Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “two-color”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1984

Fuel spray diagnostics

Several laser measurement methods are being studied to provide the capability to make droplet size and velocity measurements under a variety of spray conditions. The droplet sizing interferometer (DSI) promises to be a successful technique because of its capability for rapid data acquisition, compilation and analysis. Its main advantage is the ability to obtain size and velocity measurements in air-fuel mixing studies and hot flows. The existing DSI at NASA Lewis is a two-color, two-component system. Two independent orthogonal measurements of size and velocity components can be made simultaneously. It also uses an off-axis large-angle light scatter detection. The fundamental features of the system are optics, signal processing and data management system. The major component includes a transmitter unit, two receiver units, two signal processors, two data management systems, two Bragg cell systems, two printer/plotters, a laser, power supply and color monitor.

Bosque, M. A.↗
NASA NTRS1984

Development and implementation of advanced diagnostic techniques

Two techniques were identified which offer great potential in the measurement of sprays. The first is referred to as IMAX, and it consists of a nonintrusive pulse height analyzer. The second is referred to as Visibility/Intensity (V/I) and it performs a size measurement by examining the visibility and the pedestal intensity that the IMAX technique provides a larger dynamic range and higher accuracy than V/I. It also shows that the two-color IMAX concept provides a higher S/N primarily because of the high efficiency in spectrally separating the two signals. The size distribution of two kinds of sprays are reported. The first spray was produced by a Berglund-Liu droplet generator with dispersion air. The second spray was produced by a pressure nozzle.

Hess, C. F.↗
NASA NTRS1984

Turbulent swirling combustion

The non-reacting flow produced by two confined, co- and/or counter-swirling jets wre measured by means of a two-color laser Doppler velocimeter. These results are compared with earlier experiments and with numerical predictions. It is shown that under both swirl conditions, a closed recirculation zone is created at the combustor center line. This zone is characterized by the presence of a one-cell toroidal vortex, low tangential velocities, high turbulent intensity, and large dissipation rates of the kinetic energy of turbulence.

Sommer, H. T.↗
NASA NTRS1984

Theoretical and experimental analysis of laser altimeters for barometric measurements over the ocean

The statistical characteristics and the waveforms of ocean-reflected laser pulses are studied. The received signal is found to be corrupted by shot noise and time-resolved speckle. The statistics of time-resolved speckle and its effects on the timing accuracy of the receiver are studied in the general context of laser altimetry. For estimating the differential propagation time, various receiver timing algorithms are proposed and their performances evaluated. The results indicate that, with the parameters of a realistic altimeter, a pressure measurement accuracy of a few millibars is feasible. The data obtained from the first airborne two-color laser altimeter experiment are processed and analyzed. The results are used to verify the pressure measurement concept.

Tsai, B. M.↗
NASA NTRS1984

Photographic surveys of the southern sky

Parameters of the UK 1.2 meter Schmidt telescope are described. Plates taken with this instrument are in two categories, those for systematic sky surveys and those taken at the request of research users. A collaborative project with the European Southern Observatory was undertaken to obtain a two-color survey of the sky south of -20 deg declination to complement the Palomar survey. A near infrared survey of the Galactic Plane and the Megallanic Clouds is being done. The area south of -20 deg and the zone between 0 deg and -15 deg are also being surveyed. Pending a decision on survey parameters, all available A quality prism plates are being retained to form a basis for systematic survey. Nearly half the plates taken on a service basis for the UK astronomical community are to fulfill nonsurvey requests. Plates taken for surveys which are not of A grade quality are also made available for research purposes.

Sim, M. E.↗
NASA NTRS1984

High-efficiency solar cells fabricated by vacuum MO-CVD

High-efficiency, monolithic, two-color, three-terminal solar cells were fabricated by a novel growth technique, vacuum metal-organic chemical vapor deposition. The technique uses the expensive metal alkyls efficiently and toxic gases sparingly. The fact that the outer chamber is constructed of nonbreakable stainless steel is an attractive safety feature associated with this deposition system.

Fraas, L. M.↗
NASA NTRS1984

Mass and momentum turbulent transport experiments with confined coaxial jets

An experimental study of mixing downstream of coaxial jets discharging into an expanded circular duct was conducted to obtain data for the evaluation and improvement of turbulent transport models. A combination of turbulent momentum transport rate and two components of velocity data were obtained from simultaneous measurements with a two-color LV system. A combination of turbulent mass transport rate, concentration and velocity data were obtained from simultaneous measurements with laser velocimeter (LV) and laser induced fluorescence (LIF) systems.

