Engineering Papers⌕ Search

SEARCH · Engineering Papers

Results for “Particle size distribution”

Search indexed NASA NTRS and DOE OSTI research on propulsion, heat transfer, battery materials and energy systems. Follow report and document links to the original sources.

Quote a phrase for an exact phrase match. Source license links do not imply unrestricted reuse.

At least 703 records · Page 39

Calculating the obscuration ratio due to particle surface contamination

A useful method for the calculation of the obscuration ratio due to particle surface contamination is described. Equations are developed for calculating the obscuration ratio for spherical particles (with diameters greater than 1 micron) and fibers for surfaces where the particle size distribution is either known to be or assumed to be of the form of a MIL-STD-1246A distribution. A simple approximation to the obscuration ratio discrete data is then derived, where the contribution from a single size interval only is treated. This derivation obtains tighter bounds on the approximation error than are provided by the usual direct approach.

Barengoltz, Jack↗

Analysis of mid-tropospheric Space Shuttle exhausted aluminum oxide particles

Aluminum oxide particles from the exhaust of the Space Shuttle were collected immediately after the launch of the SEPEX mission and during the descent over the altitude interval of 7.6-4.6 km. The SEM examination revealed that the particles were spherical and ranged in diameter from about 0.1 micron to 10 microns. Results from the energy dispersive analysis (by an X-ray method) and of the particle chemistry (by electron spectroscopy) confirmed that the particles were predominantly composed of aluminum and oxygen. The particle size distribution of the Al2O3 was bimodal, with one observed peak centered near 2.0 microns; the other distribution mode centered at a diameter of less than 0.3 micron, but could not be accurately located. A mass median diameter was slightly less than 2 microns. Evaluation of ice nucleation activity revealed only a small fraction (about 1 ppm) of active ice nuclei among the Al2O3 particulates.

Cofer, Wesley R., III↗

Performance and operating envelope of imaging and scattering particle sizing instruments

Scattering and imaging type particle sizing instruments are analyzed in terms of their ability to make accurate determinations of particle size distributions, number density, and total mass. Sources of counting and sizing errors are explained. Ways are described of identifying these errors and how these errors can effect the measurements.

Hovenac, Edward A.↗

Photometric properties of lunar terrains derived from Hapke's equation

The fitting of Hapke's (1986) photometric parameters to the lunar disk-integrated visual lightcurve, as well as to disk-resolved data of Shorthill et al. (1969) for dark, average, and bright lunar terrains, leads to computational results from the disk-integrated results for the nearside geometric albedo and phase integral that are consistent with those of earlier investigations. The angular width of the opposition surge, which is noted to be greatest in dark terrains, can be accounted for in terms of modest differences in regolith particle-size distributions that could be associated with regolith maturation.

Helfenstein, Paul↗

On the relationship between optical polarization and extinction

A sample of stars including lines of sight within various dense clouds and stars in the diffuse interstellar medium are examined in order to investigate the relationship between various color ratios and the wavelength of the maximum of the interstellar polarization, lambda(max). The correlation of Serkowski (1975) is confirmed. The extinction laws have been fitted by minimizing the square deviations from the observed colors and the derived law. The results suggest that variations in lambda(max) are caused by differences in particle size distributions. Stars with large lambda(max) are noted in the outer regions of dense clouds, regions which are probably disturbed.

Clayton, Geoffrey C.↗

Color gradients in the coma of P/Halley

Some important information relevant to the understanding of the gas/dust dynamics near the surface of a comet nucleus concerns knowledge of the grain composition and scattering properties as well as the particle size distribution of dust in the coma. Ground based measurements of light scattered from the dust comae can provide some information about the physical grain properties, in particular about the mean optically dominant grain size. Optical spectra of continua of nine comets presented by Jewitt and Meech, 1986, show that all of the scattered light is reddened with respect to the Sun. There is significant scatter in the amount of reddening seen for different comets. In the near IF regions, the reddening decreases until near 2 to 3 micrometers where the reflectivity is nearly neutral. It is of particular interest to see if there are any observable changes in the grain size distribution during outburst. Although no coma colar changes were observed during the Nov. 1985 outbursts, a color gradient within the coma has been observed in Halley. Radial color gradients in J, H, and K images of Halley as reported by Campins have not been observed by the author.

