SEARCH · Engineering Papers
Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.
Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.
Measurements of angle of arrival and amplitude fluctuations on millimeter wavelength Earth-space communication links are described. Measurement of rainfall attenuation and radiometric temperature statistics and the assessment of the performance of a self-phased array as a receive antenna on an Earth-space link are also included.
A satellite borne synthetic aperture radar can image a wide swath in the order of 700 km with one-look 100-m resolution. If the design meets the ambiguity constraints at the far edge of the swath, the maximum swath width is independent of both radar wavelength and shape of the physical antenna aperture. The antenna pattern can be a pencil beam scanned in the elevation plane, or a fan beam formed by a long antenna. The scanning pencil beam antenna may be a phased array or multiple-feed reflector which may be more practical than a long antenna to image a wide swath. Design performance trade computations are presented involving resolution, swath width, antenna area, average transmitter power and digital data rate.
Guidance system for wire-following vehicles tested successfully at speeds exceeding 50 mi/h (80 km/h) on difficult 1 mile (1.6km) course. Unlike previous sensors that compare amplitudes of signals picked up from guide wire, new system compares signal phases. Array of coils is mounted in line along front bumper of vehicle and monitors electromagnetic signal radiating from wire. Guide wire on ground beneath vehicle carrier 6- to 7-kHz alternating current.
An iterative optical vector-matrix multiplier with a microprocessor-controlled feedback loop capable of performing a wealth of diverse operations was described. A survey and description of many of its operations demonstrates the versatility and flexibility of this class of optical processor and its use in diverse applications. General operations described include: linear difference and differential equations, linear algebraic equations, matrix equations, matrix inversion, nonlinear matrix equations, deconvolution and eigenvalue and eigenvector computations. Engineering applications being addressed for these different operations and for the IOP are: adaptive phased-array radar, time-dependent system modeling, deconvolution and optimal control.
A novel antenna configuration of two reflecting surfaces and a phased array is examined for application to satellite communications and shown to be superior in every respect to earlier designs for service to the continental United States from synchronous orbit. The vignetting that afflicts other two reflector optical systems is eliminated by use of a reflecting field element. The remaining aberrations, predominantly coma, are isolated in the time delay distribution at the surface of the array and can be compensated by ordinary array techniques. The optics exhibits infinite bandwidth and the frequency range is limited only by the design of the array.
Voltage-controlled optical phase shifter is key. Optical phase shifter stabilizes propagation delay of fiber-optic transmission line by compensating for temperature and pressure effects. Applicable to phased array antenna systems and very-long-baseline interferometer distribution systems.
The transmission of information by optical signals over a space channel with a power efficiency of 2.5 bits/detected photon markedly increases the amount of information that can be transmitted to satellites. An account is given of the research program at the Jet Propulsion Laboratory that is attempting to demonstrate that optical signals can be used to transmit information over a space channel with this power efficiency. It is noted, however, that the ability to attain 2.5 bits/detected photon (or higher) depends heavily on the validity of the mathematical models used in the performance analysis. Therefore, verification of the channel dark current noise models is a crucial first step. Another prerequisite is a high-brightness, single-spatial mode laser emitter. It is believed that single spatial model devices with power outputs of about 1W can be achieved by coherently combining a number of GaAs lasers in what effectively amounts to a phased array.
The development of fully monolithic gallium arsenide receive and transmit modules is described. These modules are slated for phased array antenna applications in future 30/20 gigahertz communications satellite systems. Performance goals and various approaches to achieve them are discussed. The latest design and performance results of components, submodules and modules are presented.
Current development activities at JPL for ground mobile vehicle antennas to be used with the Land Mobile Satellite Service (LMSS) system are described. Both low gain and electronically steerable high gain type antennas are discussed in terms of their design concept and RF performance. For the low gain type, three classes of antennas are under various stages of development. These are the crossed-drooping dipole, quadrifilar helix, and microstrip patch designs. The antennas are intended to provide circularly-polarized radiation with a minimum of 3-dB gain in the angular region from 19 degrees to 60 deg from the horizon in elevation plane and with an omnidirectional pattern in azimuthal plane. For the electronically steerable high gain type, circularly-polarized microstrip patch phased arrays formed on a planar surface and on the surface of a truncated cone are under study. The arrays are intended to provide a minimum of 12 dB gain in the same angular region in elevation plane at all azimuthal angles. This coverage is accomplished by scanning the high gain pencil beam in both elevation and azimuthal directions. Both types of antennas are to transmit at 821-831 MHz band and to receive at 866-876 MHz band. They must be of low cost design and reasonably conformal to the vehicle.
A fan-dipole or bowtie element operating over a ground plane has been empirically designed to maximize the impedance bandwidth near the half-wavelength resonance. It is shown that a bandwidth of 37 percent can be achieved with a simple bowtie element less than a half-wavelength at the center frequency. This design could be useful as a radiating element in a wide-band phased array application or as a wide-band reflector feed or cavity-backed dipole.
