SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Low visibility approach and landing simulation for jet transports
A method for determining the appropriate longitudinal and lateral decision height dispersion limits for any airplane/control system combination during an instrument landing approach is presented. An example is worked out to clarify the steps required. It is shown that the current longitudinal decision height dispersion limits are well suited for a DC-8 with the example control system, but that the lateral limits are too loose to guarantee acceptable touchdowns with the example system subjected to recommended wind and shear disturbances.
As part of a general investigation of the effectiveness of pictorial displays for manual control and monitoring of aircraft approaches and landings, a simulator study was conducted in which pilot performance with three pictorial displays was evaluated. These displays differed in the type of guidance symbology added to the basic perspective runway display. The effect of decreased resolution and update rate of the runway image on pilot performance was also determined. The results indicate that for pictorial displays with added guidance symbology, there was a marked improvement in pilot performance compared to results of a previous study in which the display consisted of only a runway image and aircraft attitude.
Flight tests were performed to evaluate the vortex wake characteristics of a Boeing 727 aircraft during conventional and two-segment instrument landing approaches. Smoke generators were used for vortex marking. The vortex was intentionally intercepted by a Lear Jet and a Piper Comanche aircraft. The vortex location during landing approach was measured using a system of phototheodolites. The tests showed that at a given separation distance there are no readily apparent differences in the upsets resulting from deliberate vortex encounters during the two types of approaches. The effect of the aircraft configuration on the extent and severity of the vortices is discussed.
The results of baseline noise flight tests are presented. Data are given for a point 1.85 kilometers (1.0 nautical mile) from the runway threshold, and experimental results of level flyover noise at altitudes of 122 meters (400 feet) and 610 meters (2,000 feet) are also shown for several different power levels. The experimental data are compared with data from other sources and reasonable agreement is noted. A description of the test technique, instrumentation, and data analysis methods is included.
A series of instrument landing system approaches were conducted using seven airline-rated Boeing 737 pilots in a Federal Aviation Administration qualified simulator. The test matrix included both manual and coupled approaches with and without atmospheric turbulence in Category II visibility conditions. A nonintrusive oculometer system was used to track the pilot eye-point-of-regard throughout the approach. The results indicate that, in general, the pilots use different scan techniques for the manual and coupled conditions and that the introduction of atmospheric turbulence does not greatly affect the scan behavior in either case. The pilots consistently ranked the instruments in terms of most used to least used. The ranking obtained from the oculometer data agrees with the pilot ranking for the flight director and airspeed, the most important instruments. However, the pilots apparently ranked the other instruments in terms of their concern for information rather than according to their actual scanning behavior.
Papers are presented on superconductivity applications including magnets, electronics, rectifiers, magnet stability, coil protection, and cryogenic techniques. Also considered are insulation, heat transfer to liquid helium and nitrogen, heat and mass transfer in He II, superfluid pumps, and refrigeration for superconducting systems. Other topics include cold compressors, refrigeration and liquefaction, magnetic refrigeration, and refrigeration for space applications. Papers are also presented on cryogenic applications, commercial cryogenic plants, the properties of cryogenic fluids, and cryogenic instrumentation and data acquisition.
The present conference on heat transfer characteristics of gas turbines and three-dimensional flows discusses velocity-temperature fluctuation correlations at the flow stagnation flow of a circular cylinder in turbulent flow, heat transfer across turbulent boundary layers with pressure gradients, the effect of jet grid turbulence on boundary layer heat transfer, and heat transfer characteristics predictions for discrete-hole film cooling. Also discussed are local heat transfer in internally cooled turbine airfoil leading edges, secondary flows in vane cascades and curved ducts, three-dimensional numerical modeling in gas turbine coal combustor design, numerical and experimental results for tube-fin heat exchanger airflow and heating characteristics, and the computation of external hypersonic three-dimensional flow field and heat transfer characteristics.
Papers are presented on the control of distributed parameter systems using the coprime factorization approach, a hierarchy of geometrically exact models of rotating beams, and the temperature stability of a flux modulated radiant slab. Also considered are a network representation for robots, recovery from controller bounding, and the design of controllers for robust tracking and model following. Other topics include an active control law synthesis for flexible aircraft, the low-order control of large aerospsace structures using residual model filters, and a comparison of component cost methods for component model reduction.
