Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “disulfides”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
DOE OSTI2026

Spontaneous Polarization Suppression of Exciton–Exciton Annihilation in Rhombohedral-Stacked Bilayer Molybdenum Disulfide

Rapid exciton–exciton annihilation (EEA) in two-dimensional semiconductors limits access to high-density excitonic regimes essential for efficient optoelectronic operation under strong excitation. Here, we show that EEA is strongly suppressed in rhombohedral (3R)-stacked MoS 2 bilayers relative to nonpolar 2H bilayers, and that this suppression is quantitatively consistent with repulsive dipole–dipole interactions between layer-polarized excitons induced by spontaneous polarization. Using ultrafast pump–probe spectroscopy, we measure an EEA rate of γ EEA = (5.03 ± 0.99) × 10 –3 cm 2 s –1 in 3R bilayers, which is approximately 18.2-fold smaller than that in monolayers and 2.9-fold smaller than that in nonpolar 2H bilayers. Despite the higher exciton diffusivity recently reported for 3R relative to 2H bilayers, the reduced EEA rate in 3R indicates a rate-limited regime governed by the close-encounter annihilation probability rather than diffusion. A rate-limited annihilation model incorporating a dipole–dipole repulsive potential captures the observed ratio γ EEA,3R /γ EEA,2H ≈ 0.35 for an exciton–exciton encounter distance of ∼1.3 nm, consistent with the bilayer exciton Bohr radius. These results indicate that spontaneous polarization in 3R-stacked bilayers can suppress nonlinear excitonic losses and provide a route toward high-density excitonics.

dipolar excitons↗
DOE OSTI2023

Molybdenum Disulfide Nanoribbons with Enhanced Edge Nonlinear Response and Photoresponsivity

MoS 2 nanoribbons have attracted increased interest due to their properties, which can be tailored by tuning their dimensions. Herein, the growth of MoS 2 nanoribbons and triangular crystals formed by the reaction between films of MoOx (2 2 nanoribbons arising from distinct contributions from the single–layer edges and multilayer core. Nanoscale imaging reveals a blue-shifted exciton emission of the monolayer edge compared to the isolated MoS 2 monolayers due to built-in local strain and disorder. We further report on an ultrasensitive photodetector made of a single MoS 2 nanoribbon with a responsivity of 8.72 × 10 2 A W –1 at 532 nm, among the highest reported up-to-date for single-nanoribbon photodetectors. These findings can inspire the design of MoS 2 semiconductors with tunable geometries for efficient optoelectronic devices.

36 MATERIALS SCIENCE↗
DOE OSTI2022

Layered Nano-Mosaic of Niobium Disulfide Heterostructures by Direct Sulfidation of Niobium Carbide MXenes for Hydrogen Evolution

MXene-transition metal dichalcogenide (TMD) heterostructures are synthesized through a one-step heat treatment of Nb 2 C and Nb 4 C 3 . These MXenes are used without delamination or any pre-treatment. Heat treatments accomplish the sacrificial transformation of these MXenes into TMD (NbS 2 ) at 700 and 900 °C under H 2 S. This work investigates, for the first time, the role of starting MXene phase in the derivative morphology. It is shown that while treatment of Nb 2 C at 700 °C leads to the formation of pillar-like structures on the parent MXene, Nb 4 C 3 produces nano-mosaic layered NbS 2 . At 900 °C, both MXene phases, of the same transition metal, fully convert into nanomosaic layered NbS 2 preserving the parent MXene’s layered morphology. When tested as electrodes for hydrogen evolution reaction, Nb 4 C 3 -derived hybrids show better performance than Nb 2 C derivatives. The Nb 4 C 3 -derived heterostructure exhibits a low overpotential of 198 mV at 10 mA cm -2 and a Tafel slope of 122 mV dec -1 , with good cycling stability in an acidic electrolyte

36 MATERIALS SCIENCE↗
DOE OSTI2023

Solution synthesis of two-dimensional zinc oxide (ZnO)/molybdenum disulfide (MoS 2 ) heterostructure through reactive templating for enhanced visible-light degradation of rhodamine B

Numerous inorganic materials have been identified as potential candidates for high-performance photocatalysts. However, their solar-to-energy conversion efficiencies still fail to meet commercial requirements. Here, the main hurdle is the rapid recombination of photoexcited electrons and holes in single-phase materials. A viable predicted approach to suppress charge recombination is coupling two materials to form a two-dimensional (2D) heterostructure that physically separates photoinduced electrons and holes in different layers. In this work, the heterostructure-based paradigm was tested and a scalable solution synthesis of epitaxial ZnO-MoS 2 heterostructure was developed. A 2D ZnO-MoS 2 heterostructure was synthesized under hydrothermal conditions by stabilizing intermediate Zn-hydroxide states on a functionalized MoS 2 surface. Detailed characterization showed the formation of multilayer heterostructure with MoS 2 flakes intercalated between large size ZnO plates. The performance of this heterostructure was evaluated using photocatalytic degradation of rhodamine B. A degradation efficiency of 70% was measured within 90 minutes of visible-light irradiation, almost doubling the efficiency of the corresponding single-phase materials or their physical mixtures.