The coherent radar technique is reviewed with special emphasis to mesosphere-stratosphere-troposphere (MST) radars operating in the VHF band. Some basic introduction to Doppler radar measurements and the radar equation is followed by an outline of the characteristics of atmospheric turbulence, viewed from the scattering and reflection processes of radar signals. Radar signal acquisition and preprocessing, namely coherent detection, digital sampling, pre-integration and coding, is briefly discussed. The data analysis is represented in terms of the correlation and spectrum analysis, yielding the essential parameters: power, signal-to-noise ratio, average and fluctuating velocity and persistency. The techniques to measure wind velocities, viz. the different modes of the Doppler method as well as the space antenna method are surveyed and the feasibilities of the MST radar interferometer technique are elucidated. A general view on the criteria to design phased array antennas is given. An outline of the hardware of a typical MST radar system is presented.
The sizing and performance analyses have been conducted in the design of long-endurance, high-altitude airplanes. These airplanes receive power either continuously beamed from a phased array transmitter or intermittently beamed from a dish transmitter. Results are presented for the cases of flight in zero wind speed and nonzero wind speed. Sensitivity studies indicate that the vehicle size is relatively insensitive to changes in the transmitter size. Cost estimates were made using models that excluded the airplane cost. Using a reference payload, results obtained from array and dish configurations were compared. Comparisons showed savings in cost as well as smaller vehicle sizes when an array transmitter was used.
There is considerable interest in developing stratosphere troposphere (ST) and mesosphere stratosphere troposphere (MST) radars for higher resolution to study small-scale turbulent structures and waves. At present most ST and MST radars have resolutions of 150 meters or larger, and are not able to distinguish the thin (40 - 100 m) turbulent layers that are known to occur in the troposphere and stratosphere, and possibly in the mesosphere. However the antenna beam width and sidelobe level become important considerations for radars with superior height resolution. The objective of this paper is to point out that for radars with range resolutions of about 150 meters or less, there may be significant range smearing of the signals from mesospheric altitudes due to the finite beam width of the radar antenna. At both stratospheric and mesospheric heights the antenna sidelobe level for lear equally spaced phased arrays may also produce range aliased signals. To illustrate this effect the range smearing functions for two vertically directed antennas have been calculated, (1) an array of 32 coaxial-collinear strings each with 48 elements that simulates the vertical beam of the Poker Flat, Glaska, MST radar; and (2) a similar, but smaller, array of 16 coaxial-collinear strings each with 24 elements.
Ground reflections which are similar for all (Yagi) elements of a phased array and change the radiation pattern of the single elements are discussed. This consequently yields a change of the radiation pattern of the entire array. It is assumed that the radiation pattern of a Yagi antenna can be treated in a good approximation for the present purpose, similar to the pattern of a single dipole, if one confines to radiation angles which are roughly perpendicular to the main beam of the Yagi antenna.
SCIPVIS, the computational model discussed by Dash et al. (1985), is assessed in predicting the complicated flow structure associated with shock-containing plumes. In addition, the analysis in this study examines this code's applicability as a basic part of a program for estimating broadband shock noise radiation. The results of this study show that excellent agreement exists between predicted and measured static pressure distributions for both underexpanded and overexpanded flow cases considered. Of the three turbulence closure models incorporated in the SCIPVIS code, the kW model of Spalding produces the most uniform agreement with measurement. The k-epsilon-2 model of Launder consistently overestimates plume spreading for supersonic jets with exit Mach numbers in the 1-2 range. Dash's (1983) k-epsilon-2-cc, compressibility-corrected version of Launder's model underestimates plume spreading. Good qualitative agreement was also obtained between the measured longitudinal turbulence intensity and that predicted by the code for the same trial case. Comparison of measured and predicted broadband shock noise spectrum peak values were found to be in excellent agreement. This utilized a variant of the Harper-Bourne and Fisher (1973) phase-array model: the effective shock spacing was reinterpreted as the value of the end of the plume potential core, determined herein by the SCIPVIS code.
The MU (Middle and Upper Atmosphere) radar is a 46.5 MHz pulse modulated monostatic Doppler radar with an active phased array system. The nominal beam width is 3.6 deg, and the peak radiation power is 1 MW with maximum average power of 50 kW. A brief description of the system and the initial observational results are presented.
The feasibility of acoustic verification of microwave near field to far field transformation algorithms using the Phased Array Sonic Simulation System was studied. Existing electromagnetic near field measurement techniques and transformation algorithms (equations) were investigated. It was analytically determined that acoustic verification is valid. Acoustic simulation of electromagnetic near field to far field transformations is emphasized. The acoustic simulation of electromagnetic near field to far field transformation is verified for the modal expansion method. In the modal expansion method, data from antenna near field measurements are converted to a summation or spectrum of modes corresponding to wave numbers in the measurement coordinate system. Fourier transformation of those measurements preserves the far field information in a spectral form that is then readily extractable.
Endfire-tapered slot antennas are suitable for many integrated circuit applications, imaging and phased arrays. An investigation of single elements of such antennas, including slots which are exponentially tapered (Vivaldi), linearly tapered, and constant width. For antennas of all types, a good general agreement is obtained for curves of beamwidth-versus-length, normalized to wavelength, when one compares the data with that for traveling-wave antennas published by Zucker (1961). An important condition for this agreement is that the effective dielectric thickness, defined in the text, is in a certain optimum range. This condition is qualitatively explained in terms of the theory for traveling-wave antennas.