Attention is given to such topics as an evaluation of block algorithm variants in LAPACK and presents a large-grain parallel sparse system solver, a multiprocessor method for the solution of the generalized Eigenvalue problem on an interval, and a parallel QR algorithm for iterative subspace methods on the CM2. A discussion of numerical methods includes the topics of asynchronous numerical solutions of PDEs on parallel computers, parallel homotopy curve tracking on a hypercube, and solving Navier-Stokes equations on the Cedar Multi-Cluster system. A section on differential equations includes a discussion of a six-color procedure for the parallel solution of elliptic systems using the finite quadtree structure, data parallel algorithms for the finite element method, and domain decomposition methods in aerodynamics. Topics dealing with massively parallel computing include hypercube vs. 2-dimensional meshes and massively parallel computation of conservation laws. Performance and tools are also discussed.
We present an analysis of the compact X-ray source population in the Seyfert 2 galaxy NGC 1068, imaged with a approx. 50 ks Chandra observation. We find a total of 84 compact sources on the S3 chip, of which 66 are located within the 25.0 B-mag/arcsec isophote of the galactic disk of NGC 1068. Spectra have been obtained for the 21 sources with at least 50 counts and modeled with both multicolor disk blackbody and power-law models. The power-law model provides the better description of the spectrum for 18 of these sources. For fainter sources, the spectral index has been estimated from the hardness ratio. Five sources have 0.4 - 8 keV intrinsic luminosities greater than 10(exp 39)ergs/ s, assuming that their emission is isotropic and that they are associated with NGC 1068. We refer to these sources as intermediate-luminosity X-ray objects (ISOs). If these five sources are X-ray binaries accreting with luminosities that are both sub-Eddington and isotropic, then the implied source masses are approx greater than 7 solar mass, and so they are inferred to be black holes. Most of the spectrally modeled sources have spectral shapes similar to Galactic black hole candidates. However, the brightest compact source in NGC 1068 has a spectrum that is much harder than that found in Galactic black hole candidates and other ISOs. The brightest source also shows large amplitude variability on both short-term and long-term timescales, with the count rate possibly decreasing by a factor of 2 in approx. 2 ks during our Chundra observation, and the source flux decreasing by a factor of 5 between our observation and the grating observations taken just over 9 months later. The ratio of the number of sources with luminosities greater than 2.1 x 10(exp 38) ergs/s in the 0.4 - 8 keV band to the rate of massive (greater than 5 solar mass) star formation is the same, to within a factor of 2, for NGC 1068, the Antennae, NGC 5194 (the main galaxy in M51), and the Circinus galaxy. This suggests that the rate of production of X-ray binaries per massive star is approximately the same for galaxies with currently active star formation, including "starbursts."
No abstract available
This viewgraph presentation reviews some of the logistic issues that the Vision for Space Exploration will entail. There is a review of the vision and the timeline for the return to the moon that will lead to the first human exploration of Mars. The lessons learned from the International Space Station (ISS) and other such missions are also reviewed.
This case study describes the implementation of several emerging lighting techniques at the new Chicago offices of IMEG Corp, an engineering and design consulting firm. IMEG collaborated with Pacific Northwest National Lab as part of a study to better understand the physiological and psychological impacts of advanced lighting strategies on occupant comfort, well-being, and energy savings. The project was recognized as part of DOE's Integrated Lighting Campaign.
Herein, we propose a strategy of developing novel dual anionic-cationic crosslinked poly(IL)-IL composite membranes via a photopolymerization method for enhanced CO2 separations. These are the first examples of dually photopolymerized anionic-cationic poly(IL)-IL composite systems, in which the backbones of poly(IL)s feature both pendant anions and cations without any mobile counterions unlike poly(IL) reported so far in the literature. A new type of dual photopolymerizable anionic-cationic IL (DIL) monomer having methacrylate functional group tethered with highly delocalized sulfonimide anion (–SO2–N(-)–SO2–C7H7) and a vinylimidazolium counterion ([C4(vim)](+)) was successfully synthesized and photopolymerized with four distinct amounts of free IL with a structurally analogous cation ([C4(mim)][Tf2N]) and 20 wt% PEGDA crosslinker, offering novel composite matrices. Further, the structure-property relationships as well as gas separation behaviors of the four newly developed dual anioniccationic poly(IL)-IL composite membranes were extensively characterized by FT-IR, DSC, and XRD. All of the newly developed dual anionic-cationic poly(IL)-IL composite membranes displayed outstanding permselectivites for CO2/CH4, CO2/N2, and CO2/H2 gas pairs together with reasonable CO2 permeabilities. As a result, all the dual anionic-cationic poly(IL)-IL composite membranes outperformed the common poly(IL)-IL systems in the upper bound limit plots with best CO2 permeability of 40 barrer and CO2/CH4 permselectivity of 85. This study may pave a new platform to explore countless potential poly(IL)-IL composites for selective separation of CO2 from flue gas, natural gas, and syngas streams.
