Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Radio Electronics”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1981

Pulsations in total columnar electron content

Radio signals from the ATS 6 beacon received at Boulder reveal small-amplitude, quasi-sinusoidal fluctuations with periods in the range of 10 to 50 s. Visual comparisons of these data (116 events for October 1974 to April 1975) shows a good correspondence with simultaneous geomagnetic pulsations at Boulder in two thirds of the cases for which Boulder magnetograms were available, but they do not necessarily correspond with magnetic pulsations on ATS 6. Spectral analyses, by the method of maximum entropy, were made on sample records. The principal results are the following: (1) The occurrence of the pulsations is higher on magnetically disturbed days. (2) The maximum likelihood of occurrence is around 2100 UT (1400 LT). (3) The dominant spectrum peaks of the radio fluctuations and geomagnetic field on the ground generally coincide. Cases are found also in which temporal characteristics of the spectra are similar. These results indicate a close association of the radio fluctuations with the Pc 3-4 type pulsations of the geomagnetic field on the ground. It is suggested that the radio fluctuations originate mainly in the F region of the ionosphere, while some of them could be due to plasmapause effects.

Okuzawa, T.↗
NASA NTRS2005

Cumulative Interference to Aircraft Radios from Multiple Portable Electronic Devices

Cumulative interference effects from portable electronic devices (PEDs) located inside a passenger cabin are conservatively estimated for aircraft radio receivers. PEDs' emission powers in an aircraft radio frequency band are first scaled according to their locations' interference path loss (IPL) values, and the results are summed to determine the total interference power. The multiple-equipment-factor (MEF) is determined by normalizing the result against the worst case contribution from a single device. Conservative assumptions were made and MEF calculations were performed for Boeing 737's Localizer, Glide-slope, Traffic Collision Avoidance System, and Very High Frequency Communication radio systems where full-aircraft IPL data were available. The results show MEF for the systems to vary between 10 and 14 dB. The same process was also used on the more popular window/door IPL data, and the comparison show the multiple-equipment-factor results came within one decibel (dB) of each other.

Nguyen, Truong X.↗
NASA NTRS1974

Stabilization of electron streams in type III solar radio bursts

We show that the electron streams that give rise to type III solar radio bursts are stable and will not be decelerated while propagating out of the solar corona. The stabilization mechanism depends on the parametric oscillating two-stream instability. Radiation is produced near the fundamental and second harmonic of the local electron plasma frequency. Estimates of the emission at the second harmonic indicate that the wave spectra created by the oscillating two-stream instability can account for the observed intensities of type III bursts.

Papadopoulos, K.↗
NASA NTRS1991

Small Business Innovations (MISER)

Lightwave Electronics Corporation, Mountain View, CA, developed the Series 120 and 122 non-planner diode pumped ring lasers based on a low noise ring laser with voltage tuning that they delivered to Jet Propulsion Laboratory under a Small Business Innovation Research (SBIR) contract. The voltage tuning feature allows "phase-locking" the lasers, making them "electronic," similar to radio and microwave electronic oscillators. The Series 120 and 122 can be applied to fiber sensing, coherent communications and laser radar.

Source record↗
NASA NTRS2017

Programmable Logic Device (PLD) Design Description for the Integrated Power, Avionics, and Software (iPAS) Space Telecommunications Radio System (STRS) Radio

The Space Telecommunications Radio System (STRS) provides a common, consistent framework for software defined radios (SDRs) to abstract the application software from the radio platform hardware. The STRS standard aims to reduce the cost and risk of using complex, configurable and reprogrammable radio systems across NASA missions. To promote the use of the STRS architecture for future NASA advanced exploration missions, NASA Glenn Research Center (GRC) developed an STRS compliant SDR on a radio platform used by the Advance Exploration System program at the Johnson Space Center (JSC) in their Integrated Power, Avionics, and Software (iPAS) laboratory. At the conclusion of the development, the software and hardware description language (HDL) code was delivered to JSC for their use in their iPAS test bed to get hands-on experience with the STRS standard, and for development of their own STRS Waveforms on the now STRS compliant platform.The iPAS STRS Radio was implemented on the Reconfigurable, Intelligently-Adaptive Communication System (RIACS) platform, currently being used for radio development at JSC. The platform consists of a Xilinx ML605 Virtex-6 FPGA board, an Analog Devices FMCOMMS1-EBZ RF transceiver board, and an Embedded PC (Axiomtek eBox 620-110-FL) running the Ubuntu 12.4 operating system. Figure 1 shows the RIACS platform hardware. The result of this development is a very low cost STRS compliant platform that can be used for waveform developments for multiple applications.The purpose of this document is to describe the design of the HDL code for the FPGA portion of the iPAS STRS Radio particularly the design of the FPGA wrapper and the test waveform.

