Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “experience report”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 721 records · Page 40

Soft X-ray observations of the binary sigma Cr B with HEAO-1

The detection of X-ray emission in the 0.15-2 keV band from the vicinity of the radio-emitting binary star HD 146361 in the binary system sigma-Corona Borealis, with low-energy detectors of the HEAO A-2 experiment, is reported. Graphs are presented that show plots of count rate versus scan angle in half-degree bins, that are obtained from the superposition of the 13 source scans. Attention is given to source position and identification as well as to the energy spectrum of the source.

Agrawal, P. C.↗

Recent developments in aircraft engine noise reduction technology

Some of the more important developments and progress in jet and fan noise reduction and flight effects are reviewed. Experiments are reported which show that nonaxisymmetric coannular nozzles have the potential to reduce jet noise for conventional and inverted velocity profiles. It is shown that an improved understanding of suppressive linear behavior, coupled with the new understanding of fan source noise, will soon allow the joint optimization of acoustic liner and fan design for low noise. It is also shown that fan noise source reduction concepts are applicable to advanced turboprops. Advances in inflow control device design are reviewed that appear to offer an adequate approach to the ground simulation of inflight fan noise.

Stone, J. R.↗

The very soft X-ray transient H1853 + 60

The detection of a new soft X-ray transient, H1853 + 60, using data from the Low Energy Detectors (LEDs) on the HEAO 1 A-2 experiment, is reported. Although the solar flare hypothesis cannot be ruled out, the similarity between this X-ray transient's temporal and spectral characteristics and those of several other transients observed by HEAO 1 LEDs, suggest a common emission mechanism for these events. It is unlikely that more transients as strong as these will be discovered, except on an individual scan basis.

Stern, R. A.↗

Wave direction measured by four different systems

A March 1977 wave direction measurement experiment is reported in which four systems were used to provide offshore wave-direction information: (1) synthetic aperture radar (SAR), (2) a coastal imaging radar, (3) an offshore pressure-gage array, and (4) aerial photography. From the coastal radar images and aerial photographs, the direction and length of the principal wavetrains were measured by a manual analysis. The SAR images were processed using fast Fourier transform to give two-dimensional wave spectra. Scatter diagrams are presented which intercompare the measurements of all four systems, and show good agreement among all imaging systems. It is concluded that aerial photography and SAR will prove more useful when wave measurements are needed over a large area or when there are rapidly changing wave characteristics.

Mattie, M. G.↗

NASA service experience with composite components

NASA Langley has been active in sponsoring flight service programs with advanced composites during the past decade. A broad data base and confidence in the durability of composite structures are being developed. Flight service experience is reported for more than 140 composite aircraft components with up to 8 years service and almost two million successful component flight hours. Composite components are being evaluated on Boeing, Douglas, and Lockheed transport aircraft. Components are currently under development for service evaluation on Bell and Sikorsky helicopters. Design concepts and inspection and maintenance results are reported for components currently in service. Components under development in the NASA Aircraft Energy Efficiency (ACEE) program are discussed. Results of flight, outdoor ground, and controlled laboratory environmental tests on composite materials used in the flight service programs are also presented.

Dexter, H. B.↗

Tests on Double Layer Metalization

28 page report describes experiments in fabrication of integrated circuits with double-layer metalization. Double-layer metalization requires much less silicon "real estate" and allows more flexibility in placement of circuit elements than does single-layer metalization.

Woo, D. S.↗

Hydrazines and carbohydrazides produced from oxidized carbon in earth's primitive environment

Whether abiological organic compounds can be formed from the interactions of energy sources with nitrogen, oxidized carbon and water is held to be of importance in geochemical models of the primordial earth atmosphere. It is reported that experiments using quenched spark discharges through molecular nitrogen on aqueous suspensions of CaCO3 and other reactants to simulate the hydrosphere/atmosphere interface yield hydrazine and carbohydrazine in significant but low yields. Such reactions in primitive aquatic environments may have supplied a pathway for chemical evolution and the origin of life, on a primitive earth in which fully oxidized states of carbon were available for the primary synthesis of organic matter.

Folsome, C. E.↗

A tensor approach to modeling of nonhomogeneous nonlinear systems

Model following control methodology plays a key role in numerous application areas. Cases in point include flight control systems and gas turbine engine control systems. Typical uses of such a design strategy involve the determination of nonlinear models which generate requested control and response trajectories for various commands. Linear multivariable techniques provide trim about these motions; and protection logic is added to secure the hardware from excursions beyond the specification range. This paper reports upon experience in developing a general class of such nonlinear models based upon the idea of the algebraic tensor product.

Yurkovich, S.↗

Stratospheric ozone and hydroxyl radical measurements by balloon-borne lidar

An experiment is reported in which a balloon-borne lidar system was used to measure ozone and the hydroxyl radical in the stratosphere by two lidar techniques. Ozone was measured in the 20-37 km altitude range using differential absorption lidar, and the hydroxyl radical was measured in the 34-37 km range using remote laser-induced fluorescence. Ozone concentrations were determined with a vertical resolution of 0.5 km, and in addition, horizontally resolved ozone measurements with 0.15-km resolution were obtained over a 2-km range. The temporal variation of the hydroxyl radical concentration ranged from 40 parts/trillion shortly after noon to about 5 parts/trillion two hours after sunset. Possible modifications to the system are discussed which can yield an improvement in the sensitivity of between one and two orders of magnitude, thus permitting measurements of the hydroxyl radical in the 20-30-km altitude range.

