SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Optoelectronics can increase speed and efficiency of information technology. There is a need to miniaturize components below the difrraction limit. Computational pre-screening increases the speed of materials discovery. Factors that must be accounting for beyond raw performance are material stability, cost, and environmental impact.
Plastic deformation of corrosion resistant steel, CER-VIT 101, and fused silica as function of applied torsional stress
The spectral luminescence induced in UV grade sapphire, MgF2 and LiF2, three fused silicas, and three Corning glasses, by 1/2, 1, 2, and 3 MeV electrons was recorded. In the wavelength range from the LiF UV cutoff to the near visible, a plane-grating spectrograph with photographic recording at resolutions of 0.8 and 1.6 nm was utilized. Qualitative results based on relative density tracings of seven of the nine materials obtained from preliminary plates are given.
The effect of simulated Nimbus spacecraft orbital (1100 km, circular, and polar) radiation on wide bandpass glass filters, narrow bandpass thin film interference filters, and several fused silicas was determined by transmittance measurements over the 200 to 3400 nanom wavelength region. No changes were observed in the filters, which were shielded with fused silica during irradiation, after exposure to a 1-year equivalent orbital dose of electrons, nor in the fused silicas after the same electron exposure plus a 1-year equivalent dose of protons. Exposure to a 1/2-year equivalent dose of solar ultraviolet radiation caused a significant degradation in the transmittance of two ultraviolet-transmitting interference filters but had no effect on two colored glass filters that transmitted in the visible and near infrared regions. As a result of the ultraviolet exposure the fused silicas exhibited losses of several percent over the 200- to 300 nanom wavelength region.
The effect of simulated Nimbus spacecraft orbital (1100 km, circular, and polar) radiation on wide-band-pass glass filters, narrow-bandpass thin-film interference filters, and several fused silicas was determined by transmittance measurements over the 200-3400-nm wavelength region. No changes were observed in the filters, which were shielded with fused silica during irradiation, after exposure to a 1-yr equivalent orbital dose of electrons, nor were changes observed in the fused silicas after the same electron exposure plus a 1-yr equivalent dose of protons. Exposure to a 1/2-yr equivalent dose of solar uv radiation, however, caused a significant degradation in the transmittance of two uv-transmitting interference filters but had no effect on two colored glass filters that transmitted in the visible and near-ir regions. As a result of the uv exposure, the fused silicas exhibited losses of several percent over the 200-300-nm wavelength region.
The recent progress in the application of nonlinear techniques to extend the frequency of laser sources has come from the joint progress in laser sources and in nonlinear materials. A brief summary of the progress in diode pumped solid state lasers is followed by an overview of progress in nonlinear frequency extension by harmonic generation and parametric processes. Improved nonlinear materials including bulk crystals, quasiphasematched interactions, guided wave devices, and quantum well intersubband studies are discussed with the idea of identifying areas of future progress in nonlinear materials and devices.
New results achieved with recently grown Hg2Cl2 and PbBr2 crystals are described. With an optimized crystal growth technique Hg2Cl2 crystals were grown that show a significantly reduced acoustic attenuation compared to prior crystals, from 13.4 to 8 dB/microsec-GHz-squared. These crystals allow the development of Hg2Cl2 Bragg cells with time-bandwidth product figures in the 5100 to 6900 range, frequency operation as high as that for TeO2, and resolution about 25 percent higher than TeO2 for similar crystal lengths. PbBr2 crystals were also grown that exhibit a large figure of merit (M2 = 550) with an attenuation coefficient of 12 dB/microsec-GHz-squared. This material may be the choice for infrared devices where large diffraction efficiencies are needed.
The purpose of the experiment was the following: development of containerless glass melting technique; fabrication of high purity glass; and development of acoustic levitation technique. For the space experiment, glass 65CaO-25Ga2O3-10GeO2 was selected out of various types of glasses. The expected results are: ultra-high purity glass and manipulation by acoustics.
A ruggedness evaluation of approaches to damage threshold testing was performed to determine the influence of three procedural variables on damage threshold data. The differences between the number of test sites evaluated at an applied fluence level (1 site versus 10 sites), the number of laser pulses at each test site (1 pulse versus 200 pulses), and the beam diameter (0.35 mm versus 0.70 mm) were all found to significantly influence the damage threshold data over a 99-percent confidence interval.
