominantly single-mode pulsed dye laser system giving a well characterized spatial and temporal output suitable for absolute two-photon absorptivity measurements was used to study the NO gamma(0,0) S11 + R21 (J double prime = 7-1/2) transition. Using a calibrated induced-fluorescence technique, an absorptivity parameter of 2.8 + or - 1.4 x 10 to the minus 51st power cm to the 6th power was obtained. Relative strengths of other rotational transitions in the gamma(0,0) band were also measured and shown to compare well with predicted values in all cases except the O12 (J double prime = 10-1/2) transition.

Gross, K. P.↗

NASA NTRS1982

Influence of surface static-pressure orifices on boundary-layer transition

An investigation of the interaction of a laminar boundary layer and surface static-pressure orifices was conducted on a natural laminar flow airfoil. The effects of both favorable and adverse pressure gradients were studied at Reynolds numbers based on airfoil chord from approximately 500,000 to 6,000,000 with Mach number varying accordingly from about 0.03 to 0.42. The smaller the diameter of the orifice, the less likely it will cause premature transition. Locating the orifices in a chord-wise row aligned with the flow appears to have an additive, adverse effect on transition. Tube length-to-orifice diameter ration does not seem to have a consistent influence on transition.

Somers, D. M.↗

NASA NTRS1982

Study of boundary-layer transition using transonic cone Preston tube data

Laminar layer Preston tube data on a sharp nose, ten degree cone obtained in the Ames 11 ft TWT and in flight tests are analyzed. During analyses of the laminar-boundary layer data, errors were discovered in both the wind tunnel and the flight data. A correction procedure for errors in the flight data is recommended which forces the flight data to exhibit some of the orderly characteristics of the wind tunnel data. From corrected wind tunnel data, a correlation is developed between Preston tube pressures and the corresponding values of theoretical laminar skin friction. Because of the uncertainty in correcting the flight data, a correlation for the unmodified data is developed, and, in addition, three other correlations are developed based on different correction procedures. Each of these correlations are used in conjunction with the wind tunnel correlation to define effective freestream unit Reynolds numbers for the 11 ft TWT over a Mach number range of 0.30 to 0.95. The maximum effective Reynolds numbers are approximately 6.5% higher than the normal values. These maximum values occur between freestream Mach numbers of 0.60 and 0.80. Smaller values are found outside this Mach number range. These results indicate wind tunnel noise affects the average laminar skin friction much less than it affects boundary layer transition. Data on the onset, extent, and end of boundary layer transition are summarized. Application of a procedure for studying the relative effects of varying nose radius on a ten degree cone at supercritical speeds indicates that increasing nose radius promotes boundary layer transition and separation of laminar boundary layers.

Reed, T. D.↗

NASA NTRS1981

New interstellar molecular transitions in the 2 millimeter range

A Sgr B2 kinetic temperature of about 47 K is derived based on observations of K components of the 9K-8K transition of CH3CCH. Interstellar line emission is detected in the 2 mm wavelength region from SO, (S-34)O, SO2, CH3OH, CH3CCH, CH3CH2CN, HC3N, and nine unidentified transitions. The methylacetylene K component data combined with the derived data reduction technique, demonstrates the utility of the molecule as a temperature probe of molecular clouds when two or more rotational transitions are observed. Evidence for the existence of interstellar HNO is presented, and an attempt is made to detect sulfuric acid, formic anhydride, and the 0-18 isotopic for CO2 in interstellar clouds and in the Venusian atmosphere during inferior conjunction.

Hollis, J. M.↗

NASA NTRS1982

Laser-excitation technique for the measurement of absolute transition probabilities of weak atomic lines

A new technique is presented for the measurement of transition probabilities for weak allowed, intersystem, and forbidden lines. The method exploits the fact that oscillator strength is proportional to the number of stimulated absorptions and emissions produced by a narrow-band laser pulse of known energy which is in resonance with an atomic transition. The method is tested for a particular transition of Mg I with a known oscillator strength value and of appropriate magnitude. The number densities are measured using a Mach-Zehnder interferometer and the hook method for the lower level population and by measuring an absorption-equivalent width for the other. The apparatus consisted of a high-power tunable laser and a magnesium oven to produce excited Mg vapor, and a laser-plasma background continuum. The results are in good agreement with theoretical and other experimental data.

Kwong, H. S.↗

NASA NTRS1982

Transit telescope designs optimized for multiple object spectroscopy with fibers

Instruments to simultaneously study the spectra of many objects in the field of view of a telescope can be made using fused silica fibers. The spectrograph at the 2.3m telescope of the University of Arizona has been modified for such operation, and is used routinely to study the dynamics of galaxy clusters. Consideration has been given to how the multifiber technique can best be used to obtain spectra of the many faint objects identified by deep transit survey instruments and new space and radio telescopes. A transit survey such as that planned by McGraw et al. (1980), with CCDs at the focus of a 2m transit telescope, will identify objects down to 24th magnitude, and down to 22nd magnitude will give very complete data on variability and optical energy distribution. A telescope with much larger aperture is required for spectroscopic follow up. It is suggested that large telescopes dedicated to this type of work can be made and operated for only a fraction of the cost of a general-purpose telescope.

Angel, J. R. P.↗

NASA NTRS1983

Electrical Dissipation Measurement of Polymer Phase Transitions

Technique measures solid/solid, glass/rubber, and liquid/liquid transition temperatures in polymers having dipole moments. Technique based on change in dipole packing that occurs with each transition and measured as change in electrical dissipation factor. Change in dipole packing occuring with each transition sensed by effect on dissipation factor.

Long, E. R., R↗

NASA NTRS1982

High density bit transition requirements versus the effects on BCH error correcting code

The design to achieve the required bit transition density for the Space Shuttle high rate multiplexes (HRM) data stream of the Space Laboratory Vehicle is reviewed. It contained a recommended circuit approach, specified the pseudo random (PN) sequence to be used and detailed the properties of the sequence. Calculations showing the probability of failing to meet the required transition density were included. A computer simulation of the data stream and PN cover sequence was provided. All worst case situations were simulated and the bit transition density exceeded that required. The Preliminary Design Review and the critical Design Review are documented. The Cover Sequence Generator (CSG) Encoder/Decoder design was constructed and demonstrated. The demonstrations were successful. All HRM and HRDM units incorporate the CSG encoder or CSG decoder as appropriate.

Ingels, F. M.↗

NASA NTRS1982

A Corrosion Control Manual for Rail Rapid Transit

This manual addresses corrosion problems in the design, contruction, and maintenance of rapid transit systems. Design and maintenance solutions are provided for each problem covered. The scope encompasses all facilities of urban rapid transit systems: structures and tracks, platforms and stations, power and signals, and cars. The types of corrosion and their causes as well as rapid transit properties are described. Corrosion control committees, and NASA, DOD, and ASTM specifications and design criteria to which reference is made in the manual are listed. A bibliography of papers and excerpts of reports is provided and a glossary of frequently used terms is included.

Gilbert, L. O.↗