Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “maximum”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 703 records · Page 39

Maximum power flux of auroral kilometric radiation

Distant observations of intense auroral kilometric radiation (AKR) are discussed in light of the increased maximum AKR power flux registered by the 3D radio-mapping instrument on ISEE 3. Only AKR events that contain the highest frequency signals are selected, and during spacecraft rotation the spacecraft antenna gain is employed to increase the dynamic range of the instrument. The technique is found to result in the screening of false signals created by instrument overloading as well as the detection of genuine second-harmonic AKR signals while the spacecraft was 17 R(E) from earth. A very strong power flux of fundamental AKR is also reported, exceeding 3 x 10 to the -13th W/sq m/Hz at 360 kHz. The most intense source-region values detected by Isis I and Viking measurements are compared to the strong signal, and the signal is concluded to be the combined signal of a number of sources.

Benson, Robert F.↗

Experiences with optimizing airfoil shapes for maximum lift over drag

The goal was to find airfoil shapes which maximize the ratio of lift over drag for given flow conditions. For a fixed Mach number, Reynolds number, and angle of attack, the lift and drag depend only on the airfoil shape. This then becomes a problem in optimization: find the shape which leads to a maximum value of lift over drag. The optimization was carried out using a self contained computer code for finding the minimum of a function subject to constraints. To find the lift and drag for each airfoil shape, a flow solution has to be obtained. This was done using a two dimensional Navier-Stokes code.

Doria, Michael L.↗

The 1988 Solar Maximum Mission event list

Information on solar burst and transient activity observed by the Solar Maximum Mission (SMM) during 1988 pointed observations is presented. Data from the following SMM experiments are included: (1) gamma ray spectrometer; (2) hard x ray burst spectrometer; (3) flat crystal spectrometers; (4) bent crystal spectrometer; (5) ultraviolet spectrometer polarimeter; and (6) coronagraph/polarimeter. Correlative optical, radio, and Geostationary Operational Environmental Satellite (GOES) x ray data are also presented. Where possible, bursts, or transients observed in the various wavelengths were grouped into discrete flare events identified by unique event numbers. Each event carries a qualifier denoting the quality or completeness of the observation. Spacecraft pointing coordinates and flare site angular displacement values from sun center are also included.

Dennis, B. R.↗

The 1984 - 1987 Solar Maximum Mission event list

Information on solar burst and transient activity observed by the Solar Maximum Mission (SMM) during 1984-1987 pointed observations is presented. Data from the following SMM experiments are included: (1) gamma ray spectrometer; (2) hard x-ray burst spectrometer; (3) flat crystal spectrometer; (4) bent crystal spectrometer; (5) ultraviolet spectrometer polarimeter; and (6) coronograph/polarimeter. Correlative optical, radio, and Geostationary Operational Environmental Satellite (GOES) x ray data are also presented. Where possible, bursts or transients observed in the various wavelengths were grouped into discrete flare events identified by unique event numbers. Each event carries a qualifier denoting the quality or completeness of the observations. Spacecraft pointing coordinates and flare site angular displacement values from sun center are also included.

Dennis, B. R.↗

Toxicological approach to setting spacecraft maximum allowable concentrations for carbon monoxide

The Spacecraft Maximum Allowable Concentrations (SMACs) are exposure limits for airborne chemicals used by NASA in spacecraft. The aim of these SMACs is to protect the spacecrew against adverse health effects and performance decrements that would interfere with mission objectives. Because of the 1 and 24 hr SMACs are set for contingencies, minor reversible toxic effects that do not affect mission objectives are acceptable. The 7, 30, or 180 day SMACs are aimed at nominal operations, so they are established at levels that would not cause noncarcinogenic toxic effects and more than one case of tumor per 1000 exposed individuals over the background. The process used to set the SMACs for carbon monoxide (CO) is described to illustrate the approach used by NASA. After the toxicological literature on CO was reviewed, the data were summarized and separated into acute, subchronic, and chronic toxicity data. CO's toxicity depends on the formation of carboxyhemoglobin (COHb) in the blood, reducing the blood's oxygen carrying capacity. The initial task was to estimate the COHb levels that would not produce toxic effects in the brain and heart.

Wong, K. L.↗

Maximum aposteriori joint source/channel coding

A maximum aposteriori probability (MAP) approach to joint source/channel coder design is presented in this paper. This method attempts to explore a technique for designing joint source/channel codes, rather than ways of distributing bits between source coders and channel coders. For a nonideal source coder, MAP arguments are used to design a decoder which takes advantage of redundancy in the source coder output to perform error correction. Once the decoder is obtained, it is analyzed with the purpose of obtaining 'desirable properties' of the channel input sequence for improving overall system performance. Finally, an encoder design which incorporates these properties is proposed.