Johnson, B. V.↗
NASA NTRS1985

Optical multicolors - A poor person's z machine for galaxies

The feasibility, limits, accuracy, and uncertainties of using optical broadband colors in the form of two-color plots to measure the redshifts of faint galaxies are explored. Comparison of redshifts from slit spectra and 4-m photographic UBVI photometry of 100 faint galaxies confirms that colors do yield redshifts. These galaxies of 17-23 mag in B span a wide range of intrinsic color and are thus unlike previous samples of faint galaxies that were largely radio or cluster galaxies of early (red) type. For redshifts less than 0.35, two-thirds of the color redshifts agree with the spectroscopic values to within + or - 0.04 in z; for higher redshifts to z of 0.6, the errors increase to + or - 0.06. These accuracies were achieved for blue as well as red galaxies, and ensure that multicolors can serve as a poor person's redshift machine to study distant galaxies in clusters and the field.

Koo, D. C.↗
NASA NTRS1985

Atmospheric refractivity corrections in satellite laser ranging

Atmospheric refraction can cause significant errors in satellite laser ranging (SLR) systems. There are two techniques which can be used to correct for these errors. Atmospheric models based upon surface measurements of pressure, temperature, and relative humidity have been shown by ray tracing to be accurate to within a few centimeters at 20 deg elevation angle. The residual errors in the models are thought to be primarily caused by horizontal gradients in the refractivity. Although models have been developed to predict the gradient effects, initial studies show that they can be sensitive to local topographic effects. Atmospheric turbulence can introduce random fluctuations in the refractivity, but only introduces centimeter level errors at elevation angles below 10 deg. Pulsed two-color ranging systems can directly measure the atmospheric delay in satellite ranging. These systems require mode-locked multiple-frequency lasers and streak-camera-based receivers and currently appear capable of measuring the atmospheric delay with an accuracy of 0.5 cm or better.

Abshire, J. B.↗
NASA NTRS1985

Characteristics of an axisymmetric sudden expansion flow

A two-color, two component Laser Doppler Velocimeter (LDV) system operating in forward scatter has been developed in order to make simultaneous measurements of the axial and radial velocity components in an axisymmetric sudden expansion flow with and without combustion. The LDV system includes Bragg cell modulators in the four beam paths to allow a net frequency shift of 5MHz in both the green and blue beams. This permits an unambiguous measurement of negative velocities and also eliminates incomplete signal bias. The green beam probe volume has a waist diameter of 0.200 mm and is approximately 2mm long. The blue beam has a probe volume waist of 0.250 mm and is approximately 1 mm long. The scattered light from the probe volume is separated so that approximately 80% of each color passes to its respective photomultiplier tube by using a dichroic filter. Narrow bandpass filters are used to further filter unwanted signals before they are detected. A schematic diagram of the LDV system is shown.

Stevenson, W. H.↗
NASA NTRS1986

Resonance ionization mass spectrometry for isotopic abundance measurements

Resonance ionization mass spectrometry (RIMS) is a relatively new laser-based technique for the determination of isotopic abundances. The resonance ionization process depends upon the stepwise absorption of photons from the laser, promoting atoms of the element of interest through progressively higher electronic states until an ion is formed. Sensitivity arises from the efficiency of the resonant absorption process when coupled with the power available from commercial laser sources. Selectivity derives naturally from the distinct electronic structure of different elements. This isobaric discrimination has provided the major impetus for development of the technique. Resonance ionization mass spectrometry was used for analysis of the isotopic abundances of the rare earth lutetium. Isobaric interferences from ytterbium severely effect the ability to measure small amounts of the neutron-deficient Lu isotopes by conventional mass spectrometric techniques. Resonance ionization for lutetium is performed using a continuous-wave laser operating at 452 nm, through a sequential two-photon process, with one photon exciting the intermediate resonance and the second photon causing ionization. Ion yields for microgram-sized quantities of lutetium lie between 10(6) and 10(7) ions per second, at overall ionization efficiencies approaching 10(-4). Discrimination factors against ytterbium greater than 10(6) have been measured. Resonance ionization for technetium is also being explored, again in response to an isobaric interference, molybdenum. Because of the relatively high ionization potential for Tc, three-photon, two-color RIMS processes are being developed.

Miller, C. M.↗
NASA NTRS1986

Ignition of bulk 302 stainless steel in oxygen by laser heating

The effect of oxygen pressure on the ignition temperature of cylindrical 302 SS specimens ignited by a focused CW CO2 laser beam in a cool, static, oxygen environment was investigated. The ignition temperature was determined quantitatively from the specimen temperature history obtained from a fast response, near infrared, two-color pyrometer, which recorded the temperature history of a spot approximately 0.5 mm in diameter and located at the center of the cylindrical 302 SS specimen's top surface. Ignition and combustion occurred in three stages. The first stage began with specimen heating and ended with ignition, the second stage corresponded to combustion, and the third stage represented cooling. The physical changes that occurred in the first stage are described.