Heaps, W. S.↗

Standard free energy of formation of iron iodide

An experiment is reported where silver iodide is used to determine the standard free energy of formation of iron iodide. By using silver iodide as a solid electrolyte, a galvanic cell, Ag/AgI/Fe-FeI2, is formulated. The standard free energy of formation of AgI is known, and hence it is possible to estimate the standard free energy of formation of FeI2 by measuring the open-circuit emf of the above cell as a function of temperature. The free standard energy of formation of FeI2 determined by this method is -38784 + 24.165T cal/mol. It is estimated that the maximum error associated with this method is plus or minus 2500 cal/mol.

Khandkar, A.↗

Late skin damage in rabbits and monkeys after exposure to particulate radiations

Preliminary results are reported of experiments on the late effects of exposure to particulate radiations on stem cell populations. Skin biopsies were taken from the ears of rabbits irradiated 2-5 years previously with 530 MeV/amu Ar ions (LET 90 keV/micron), or 365 MeV/amu Ne ions (LET 35 keV micron), and from the chests and inner thighs of rhesus monkeys irradiated 16-18 years previously with 32-MeV protons (LET about 1.2 keV/micron). Skin fibroblast cultures obtained from the biopsy samples in rabbits were observed to undergo dose-dependent decreases in in vitro life span, with estimated survival curves showing the effects of Ar-ion irradiation to be more severe than those of Ne-ion irradiation. In addition, the healing of the biopsy wound was observed to become slower as radiation dose increased. In the monkey, radiation reduced the average number of fibroblasts at the time of cessation of growth in culture. Results thus demonstrate the capacity of skin sampling to reveal stem cell destruction, and have important implications for astronauts and other persons at risk of particle exposure with regard to healing responses to trauma or surgery.

Bergtold, D. S.↗

Pure Glasses From Multicomponent Gels

Report describes experiments with multicomponent gels for preparation of pure glass. Experiments aimed at developing zerogravitation process for fabrication of low-loss optical fibers.

Mukherjee, S. P.↗

The effects of vegetation and soil hydraulic properties on passive microwave sensing of soil moisture: Data report for the 1982 fiels experiments

Field experiments to (1) study the biomass and geometrical structure properties of vegetation canopies to determine their impact on microwave emission data, and (2) to verify whether time series microwave data can be related to soil hydrologic properties for use in soil type classification. Truck mounted radiometers at 1.4 GHz and 5 GHz were used to obtain microwave brightness temperatures of bare vegetated test plots under different conditions of soil wetness, plant water content and canopy structure. Observations of soil moisture, soil temperature, vegetation biomass and other soil and canopy parameters were made concurrently with the microwave measurements. The experimental design and data collection procedures for both experiments are documented and the reduced data are presented in tabular form.

Oneill, P.↗

Space Processing Applications Rocket (SPAR) project, SPAR 9

SPAR 9 (R-17) payload configuration, rocket performance, payload support, science payload instrumentation, and payload recovery are discussed. Directional solidification of magnetic composites, directional solidification of immiscible aluminum-indium alloys, and comparative alloy solidification experiments are reported.

Poorman, R.↗

GP-B error modeling and analysis

The analysis and modeling for the Gravity Probe B (GP-B) experiment is reported. The finite-wordlength induced errors in Kalman filtering computation were refined. Errors in the crude result were corrected, improved derivation steps are taken, and better justifications are given. The errors associated with the suppression of the 1-noise were analyzed by rolling the spacecraft and then performing a derolling operation by computation.

Source record↗

Observing system simulation experiments related to space-borne Lidar wind profiling. Part 2: Sensitivity to atmospheric and instrumental influences

Three major potential sources of errors that influence the performance of the proposed LIDAR wind profiling systems are accounted for in the following simulation studies. First, the coherent CO2 laser system proposed by NOAA/ERL for the WINDSAT requires distributions of 10 microns size aerosol concentrations throughout the atmosphere to determine the Doppler shifted backscatter signal. Second, atmospheric influences such as clouds and precipitation affect the LIDAR system's ability to obtain complete vertical wind profiles. In this study, experiments are reported on in which the complete wind profiles are only available in model generated cloud-free regions down to model cloud tops. Third, constraints on the available power required for the expected operational lifetime duration of a LIDAR system govern the number of pulses which can be used to sample a 300 km square area.

Dlouhy, R.↗

The application of a low-order panel method - program VSAERO to powerplant and airframe flow studies

Results from the application of VSAERO, a low-order panel method, to three practical aircraft configurations are presented. The Grumman 698-411 tilt-nacelle V/STOL model is analyzed with particular emphasis on the inlet pressures and the nacelle/fuselage interference effects. Excellent correlation with experiment is reported for the inlet pressure ratio and the inlet operational boundaries. Analysis of an inlet designed for a tilt-rotor/nacelle aircraft is presented. The code was used in a design environment for this configuration to determine an inlet geometry that maintained attached flow for three design flight conditions: hover, hover-transition and cruise. VSAERO is also used to examine the prop-slipstream induced loading for the Langley prop-fan configuration. The versatility and economy of the aerodynamic modeling program, VSAERO, is demonstrated.

Strash, D. J.↗