Cytokines elicit pleiotropic and non-redundant activities despite strong overlap in their usage of receptors, JAKs and STATs molecules. We use IL-6 and IL-27 to ask how two cytokines activating the same signaling pathway have different biological roles. We found that IL-27 induces more sustained STAT1 phosphorylation than IL-6, with the two cytokines inducing comparable levels of STAT3 phosphorylation. Mathematical and statistical modeling of IL-6 and IL-27 signaling identified STAT3 binding to GP130, and STAT1 binding to IL-27Rα, as the main dynamical processes contributing to sustained pSTAT1 levels by IL-27. Mutation of Tyr613 on IL-27Rα decreased IL-27-induced STAT1 phosphorylation by 80% but had limited effect on STAT3 phosphorgylation. Strong receptor/STAT coupling by IL-27 initiated a unique gene expression program, which required sustained STAT1 phosphorylation and IRF1 expression and was enriched in classical Interferon Stimulated Genes. Interestingly, the STAT/receptor coupling exhibited by IL-6/IL-27 was altered in patients with systemic lupus erythematosus (SLE). IL-6/IL-27 induced a more potent STAT1 activation in SLE patients than in healthy controls, which correlated with higher STAT1 expression in these patients. Partial inhibition of JAK activation by sub-saturating doses of Tofacitinib specifically lowered the levels of STAT1 activation by IL-6. Our data show that receptor and STATs concentrations critically contribute to shape cytokine responses and generate functional pleiotropy in health and disease.
The addition of ionic liquids (ILs) to a mixture containing a molecular solvent and other ionic species can induce the heterogeneous redistribution of cations and anions at the gas–liquid interface. This nonuniform redistribution of cations and anions driven by the differences in the solvophilicity of ions can improve the thermophysical and interfacial properties of such mixtures, creating a local chemical environment that is conducive to some reactions. In this work, ILs are added to a mixture of potassium hydroxide (KOH) and ethylene glycol (EG), used as a reactive absorbent and electrolyte in the migration-assisted moisture-gradient (MAMG) process for CO 2 capture. Molecular dynamics (MD) simulations are employed to probe into the effects of complex ion–ion and ion–solvent interactions and to examine the chemical composition at the gas–liquid interface. A total of 12 systems are investigated using molecular simulations to identify trends in the performance of IL additives based on the choice of cation, anion, and IL concentration. The cation effects are studied using IL additives based on 1-ethyl-3-methylimidazolium ([EMIM] + ) and 1-butyl-3-methylimidazolium ([BMIM] + ), while the impact of anions is examined using additives based on dicyanamide [DCA] − , triflate [TfO] − , bistriflimide [NTf 2 ] − , and hexafluorophosphate [PF 6 ] − anions, respectively. The influence of the IL concentration is also evaluated at molar concentrations between 1% and 4%. The simulation results indicate that the use of IL additives can affect the physical CO 2 solubility, surface tension, and the localization of CO 2 around the [OH] − ions at the gas–liquid interface. It is also evident that the choice of cations, anions, and IL concentration determines the extent to which the IL additives impact the local physicochemical properties. Physical dissolution, diffusive transport, and interaction with [OH] − are critical intermediate steps toward reactive CO 2 capture using a liquid absorbent. Hence, the improvement in one or more of these properties, aided by IL additives, is expected to improve the overall CO 2 capture performance. Experiments reaffirmed the impact of IL additives on CO 2 capture performance and the sensitivity to the choice of the cation, anion, and concentration of the IL additive.