Compositions capable of simultaneous two-photon absorption and higher order absorptivities are disclosed. Many of these compositions are compounds satisfying the formulae D-.PI.-D, A-.PI.-A, D-A-D and A-D-A, wherein D is an electron donor group, A is an electron acceptor group and .PI. comprises a bridge of .pi.-conjugated bonds connecting the electron donor groups and electron acceptor groups. In A-D-A and D-A-D compounds, the .pi. bridge is substituted with electron donor groups and electron acceptor groups, respectively. Also disclosed are methods that generate an electronically excited state of a compound, including those satisfying one of these formulae. The electronically excited state is achieved in a method that includes irradiating the compound with light. Then, the compound is converted to a multi-photon electronically excited state upon simultaneous absorption of at least two photons of light. The sum of the energies of all of the absorbed photons is greater than or equal to the transition energy from a ground state of the compound to the multi-photon excited state. The energy of each absorbed photon is less than the transition energy between the ground state and the lowest single-photon excited state of the compound is less than the transition energy between the multi-photon excited state and the ground state.
Disclosed are highly efficient multiphoton absorbing compounds and methods of their use. The compounds generally include a bridge of pi-conjugated bonds connecting electron donating groups or electron accepting groups. The bridge may be substituted with a variety of substituents as well. Solubility, lipophilicity, absorption maxima and other characteristics of the compounds may be tailored by changing the electron donating groups or electron accepting groups, the substituents attached to or the length of the pi-conjugated bridge. Numerous photophysical and photochemical methods are enabled by converting these compounds to electronically excited states upon simultaneous absorption of at least two photons of radiation. The compounds have large two-photon or higher-order absorptivities such that upon absorption, one or more Lewis acidic species, Lewis basic species, radical species or ionic species are formed.
Disclosed are highly efficient multiphoton absorbing compounds and methods of their use. The compounds generally include a bridge of pi-conjugated bonds connecting electron donating groups or electron accepting groups. The bridge may be substituted with a variety of substituents as well. Solubility, lipophilicity, absorption maxima and other characteristics of the compounds may be tailored by changing the electron donating groups or electron accepting groups, the substituents attached to or the length of the pi-conjugated bridge. Numerous photophysical and photochemical methods are enabled by converting these compounds to electronically excited states upon simultaneous absorption of at least two photons of radiation. The compounds have large two-photon or higher-order absorptivities such that upon absorption, one or more Lewis acidic species, Lewis basic species, radical species or ionic species are formed.
Disclosed are highly efficient multiphoton absorbing compounds and methods of their use. The compounds generally include a bridge of pi-conjugated bonds connecting electron donating groups or electron accepting groups. The bridge may be substituted with a variety of substituents as well. Solubility, lipophilicity, absorption maxima and other characteristics of the compounds may be tailored by changing the electron donating groups or electron accepting groups, the substituents attached to or the length of the pi-conjugated bridge. Numerous photophysical and photochemical methods are enabled by converting these compounds to electronically excited states upon simultaneous absorption of at least two photons of radiation. The compounds have large two-photon or higher-order absorptivities such that upon absorption, one or more Lewis acidic species, Lewis basic species, radical species or ionic species are formed.
Explore the source record for details and available documents.
This edition is the result of an extensive revision and reworking of the second edition of the Space Materials Handbook along with the incorporation of entirely new subject matter coverage and new materials data. All of the most significant material, phenomena, properties, and principles covered in the original Handbook are presented and expanded in this revised and updated version. However, treatment of theoretical aspects has been condensed in order that more emphasis could be placed on the extensive new materials knowledge and data obtained from the design and successful launching of a wide variety of space systems. The handbook is organized into four parts, namely: space environment, effect of space environment on materials, materials in space, and biological interaction with spacecraft materials. Information on mechanical, physical, and chemical properties and characteristics is given for a wide variety of metallic and nonmetallic materials. The effects of natural and induced environments on materials are appraised. Materials categories include coverage of thermal control materials, optical materials, adhesives, organic structural materials, inorganic structural materials, electronic components and materials, materials for sealing applications, and lubrication materials. In addition, a comprehensive multiple citation index is incorporated which gives ready access to information on specific subject areas with regard to their locations within the Handbook.
Poster presentation abstracts from the tenth International Conference on Crystal Growth (ICCG) (Aug. 16-21, 1992) are provided. Topics discussed at the conference include crystal growth mechanisms, superconductors, semiconductors, laser materials, optical materials, and biomaterials. Organizing committees, ICCG advisory board and officers, and sponsors of the conference are also included.
Reflectance spectroscopy, especially at infrared wavelengths, is often used for contact, standoff, and remote sensing of solid materials. The reflectance spectra of solids, however, are complex, relying on many factors, even for the same material. Such phenomena can be modeled if the optical constants as a function of wavelength or wavenumber, n(?) and k(?), are known. Methods to measure the optical constants of solids, however, are challenging, particularly for powdered materials. For powdered materials, a pressed pellet of the neat material is often used when a crystalline specimen is not available. In this work, three techniques, including ellipsometry, single-angle reflectance and KBr transmission spectroscopy, are applied to an organic material, acetaminophen, for comparison, and the effects on the modeled spectra are shown.