Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “BIT SYNCHRONIZATION”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 73 records · Page 4
All sourcesNASA NTRSDOE OSTI
NASA NTRS1975

Digital simulation of a communication link for Pioneer Saturn Uranus atmospheric entry probe, part 1

A digital simulation study is presented for a candidate modulator/demodulator design in an atmospheric scintillation environment with Doppler, Doppler rate, and signal attenuation typical of the conditions of an outer planet atmospheric probe. The simulation results indicate that the mean channel error rate with and without scintillation are similar to theoretical characterizations of the link. The simulation gives information for calculating other channel statistics and generates a quantized symbol stream on magnetic tape from which error correction decoding is analyzed. Results from the magnetic tape data analyses are also included. The receiver and bit synchronizer are modeled in the simulation at the level of hardware component parameters rather than at the loop equation level and individual hardware parameters are identified. The atmospheric scintillation amplitude and phase are modeled independently. Normal and log normal amplitude processes are studied. In each case the scintillations are low pass filtered. The receiver performance is given for a range of signal to noise ratios with and without the effects of scintillation. The performance is reviewed for critical reciever parameter variations.

Hinrichs, C. A.↗
NASA NTRS1975

Uniform sampling analysis of a hybrid phase-locked loop with a sample-and-hold phase detector

Phase-locked-loop (PLL) bit synchronizers often employ integrate-and-dump type phase detectors that provide phase error information only at discrete points in time. Usually these phase detectors are followed by sample-and-hold circuits to produce a stairstep error voltage as the input to a standard analog circuit loop filter. When the loop is configured in this manner, it is referred to as a hybrid PLL. Sampled-data analysis methods (Z transforms) are used to determine the stability and transient response of this loop.

Barab, S.↗
NASA NTRS1976

Power spectra of sinusoidal amplitude-modulated binary signals

Power spectra for binary phase-shift keyed (PSK) and frequency-shift keyed (FSK) signals with combined sinusoidal amplitude modulation by the bit rate clock are presented. Such signal formats have application in 'burst' communication systems wherein reliable bit synchronization is provided with relative receiver simplicity. Effects of the clock amplitude modulation index and phase are considered, and corresponding power spectra are illustrated. Further, effects of the clock parameters on the rate of spectral rolloff are given and compared with those of conventional PSK and FSK spectra.

Gee, T. H.↗
NASA NTRS1977

Ku-band signal design study

The acquisition/tracking performance of a practical squaring loop in which the times two multiplier is mechanized as a limiter/multiplier combination is evaluated. This squaring approach serves to produce the absolute value of the arriving signal as opposed to the perfect square law action which is required in order to render acquisition and tracking performance equivalent to that of a Costas loop. The Ku-Band orbiter signal design for the forward link is assessed. Acquisition time results and acquisition and tracking thresholds are summarized. A tradeoff study which pertains to bit synchronization techniques for the high rate Ku-Band channel is included and an optimum selection is made based upon the appropriate design constraints.

Lindsey, W. L.↗
NASA NTRS1980

Microprocessor-controlled receiver

Microprocessor and radio receiver are combined in low-cost, high performance, data communications receiver. Hybrid receiver automatically acquires and tracks UHF channels despite low signal-to-noise ratios, fading signal strengths, and high Doppler offset. It also performs digital bit synchronization, which has traditionally required separate unit.

Grant, T. L.↗
NASA NTRS1980

Mark 3 wideband digital recorder in perspective

The tape recorder used for the Mark 3 data acquisition and processing system is compared with earlier very long baseline interferometry recorders. Wideband 33-1/3 kbpi digital channel characteristics of instrumentation recorders and of a modern video cassette recorder are illustrated. Factors which influenced selection of the three major commercial components (transport, heads, and tape) are discussed. A brief functional description and the reasons for development of efficient signal electronics and necessary auxiliary control electronics are given. The design and operation of a digital bit synchronizer is illustrated as an example of the high degree of simplicity achieved.

Hinteregger, H. F.↗
NASA NTRS1981

The effects of transmitter/receiver clock time base instability on coherent communication system performance

The purpose of this paper is to present a model and associated analysis of the deleterious effects which both transmitter and receiver data clock time-base instability have on bit error probability. The types of time-base instability modeled and analyzed include bit jitter (epoch jitter), bit jitter rate (time interval jitter) and data asymmetry. The bit error probability is determined as a function of the statistical characteristics of the time-base instability, the data transition density, the signal-to-noise ratio in the bit rate bandwidth and the mechanizations of both the data bit detector and bit synchronizer. Numerical results are provided.