Sayood, Khalid↗

The 1989 Solar Maximum Mission event list

This document contains information on solar burst and transient activity observed by the Solar Maximum Mission (SMM) during 1989 pointed observations. Data from the following SMM experiments are included: (1) Gamma Ray Spectrometer, (2) Hard X-Ray Burst Spectrometer, (3) Flat Crystal Spectrometer, (4) Bent Crystal Spectrometer, (5) Ultraviolet Spectrometer Polarimeter, and (6) Coronagraph/Polarimeter. Correlative optical, radio, and Geostationary Operational Satellite (GOES) X-ray data are also presented. Where possible, bursts or transients observed in the various wavelengths were grouped into discrete flare events identified by unique event numbers. Each event carries a qualifier denoting the quality or completeness of the observations. Spacecraft pointing coordinates and flare site angular displacement values from sun center are also included.

Dennis, B. R.↗

Solar irradiance measurements - Minimum through maximum solar activity

The Earth Radiation Budget Satellite (ERBS) and the NOAA-9 spacecraft solar monitors were used to measure the total solar irradiance during the period October 1984 to December 1989. Decreasing trends in the irradiance measurements were observed as sunspot activity decreased to minimum levels in 1986; after 1986, increasing trends were observed as sunspot activity increased. The magnitude of the irradiance variability was found to be approximately 0.1 percent between sunspot minimum and maximum (late 1989). When compared with the 1984 to 1989 indices of solar magnetic activity, the irradiance trends appear to be in phase with the 11-year sunspot cycle. Both irradiance series yielded 1,365/sq Wm as the mean value of the solar irradiance, normalized to the mean earth/sun distance. The monitors are electrical substitution, active-cavity radiometers with estimated measurement precisions and accuracies of less than 0.02 and 0.2 percent, respectively.

Lee, R. B., III↗

Maximum likelihood estimates of polar motion parameters

Two estimators developed by Jeffreys (1940, 1968) are described and used in conjunction with polar-motion data to determine the frequency (Fc) and quality factor (Qc) of the Chandler wobble. Data are taken from a monthly polar-motion series, satellite laser-ranging results, and optical astrometry and intercompared for use via interpolation techniques. Maximum likelihood arguments were employed to develop the estimators, and the assumption that polar motion relates to a Gaussian random process is assessed in terms of the accuracies of the estimators. The present results agree with those from Jeffreys' earlier study but are inconsistent with the later estimator; a Monte Carlo evaluation of the estimators confirms that the 1968 method is more accurate. The later estimator method shows good performance because the Fourier coefficients derived from the data have signal/noise levels that are superior to those for an individual datum. The method is shown to be valuable for general spectral-analysis problems in which isolated peaks must be analyzed from noisy data.

Wilson, Clark R.↗

Teleoperator performance in simulated Solar Maximum Satellite repair

An investigation is conducted of the relative benefits of different teleoperator control modes in simulated space servicing. The simulation replicates part of the Solar Maximum EVA Satellite Repair (SMSR) mission of STS-13, in 1974. The formal experimental design and statistical analysis presented demonstrates that position control is superior for small workspace volume management. Quantitative studies demonstrate significant benefits of shared Cartesian control modes for contact tasks; good performance will require the systematic analysis and synthesis of man-machine systems.

Schenker, Paul S.↗

Maximum life spiral bevel reduction design

Optimization is applied to the design of a spiral bevel gear reduction for maximum life at a given size. A modified feasible directions search algorithm permits a wide variety of inequality constraints and exact design requirements to be met with low sensitivity to initial values. Gear tooth bending strength and minimum contact ratio under load are included in the active constraints. The optimal design of the spiral bevel gear reduction includes the selection of bearing and shaft proportions in addition to gear mesh parameters. System life is maximized subject to a fixed backcone distance of the spiral bevel gear set for a specified speed reduction, shaft angle, input torque, and power. Design examples show the influence of the bearing lives on the gear parameters in the optimal configurations. For a fixed back-cone distance, optimal designs with larger shaft angles have larger service lives.

Savage, M.↗

Maximum life spiral bevel reduction design

Optimization is applied to the design of a spiral bevel gear reduction for maximum life at a given size. A modified feasible directions search algorithm permits a wide variety of inequality constraints and exact design requirements to be met with low sensitivity to initial values. Gear tooth bending strength and minimum contact ratio under load are included in the active constraints. The optimal design of the spiral bevel gear reduction includes the selection of bearing and shaft proportions in addition to gear mesh parameters. System life is maximized subject to a fixed back-cone distance of the spiral bevel gear set for a specified speed ratio, shaft angle, input torque, and power. Significant parameters in the design are: the spiral angle, the pressure angle, the numbers of teeth on the pinion and gear, and the location and size of the four support bearings. Interpolated polynomials expand the discrete bearing properties and proportions into continuous variables for gradient optimization. After finding the continuous optimum, a designer can analyze near optimal designs for comparison and selection. Design examples show the influence of the bearing lives on the gear parameters in the optimal configurations. For a fixed back-cone distance, optimal designs with larger shaft angles have larger service lives.

