Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “RANGE MEASUREMENT”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1979

Polar motion from laser range measurements of GEOS-3

Using two-day arcs of GEOS-3 laser data, simultaneous solutions for pole position components, x sub p and y sub p, and orbit elements have been obtained for the period spanning 3 February to 6 March 1976 using three NASA Goddard Space Flight Center laser stations located near Washington, D.C. (STALAS) and on the islands of Bermuda and Grand Turk. The results are in general agreement with the BIH results. However, because of the locations of the laser sites, the x sub p solution is weaker than the y sub p solution. The x sub p and y sub p estimates were smoothed with a straight line by weighted least squares using the variance associated with the pole estimates as weights in order to reflect the effect of widely different data distributions. The smoothed y sub p differs by one meter with respect to the BIH smoothed values and the smoothed x sub p differs by about two meters. Spectral analysis of the results has identified frequencies associated with the orbital motion indicating the need for further improvements in the model of the physical system.

Schutz, B. E.↗
NASA NTRS1984

T/R switch design for short-range measurements, part 6.1A

The positive intrinsic negative (PIN) diode switch which is designed to protect the receiver from burnout or damage on transmission and channel the echo signal to the receiver on reception is outlined. The receiver must be protected firmly. A schematic diagram of a transformer rectifier (TR-ATR) switch for the Urbana Radar is shown. The T/R switch consists of a half wavelength coaxial cavity with tuning condenser and PIN diodes. Two UM4300 PIN diodes were mounted between the inner and outer conductor. The dc biasing voltage required for the PIN diodes is supplied by a control circuit. On transmission, the PIN diodes are forward biased to about 0.5 amperes. On reception, about 10 volts reverse voltage is applied to the diodes, which produces an initial reverse current to speed the recovery time. The T/R switch characteristics are estimated and the result of testing at different peak transmitter powers from 410 kW to 1500 kW is shown.

Yu, B.↗
NASA NTRS1987

Modified-Edge Compact-Range Measurement System

Large curved edge termination reduces edge-scattered field in target area by one order of magnitude. Large, curved-edge treatment, involves radius of curvature equal to or greater than focal distance, provides improvement by creating reflected field that goes smoothly from parabolic surface to curved surface termination. Concept used on any reflector configuration requiring creation of field without diffraction from edge terminations.

Gilreath, Melvin C.↗
NASA NTRS1988

Television-and-Laser Range-Measuring System

Triangulation system measures angle between two lines of sight to point on object, determining distance to object. Amenable to automation. Includes automatically aimed rotatable mirrors and laser beam to define one of lines of sight. Adjusts automatically to bring two lines of sight into convergence at common point on object.

Russell, J. Kevin↗
NASA NTRS1993

Electromagnetic bias in sea surface range measurements at frequencies of the TOPEX/POSEIDON satellite

Measurements of EM bias at the 13.6 GHz and 5.3 GHz operating frequencies of the NASA altimeter on the TOPEX/POSEIDON satellite in a series of 11 aircraft flights from January 17, 1991 through March 4, 1991, during the Surface Wave Dynamics Experiment, are reported. The data are consistent with an earlier set of airborne measurements and indicate that EM bias is slightly higher at 5.3 GHz than at 13.6 GHz, and that the magnitudes of both biases increase with increasing wind speed, as does their difference. With some exceptions, EM bias shows little variation over a mesoscale region on a given day or within 1 or 2 h, but it can change significantly over a 6-h period. Recent tower, airborne, and satellite measurements exhibit a consistency in the characteristics of the wind speed dependence but suggest that there may be a height dependence in the determinations, with the bias decreasing with increasing altitude.

Hevizi, Laszlo G.↗
NASA NTRS1993

A simulation of GPS and differential GPS sensors

The Global Positioning System (GPS) is a revolutionary advance in navigation. Users can determine latitude, longitude, and altitude by receiving range information from at least four satellites. The statistical accuracy of the user's position is directly proportional to the statistical accuracy of the range measurement. Range errors are caused by clock errors, ephemeris errors, atmospheric delays, multipath errors, and receiver noise. Selective Availability, which the military uses to intentionally degrade accuracy for non-authorized users, is a major error source. The proportionality constant relating position errors to range errors is the Dilution of Precision (DOP) which is a function of the satellite geometry. Receivers separated by relatively short distances have the same satellite and atmospheric errors. Differential GPS (DGPS) removes these errors by transmitting pseudorange corrections from a fixed receiver to a mobile receiver. The corrected pseudorange at the moving receiver is now corrupted only by errors from the receiver clock, multipath, and measurement noise. This paper describes a software package that models position errors for various GPS and DGPS systems. The error model is used in the Real-Time Simulator and Cockpit Technology workstation simulations at NASA-LaRC. The GPS/DGPS sensor can simulate enroute navigation, instrument approaches, or on-airport navigation.

Rankin, James M.↗
NASA NTRS2006

Video Guidance Sensor System With Integrated Rangefinding

A video guidance sensor system for use, p.g., in automated docking of a chase vehicle with a target vehicle. The system includes an integrated rangefinder sub-system that uses time of flight measurements to measure range. The rangefinder sub-system includes a pair of matched photodetectors for respectively detecting an output laser beam and return laser beam, a buffer memory for storing the photodetector outputs, and a digitizer connected to the buffer memory and including dual amplifiers and analog-to-digital converters. A digital signal processor processes the digitized output to produce a range measurement.

Book, Michael L.↗
NASA NTRS1970

Multipath error in range rate measurement by PLL-transponder/GRARR/TDRS

Range rate errors due to specular and diffuse multipath are calculated for a tracking and data relay satellite (TDRS) using an S band Goddard range and range rate (GRARR) system modified with a phase-locked loop transponder. Carrier signal processing in the coherent turn-around transponder and the GRARR reciever is taken into account. The root-mean-square (rms) range rate error was computed for the GRARR Doppler extractor and N-cycle count range rate measurement. Curves of worst-case range rate error are presented as a function of grazing angle at the reflection point. At very low grazing angles specular scattering predominates over diffuse scattering as expected, whereas for grazing angles greater than approximately 15 deg, the diffuse multipath predominates. The range rate errors at different low orbit altutudes peaked between 5 and 10 deg grazing angles.

Sohn, S. J.↗