VHDL↗
NASA NTRS1979

A theory of solar type 3 radio bursts

Energetic electrons propagating through the interplanetary medium are shown to excite the one dimensional oscillating two stream instability (OTSI). The OTSI is in turn stabilized by anomalous resistivity which completes the transfer of long wavelength Langmuir waves to short wavelengths, out of resonance with the electrons. The theory explains the small energy losses suffered by the electrons in propagating to 1 AU, the predominance of second harmonic radiation, and the observed correlation between radio and electron fluxes.

Goldstein, M. L.↗
NASA NTRS1973

Stabilization of electron streams in type 3 solar radio bursts

It is shown that the electron streams that give rise to Type 3 solar radio bursts are stable and will not be decelerated while propagating out of the solar corona. The stabilization mechanism depends on the parametric oscillating two stream instability. Radiation is produced near the fundamental and second harmonic of the local electron plasma frequency. Estimates of the emission at the second harmonic indicate that the wave spectra created by the oscillating two stream instability can account for the observed intensities of Type 3 bursts.

Papadopoulos, K.↗
NASA NTRS1976

Firefighters' Radios

Public Technology Inc. asked for NASA assistance to devise the original firefighter's radio. Good short-range radio communications are essential during a fire to coordinate hose lines, rescue victims, and otherwise increase efficiency. Useful firefighting tool is lower cost, more rugged short range two-way radio. Inductorless electronic circuit replaced inductances and coils in radio circuits with combination of transistors and other low-cost components. Substitution promises reduced circuit size and cost. Enhanced electrical performance made radio more durable and improved maintainability by incorporating modular construction.

Source record↗
NASA NTRS1981

A comparison of equatorial electron densities measured by whistlers and by a satellite radio technique

Magnetospheric equatorial electron densities determined from whistler observations are compared with in situ satellite measurements of electron density along near-equatorial orbits. Whistler data was recorded at Siple and Palmer, Antarctica, while the sweep frequency receiver on ISEE-1 was used to measure plasma densities during passes within about 15 deg of the whistler station longitudes at L values between 3 and 5.2. The whistler and satellite data sets are found to be in good agreement for the three rendezvous considered, suggesting that the diffusive equilibrium model applied to calculate electron densities from whistler measurements was appropriate for the description of electron density distributions along field lines in the outer plasmasphere. Data also indicate that density enhancements within the whistler ducts were not more than about 30% of the mean or interduct level, and that there were no significant east-west density gradients within about 15 deg of whistler station longitudes over the L range of the study.

Carpenter, D. L.↗
NASA NTRS1994

The effect of comet Shoemaker-Levy 9 on Jupiter's synchrotron radiation

Solid material from comet Shoemaker-Levy 9 is expected to modify Jupiter's decimetric radio emission. Electrons passing through dust grains suffer a degradation in their energy, while larger sized material absorbs all electrons impinging on it. If there is enough dust and/or larger sized material in the magnetosphere, the effect on the energetic electrons can be observed via their synchrotron radiation, emitted at microwave frequencies. The planet's radio emission is expected to decrease, and the presence of dust induces a hardening in the radio spectrum. We expect the intensity to decrease immediately after cometary material enters the radiation belts; the radio emission continues to drop for many months as electrons diffuse inwards through a dusty magnetosphere. Radio observations of the planet during and after the cometary impact thus yield information on the amount of cometary material (optical depth of the dust and macroscopic material), impacts between cometary material and Jupiter's ring, and the diffusion process of energetic electrons through the magnetosphere.

De Pater, Imke↗
DOE OSTI2023

Frontiers in the Application of RF Vacuum Electronics

The application of radio frequency (RF) vacuum electronics for the betterment of the human condition began soon after the invention of the first vacuum tubes in the 1920s and has not stopped since. Today, microwave vacuum devices are powering important applications in health treatment, material and biological science, wireless communication-terrestrial and space, Earth environment remote sensing, and the promise of safe, reliable, and inexhaustible energy. This article highlights some of the exciting application frontiers of vacuum electronics.

42 ENGINEERING↗