Savage, M.↗

Determination of the stability and control derivatives of the F/A-18 HARV from flight data using the maximum likelihood method

The research being conducted pertains to the determination of the stability and control derivatives of the F/A-18 High Alpha Research Vehicle (HARV) from flight data using the Maximum Likelihood Method. The document outlines the approach used in the parameter estimation (PID) process and briefly describes the mathematical modeling of the F/A-18 HARV and the maneuvers designed to generate a sufficient data base for the PID research.

Napolitano, Marcello R.↗

System for memorizing maximum values

The invention discloses a system capable of memorizing maximum sensed values. The system includes conditioning circuitry which receives the analog output signal from a sensor transducer. The conditioning circuitry rectifies and filters the analog signal and provides an input signal to a digital driver, which may be either linear or logarithmic. The driver converts the analog signal to discrete digital values, which in turn triggers an output signal on one of a plurality of driver output lines n. The particular output lines selected is dependent on the converted digital value. A microfuse memory device connects across the driver output lines, with n segments. Each segment is associated with one driver output line, and includes a microfuse that is blown when a signal appears on the associated driver output line.

Bozeman, Richard J., Jr.↗

Solar maximum mission/ultraviolet spectrometer and polarimeter studies

This final report for NASA Contract No. NAS8-35921 describes various studies performed for the Ultraviolet Spectrometer and Polarimeter (UVSP) experiment, one of several instruments on the Solar Maximum Mission (SMM) satellite which was launched on 14 February 1980. The UVSP consisted primarily of a Gregorian telescope and an Ebert-Fastie spectrometer with a polarimeter that could be inserted into the light path. The spacecraft and most of the instruments, including the UVSP, operated successfully until 23 November 1980, when part of the SMM attitude control system (fine pointing control) failed. The UVSP was then unable to observe the Sun until 18 April 1984, when the SMM was visited by the space shuttle and the attitude control module was replaced by astronauts. The SMM mission ended when the spacecraft reentered the atmosphere of the Earth and was thereby destroyed on 2 December 1989. The topics covered in this report include the following: (1) ultraviolet stellar polarimetry (probably the first such attempted measurement); no polarization as detected and the upper limits, based on the sensitivity as determined by the observed count rate, are rather high; (2) an investigation into the possible position of the UVSP wavelength drive after it became stuck on 26 April 1985; (3) fast timing tests for sit-and-state observations involving one or two detectors; (4) development of computer subroutines to allow the calculation of the component of the SMM spacecraft orbital velocity along the line of sight to the Sun at any desired time during the 1984/1985 period when the UVSP wavelength drive was operating properly; (5) listing of published research papers; (6) description of the UVSP catalog of observations; and (7) description of UVSP calibration report and data users guide.

Henze, William, Jr.↗

Maximum and minimum return losses from a passive two-port network terminated with a mismatched load

This article presents an analytical method for determining the exact distance a load is required to be offset from a passive two-port network to obtain maximum or minimum return losses from the terminated two-port network. Equations are derived in terms of two-port network S-parameters and load reflection coefficient. The equations are useful for predicting worst-case performances of some types of networks that are terminated with offset short-circuit loads.

Otoshi, T. Y.↗

Coronal abundances in solar active regions measured by the Solar Maximum Mission flat crystal spectrometer

High resolution soft X-ray spectra acquired by the Flat Crystal Spectrometer (FCS) on solar Maximum Mission provide an excellent data base to study the relative abundances of O, Ne, Mg, and Fe in solar active regions. The FCS data show significant variability for all combinations of these elements. The largest variation occurs for Fe:Ne, which shows region to region changes of up to a factor of 7, and frequent factor of 2 variations in day to day samples of a given region. The atomic data and the ionization balance calculations used to interpret the line ratios affect the actual abundance values obtained, but have little effect on the magnitude of the total range of variation inferred. Resonance scattering of Fe XVII could cause a systematic offset in the abundances determined, but cannot be responsbile for the bulk of the observed variability. While abundance variability complicates the derivation of plasma parameters from spectroscopic measurements, it should offer exciting new clues to the processes which form and heat the corona.

Saba, Julia L. R.↗