2D heterostructure↗
DOE OSTI2020

Rational design of stable sulfur vacancies in molybdenum disulfide for hydrogen evolution

Sulfur (S) vacancies in MoS 2 have been found to act as a new active center, which shows an unprecedented intrinsic HER activity under elastic strain. However, such S-vacancies are unstable and the activities are very sensitive to the vacancy concentration. A strategy to stabilize these abundant active sites is thus highly desirable. Herein, we rationally design a catalyst system to stabilize S-vacancies in the basal plane of $2H-$MoS 2 supported on defective vertical graphene network (VGN). The energetically favorable line-shaped S-vacancies in MoS 2 shows a consistently high HER activity that is insensitive to S-vacancy concentration. Moreover, the defective graphene support effectively stabilizes these S-vacancies. The optimized catalyst exhibits a superior HER activity with overpotential of 128 mV at 10 mA cm -2 and Tafel slope of 50 mV dec -1 . Most importantly, the catalyst shows greatly increased stability over 500 h; benchmarking the most stable nonprecious HER catalyst in acidic media to date.

2D heterostructure↗
DOE OSTI2025

Phase transition in two-dimensional monolayer (1L)-molybdenum disulfide induced by atomic S-basal plane gliding via synchrotron X-ray monochromatic beam radiation for superior electronic performance

Here, in this work, we report a novel approach to reduce the channel resistance by inducing a phase transition behavior from 2H to 1T in a monolayer MoS 2 (1L-MoS 2 ) by a synchrotron X-ray monochromatic beam (mono-beam) radiation. The effects of the biphase structure by the mono-beam on the 1L-MoS2 film were investigated using Raman spectra, photoluminescence (PL) spectra, scanning tunneling microscopy, and scanning tunneling spectroscopy, respectively. Through material characterization, we identified that the lateral sliding of S-vacancies along the S-plane in the 1L-MoS 2 is the key reason for the origin of unidirectional phase transition. The precise phase engineering triggered by the mono-beam radiation process allows the realization of field-effect transistors (FET) with 2X improvement in mobility toward a high on/off ratio (~10 8 ) and a near-ideal subthreshold swing of ~88 mV per decade. The validity of the phase engineering could be further extended for its application as a memory device, exhibiting a gate tunable conduction modulation behavior and a high resistance ratio of ~10 2 at a gate bias of 5 V with endurance of ~100 cycles. Furthermore, an artificial neural network using the synaptic weight update with accuracy of ~93 % was achieved.

36 MATERIALS SCIENCE↗
DOE OSTI2024

Intercalation-Induced Topotactic Phase Transformation of Tungsten Disulfide Crystals

Recent research has demonstrated the potential for topological superconductivity, anisotropic Majorana bound states, optical nonlinearity, and enhanced electrochemical activity for transition metal dichalcogenides (TMDs) with a 2M structure. These unique TMD compounds exhibit metastability and, upon heating, undergo a transition to the thermodynamically stable 2H phase. The 2M phase is commonly made at high temperatures using traditional solid-state methods, and this metastability further complicates the growth of large 2M WS 2 crystals. Herein, a novel synthetic method was developed, focusing on a molten salt reaction to synthesize large 2H crystals and then inducing transformation to the 2M phase through intercalation and thermal treatment. The 2H crystals were intercalated via a room-temperature sodium naphthalenide solution, producing a previously unreported Na-intercalated 2H WS 2 phase. Thermal heating was required to facilitate the phase transition to the intercalated 2M crystal structure. This phase transition was studied by X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), selected area electron diffraction (SAED), electron dispersive X-ray spectroscopy (EDS), and Raman spectroscopy, which confirmed the synthesis of the intercalated 2M phase. Upon deintercalation, crystal and powder samples showed superconductivity with a T c of 8.6–8.7 K, similar to previously reported values. The generality of this process was further demonstrated using alkali metal triethyl borohydride to intercalate 2H WS 2 and produced the desired 2M phase. This novel synthetic method has broad implications for discovering metastable phases in other TMD families and layered materials. Furthermore, separation of the intercalation and phase transition also has the potential to allow for large-scale synthesis of this technologically important phase with greater control over each step of the reaction.

36 MATERIALS SCIENCE↗