Meech, Karen↗

Radar observations of Comet Halley

Five nights of Arecibo radar observations of Comet Halley are reported which reveal a feature in the overall average spectrum which, though weak, seems consistent with being an echo from the comet. The large radar cross section and large bandwidth of the feature suggest that the echo is predominantly from large grains which have been ejected from the nucleus. Extrapolation of the dust particle size distribution to large grain sizes gives a sufficient number of grains to account for the echo. The lack of a detectable echo from the nucleus, combined with estimates of its size and rotation rate from spacecraft encounters and other data, indicate that the nucleus has a surface of relatively high porosity.

Campbell, D. B.↗

SAGE II aerosol data validation and initial data use - An introduction and overview

The process of validating data from the Stratospheric Aerosol and Gas Experiment (SAGE) II and the initial use of the validated data are reviewed. The instruments developed for the SAGE II, the influence of the eruption of El Chichon on the global stratospheric aerosol, and various data validation experiments are discussed. Consideration is given to methods for deriving aerosol physical and optical properties from SAGE II extinction data and for inferring particle size distribution moments from SAGE II spectral extinction values.

Russell, P. B.↗

Infrared imaging of the coma of Comet Wilson

The brightness of the nuclear condensation noted in March 13-15, 1987 thermal IR images of Comet Wilson did not vary, in contrast to Comet Halley's behavior; a dynamical analysis of the dust coma/tail structure establishes that the particle size distribution in this comet, while different from that of Comet Giacobini-Zinner, is nevertheless more similar to that in Comet Halley. The nonisotropic character of the dust ejection is taken to be evidence for prograde rotation of the nucleus, and it is speculated that Comet Wilson is too young to have developed a dust mantle; this would account for the lack of short time scale variability.

Campins, Humberto↗

On the use of IR lidar and K(sub a)-band radar for observing cirrus clouds

Advances in lidar and radar technology have potential for providing new and better information on climate significant parameters of cirrus. Consequently, the NOAA Wave Propagation Lab. is commencing CLARET (Cloud Lidar And Radar Exploratory Test) to evaluate the promise of these new capabilities. Parameters under study include cloud particle size distribution, height of cloud bases, tops, and multiple layers, and cloud dynamics revealed through measurement of vertical motions. The first phase of CLARET is planned for Sept. 1989. The CO2 coherent Doppler lidar and the sensitive K sub a band radar hold promise for providing valuable information on cirrus that is beyond the grasp of current visible lidars.

Eberhard, Wynn L.↗

Physical characterization of asteroid surfaces from photometric analysis

The feasibility of using photometric models like Hapke's (1981, 1984, 1986) equation for deriving physical properties of asteroids from photometric observations is discussed. Using data for Ceres and Vesta, it is shown that the incomplete phase-angle coverage limits the reliable determination of Hapke's photometric parameters from asteroid disk-integrated phase curves (the second limitation is the nonsphericity of many asteroids). However, within this limitations, certain trends among asteroids can be compared. It is shown that there is a general similarity among the Hapke's parameters other than the h parameter, which characterizes the width of the opposition surge in terms of soil structure (porosity, particle-size distribution, and the rate of compaction with depth), derived for similar objects, e.g., average C asteroids and Ceres, and average S asteroids, 1982 Apollo, and Vesta.

Helfenstein, P.↗

Aircraft microwave observations and simulations of deep convection at 18-183 GHz

A radiative transfer model is used to simulate the aircraft multichannel microwave observations and to study a storm system observed on June 29, 1986 during the Cohmex program. The model, which is a revision of the model used by Wilheit et al. (1982), is described. The microwave upwelling brightness temperatures at the top of the atmosphere are calculated from hydrometeor profiles derived from ground-based radar data. The model is used to study various vertical hydrometeor phase profiles and particle size distributions. The results are compared with aircraft data from the Multispectral Cloud Radiometer and the Microwave Precipitation Radiometer. The results show that the brightness temperatures are directly influenced by the complex nature of hydrometeors, including size distribution and the mixture of ice and water phases.