Chie, C. M.↗
NASA NTRS1997

Reduction of ETS-VI Laser Communication Equipment Optical-Downlink Telemetry Collected During GOLD

Free-space laser communications experiments were conducted between the laser communication equipment (LCE) on board the Japanese Engineering Test Satellite VI (ETS-VI) and the ground station located at the Table Mountain Facility (TMF) during late 1995 and early 1996. This article describes the on-line data reduction process used to decode LCE telemetry (called E2) downlinked on the optical carrier during the Ground/Orbiter Lasercomm Demonstration (GOLD) experiments. The LCE has the capability of transmitting real-time sensor and status information at 128 kbps by modulating the onboard diode laser. The optical downlink was detected on the ground, bit synchronized, and the resulting data stream stored on a data recorder. The recorded data were subsequently decoded by on-line data processing that included cross-correlation of the known telemetry data format and the downlink data stream. Signals obtained from the processing can be useful not only in evaluating the characteristics of the LCE but also in understanding uplink and downlink signal quality.

Toyoshima, M.↗
NASA NTRS2012

Low-Cost Telemetry System for Small/Micro Satellites

A Software Defined Radio (SDR) concept uses a minimum amount of analog/radio frequency components to up/downconvert the RF signal to/from a digital format. Once in the digital domain, all other processing (filtering, modulation, demodulation, etc.) is done in software. The project will leverage existing designs and enhance capabilities in the commercial sector to provide a path to a radiation-hardened SDR transponder. The SDR transponder would incorporate baseline technologies dealing with improved Forward Error Correcting (FEC) codes to be deployed to all Near Earth Network (NEN) ground stations. By incorporating this FEC, at least a tenfold increase in data throughput can be achieved. A family of transponder products can be implemented using common platform architecture, allowing new products to be more quickly introduced into the market. Software can be reused across products, reducing software/hardware costs dramatically. New features and capabilities, such as encoding and decoding algorithms, filters, and bit synchronizers, can be added to the existing infrastructure without requiring major new capital expenditures, allowing implementation of advanced features in the communication systems. As new telecommunication technologies emerge, incorporating them into the SDR fabric will be easily accomplished with little or no requirements for new hardware. There are no preferred flight platforms for the SDR technology, so it can be used on any type of orbital or sub-orbital platform, all within a fully radiation hardened design.

Sims, William↗
NASA NTRS1985

Detection and Symbol Synchronization for Multiple-bit Per Photon Optical Communications

Methods of detection and synchronization in a highly efficient direct detection optical communication system are reported. Results of measurements on this moderate-rate demonstration system capable of transmitting 2.5 bits/detected photon in low-background situations indicate that symbol slot synchronization is not a problem, and that a simple symbol detection scheme is adequate for this situation. This system is a candidate for interplanetary optical communications.

Marshall, W. K.↗
NASA NTRS1994

Decoder synchronization for deep space missions

The Consultative Committee for Space Data Standards (CCSDS) recommends that space communication links employ a concatenated, error-correcting, channel-coding system in which the inner code is a convolutional (7,1/2) code and the outer code is a (255,223) Reed-Solomon code. The traditional implementation is to perform the node synchronization for the Viterbi decoder and the frame synchronization for the Reed-Solomon decoder as separate, sequential operations. This article discusses a unified synchronization technique that is required for deep space missions that have data rates and signal-to-noise ratios (SNR's) that are extremely low. This technique combines frame synchronization in the bit and symbol domains and traditional accumulated-metric growth techniques to establish a joint frame and node synchronization. A variation on this technique is used for the Galileo spacecraft on its Jupiter-bound mission.

Statman, J. I.↗
NASA NTRS1975

Synchronous Meteorological Satellite spin testing

The end-to-end spin tests conducted on the Synchronous Meteorological Satellite are described in detail. It is noted that the objective of these tests was to demonstrate that the satellite performed its intended functions under spinning conditions and that all satellite functions were tested except for solar-panel illumination, pyrotechnic-device operation, VISSR infrared operation, and auxiliary propulsion-system operation. Tests discussed include antenna pointing, S-band and UHF equivalent isotropic radiated power, output-power ripple, bit error rate, synchronous electromagnetic interference, earth width measurement, and satellite magnetic-field measurement. The purpose, technique, salient results, and problems of each test are outlined.

Mcbrady, D. J.↗
NASA NTRS1983

Symbol synchronization for the TDRSS decoder

Each 8 bits out of the Viterbi decoder correspond to one symbol of the R/S code. Synchronization must be maintained here so that each 8-bit symbol delivered to the R/S decoder corresponds to an 8-bit symbol from the R/S encoder. Lack of synchronization, would cause an error in almost every R/S symbol since even a - 1-bit sync slip shifts every bit in each 8-bit symbol by one position, therby confusing the mapping betweeen 8-bit sequences and symbols. The error correcting capability of the R/S code would be exceeded. Possible ways to correcting this condition include: (1) designing the R/S decoder to recognize the overload and shifting the output sequence of the inner decoder to establish a different sync state; (2) using the characteristics of the inner decoder to establish symbol synchronization for the outer code, with or without a deinterleaver and an interleaver; and (3) modifying the encoder to alternate periodically between two sets of generators.

Costello, D. J., Jr.↗