Nguyen, K.↗
NASA NTRS1986

Three-dimensional flow field measurements in a radial inflow turbine scroll using LDV

The results of an experimental study of the three-dimensional flow field in a radial inflow turbine scroll are presented. A two-color LDV system was used in the measurement of three orthogonal velocity components at 758 points located throughout the scroll and the unvaned portion of the nozzle. The cold flow experimental results are presented for through-flow velocity contours and the cross velocity vectors.

Malak, M. F.↗
NASA NTRS1986

UGC 8508 - A dwarf galaxy associated with the M 101 group

Two-color CCD photometry of UGC 8508 has resolved the system into stars. The color-magnitude diagram shows blue and red supergiants, the apparent magnitudes of the brightest stars indicate that UGC 8508 lies within 2 Mpc of the adopted 6 Mpc distance of the M 101 group. The galaxy contains a significant color gradient; star formation is confined to the central 1.5 scale lengths (0.8 kpc). UGC 8508 has a central surface brightness intermediate between bursting and quiescent dwarf irregular galaxies.

Mould, J. R.↗
NASA NTRS1986

Near-simultaneous ultraviolet and optical spectrophotometry of T Tauri stars

A set of near-simultaneous ultraviolet and optical spectra and UBVR(J)I(J) photometry of five T Tauri stars has been analyzed for the shape of the energy distribution shortward of 3000 A. The far-ultraviolet continua of these stars are very much stronger than the level of light scattered from longer wavelengths in the IUE spectrograph. The results, expressed as two-color plots, show that the UV colors of T Tauri stars differ significantly from those expected from their optical spectral types. Although these particular K-type T Tauri stars are not extreme members of the class, they have the UV colors of A stars. The spectral shape of this UV excess is approximately that expected from published chromospheric models of T Tauri stars.

Goodrich, Robert W.↗
NASA NTRS1986

Gated photochemical hole burning in photoadducts of polyacenes

A photoadduct of anthracene and tetracene (A-T) in a polymer matrix at 1.5 K generates an absorption spectrum which exhibits two-color, photon-gated photochemical hole burning (PHB) when irradiated with narrowband exciting light into the 0-0 band of the S1-S0 absorption. The efficiency of this PHB process is found to be enhanced by simultaneous irradiation near the maximum of the Tn-T1 absorption of A-T; hole widths of less than 0.07/cm have been observed for this photochemical cleavage of A-T.

Iannone, Mark↗
NASA NTRS1986

Laser ignition of bulk 1018 carbon steel in pure oxygen

Experiments were undertaken to study the ignition characteristics of bulk 1018 carbon steel in a pure oxygen environment. Cylindrical 1018 carbon steel specimens 5 mm in diameter and 5 mm high were ignited by a focused CW CO2 laser beam in a cool, static, pure oxygen environment at oxygen pressures ranging from 0.103 to 6.895 MPa. A two-color pyrometer was designed and used to measure the ignition temperatures of the specimens. The temperature history of a spot approximately 0.5 mm in diameter located at the center of the specimen top surface was recorded with a maximum time resolution of 25 microsec, and with an accuracy of a few percent. Ignition temperature of bulk 1018 carbon steel was identified from the temperature history curve with the aid of the light intensity curve. Results show that 1018 carbon steel specimens ignite at temperatures between 1388 and 1450 K, which are below the melting range of the alloy (1662-1685 K). The ignition temperature of 1018 carbon steel is mildly dependent on oxygen pressure over the range of oxygen pressure investigated in this study.

Nguyen, K.↗
NASA NTRS1954

Determination of Flame Temperatures from 2000 to 3000 K by Microwave Absorption

Equations are derived for the measurement of flame temperatures from the attenuation of a microwave beam by temperature-induced free electrons from chemical elements introduced in the flame. Corrections are developed to account for the electron distribution in the flame. Procedure for obtaining the temperature from absorption is outlined. The free electron collision frequency and an effective ionization potential for four alkali elements were determined experimentally. The data were taken on a gas burner with a temperature range from 1900deg to 2400deg K. The effective ionization potential of sodium agrees with the spectral-line limit value. From these experimental ionization potentials and the experimental collision frequency, an accuracy of +/-600 K in the temperature was obtained. Fluctuating and average temperature data of a liquid propellant burner are presented primarily from 1.25-centimeter-wavelength microwave measurements in comparison with simultaneous two-color pyrometer and sound intensity measurements in the region from 2200deg to 2900deg K.

Kuhns, Perry W↗