Adler, R. F.↗

Coarsening in high volume fraction nickel-base alloys

The coarsening behavior of the gamma-prime precipitate has been examined in high volume fraction nickel-base alloys aged at elevated temperatures for times of up to 5000 h. Although the cube rate law was observed during coarsening, none of the presently available coarsening theories showed complete agreement with the experimental particle size distributions (PSDs). These discrepancies were thought to be due to elastic coherency strains which were not considered by the available models. Increasing the Mo content significantly influenced the PSDs and decreased the coarsening rate of the gamma-prime cubes, as a result of increasing the magnitude of the lattice mismatch. After extended aging times, the gamma-prime cubes underwent massive coalescence into plates at a rate which was much faster than the cuboidal coarsening rate. Once the gamma-prime plates were formed, further coarsening was not observed, and this stabilization of the microstructure was attributed to the development of dislocation networks at the gamma-gamma-prime interfaces.

Mackay, R. A.↗

Possible Aeolian megaripples on Mars

Viking orbiter image frames 442B01-10, at 8 m/pxl resolution show that valley floors are not smooth at all, but rather are covered with mounds of material interpreted as dunes. Striations oriented perpendicular to the valley axis can be seen in several locations. The striations are here interpreted to be aeolian megaripples formed from debris weathered from the yardangs. Terrestrial aeolian megaripples have wavelengths up to 25 m; it is not unreasonable that larger megaripples might form under favorable Martian conditions, given the wind speeds available and the lower Martian gravity. If the megaripple interpretation is correct, then by terrestrial analog the deposit in which they occur has a bimodal particle size distribution. One size will undergo saltation; the other, concentrated at the crests of the megaripples, is too large/and or too dense to be put into saltation. For Mars the former is sand-sized, the latter gravel-sized, provided the materials have typical densities.

Williams, S. H.↗

A global data set of soil particle size properties

A standardized global data set of soil horizon thicknesses and textures (particle size distributions) was compiled. This data set will be used by the improved ground hydrology parameterization designed for the Goddard Institute for Space Studies General Circulation Model (GISS GCM) Model 3. The data set specifies the top and bottom depths and the percent abundance of sand, silt, and clay of individual soil horizons in each of the 106 soil types cataloged for nine continental divisions. When combined with the World Soil Data File, the result is a global data set of variations in physical properties throughout the soil profile. These properties are important in the determination of water storage in individual soil horizons and exchange of water with the lower atmosphere. The incorporation of this data set into the GISS GCM should improve model performance by including more realistic variability in land-surface properties.

Webb, Robert S.↗

Lidar measurements at Garmisch, conversion model, and midlatitude aerosol effects

Lidar backscatter soundings of stratospheric aerosol layer were routinely made at the IFU, Garmisch-Partenkirchen. After 1979 significant perturbations of the stratosphere were observed after volcano eruptions from 1980 to 1985. A volcanically quiescent period followed until the eruption at the end of 1989. Determinations of particle extinction, mass and surface area of the stratospheric particulate load are important in climatic considerations and heterogeneous chemistry effects. Balloon-borne particle counter measurements are used to derive height and time resolved conversion factors to convert lidar backscatter data to extinction, mass and surface area values. This is done by combining particle size distributions with Mie backscatter and extinction functions. These conversion factors are applicable to midlatitude lidar observations and were used to convert ruby lidar measurement at the IFU.

Jaeger, Horst↗

Improved evaluation of optical depth components from Langley plot data

A simple, iterative procedure to determine the optical depth components of the extinction optical depth measured by a solar radiometer is presented. Simulated data show that the iterative procedure improves the determination of the exponent of a Junge law particle size distribution. The determination of the optical depth due to aerosol scattering is improved as compared to a method which uses only two points from the extinction data. The iterative method was used to determine spectral optical depth components for June 11-13, 1988 during the MAC III experiment.

Biggar, S. F.↗

Mechanical alloying, characterization and consolidation of Ti-Al-Ni alloys

Mechanical alloying is being investigated as a processing route for the production of aluminide intermetallics. This program involves powder production and characterization, consolidation and thermal treatments and determination of microstructure-property relationships. An attritor mill is being used to produce powder in lots up to 1000 grams and the processing parameters are being systematically varied to establish the optimum milling conditions. The mill is being instrumented to generate data related to the processing to provide a basis for theoretical modeling. Powder is being characterized using thermal analysis, optical and electron microscopy and X-ray diffraction. Particle size distributions and powder density are being determined. Consolidation of the powder is being approached in several different ways including, cold isostatic pressing, sintering, extrusion and hot pressing. The results of the program so far will be presented and future directions discussed.

Nash, P.↗